Experimental determination of layer cloud edge charging from cosmic ray ionisation

The cloud-air transition zone at stratiform cloud edges is an electrically active region where droplet charging has been predicted. Cloud edge droplet charging is expected from vertical flow of cosmic ray generated atmospheric ions in the global electric circuit. Experimental confirmation of stratiform cloud edge electrification is presented here, through charge and droplet measurements made within an extensive layer of supercooled stratiform cloud, using a specially designed electrostatic sensor. Negative space charge up to 35 pC m−3 was found in a thin (<100 m) layer at the lower cloud boundary associated with the clear air-cloud conductivity gradient, agreeing closely with space charge predicted from the measured droplet concentration using ion-aerosol theory. Such charge levels carried by droplets are sufficient to influence collision processes between cloud droplets.

Compact cosmic ray detector for unattended atmospheric ionisation monitoring

Two vertical cosmic ray telescopes for atmospheric cosmic ray ionization event detection are compared. Counter A, designed for low power remote use, was deployed in the Welsh mountains; its event rate increased with altitude as expected from atmospheric cosmic ray absorption. Independently, Counter B’s event rate was found to vary with incoming particle acceptance angle. Simultaneous colocated comparison of both telescopes exposed to atmospheric ionization showed a linear relationship between their event rates.

Vertical profile measurements of lower troposphere ionisation

Vertical soundings of the atmospheric ion production rate have been obtained from Geiger counters integrated with conventional meteorological radiosondes. In launches made from Reading (UK) during 2013-2014, the Regener-Pfotzer ionisation maximum was at an altitude equivalent to a pressure of (63.1±2.4) hPa, or, expressed in terms of the local air density, (0.101±0.005) kgm−3. The measured ionisation profiles have been evaluated against the Usoskin-Kovaltsov model and, separately, surface neutron monitor data from Oulu. Model ionisation rates agree well with the observed cosmic ray ionisation below 20 km altitude. Above 10 km, the measured ionisation rates also correlate well with simultaneous neutron monitor data, although, consistently with previous work, measured variability at the ionisation maximum is greater than that found by the neutron monitor. However, in the lower atmosphere (below 5 km altitude), agreement between the measurements and simultaneous neutron monitor data is poor. For studies of transient lower atmosphere phenomena associated with cosmic ray ionisation, this indicates the need for in situ ionisation measurements and improved lower atmosphere parameterisations.

Effect of hydrogen/air flow rates and scan rate on the flame ionisation detection response of phopholipids, and their quantitative and qualitative analysis by Iatroscan (Mark‐6s) TLC‐FID

The combined effect of scan speed, hydrogen and air flow rates on the flame ionization detection (FID) peak response of phospholipid classes has been studied to determine the optimum levels of these parameters. The phospholipid composition of different types of commercial lecithins, as well as lecithins combined with fish oils, has been analyzed by Iatroscan TLC‐FID Mark‐6s under optimized conditions. An air flow rate of 2 L/min, a hydrogen flow rate of 150–160 mL/min, and a scan speed of 30 s/rod seem to be the ideal conditions for scanning phospholipids with complete pyrolysis in the flame in the Mark‐6 model. Increasing the scan speed rapidly decreased the FID response. A hydrogen flow rate as high as 170 mL/min could be used at relatively low air flow rates (&#x003C2 L/min) and the response declined when both air flow rate and hydrogen flow rate increased simultaneously. Both linear and curvilinear relationships had highly significant correlations (p&#x003C0.01) with the sample load. Time course reactions, including the hydrolysis of phosphatidylserine using enzymes, can be successfully monitored by the Iatroscan TLC‐FID Chromarod system.

Solid-phase extraction of sugar cane soot extract for analysis by gas chromatography with flame ionisation and mass spectrometric detection

The incomplete combustion of biomass is one of the most important sources of emissions of organic compounds into the atmosphere, like polycyclic aromatic hydrocarbons (PAHs) which show genotoxic activity. Since environmental samples generally contain interferents and trace amounts of PAHs of interest, concentration and clean-up procedures are usually required prior to the final chromatographic analysis. This paper discusses the performance of Sep-Pak cartridges (silica gel and RP18) on clean-up of sugar cane soot extract. The best results were obtained with a silica Sep-Pak cartridge. The recoveries ranged from 79% (benzo[b]fluoranthene) to 113% (benzo[e]pyrene). (C) 2000 Elsevier B.V. B.V. All rights reserved.

Entwicklung und Anwendung eines Verfahrens zur Bestimmung von halogenierten Kohlenwasserstoffen in Luft mittels anreichernder Probenahme,Thermodesorption und GC,MS mit negativer chemischer Ionisation

Flüchtige organische Halogenverbindungen übernehmen in der Chemie der Troposphäre eine Schlüsselrolle. Photolytisch gebildete Halogenatome reagieren mit troposphärischem Ozon und können durch Oxidation, vor allem von Iod, zur Neubildung von Partikeln beitragen. Auf diese Weise beeinflussen Halogenalkane den Strahlungshaushalt der Atmosphäre. Aus analytischem Blickwinkel ist es wichtig die Konzentration der einzelnen Spezies zu untersuchen um Rückschlüsse auf deren biotische oder abiotische Quellen ziehen und die Emissionswege besser verstehen zu können. Im Rahmen der vorliegenden Arbeit wurde daher eine sensitive Methode zur Untersuchung von halogenierten Kohlenwasserstoffen entwickelt, basierend auf anreichernder Probenahme mit anschließender Thermodesorption und der Analyse mittels Massenspektrometrie mit negativer chemischer Ionisation. Die Kennwerte der Methode sind: Nachweisgrenzen zwischen 0.11 pg und 5.86 pg bzw. zwischen 1.0 ppqV und 44.7 ppqV, Linearität zwischen R2=0.993 und R2=1.000, Reproduzierbarkeit (Triplikate) RSD < 15 % und ein sicheres Probenahmevolumen von 10 L. Die Methode wurde im Anschluss im Rahmen von zwei Feldmessungen, in Mace Head, Irland und auf einer Schiffskampagne im antarktischen Amundsen-Meer, angewendet. Durch die Ergebnisse aus Irland kann gezeigt werden, dass die Mischungsverhältnisse der Iodalkane mit denen früherer Studien vergleichbar sind, und dass die verschiedenen untersuchten Algenarten deutlich unterschiedliche Emissionsraten zeigen. Die Ergebnisse der Kampagne im Amundsen-Meer zeigen einen großen Einfluss der Windrichtung auf die Halogenalkan-Konzentrationen. So sind die Mischungsverhältnisse der Halogenalkane deutlich höher, wenn der Wind zuvor über die antarktischen Eisflächen strömt. Für die biotischen Quellen wurden die Emissionsraten ausgewählter Makroalgen unter dem Einfluss von Ozon untersucht. Die Emissionsrate der Iodalkane zeigt einen exponentiellen Zusammenhang, sowohl zur I2-Emission als auch zum Gesamtiodgehalt der Algen. Unter oxidativen Bedingungen zeigt L. Digitata eine linear steigende Iodalkanemission. Mit diesem Verhalten wird die These der Bildung von Iodalkanen als Nebenprodukt beim Abbau reaktiver Sauerstoffspezies unterstützt. Neben den Makroalgen wurden auch Mikroalgen als biotische Quellen untersucht. Hierbei können zwei unterschiedliche Emissionsmuster der Halogenalkane für Diatomeen und Phaeocystis sp. gezeigt werden. Im Gegensatz zur Iodalkan-Emission hängt die I2 Emission der Mikroalgenproben von der Ozonkonzentration der Luft ab. Durch die lineare Korrelation der I2-Emission mit der Iodid-Konzentration der wässrigen Phase einerseits, und dem Ozonverbrauch andererseits, kann die Bildung von I2 durch Oxidation von Iodid durch Ozon bestätigt werden. Für das Emissionsverhalten der Mikroalgenprobe aus dem Sylter Wattenmeer, welche keine Korrelation mit dem verbrauchten Ozon zeigt, gibt es zwei Erklärungen: Zum einen kann I2 durch den hohen Gehalt an organischen Verbindungen an diesen adsorbiert bzw. chemisch gebunden werden und wird dann nicht mehr in die Gasphase emittiert. Zum anderen können aktive organische Verbindungen das Gleichgewicht zwischen HOI und I2 in Richtung HOI verlagern. Im Versuch zur abiotischen Bildung von Iodalkanen aus Partikeln, bestehend aus I2O5 und verschiedenen Alkoholen, kann gezeigt werden, dass die Bildung von Iodmethan und Diiodmethan abläuft, dass jedoch die Emission bis zu zwei Größenordnungen kleiner ist als die von I2. Somit trägt die Bildung von Iodalkanen nur in einem sehr eingeschränkten Rahmen zum Recycling des Iods in der Atmosphäre bei. Der vorgestellte abiotische Bildungsweg hängt sowohl vom pH-Wert als auch vom Mischungsverhältnis im Partikel ab.

Study of rapid ionisation for simulation of soft X-ray lasers with the 2D hydro-radiative code ARWEN

We present our fast ionisation routine used to study transient softX-raylasers with ARWEN, a two-dimensional hydrodynamic code incorporating adaptative mesh refinement (AMR) and radiative transport. We compute global rates between ion stages assuming an effective temperature between singly-excited levels of each ion. A two-step method is used to obtain in a straightforward manner the variation of ion populations over long hydrodynamic time steps. We compare our model with existing theoretical results both stationary and transient, finding that the discrepancies are moderate except for large densities. We simulate an existing Molybdenum Ni-like transient softX-raylaser with ARWEN. Use of the fast ionisation routine leads to a larger increase in temperature and a larger gain zone than when LTE datatables are used.

Uber die Absorption der Rontgenstrahlen durch Metallbleche verschiedener Dicke, gemessen durch die von den Rontgenstrahlen bewirkte Ionisation der Gase.

Thesis (doctoral)--Universitat Basel.

Ionisation der Luft des rheinisch-westfälischen Industrregebiets und Radioaktivität von Bodenproben des Karbons /

Thesis (doctoral)--Universität Freiburg im Breisgau, 1908.

Peptide quantification by matrix-assisted laser desorption ionisation time-of-flight mass spectrometry: Investigations of the cyclotide kalata B1 in biological fluids

A rapid method has been developed for the quantification of the prototypic cyclotide kalata B I in water and plasma utilizing matrix-assisted laser desorption ionisation time-of-flight (MALDI-TOF) mass spectrometry. The unusual structure of the cyclotides means that they do not ionise as readily as linear peptides and as a result of their low ionisation efficiency, traditional LC/MS analyses were not able to reach the levels of detection required for the quantification of cyclotides in plasma for pharmacokinetic studies. MALDI-TOF-MS analysis showed linearity (R-2 > 0.99) in the concentration range 0.05-10 mu g/mL with a limit of detection of 0.05 mu g/mL (9 fmol) in plasma. This paper highlights the applicability of MALDI-TOF mass spectrometry for the rapid and sensitive quantification of peptides in biological samples without the need for extensive extraction procedures. (c) 2005 Elsevier B.V. All rights reserved.

Performance of five different electrospray ionisation sources in conjunction with rapid monolithic column liquid chromatography and fast MS/MS scanning

The performances of five different ESI sources coupled to a polystyrene-divinylbenzene monolithic column were compared in a series of LC-ESI-MS/MS analyses of Escherichia coli outer membrane proteins. The sources selected for comparison included two different modifications of the standard electrospray source, a commercial low-flow sprayer, a stainless steel nanospray needle and a coated glass Picotip. Respective performances were judged on sensitivity and the number and reproducibility of significant protein identifications obtained through the analysis of multiple identical samples. Data quality varied between that of a ground silica capillary, with 160 total protein identifications, the lowest number of high quality peptide hits obtained (3012), and generally peaks of lower intensity; and a stainless steel nanospray needle, which resulted in increased precursor ion abundance, the highest-quality peptide fragmentation spectra (5414) and greatest number of total protein identifications (259) exhibiting the highest MASCOT scores (average increase in score of 27.5% per identified protein). The data presented show that, despite increased variability in comparative ion intensity, the stainless steel nanospray needle provides the highest overall sensitivity. However, the resulting data were less reproducible in terms of proteins identified in complex mixtures -- arguably due to an increased number of high intensity precursor ion candidates.

Matrix-free mass spectrometric imaging using laser desorption ionisation Fourier transform ion cyclotron resonance mass spectrometry

Mass spectrometry imaging (MSI) is a powerful tool in metabolomics and proteomics for the spatial localization and identification of pharmaceuticals, metabolites, lipids, peptides and proteins in biological tissues. However, sample preparation remains a crucial variable in obtaining the most accurate distributions. Common washing steps used to remove salts, and solvent-based matrix application, allow analyte spreading to occur. Solvent-free matrix applications can reduce this risk, but increase the possibility of ionisation bias due to matrix adhesion to tissue sections. We report here the use of matrix-free MSI using laser desorption ionisation performed on a 12 T Fourier transform ion cyclotron resonance (FTICR) mass spectrometer. We used unprocessed tissue with no post-processing following thaw-mounting on matrix-assisted laser desorption ionisation (MALDI) indium-tin oxide (ITO) target plates. The identification and distribution of a range of phospholipids in mouse brain and kidney sections are presented and compared with previously published MALDI time-of-flight (TOF) MSI distributions.