Yielding of engineering polymers at strain rates of up to 500 s-1

A method is described for measuring the mechanical properties of polymers in compression at strain rates in the range approximately 300-500 s-1. A gravity-driven pendulum is used to load a specimen on the end of an instrumented Hopkinson output bar and the results are processed by a microcomputer. Stress-strain curves up to high strains are presented for polycarbonate, polyethersulphone and high density polyethylene over a range of temperatures. The value of yield stress, for all three polymers, was found to vary linearly with log (strain rate) at strain rates up to 500 s-1. © 1985.

Subcarrier modulation for transmission of 1-Gbit/s channels over 500 m of 62.5-μm multimode fiber

The use of two different subcarriers at frequencies up to 5.5 GHz each transmitting 1 Gbit/s over 500 m of multimode fiber (MMF) is demonstrated. By transmitting the two subcarrier channels simultaneously alongside the baseband signal, an aggregate bit rate of 2.8 Gbit/s is possible.

Comparison of Pax1/9 locus reveals 500-Myr-old syntenic block and evolutionary conserved noncoding regions

Identification of conserved genomic regions within and between different genomes is crucial when studying genome evolution. Here, we described regions of strong synteny conservation between vertebrate deuterostomes (tetrapods and teleosts) and invertebrat

500 fs wideband tunable fiber laser mode-locked by nanotubes

Sub-picosecond tunable ultrafast lasers are important tools for many applications. Here we present an ultrafast tunable fiber laser mode-locked by a nanotube based saturable absorber. The laser outputs ∼500fs pulses over a 33 nm range at 1.5μm. This outperforms the current achievable pulse duration from tunable nanotube mode-locked lasers. © 2012 Elsevier B.V. All rights reserved.

抗辐射500门阵列的设计与制造

Submitted by zhangdi (zhangdi@red.semi.ac.cn) on 2009-04-13T11:45:31Z

SIMI 500综合业务通信系统

Submitted by zhangdi (zhangdi@red.semi.ac.cn) on 2009-04-13T11:45:31Z

DIRECT ION-BEAM DEPOSITION OF CARBON-FILMS ON SILICON IN THE ION ENERGY-RANGE OF 15-500 EV

Direct ion beam deposition of carbon films on silicon in the ion energy range of 15-500 eV and temperature range of 25-800-degrees-C has been studied. The work was carried out using mass-separated C+ and CH3+ ions under ultrahigh vacuum. The films were characterized with x-ray photoelectron spectroscopy, Raman spectroscopy, transmission electron microscopy, and transmission electron diffraction analysis. In the initial stage of the deposition, carbon implanted into silicon induced the formation of silicon carbide, even at room temperature. Further carbon ion bombardment then led to the formation of a carbon film. The film properties were sensitive to the deposition temperature but not to the ion energy. Films deposited at room temperature consisted mainly of amorphous carbon. Deposition at a higher temperature, or post-deposition annealing, led to the formation of microcrystalline graphite. A deposition temperature above 800-degrees-C favored the formation of microcrystalline graphite with a preferred orientation in the (0001) direction. No evidence of diamond formation in these films was observed.

Growth of near planar Si0.5Ge0.5 epitaxial layers directly on Si substrate by UHV/CVD at 500℃

The relationship between Ge content of Si1-xGex layers and growth conditions was investigated via UHV/CVD system at relative low temperature of 500℃. Si1-xGex layers were in a metastable state in this case. 10-period strained 3.0 nm- Si0.5Ge0.5/3.4 nm- Si multi quantum wells were obtained directly on Si substrate. Raman Measurement, high resolution electron microscopy and photoluminescence were used to characterize the structural and optical properties. It is found that such relative thick Si0.5Ge0.5/Si multi quantum wells are still near planar and free of dislocations, that makes it exploit applications to electrical and optical devices.

连续波500 W全固态Nd∶YAG激光器研究

研制了全国产化全固态半导体激光器(LD)抽运模块，Nd∶YAG激光输出功率达500 W。介绍了优化抽运模块结构参数的程度。从增益分布特性等方面，介绍了研究其输入-输出功率特性的实验装置，随着抽运功率的增加，Nd∶YAG激光输出以斜率效率47%线性增加，最大输出功率达到575 W，光-光转换效率达26.1%。采用He-Ne激光探测法实验测量了该抽运模块中的热透镜效应。通过测量热焦距，分析了其热透镜效应

SULFUR IX TO XIII SPECTRAL MEASURMENTS BETWEEN 170 AND 500Å

This paper reports laboratory measurements of the spectrum of highly ionized sulfur. The spectrum of S Ⅸ–S ⅩⅢ has been observed in the wavelength range 170–500 Å. A total of 54 lines have been measured. Forty-two of them have been classified as 2s22pk–2s2pk+1and 2s2pk–2pk+1 transitions. Twelve other lines have been ascribed to 2s–2p,4p–5s,5p–6s,5d–6p, and 6p–8d transitions. These spectral lines have been identified, among which 22 are new and accurately measured. The analysis of the spectra was based on a comparison with other experimental results and calculated values.

Precipitation at Lake Qinghai；NE Qinghai-Tibet Plateau；and its relation to Asian summer monsoons on decadal/interdecadal scales during the past 500 years

IEECAS SKLLQG