A single-phase single-stage buck-boost inverter intended for low power alternative energy conversion systems: Analysis, design and experimentation

This paper presents the operational analysis of the single-phase integrated buck-boost inverter. This topology is able to convert the DC input voltage into AC voltage with a high static gain, low harmonic content and acceptable efficiency, all in one single-stage. Main functionality aspects are explained, design procedure, system modeling and control, and also component requirements are detailed. Main simulation results are included, and two prototypes were implemented and experimentally tested, where its results are compared with those corresponding to similar topologies available in literature. © 2012 IEEE.

Accuracy of five electronic foramen locators with different operating systems: na ex vivo study

Objective: The aim of this study was to evaluate, ex vivo, the precision of five electronic root canal length measurement devices (ERCLMDs) with different operating systems: the Root ZX, Mini Apex Locator, Propex II, iPex, and RomiApex A-15, and the possible influence of the positioning of the instrument tips short of the apical foramen. Material and Methods: Forty-two mandibular bicuspids had their real canal lengths (RL) previously determined. Electronic measurements were performed 1.0 mm short of the apical foramen (-1.0), followed by measurements at the apical foramen (0.0). The data resulting from the comparison of the ERCLMD measurements and the RL were evaluated by the Wilcoxon and Friedman tests at a significance level of 5%. Results: Considering the measurements performed at 0.0 and -1.0, the precision rates for the ERCLMDs were: 73.5% and 47.1% (Root ZX), 73.5% and 55.9% (Mini Apex Locator), 67.6% and 41.1% (Propex II), 61.7% and 44.1% (iPex), and 79.4% and 44.1% (RomiApex A-15), respectively, considering ±0.5 mm of tolerance. Regarding the mean discrepancies, no differences were observed at 0.0; however, in the measurements at -1.0, the iPex, a multi-frequency ERCLMD, had significantly more discrepant readings short of the apical foramen than the other devices, except for the Propex II, which had intermediate results. When the ERCLMDs measurements at -1.0 were compared with those at 0.0, the Propex II, iPex and RomiApex A-15 presented significantly higher discrepancies in their readings. Conclusions: Under the conditions of the present study, all the ERCLMDs provided acceptable measurements at the 0.0 position. However, at the -1.0 position, the ERCLMDs had a lower precision, with statistically significant differences for the Propex II, iPex, and RomiApex A-15.

Articulated Narrowcasting for Privacy and Awareness in Multimedia Conferencing Systems and Design for Implementation Within a SIP Framework

This article proposes a new focus of research for multimedia conferencing systems which allows a participant to flexibly select another participant or a group for media transmission. For example, in a traditional conference system, participants voices might by default be shared with all others, but one might want to select a subset of the conference members to send his/her media to or receive media from. We review the concept of narrowcasting, a model for limiting such information streams in a multimedia conference, and describe a design to use existing standard protocols (SIP and SDP) for controlling fine-grained narrowcasting sessions.

Measurement of Distributed Antenna Systems at 2.4 GHz in a Realistic Subway Tunnel Environment.

Accurate characterization of the radio channel in tunnels is of great importance for new signaling and train control communications systems. To model this environment, measurements have been taken at 2.4 GHz in a real environment in Madrid subway. The measurements were carried out with four base station transmitters installed in a 2-km tunnel and using a mobile receiver installed on a standard train. First, with an optimum antenna configuration, all the propagation characteristics of a complex subway environment, including near shadowing, path loss,shadow fading, fast fading, level crossing rate (LCR), and average fade duration (AFD), have been measured and computed. Thereafter, comparisons of propagation characteristics in a double-track tunnel (9.8-m width) and a single-track tunnel (4.8-m width) have been made. Finally, all the measurement results have been shown in a complete table for accurate statistical modeling.

Active learning and generic competences in an operating systems course

The Bologna Declaration and the implementation of the European Higher Education Area are promoting the use of active learning methodologies. The aim of this study is to evaluate the effects obtained after applying active learning methodologies to the achievement of generic competences as well as to the academic performance. This study has been carried out at the Universidad Politécnica de Madrid, where these methodologies have been applied to the Operating Systems I subject of the degree in Technical Engineering in Computer Systems. The fundamental hypothesis tested was whether the implementation of active learning methodologies (cooperative learning and problem based learning) favours the achievement of certain generic competences (‘teamwork’ and ‘planning and time management’) and also whether this fact improved the academic performance of our students. The original approach of this work consists in using psychometric tests to measure the degree of acquired student’s generic competences instead of using opinion surveys, as usual. Results indicated that active learning methodologies improve the academic performance when compared to the traditional lecture/discussion method, according to the success rate obtained. These methods seem to have as well an effect on the teamwork competence (the perception of the behaviour of the other members in the group) but not on the perception of each students’ behaviour. Active learning does not produce any significant change in the generic competence ‘planning and time management'.

Complex Protection System of Metadata-based Distributed Information Systems

A description of architecture and approaches to the implementation of a protection system of metadatabased adaptable information systems is suggested. Various protection means are examined. The system described is a multilevel complex based on a multiagent system combining IDS functional abilities with structure and logics protection means.

Distributed Visualization Systems in Remote Sensing Data Processing Grid

Implementation of GEOSS/GMES initiative requires creation and integration of service providers, most of which provide geospatial data output from Grid system to interactive user. In this paper approaches of DOS- centers (service providers) integration used in Ukrainian segment of GEOSS/GMES will be considered and template solutions for geospatial data visualization subsystems will be suggested. Developed patterns are implemented in DOS center of Space Research Institute of National Academy of Science of Ukraine and National Space Agency of Ukraine (NASU-NSAU).

Control d'Accés d'Usuaris als Serveis de Xarxa CAUSiX

L'objectiu final d'aquest treball és l'obtenció d'un sistema que permeti regular l'accés de manera fàcil i flexible a determinats serveis de xarxa per a un conjunt d'usuaris que tenen necessitats i atributs diferents d'ús de la xarxa segons el seu perfil i segons el moment.

Diseño e implementación de un sistema de autenticación, autorización y acceso a una red inalámbrica vía FreeRADIUS y Active Directory

L'objectiu d'aquest projecte és estudiar i implementar una solució segura de connectivitat sense fil a la infraestructura actual aprofitant al màxim tots els sistemes ja implementats, de manera que no pateixin greus canvis estructurals.

Modificació d'un sistema de generació de grafisme per televisió amb la incorporació d'objectes generats amb OpenGL

Els objectius inicials d'aquest projecte eren la incorporació d'OpenGL a l'eina ja existent de generació de grafisme per televisió. Com que l'aplicador ja dissenyat es basava en un reduït tipus d'objectes sobre els quals es podien aplicar diferents paràmetres i agrupar-los de diferents maneres, calia trobar un nou tipus d'objecte que tingués alguna particularitat que el fes prou atractiu per a incorporar-lo a l'aplicació. El resultat va ser un objecte polièdric per a poder-hi mapar diferents textures i un text aplicant-hi una ombra en tres dimensions segons la posició del dibuix.

Procés de creació i personalització d'un CD-Live

Aquest projecte tracta del procés de creació d'un CD-Live (CD autoarrencable) complet amb els requeriments d'un alumne de la UOC, basat en el projecte Metadistros. El procés inclou tres grans apartats: en primer lloc, la configuració de l'equip per a poder crear les metadistribucions d'una manera genèrica; en segon lloc, la instal·lació i la configuració d'un sistema mínim, i, finalment, la personalització d'aquest sistema fins a tenir una distribució adaptada al perfil d'un alumne de la UOC.