IRRIGATION OF UROPIGIAN GLAND OF DOMESTIC FOWLS (Gallus gallus domesticus) OF COBB LINEAGE

In this study was evaluated the vascular system of uropigian gland in 34 fowls (Gallus gallus domesticus), of Cobb lineage. The material was donated by the firm Globo Aves, located in Uberlandia - MG. Was specially studied the origin of collaterals that are aimed to that gland. Animals had them arterial contingents injected with a colored solution of neoprene latex, by polyethylene canulas through the right isquiatic artery. Then was injected an aqueous solution of formol 10%, in subcutaneous and intracavity spaces, which made possible the material fixation. Finally was proceeded the individually dissection of circumscribed region of uropigian gland. Opportunely was used a monocular lens in observation of vascular profile and was prepared schematics models representing the irrigation of each fowl. Uropigian gland showed itself as irrigated by mediana caudal artery in all (100%) animals, through its intersegmentaries branches, which emit right and left lateral glandular branchs and, right and left medials. Was counted the sub-branches, and was verified bigger emission in the right by the M. D. 1,1 and 1,2; and in the left by the M. E. 1,1 and 1,2.

Qualitative Analysis of the Removal of the Smear Layer in the Apical Third of Curved Roots: Conventional Irrigation versus Activation Systems

Introduction: The aim of this study was to evaluate the effectiveness of different irrigant agitation techniques on smear layer removal in curved root canals. Methods: Mesiobuccal canals of 62 extracted lower molars with a curvature of 33 degrees were used and instrumented up to Pro Taper F2. The samples were divided into 3 experimental groups according to the final irrigation: conventional irrigation, ultrasonic irrigation, and sonic irrigation by using the Endo Activator system. The control group was composed of 2 specimens without any final irrigation. In all of the experimental groups, 5 mL of 17% ethylenediaminetetraacetic acid was used for 1 minute, and 5 mL of 2.5% NaOCl was used for 30 seconds. The analysis of the apical region was performed via scanning electron microscopy by 3 examiners. The data were submitted to the Kruskal-Wallis and Dunn tests (P<.05). Results: The activation systems removed significantly more smear layer than did conventional irrigation. Conclusions: Sonic and ultrasonic irrigation resulted in better removal of the smear layer in the apical third of curved root canals than did conventional irrigation. (J Endod 2011;37:1268-1271)

Sex-biased hatching sequences in the cooperatively breeding Noisy Miner

The Noisy Miner Manorina melanocephala (Meliphagidae) is a cooperatively breeding bird species in which sons often remain on their natal home ranges and help one or both of their parents. In a population of Noisy Miners in SE Queensland, Australia, a molecular technique was used to explore adult and offspring sex ratios. and also hatching sequences. Among the adult population, there were 2.31 males for every female, and roughly 99% of helping was performed by males. At hatching and fledging, the population sex ratio was even, with exactly 57 males and 57 females. However, in 17 out of 18 broods the first egg to hatch was male, First-hatched males were significantly larger and heavier than their sisters just prior to fledging. Through their helping behaviour, large healthy sons could clearly enhance the future reproductive success of parents. and benefit the entire group. Sex-biased hatching sequences could potentially provide cooperatively breeding birds with a subtle and precise way of varying investment in the helping sex.

The management of rice grown on raised beds with continuous furrow irrigation

A field experiment compared two rice (Oryza sativa L.) cropping systems: paddy or raised beds with continuous furrow irrigation; and trialled four cultivars: Starbonnet, Lemont, Amaroo and Ceysvoni, and one test line YRL39; that may vary in adaptation to growth on raised beds. The grain yield of rice ranged from 740 to 1250 g/m(2) and was slightly greater in paddy than on raised beds. Although there were early growth responses to fertilizer nitrogen on raised beds, the crop nitrogen content at maturity mostly exceeded 20 g/m(2) in both systems, so nitrogen was unlikely to have limited yield. Ceysvoni yielded best in both systems, a result of good post-anthesis growth and larger grain size, although its whole-grain mill-out percentage was poor relative to the other cultivars. Starbonnet and Lemont yielded poorly on raised beds, associated with too few tillers and too much leaf area. When grown on raised beds all cultivars experienced a delay in anthesis resulting in more tillers, leaf area and dry weight at anthesis, and probably a greater yield potential. The growth of rice after anthesis, however, was similar on raised beds and in paddy, so reductions in harvest index and grain size on raised beds were recorded. The data indicated that water supply was not a major limitation to rice growth on raised beds, but slower crop development was an issue that would affect the use of raised beds in a cropping system, especially in rice-growing areas where temperatures are too cool for optimal crop development. (C) 2001 Elsevier Science B.V. All rights reserved.

Genotype-by-management interactions for grain yield and grain protein concentration of wheat

The magnitude of genotype-by-management (G x M) interactions for grain yield and grain protein concentration was examined in a multi-environment trial (MET) involving a diverse set of 272 advanced breeding lines from the Queensland wheat breeding program. The MET was structured as a series of management-regimes imposed at 3 sites for 2 years. The management-regimes were generated at each site-year as separate trials in which planting time, N fertiliser application rate, cropping history, and irrigation were manipulated. irrigation was used to simulate different rainfall regimes. From the combined analysis of variance, the G x M interaction variance components were found to be the largest source of G x E interaction variation for both grain yield (0.117 +/- 0.005 t(2) ha(-2); 49% of total G x E 0.238 +/- 0.028 t(2) ha(-2)) and grain protein concentration (0.445 +/- 0.020%(2); 82% of total G x E 0.546 +/- 0.057%(2)), and in both cases this source of variation was larger than the genotypic variance component (grain yield 0.068 +/- 0.014 t(2) ha(-2) and grain protein 0.203 +/- 0.026%(2)). The genotypic correlation between the traits varied considerably with management-regime, ranging from -0.98 to -0.31, with an estimate of 0.0 for one trial. Pattern analysis identified advanced breeding lines with improved grain yield and grain protein concentration relative to the cultivars Hartog, Sunco and Meteor. It is likely that a large component of the previously documented G x E interactions for grain yield of wheat in the northern grains region are in part a result of G x M interactions. The implications of the strong influence of G x M interactions for the conduct of wheat breeding METs in the northern region are discussed. (C) 2001 Elsevier Science B.V. All rights reserved.

Breeding for low input conditions and consequences for participatory plant breeding: Examples from tropical maize and wheat

Participatory plant breeding (PPB) has been suggested as an effective alternative to formal plant breeding (FPB) as a breeding strategy for achieving productivity gains under low input conditions. With genetic progress through PPB and FPB being determined by the same genetic variables, the likelihood of success of PPB approaches applied in low input target conditions was analyzed using two case studies from FPB that have resulted in significant productivity gains under low input conditions: (1) breeding tropical maize for low input conditions by CIMMYT, and (2) breeding of spring wheat for the highly variable low input rainfed farming systems in Australia. In both cases, genetic improvement was an outcome of long-term investment in a sustained research effort aimed at understanding the detail of the important environmental constraints to productivity and the plant requirements for improved adaptation to the identified constraints, followed up by the design and continued evaluation of efficient breeding strategies. The breeding strategies used differed between the two case studies but were consistent in their attention to the key determinants of response to selection: (1) ensuring adequate sources of genetic variation and high selection pressures for the important traits at all stages of the breeding program, (2) use of experimental procedures to achieve high levels of heritability in the breeding trials, and (3) testing strategies that achieved a high genetic correlation between performance of germplasm in the breeding trials and under on-farm conditions. The implications of the outcomes from these FPB case studies for realizing the positive motivations for adopting PPB strategies are discussed with particular reference for low input target environment conditions.

Determination of breeding strategies for beef cattle bull breeders selling bulls into two competing markets on a non-linear price grid

Computer simulation was used to suggest potential selection strategies for beef cattle breeders with different mixes of clients between two potential markets. The traditional market paid on the basis of carcass weight (CWT), while a new market considered marbling grade in addition to CWT as a basis for payment. Both markets instituted discounts for CWT in excess of 340 kg and light carcasses below 300 kg. Herds were simulated for each price category on the carcass weight grid for the new market. This enabled the establishment of phenotypic relationships among the traits examined [CWT, percent intramuscular fat (IMF), carcass value in the traditional market, carcass value in the new market, and the expected proportion of progeny in elite price cells in the new market pricing grid]. The appropriateness of breeding goals was assessed on the basis of client satisfaction. Satisfaction was determined by the equitable distribution of available stock between markets combined with the assessment of the utility of the animal within the market to which it was assigned. The best goal for breeders with predominantly traditional clients was a CWT in excess of 330 kg, while that for breeders with predominantly new market clients was a CWT of between 310 and 329 kg and with a marbling grade of AAA in the Ontario carcass pricing system. For breeders who wished to satisfy both new and traditional clients, the optimal CWT was 310-329 kg and the optimal marbling grade was AA-AAA. This combination resulted in satisfaction levels of greater than 75% among clients, regardless of the distribution of the clients between the traditional and new marketplaces.

Changes in progesterone and testosterone during the breeding season of the large-footed myotis Myotis moluccarum (Microchiroptera : Vespertilionidae)

The reproductive biology of the large-footed myotis, Myotis moluccarum, was studied during the annual breeding season in southeast Queensland, Australia. Previous research has shown the species to be polyoestrous and monotoccous, producing two consecutive young with some degree of synchrony in late October to early November and again in late January to early February. Hormonal data was collected and observations of the female reproductive tract made in order to ascertain the reproductive cycle of this species. In July, when females were not pregnant, progesterone concentrations were 1.9 +/- 0.9 ng/ml. During the two gestation periods, progesterone concentrations increased progressively until late pregnancy at the end of October through to early November and again in late January to early February. During the latest stages of pregnancy, progesterone concentrations of 69.9 +/- 18.7 ng/ml were reached. It is suggested that a plasma progesterone concentration in excess of about 8 ng/ml indicates pregnancy in this species. Plasma testosterone concentration in males reached a peak of 43.1 +/- 9.81 ng/ml in July, and was then variable until December when levels declined significantly to 2.0 +/- 1.7 ng/ml.

Breeding dynamics of koalas in open woodlands

The spatial and breeding dynamics of koalas in sub-tropical woodlands at Blair Athol in central Queensland were intensively monitored between 1993 and 1998. Genetic relationships among koalas at this locality were studied to determine the breeding dynamics of males, including whether 'resident' or 'transient' males dominate as sires. Males and females were radio-collared and tracked periodically throughout each year of the study. Genotypes from hypervariable microsatellite loci identified uniquely all individuals and were used to analyse parentage as well as to determine population genetic parameters when compared with other regional localities. Koalas at Blair Athol comprise a population in genetic equilibrium. Gene diversity estimates show the population to be similar to other populations found in similar habitat in the region, and estimates of genetic differentiation among four regional populations showed that gene flow conforms to a model of isolation by distance. Analysis of parentage found that both resident and transient males sired about equal numbers of offspring. Familial DNA analysis revealed multiple paternities of successive young in this population. The conclusion from this study is that 'resident' status among males does not confer any advantage for parentage.