子洲—清涧地区上古生界储层综合研究

The exploration and study in recent years shows that the upper Paleozoic in the east of Ordos Basin possesses major exploration potential, so it is necessary to have a comprehensive and synthetic research in this area. Following the guideline of T.A. Cross’s high resolution sequences stratigraphy and combined with sedimentology, the strata and sequence in the research area are divided and correlated. This paper emphasizes on the reservoir in this area and its major fruits are: Firstly, form the framework of the high sequence stratigraphy through mainly studying on the data of core, well drilling and field section combining. Then, think that the best reservoir formation mainly appears in the middle or lower part of long arising semi-cycle, and focus on A type and C1 middle sequence cycle that contributes to the development of formation. Next, think the sedimentary source mainly comes from the epimetamorphic crystalline basement in the north of the Ordoes Basin through analyzing depositional background, researching on sandstone petrography, distribution characteristics of the sedimentary system as well as researching on heavy mineral combination characteristics. Fourthly, give priority to Zizhou-Qingjian area for the first time and gain seven lithofacies paleography maps in the No.2 member of Shanxi and the No.8 member of Shihezi through using the method of isochronal lithofacies paleogeography mapping, then bring forth that Sh2 is mainly developed a type I sequence under the margin of ramp lake-basin background. Fifthly, through researching on the characteristics of reservoir petrography and diagenesis, think that all researched areas experienced compaction and cementation, and there is different types of rocks, only little of the primary pores that are made up of litharenite and lithoclastic quartz sandstone is left, while in lithoclastic quartz sandstone, there are still many primary pores Sixthly, through studying on pore types, microstructure, as well as physical property on the key formation, think that the researched area mostly appears typical low pore, low porosity and permeability, which mainly result from sedimentary and diagenesis. Lastly, through researching on classified evaluation in the key formation, productivity analysis, and combing with reservoir distribution, the researched area is divided into three parts, and think that exploration should be emphasized on formation I and II. The characteristics of sandstones distribution in Sh23 member, gas formation distribution and open flow capacity of exploitation well are all consistent properly with the results of reservoir comprehensive evaluation in this thesis proved by the gas production development in 2006.

陕甘宁盆地储层物性预测及油气综合判识方法研究

The thesis show you seven interpretation models of erosion of MAs1+2 in the west of prospect and eroded gully of middle and east, form the interpretation technique how to built up eroded gully of the Ordovician top, according of the practical demand of oil-gas exploration in the ShanGanNing basin, using seismic information, combining well logging and well drilling data, Carefully analyzing geologic deposition background and well logging data, through a great quantity forward and inversion for geologic model and combination geologic model with seismic section. Related to research of reservoir absorption in the ShanGanNing basin, it firstly introduces PRONY transformation multidimensional filter. It can simultaneously express relationship of frequency and absorption decay coefficient, better than FUSAIPU analysis method; PRONY filter have obtain the better effect in the gas field of ZhenChuanBao in the ShanBei area after adopting PRONY filtering method to predict reservoir absorption, by analyzing fixed well and prediction of non-well drilling. In the ShanGanNing basin, general seismic inversion method can produce evident different results or misunderstanding because wave impedance and lithology, physical property, gas property are not sole, especially while have little impedance contrast and even have contract direction; the author carefully analyzes multi-parameter inversion technique, add natural gamma ray and natural potential and other parameter combined making model inversion method according of theory of seismic inversion and applying reservoir velocity and wave impedance information at last, we get the more directly reservoir physical property parameter, judging reservoir physical property is more exact. In accordance with geologic, seismic feature of Shan basin, the thesis conclude Ordovician system top erosion interpretation technology with ChangQing character, and reservoir thickness prediction technique combining inversion technique with wave character analysis, Reservoir physical property that is mainly absorption factor analysis and multi-parameter inversion and oil-gas prediction technology. These technologies obtain the better result in the oil-gas field exploration and have formed comprehensive research method and technology series with ShanGanNing character.

Formulação de pastas cimentícias com adição de suspensões de quitosana para cimentação de poços de petróleo

Primary cementing is one of the main operations in well drilling responsible for the mechanical stability and zonal isolation during the production of oil. However, the cement sheath is constantly under mechanical stresses and temperature variations caused by the recovery of heavy oil. In order to minimize fracture and wear of the cement sheath, new admixtures are developed to improve the properties of Portland cement slurries and avoid environmental contamination caused by leaking gas and oil. Polymers with the ability to form polymeric films are candidates to improve the properties of hardened cement slurries, especially their fracture energy. The present study aimed at evaluating the effect of the addition of a chitosan suspension on cement slurries in order to improve the properties of the cement and increase its performance on heavy oil recovery. Chitosan was dissolved in acetic ac id (0.25 M and 2 M) and added to the formulation of the slurries in different concentrations. SEM analyses confirmed the formation of polymeric films in the cementitious matrix. Strength tests showed higher fracture energy compared to slurries without the addition of chitosan. The formation of the polymeric films also reduced the permeability of the slurry. Therefore, chitosan suspensions can be potentially used as cementing admixtures for heavy oil well applications

Desenvolvimento de sistemas de pastas leves para aplicação em cimentação de poços petrolíferos com baixo gradiente de fratura

All around the world, naturally occurring hydrocarbon deposits, consisting of oil and gas contained within rocks called reservoir rocks , generally sandstone or carbonate exists. These deposits are in varying conditions of pressure and depth from a few hundred to several thousand meters. In general, shallow reservoirs have greater tendency to fracture, since they have low fracture gradient, ie fractures are formed even with relatively low hydrostatic columns of fluid. These low fracture gradient areas are particularly common in onshore areas, like the Rio Grande do Norte basin. During a well drilling, one of the most favorable phases for the occurrence of fractures is during cementing, since the cement slurry used can have greater densities than the maximum allowed by the rock structure. Furthermore, in areas which are already naturally fractured, the use of regular cement slurries causes fluid loss into the formation, which may give rise to failures cementations and formation damages. Commercially, there are alternatives to the development of lightweight cement slurries, but these fail either because of their enormous cost, or because the cement properties were not good enough for most general applications, being restricted to each transaction for which the cement paste was made, or both reasons. In this work a statistical design was made to determine the influence of three variables, defined as the calcium chloride concentration, vermiculite concentration and nanosilica concentration in the various properties of the cement. The use of vermiculite, a low density ore present in large amounts in northeastern Brazil, as extensor for cementing slurries, enabled the production of stable cements, with high water/cement ratio, excellent rheological properties and low densities, which were set at 12.5 lb / gal, despite the fact that lower densities could be achieved. It is also seen that the calcium chloride is very useful as gelling and thickening agent, and their use in combination with nanosilica has a great effect on gel strength of the cement. Hydrothermal Stability studies showed that the pastes were stable in these conditions, and mechanical resistance tests showed values of the order of up to 10 MPa

Characterization of operational safety in offshore oil wells

The main concern of activities developed in oil and gas well construction is safety. But safety during the well construction process is not a trivial subject. Today risk evaluation approaches are based in static analyses of existent systems. In other words, those approaches do not allow a dynamic analysis that evaluates the risk for each alteration of the context. This paper proposes the use of Quantitative and Dynamic Risk Assessment (QDRA) to assess the degree of safety of each planned job. The QDRA can be understood as a safe job analysis approach, developed with the purpose of quantifying the safety degree in entire well construction and maintenance activities. The QDRA is intended to be used in the planning stages of well construction and maintenance, where the effects of hazard on job sequence are important unknowns. This paper also presents definitions of barrier, and barriers integrated set (BIS), and a modeling technique showing their relationships. (c) 2006 Elsevier B.V. All rights reserved.

Case-based reasoning in offshore well design

Petroleum well drilling is an expensive and risky operation. In this context, well design presents itself as a fundamental key to decrease costs and risks involved. Experience acquired by engineers is notably an important factor in good drilling design elaborations. Therefore, the loss of this knowledge may entail additional problems and costs. In this way, this work represents an initiative to model a petroleum well design case-based architecture. Tests with a prototype showed that the system built with this architecture may help in a well design and enable corporate knowledge preservation. (C) 2003 Elsevier B.V. B.V. All rights reserved.

Application of ARX neural networks to model the rate of penetration of petroleum wells drilling

Bit performance prediction has been a challenging problem for the petroleum industry. It is essential in cost reduction associated with well planning and drilling performance prediction, especially when rigs leasing rates tend to follow the projects-demand and barrel-price rises. A methodology to model and predict one of the drilling bit performance evaluator, the Rate of Penetration (ROP), is presented herein. As the parameters affecting the ROP are complex and their relationship not easily modeled, the application of a Neural Network is suggested. In the present work, a dynamic neural network, based on the Auto-Regressive with Extra Input Signals model, or ARX model, is used to approach the ROP modeling problem. The network was applied to a real oil offshore field data set, consisted of information from seven wells drilled with an equal-diameter bit.

A genetic neuro-model reference adaptive controller for petroleum wells drilling operations

Motivated by rising drilling operation costs, the oil industry has shown a trend towards real-time measurements and control. In this scenario, drilling control becomes a challenging problem for the industry, especially due to the difficulty associated to parameters modeling. One of the drill-bit performance evaluators, the Rate of Penetration (ROP), has been used in the literature as a drilling control parameter. However, the relationships between the operational variables affecting the ROP are complex and not easily modeled. This work presents a neuro-genetic adaptive controller to treat this problem. It is based on the Auto-Regressive with Extra Input Signals model, or ARX model, to accomplish the system identification and on a Genetic Algorithm (GA) to provide a robust control for the ROP. Results of simulations run over a real offshore oil field data, consisted of seven wells drilled with equal diameter bits, are provided. © 2006 IEEE.

An intelligent system to detect drilling problems through drilled cuttings return analysis

Cuttings return analysis is an important tool to detect and prevent problems during the petroleum well drilling process. Several measurements and tools have been developed for drilling problems detection, including mud logging, PWD and downhole torque information. Cuttings flow meters were developed in the past to provide information regarding cuttings return at the shale shakers. Their use, however, significantly impact the operation including rig space issues, interferences in geological analysis besides, additional personel required. This article proposes a non intrusive system to analyze the cuttings concentration at the shale shakers, which can indicate problems during drilling process, such as landslide, the collapse of the well borehole walls. Cuttings images are acquired by a high definition camera installed above the shakers and sent to a computer coupled with a data analysis system which aims the quantification and closure of a cuttings material balance in the well surface system domain. No additional people at the rigsite are required to operate the system. Modern Artificial intelligence techniques are used for pattern recognition and data analysis. Techniques include the Optimum-Path Forest (OPF), Artificial Neural Network using Multilayer Perceptrons (ANN-MLP), Support Vector Machines (SVM) and a Bayesian Classifier (BC). Field test results conducted on offshore floating vessels are presented. Results show the robustness of the proposed system, which can be also integrated with other data to improve the efficiency of drilling problems detection. Copyright 2010, IADC/SPE Drilling Conference and Exhibition.

An Isopach Map and Discussion of Triassic Strata in Southern Montana and Wyoming

Oil and gas have been found in the Triassic strata of Wyoming. Although the Triassic has not as yet proven to be a large producing horizon it is very probable that ad­ditional oil will be found in Triassic strata in the future, and it is one of the goals at which oil well drillers aim their tools.