The effect of ram replacement and sex ratio on the sexual response of anoestrous ewes

It is accepted that an important source of variation in the response of anoestrous ewes, to the introduction of rams, is the intensity of male stimulation. The aim of this study was to investigate strategies capable of increasing the impact and transmission of the ram stimuli. In Experiment 1, two groups of seven ewes (Bluefaced Leicester male x Swaledale female) were individually penned with one ram and for the next 6 h the rams either remained in the pen or were replaced hourly. Blood samples revealed no difference in the pattern of plasma LH secretion. In Experiment 2, three groups of 16 ewes were either introduced to one ram, individually (H) or in groups of 8 (L), or remained isolated. Ram introduction increased the plasma LH pulsatility (P < 0.001). H ewes displayed more (nine versus six) male-induced LH pulses (pulses occurring within the first 45 min) and more pulses per 8 h intervals than the L group of ewes (1.9 +/- 0.3 versus 1.3 +/- 0.3), but these differences were not significant. It was concluded that (i) frequent replacement of rams within a few hours following ram introduction to ewes does not further improve the response of ewes, especially if the ram:ewe ratio is high; (ii) the characterization of the plasma LH secretion parameters during a period of 6-8 h does not seem to be an effective method to detect small differences in the intensity of stimulation received by the ewes when exposed to rams; (iii) North Country Mule ewes (Bluefaced Leicester male x Swaledale female) in the UK respond to the presence of rams in spring (late oestrous/early anoestrous season) with an elevation in plasma LH secretion. (c) 2005 Elsevier B.V. All rights reserved.

Describing fatigue crack growth and load ratio effects in Al 2524 T3 alloy with an enhanced exponential model

The fatigue crack behavior in metals and alloys under constant amplitude test conditions is usually described by relationships between the crack growth rate da/dN and the stress intensity factor range Delta K. In the present work, an enhanced two-parameter exponential equation of fatigue crack growth was introduced in order to describe sub-critical crack propagation behavior of Al 2524-T3 alloy, commonly used in aircraft engineering applications. It was demonstrated that besides adequately correlating the load ratio effects, the exponential model also accounts for the slight deviations from linearity shown by the experimental curves. A comparison with Elber, Kujawski and "Unified Approach" models allowed for verifying the better performance, when confronted to the other tested models, presented by the exponential model. (C) 2012 Elsevier Ltd. All rights reserved.

Natural history of Peucetia flava (Araneae, Oxyopidae): seasonal density fluctuation, phenology and sex ratio on the glandular plant Rhyncanthera dichotoma (Melastomataceae)

The seasonal density fluctuation, phenology and sex ratio of Peucetia flava (Oxyopidae) on Rhyncanthera dichotoma (Melastomataceae) were investigated during a year in a swamp in southeastern Brazil. Peucetia flava displayed an unusual non-seasonal life cycle and the population size varied little over the year. The density of Peucetia spiders increased with the increase in abundance of leaves and number of arthropods adhered to glandular trichomes on R. dichotoma leaves. Our findings suggest that seasonal density fluctuation of Peucetia may be influenced by foraging site availability (i.e. leaves) and prey supply (i.e. arthropods adhering to glandular trichomes). The unusual seasonal stability of P. flava may be related to the type of habitat in which this spider occurs (swamp), because of the constant input of allochthonous resources from the water source, i.e. aquatic insects that migrate to the terrestrial environment.

Second-order statistics for equal gain and maximal ratio diversity-combining reception

Exact and closed-form expressions for the level crossing rate and average fade duration are presented for equal gain combining and maximal ratio combining schemes, assuming an arbitrary number of independent branches in a Rayleigh environment. The analytical results are thoroughly validated by simulation.

Size distribution and sex ratio in the spider crab Epialtus brasiliensis (Dana 1852) associated with seaweed on a rocky shore in southeastern Brazil (Crustacea, Decapoda, Brachyura, Majoidea, Epialtidae).

This study analyzed a population of the spider crab Epialtus brasiliensis, in regard to its size distribution, sex ratio and Sexual maturity. The study was conducted on a rocky shore in the Ubatuba region, state of Silo Paulo, Brazil, where a wide strip of algae covers the intertidal zone. A total of 378 specimens were obtained: 200 males (128 juvenile and 72 adult crabs) and 178 females (46 juveniles and 132 adults). Their Sizes ranged from 3.4 to 16.7 mm carapace length (CL). Taking into account that the pubertal and terminal molts are coincident in majid crabs, the maximum sizes attained by males and females are especially dependent on the factors that influence sexual maturity, mainly food resources, temperature and intraspecific competition. Males of E. brasiliensis occurred in all size classes, whereas females occurred only as far the 10th size class (12-13 min CL). file total sex ratio did not differ statistically from 1 : 1, but when the juvenile and adult specimens were analyzed separately the differences between sexes were significantly different, with higher proportions of immature males and mature females. The CL50 calculated for males and females was 10.4, and 6.9 min CL, respectively. Thus, males reach their sexual maturity at a larger size than females. This feature may be important for the reproductive strategy of this species, because larger males probably have greater reproductive Success.

Relationship between the dielectric and mechanical properties and the ratio of epoxy resin to hardener of the hybrid thermosetting polymers

The relationship between the dielectric properties (dielectric constant, ε′, and loss factor, ε; activation energy, E a) and the ratio of epoxy resin (OG) to hardener of the epoxy resin thermosetting polymers was investigated. The amplitude of the ε″ peak decreases with increasing OG content until about 73 wt.% and slightly increases at higher OG content. The temperature of the position of the ε″ peak increases with the increasing of OG content, reaching maximum values for compositions in the range of 67 and 73 wt.%, and then it decreases sharply at higher OG content. The activation energy obtained from dielectric relaxation increased with increasing wt.% OG up to around 70 wt.%. Further increase in concentration of OG up to 83 wt.% reduced E a. The curves of tensile modulus and fracture toughness mechanical properties as a function of OG content presented a similar behavior. ©2006 Sociedade Brasileira de Química.