Improved capacity and stability of integrated Li and Mn rich layered-spinel Li1.17Ni0.25Mn1.08O3 cathodes for Li-ion batteries

A Li-rich layered-spinel material with a target composition Li1.17Ni0.25Mn1.08O3 (xLiLi1/3Mn2/3]O-2.(1 - x) LiNi0.5Mn1.5O4, (x = 0.5)) was synthesized by a self-combustion reaction (SCR), characterized by XRD, SEM, TEM, Raman spectroscopy and was studied as a cathode material for Li-ion batteries. The Rietveld refinement results indicated the presence of monoclinic (LiLi1/3Mn2/3]O-2) (52%), spinel (LiNi0.5Mn1.5O4) (39%) and rhombohedral LiNiO2 (9%). The electrochemical performance of this Li-rich integrated cathode material was tested at 30 degrees C and compared to that of high voltage LiNi0.5Mn1.5O4 spinel cathodes. Interestingly, the layered-spinel integrated cathode material exhibits a high specific capacity of about 200 mA h g(-1) at C/10 rate as compared to 180 mA h g(-1) for LiNi0.5Mn1.5O4 in the potential range of 2.4-4.9 V vs. Li anodes in half cells. The layered-spinel integrated cathodes exhibited 92% capacity retention as compared to 82% for LiNi0.5Mn1.5O4 spinel after 80 cycles at 30 degrees C. Also, the integrated cathode material can exhibit 105 mA h g(-1) at 2 C rate as compared to 78 mA h g(-1) for LiNi0.5Mn1.5O4. Thus, the presence of the monoclinic phase in the composite structure helps to stabilize the spinel structure when high specific capacity is required and the electrodes have to work within a wide potential window. Consequently, the Li1.17Ni0.25Mn1.08O3 composite material described herein can be considered as a promising cathode material for Li ion batteries.

Ownership and co-management: towards the integrated management of Lake Victoria

The management of Lake Victoria is a high priority to the riparian countries that benefit directly from its resources. Management regulations have been formulated and implemented with the aim of maintaining the lake's ecological quality as well as sustaining fisheries exploitation for economic gain. Results indicate, however, that the regulations have not been successful in maintaining the state of the lake's ecosystem nor the fisheries. There has been a continuing decline in fish catches as well as declining biodiversity. Currently, the riparian countries are considering the introduction of a co-management regime as an alternative managerial strategy to address the lake's problems. In this paper it is argued that the failure of the former management regulations was because ownership of the lake was not clearly defined. It is further argued that even if co-management were to be successfully instituted, it will yield very minimal results if the problem of ownership is not properly addressed. This paper explores the ownership status of the lake based on data collected in Tanzania, and examines the relationship between, and significance of, ownership and co-management. The research makes recommendations for how these concepts can contribute to an integrated management of the lake

Measurement-Integrated simulations and Kalman filter applied to a co-flowing jet

This paper deals with the experimental evaluation of a flow analysis system based on the integration between an under-resolved Navier-Stokes simulation and experimental measurements with the mechanism of feedback (referred to as Measurement-Integrated simulation), applied to the case of a planar turbulent co-flowing jet. The experiments are performed with inner-to-outer-jet velocity ratio around 2 and the Reynolds number based on the inner-jet heights about 10000. The measurement system is a high-speed PIV, which provides time-resolved data of the flow-field, on a field of view which extends to 20 jet heights downstream the jet outlet. The experimental data can thus be used both for providing the feedback data for the simulations and for validation of the MI-simulations over a wide region. The effect of reduced data-rate and spatial extent of the feedback (i.e. measurements are not available at each simulation time-step or discretization point) was investigated. At first simulations were run with full information in order to obtain an upper limit of the MI-simulations performance. The results show the potential of this methodology of reproducing first and second order statistics of the turbulent flow with good accuracy. Then, to deal with the reduced data different feedback strategies were tested. It was found that for small data-rate reduction the results are basically equivalent to the case of full-information feedback but as the feedback data-rate is reduced further the error increases and tend to be localized in regions of high turbulent activity. Moreover, it is found that the spatial distribution of the error looks qualitatively different for different feedback strategies. Feedback gain distributions calculated by optimal control theory are presented and proposed as a mean to make it possible to perform MI-simulations based on localized measurements only. So far, we have not been able to low error between measurements and simulations by using these gain distributions.

Design and operation of integrated pilot-scale dimethyl ether synthesis system via pyrolysis/gasification of corncob

The integrated pilot-scale dimethyl ether (DME) synthesis system from corncob was demonstrated for modernizing utilization of biomass residues. The raw bio-syngas was obtained by the pyrolyzer/gasifier at the yield rate of 40-45 Nm(3)/h. The content of tar in the raw bio-syngas was decreased to less than 20 mg/Nm(3) by high temperature gasification of the pyrolysates under O-2-rich air. More than 70% CO2 in the raw bio-syngas was removed by pressure-swing adsorption unit (PSA). The bio-syngas (H-2/CO approximate to 1) was catalytically converted to DME in the fixed-bed tubular reactor directly over Cu/Zn/Al/HZSM-5 catalysts. CO conversion and space-time yield of DME were in the range of 82.0-73.6% and 124.3-203.8 kg/m(cat)(3)/h, respectively, with a similar DME selectivity when gas hourly space velocity (GHSV, volumetric flow rate of syngas at STP divided by the volume of catalyst) increased from 650 h(-1) to 1500 h(-1) at 260 degrees C and 4.3 MPa. And the selectivity to methanol and C-2(+) products was less than 0.65% under typical synthesis condition. The thermal energy conversion efficiency was ca. 32.0% and about 16.4% carbon in dried corncob was essentially converted to DME with the production cost of ca. (sic) 3737/ton DME. Cu (111) was assumed to be the active phase for DME synthesis, confirmed by X-ray diffraction (XRD) characterization.

Integrated techno-economic and environmental assessments of sixty scenarios for co-firing biomass with coal and natural gas

Displacement of fossil fuel-based power through biomass co-firing could reduce the greenhouse gas (GHG) emissions from fossil fuels. In this study, data-intensive techno-economic models were developed to evaluate different co-firing technologies as well as the configurations of these technologies. The models were developed to study 60 different scenarios involving various biomass feedstocks (wood chips, wheat straw, and forest residues) co-fired either with coal in a 500 MW subcritical pulverized coal (PC) plant or with natural gas in a 500 MW natural gas combined cycle (NGCC) plant to determine their technical potential and costs, as well as to determine environmental benefits. The results obtained reveal that the fully paid-off coal-fired power plant co-fired with forest residues is the most attractive option, having levelized costs of electricity (LCOE) of $53.12–$54.50/MW h and CO2 abatement costs of $27.41–$31.15/tCO2. When whole forest chips are co-fired with coal in a fully paid-off plant, the LCOE and CO2 abatement costs range from $54.68 to $56.41/MW h and $35.60 to $41.78/tCO2, respectively. The LCOE and CO2 abatement costs for straw range from $54.62 to $57.35/MW h and $35.07 to $38.48/tCO2, respectively.

Carers and Co-Production: Enabling Expertise through Experience?

Purpose To provide a brief overview of the literature to date which has focussed on co-production within mental healthcare in the UK, including service user and carer involvement and collaboration. Design The paper presents key outcomes from studies which have explicitly attempted to introduce co-produced care in addition to specific tools designed to encourage co-production within mental health services. The paper debates the cultural and ideological shift required for staff, service users and family members to undertake co-produced care and outlines challenges ahead with respect to service redesign and new roles in practice. Findings Informal carers (family and friends) are recognised as a fundamental resource for mental health service provision, as well as a rich source of expertise through experience, yet their views are rarely solicited by mental health professionals or taken into account during decision-making. This issue is considered alongside new policy recommendations which advocate the development of co-produced services and care. Research Limitations Despite the launch of a number of initiatives designed to build on peer experience and support, there has been a lack of attention on the differing dynamic which remains evident between healthcare professionals and people using mental health services. Co-production sheds a light on the blurring of roles, trust and shared endeavour (Slay and Stephens, 2013) but, despite an increase in peer recovery workers across England, there has been little research or service development designed to focus explicitly on this particular dynamic. Practical Implications Despite these challenges, coproduction in mental healthcare represents a real opportunity for the skills and experience of family members to be taken into account and could provide a mechanism to achieve the ‘triangle of care’ with input, recognition and respect given to all (service users, carers, professionals) whose lives are touched by mental distress. However, lack of attention in relation to carer perspectives, expertise and potential involvement could undermine the potential for coproduction to act as a vehicle to encourage person-centred care which accounts for social in addition to clinical factors. Social Implications The families of people with severe and enduring mental illness (SMI) assume a major responsibility for the provision of care and support to their relatives over extended time periods (Rose et al, 2004). Involving carers in discussions about care planning could help to provide a wider picture about the impact of mental health difficulties, beyond symptom reduction. The ‘co-production of care’ reflects a desire to work meaningfully and fully with service users and carers. However, to date, little work has been undertaken in order to coproduce services through the ‘triangle of care’ with carers bringing their own skills, resources and expertise. Originality/Value This paper debates the current involvement of carers across mental healthcare and debates whether co-production could be a vehicle to utilise carer expertise, enhance quality and satisfaction with mental healthcare. The critique of current work highlights the danger of increasing expectations on service providers to undertake work aligned to key initiatives (shared decision-making, person-centred care, co-production), that have common underpinning principles but, in the absence of practical guidance, could be addressed in isolation rather than as an integrated approach within a ‘triangle of care’.

Testing symmetry and homogeneity in the almost ideal demand system with co-integrated data using fully modified estimation and the bootstrap

Conventional seemingly unrelated estimation of the almost ideal demand system is shown to lead to small sample bias and distortions in the size of a Wald test for symmetry and homogeneity when the data are co-integrated. A fully modified estimator is developed in an attempt to remedy these problems. It is shown that this estimator reduces the small sample bias but fails to eliminate the size distortion.. Bootstrapping is shown to be ineffective as a method of removing small sample bias in both the conventional and fully modified estimators. Bootstrapping is effective, however, as a method of removing. size distortion and performs equally well in this respect with both estimators.

The co-development of technology and new buildings: incorporating building integrated photovoltaics

Current approaches for the reduction of carbon emissions in buildings are often predicated on the integration of renewable technologies into building projects. Building integrated photovoltaics (BIPV) is one of these technologies and brings its own set of challenges and problems with a resulting mutual articulation of this technology and the building. A Social Construction of Technology (SCOT) approach explores how negotiations between informal groups of project actors with shared interests shape the ongoing specification of both BIPV and the building. Six main groups with different interests were found to be involved in the introduction of BIPV (Cost Watchers, Design Aesthetes, Green Guardians, Design Optimizers, Generation Maximizers and Users). Their involvement around three sets of issues (design changes from lack of familiarity with the technology, misunderstandings from unfamiliar interdependencies of trades and the effects of standard firm procedure) is followed. Findings underline how BIPV requires a level of integration that typically spans different work packages and how standard contractual structures inhibit the smooth incorporation of BIPV. Successful implementation is marked by ongoing (re-)design of both the building and the technology as informal fluid groups of project actors with shared interests address the succession of problems which arise in the process of implementation.

Are nominal exchange rates and price levels co-integrated? new evidence from threshold autoregressive and momentum-threshold autoregressive models

The goal of this paper is to examine evidence for co-integration between nominal exchange rates for Canada, the UK, Japan, Germany, Italy and France (G6) vis-à-vis the US dollar, and the relative price ratios using monthly data over the period 1973:01 to 1997:04. Motivated by the fact that exchange rate adjustment may be asymmetric, we allowed for asymmetric adjustment in exchange rates by using the threshold autoregressive model and the momentum threshold autoregressive model. We do not find any evidence of a co-integrating relationship; hence, we fail to establish long-run purchasing power parity.

Osteogenic potential of mesenchymal cells derived from canine umbilical cord matrix co-cultured with platelet-rich plasma and demineralized bone matrix

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Ab-initio calculations for a realistic sensor: A study of CO sensors based on nitrogen-rich carbon nanotubes

The use of nanoscale low-dimensional systems could boost the sensitivity of gas sensors. In this work we simulate a nanoscopic sensor based on carbon nanotubes with a large number of binding sites using ab initio density functional electronic structure calculations coupled to the Non-Equilibrium Green's Function formalism. We present a recipe where the adsorption process is studied followed by conductance calculations of a single defect system and of more realistic disordered system considering different coverages of molecules as one would expect experimentally. We found that the sensitivity of the disordered system is enhanced by a factor of 5 when compared to the single defect one. Finally, our results from the atomistic electronic transport are used as input to a simple model that connects them to experimental parameters such as temperature and partial gas pressure, providing a procedure for simulating a realistic nanoscopic gas sensor. Using this methodology we show that nitrogen-rich carbon nanotubes could work at room temperature with extremely high sensitivity. Copyright 2012 Author(s). This article is distributed under a Creative Commons Attribution 3.0 Unported License. [http://dx.doi.org/10.1063/1.4739280]

Study of CuO/CeO2 catalyst with for preferential CO oxidation reaction in hydrogen-rich feed (PROX-CO)

The CuO/CeO2 system was investigated as a catalyst for preferential CO oxidation reaction in hydrogen-rich feed (PROX-CO). The catalysts were prepared by deposition-precipitation (DEP) and co-precipitation (COP) methods and the catalytic performance reveals that the preparation method influences the properties of solids prepared, where a direct consequence is the difference in behavior of the catalysts in the PROX-CO reaction. A high specific area and a better dispersion of the metallic phase were obtained in the catalyst prepared by co-precipitation. The redox properties during the reaction were reported by measures of temperature programmed reduction (TPR), OSC measurements and X-ray absorption near edge structure (XANES-TPR) in situ showed the relationship between the preparation method, the physicochemical characteristics and redox properties in the PROX-CO reaction. By this means, the good dispersion of CuO and the best oxygen capacity are the response of the high performance of CuO/CeO2-COP catalysts for the PROX-CO reaction. Crown Copyright (c) 2012 Published by Elsevier B.V. All rights reserved.