72 resultados para Fuste
Resumo:
This research aimed to evaluate the wood and charcoal quality of hybrids clone of the crossing C. citriodora with C. torelliana in two different locations for charcoal production. Seven with 3,75 years old clones, planted at country of Itamarandiba – MG, and six 6,42 years old clones, planted in Dionísio – MG, were studied. For wood and charcoal quality analysis, samples were collected along the stem of the trees until the commercial height. Properties study of the wood was done by chemical analysis, basic density, superior heat power, and thermogravimetric analysis. The wood samples were carbonized in laboratory conditions with heating rate of 1.67 0 C.min -1 , starting at 100 0 C until 450 0 C and keeping on this temperature for 30 minutes. It were determined the carbonizations gravimetric yield, all in dry basis. The wood quality was evaluated based on the chemical immediate analysis, relative apparent density, and gross heating value. The experiment was installed according to the completely randomized design, with five repetitions. The collected data were submitted to analysis of variance and, when the evaluated effects were significant by “F” test, was applied the Scott-Knott test at 5% probability for multiple comparisons. For correlation analysis, Pearson correlation coefficient, tested by the "t" test at 5% probability was used. Results showed variability of wood between the genetic materials evaluated in relation to place and plant crossing. The thermal analysis of the wood showed significant variation between clones and it was possible to differentiate two stages of degradation (hemicelluloses and cellulose). The majority of the clones presented satisfactory properties for the charcoal production, while, clone 3, planted in Itamarandiba, obtained the best performance due it have the higher yield and energetic efficiency, thus, achieving the best potential for charcoal production. However, clone 9, planted in Dionísio, was the less indicated for charcoal production since it presented the lowest energetic efficiency, gravimetric yield, and densities.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Pós-graduação em Ciência Florestal - FCA
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
This study has investigated the genetic variation for silvicultural traits in an open-pollinated progeny test of Astronium graveolens Jacq., established at Luiz Antônio Experimental Station (State of São Paulo, Brazil). The trial was planted in a random block experimental design, containing 23 families, six replications and five plants per plot. The traits measured were diameter at breast height (DBH), total height and stem form. The assessments were taken at the age of 19 years. Significant differences were not detected by the analysis of variance, suggesting that the genetic variation was low, as well as the probability to raising genetic gains through selection among progenies. The coefficient of genetic variation was moderate for the traits height (8.2%) and DBH (21.2%) and low to stem form (4.0%). However, the average coefficient of heritability among progenies was low for all studied traits (ranging from 0.02 to 0.15), confirming the low probability of genetic improvement of this population by selection among progenies.
Resumo:
The aim of this study was to estimate the genetic parameters on a progeny test of Enterolobium contortisiliquum, located at the Fazenda Experimental de Luíz Antônio (IF-SP), São Paulo State, Brazil, for genetic selection and seed production. The coefficients of genetic variation and heritability, as well as the genetic and phenotypic correlations for the silvicultural traits diameter at breast height (DBH) and total height of plants at the age of 19, 20, and 21 years and bifurcation (BIF) and stem straightness (RET), at the age of 19 years were estimated. The F test of analysis of variance detected significant variation among the progeny for the traits DBH, height in the three tested ages, and straightness of the trunk, which indicates that the tested population can be improved by selection among progenies. The estimation of heritability at the level of progeny (h²m, minimum of 0.50) for all traits was high and at the levels of individual plants (h²i, minimum 0.18) and within progenies (h²d, minimum of 0.14) was medium, indicating that the population can be improved by selection among and within progenies. Significant high genetic and phenotypic correlations among pairwise growth traits of the same age were detected as well as among those with different ages. Therefore, the direct selection, of a trait allows indirect selection of another. The results showed the potential of this progeny test to enhance a seed orchard by selection and seed production for commercial and environmental reforestation plans.
Resumo:
Pós-graduação em Ciência Florestal - FCA
Resumo:
Pós-graduação em Agronomia (Energia na Agricultura) - FCA
Resumo:
Pós-graduação em Ciência Florestal - FCA
Resumo:
In this paper it was evaluated the influence of the relative position of logs on the trees, the type of wood (juvenile and mature wood and pith) and the dimension of sawed wood elements on the velocity of propagation of stress waves into the material on condition. P. taeda L wood (43 years old trees) from Horto Florestal of Manduri (latitude 230 00’ south, longitude 400 19’ west and altitude de 700 m) São Paulo State, Brazil were used, considering its easy growth rings visualization and the better ju regions definition. Six trees were randomly chosen in the plantation. Trees were sawed into 4 logs (2,5 m long each. In each log it was delimited the central board (80mm tick) region and the lateral boards (25mm tick) regions, cons right hand. It were evaluated relation between velocity of stress waves on logs and the correspondent lumber (central and lateral boards), on green condition, on the three main region of the elements (mature wood results obtained revealed the concordance between velocities of stress waves in the material before and after the its mechanical processing. It was also revealed statistical differences between the velocity of stress waves at juvenile wood, mature wood and pith regions. Keywords: stress wave method, velocity 17 destrutivos de propagação da propagação de ondas de tensão em toras e madeira serrada de taeda L. Hernando Alfonso Lara Palma - Universidade Estadual Paulista Faculdade de Ciências Agronômicas – FCA/UNESP – Botucatu - SP, e-mail: awballarin@fca.unesp.br Luiz Antonio Vasques Hellmeister - Universidade Estadual Paulista - Faculdade de Arquitetura, FAAC/UNESP – Bauru - SP, e-mail: hellmeister@faac.unesp.br Este trabalho teve como objetivo analisar a influência do tipo de lenho, da posição da tora ao longo do fuste e das dimensões das peças desdobradas, na velocidade de as de tensão (Stress wave method), na condição de madeira verde. P. taeda L., originária de árvores de plantio do Horto Florestal de SP., com idade aproximada de 43 anos, pela facilidade de identificação dos anéis imento e demarcação das regiões de madeira adulta e madeira juvenil. Foram amostradas 6 árvores distintas, escolhidas ao acaso do talhão selecionado. De cada árvore foram retiradas 4 toras com comprimento de 2,5 m cada. Foram demarcadas nas toras a ha central (8 cm de espessura) e 4 tábuas laterais (espessura comercial de 2,5 cm), sendo duas à esquerda e duas à direita da prancha central. Foram avaliadas as relações existentes entre as velocidades de propagação das ondas de tensão na madeira íntegra (toras) e desdobrada (pranchas e tábuas), na condição de madeira verde, nas três regiões distintas do lenho: medula, madeira adulta e madeira juvenil. A análise comparativa dos resultados revelou a concordância entre as velocidades antes e após o desdobr madeira. Houve diferenciação estatisticamente significativa entre as velocidades de propagação das ondas de tensão nos lenhos adulto, juvenil e na medula. -destrutivos, método das ondas de tensão, Pinus taeda stress wave tests on green logs and lumber of Pinus taeda In this paper it was evaluated the influence of the relative position of logs on the trees, the type of wood (juvenile and mature wood and pith) and the dimension of sawed wood elements on the velocity of propagation of stress waves into the material on L wood (43 years old trees) from Horto Florestal of Manduri (latitude 19’ west and altitude de 700 m) São Paulo State, Brazil were used, considering its easy growth rings visualization and the better juvenile and mature wood regions definition. Six trees were randomly chosen in the plantation. Trees were sawed into 4 logs (2,5 m long each. In each log it was delimited the central board (80mm tick) region and the lateral boards (25mm tick) regions, considering 2 boards on the left and 2 at the right hand. It were evaluated relation between velocity of stress waves on logs and the correspondent lumber (central and lateral boards), on green condition, on the three main region of the elements (mature wood, juvenile wood and pith). Comparative analyses of results obtained revealed the concordance between velocities of stress waves in the material before and after the its mechanical processing. It was also revealed statistical differences ty of stress waves at juvenile wood, mature wood and pith regions
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)