The log delta log t method for the determination of the coefficient of consolidation

The behaviour of saturated soils undergoing consolidation is very complex, It may not follow Terzaghi's theory over the entire consolidation process, Different soils may behave in such a way as to fit into Terzaghi's theory over some specific stages of the consolidation process (percentage of consolidation), This may be one of the reasons for the difficulties faced by the existing curve-fitting procedures in obtaining the coefficient of consolidation, c(v). It has been shown that the slope of the initial linear portion of the theoretical log U-log T curve is constant over a wider range of degree of consolidation, U, when compared with the other methods in use, This initial well-defined straight line in the log U-log T plot intersects the U = 100% line at T = pi/4, which corresponds to U = 88.3%, The proposed log delta-log t method is based on this observation, which gives the value of c(v) through simple graphical construction, In the proposed method, which is more versatile, identification of the characteristic straight lines is very clear; the intersection of these lines is more precise and the method does not depend upon the initial compression for the determination of c(v).

Evaluation. of Transverse Piezoelectric Coefficient of ZnO Thin Films Deposited on Different Flexible Substrates: A Comparative Study on the Vibration Sensing Performance

We report on the systematic comparative study of highly c-axis oriented and crystalline piezoelectric ZnO thin films deposited on four different flexible substrates for vibration sensing application. The flexible substrates employed for present experimental study were namely a metal alloy (Phynox), metal (aluminum), polyimide (Kapton), and polyester (Mylar). ZnO thin films were deposited by an RF reactive magnetron sputtering technique. ZnO thin films of similar thicknesses of 700 +/- 30 nm were deposited on four different flexible substrates to have proper comparative studies. The crystallinity, surface morphology, chemical composition, and roughness of ZnO thin films were evaluated by respective material characterization techniques. The transverse piezoelectric coefficient (d(31)) value for assessing the piezoelectric property of ZnO thin films on different flexible substrates was measured by a four-point bending method. ZnO thin films deposited on Phynox alloy substrate showed relatively better material characterization results and a higher piezoelectric d(31) coefficient value as compared to ZnO films on metal and polymer substrates. In order to experimentally verify the above observations, vibration sensing studies were performed. As expected, the ZnO thin film deposited on Phynox alloy substrate showed better vibration sensing performance. It has generated the highest peak to peak output voltage amplitude of 256 mV as compared to that of aluminum (224 mV), Kapton (144 mV), and Mylar (46 mV). Therefore, metal alloy flexible substrate proves to be a more suitable, advantageous, and versatile choice for integrating ZnO thin films as compared to metal and polymer flexible substrates for vibration sensing applications. The present experimental study is extremely important and helpful for the selection of a suitable flexible substrate for various applications in the field of sensor and actuator technology.

Estimation of the Hall-Petch strengthening coefficient of steels through nanoindentation

A method to estimate the Hall-Petch coefficient k for yield strength and flow stress of steels through nanoindentation experiments is proposed. While determination of k(f) for flow stress is on the basis of grain boundary strengthening evaluated by sharp indentation, k(y) for yield strength was computed with pop-in data from spherical indentations. Good agreement between estimated and literature data, obtained from the tensile tests, validates the proposed methodology. (C) 2014 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

Laboratory determination of coefficient of consolidation from pore water pressure measurement

In the recent past, many studies have been carried out on the determination of coefficient of consolidation (c(v)) from the time (t)-deformation (d) data obtained from conventional consolidation tests. Several researchers have also proposed different curve fitting procedures for determining cv from the t-d data. It is anticipated that the cv values obtained from the t-d data may be influenced by initial and secondary compressions. Nevertheless, the pore water pressure data measured during the consolidation process will be independent of initial and secondary compressions. In this study, the conventional Asaoka (1978) method is extended to evaluate cv and end-of-primary (EOP) consolidation from the pore water pressure data measured from laboratory experiments. Laboratory experiments were carried out on the modified one-dimensional consolidation apparatus on different remoulded clay samples measuring pore water pressure during the consolidation process. The cv and EOP computed from the proposed approach have been compared with the results of the t-d data and found to be in good agreement.

Surface Tension and Its Temperature Coefficient of Molten Tin Determined with the Sessile Drop Method at Different Oxygen Partial Pressures

The surface tension of molten tin has been determined by the sessile drop method at The surface tension of molten tin has been determined by the sessile drop method at temperatures ranging from 523 to 1033 K and in the oxygen partial pressure (P-O2) range from 2.85 x 10(-19) to 8.56 x 10(-6) MPa, and its dependence on temperature and oxygen partial pressure has been analyzed. At P-O2 = 2.85 x 10(-19) and 1.06 x 10(-15) MPa, the surface tension decreases linearly with the increase of temperature and its temperature coefficients are -0.151 and -0.094 mNm(-1) K-1, respectively. However, at high P-O2 (3.17 x 10(-10), 8.56 x 10(-6) MPa), the surface tension increases with the temperature near the melting point (505 K) and decreases above 723 K. The surface tension decrease with increasing P-O2 is much larger near the melting point than at temperatures above 823 K. The contact angle between the molten tin and the alumina substrate is 158-173degrees, and the wettability is poor.

Flow Characteristics and Its Friction Coefficient of Laminar Near-Wall Boundary Layer in Dusty Atmosphere

������������������������������������,���������������������������������������������������������������������������������������������������������,���������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������

Variations in year-class strength and estimates of the catchability coefficient of yellowfin tuna, Thunnus albacares, in the Eastern Pacific Ocean

ENGLISH: Year-class composition of catch, virtual population size and yearclass strength were determined from serial samples of size composition of catches and catch records. Murphy's Solution to the catch equation, which is free from the effects caused by changes in fishing pressure, was used to estimate year-class strength, i.e. the total population of fish age 3/4 years. The resultant estimates indicated that the X55, X56, X57, X62 and X63 year classes were above average and the X58, X59, X60, X61 and X64 year classes were below average. The year-class designation refers to the year of actual entry or presumed year of entry into the commercial fishery (at approximately 1 year of age). The strongest and poorest year classes were the X57 and X61 classes, respectively. The ratio of the strongest to the weakest year class was 2.6. This amount of variation is small compared to that found for other species of fish. It was found that the relationship between stock size and yearclass strength is of no value in predicting year-class strength. As a by-product of the analysis, estimates of the catchability coefficients (qN) of the age groups in the fishery were obtained, These estimates were found to vary with age and time. Age-two fish apparently showed the greatest vulnerability to fishing gear, followed by ages three and one, respectively. The average estimate of the catchability coefficient in weight was calculated and found to compare favorably with Schaefer's estimate. The influence of sea-surface water temperature upon year-class strength was investigated to determine whether the latter can be predicted from a knowledge of sea-surface temperatures prevailing during and following spawning. No correlation was evident. SPANISH: La composici��n de la clase anual en la captura, el tama��o de la poblaci��n virtual y la fuerza de clase anual, fueron determinados seg��n una serie de muestras de la composici��n de tama��o de las capturas y de los registros de captura. La Soluci��n de Murphy de la ecuaci��n de captura, que est�� libre de los efectos causados por los cambios de la presi��n de pesca, fue usada para estimar la fuerza de la clase anual, i.e. la poblaci��n total de peces de 3/4 a��os. Las estimaciones resultantes indican que las clases anuales X55, X56, X57, X62 y X63 fueron superiores al promedio y que las clases anuales X58, X59, X60, X61 y X64 fueron inferiores al promedio. La designaci��n de la clase anual se refiere al a��o actual de entrada o al a��o supuesto de entrada en la pesca comercial (aproximadamente a la edad de 1 a��o). Las clases anuales m��s fuertes y m��s pobres fueron la X57 y X61 respectivamente. La raz��n de la clase anual m��s fuerte en relaci��n a la m��s d��bil fue 2.6. Esta cantidad de variaci��n es peque��a comparada con la encontrada para otras especies de peces. Se encontr�� que la relaci��n entre en tama��o del stock y la fuerza de la clase anual no tiene valor en predecir la fuerza de la clase anual. Se obtuvieron estimaciones de los coeficientes de capturabilidad (qN) de los grupos de edad en la pesquer��a como un producto derivado del an��lisis. Se encontraron que estas estimaciones variaron con la edad y tiempo. Los peces de edad dos aparentemente presentaron la vulnerabilidad m��s grande en relaci��n al arte pesquero, seguidos por las edades tres y una, respectivamente. La estimaci��n promedio del coeficiente de capturabilidad en peso fue calculada y se encontr�� que pod��a compararse favorablemente con la estimaci��n de Schaefer. La influencia de la temperatura del agua superficial del mar sobre la fuerza de la clase anual fue investigada para determinar si se pod��a predecir esta ��ltima seg��n el conocim��ento de las temperaturas superficiales del mar prevalecientes durante el desove y despu��s de ��ste. No hubo correlaci��n evidente. (PDF contains 44 pages.)

Size- And Temperature-Dependent Thermal Expansion Coefficient Of A Nanofilm

The thermal expansion coefficient (TEC) of an ideal crystal is derived by using a method of Boltzmann statistics. The Morse potential energy function is adopted to show the dependence of the TEC on the temperature. By taking the effects of the surface relaxation and the surface energy into consideration, the dimensionless TEC of a nanofilm is derived. It is shown that with decreasing thickness, the TEC can increase or decrease, depending on the surface relaxation of the nanofilm.

Temperature effects on the activity coefficient of the bicarbonate ion

<p>Natural waters may be chemically studied as mixed electrolyte solutions. Some important equilibrium properties of natural waters are intimately related to the activity-concentration ratios (i.e., activity coefficients) of the ions in solution. An Ion Interaction Model, which is based on Pitzer's (1973) thermodynamic model, is proposed in this dissertation. The proposed model is capable of describing the activity coefficient of ions in mixed electrolyte solutions. The effects of temperature on the equilibrium conditions of natural waters and on the activity coefficients of the ions in solution, may be predicted by means of the Ion Interaction Model presented in this work.</p> <p>The bicarbonate ion, HCO₃^-, is commonly found in natural waters. This anion plays an important role in the chemical and thermodynamic properties of water bodies. Such properties are usually directly related to the activity coefficient of HCO₃^- in solution. The Ion Interaction Model, as proposed in this dissertation, is used to describe indirectly measured activity coefficients of HCO₃^- in mixed electrolyte solutions.</p> <p>Experimental pH measurements of MCl-MHCO₃ and MCl-H₂CO₃ solutions at 25��C (where M = K⁺, Na⁺, NH₄⁺, Ca²⁺ or Mg²⁺) are used in this dissertation to evaluate indirectly the MHCO₃ virial coefficients. Such coefficients permit the prediction of the activity coefficient of HCO₃^- in mixed electrolyte solutions. The Ion Interaction Model is found to be an accurate method for predicting the activity coefficient of HCO₃^- within the experimental ionic strengths (0.2 to 3.0 m). The virial coefficients of KHCO₃ and NaHCO₃ and their respective temperature variations are obtained from similar experimental measurements at 10�� and 40��C. The temperature effects on the NH₄HCO₃, Ca(HCO₃)₂, and Mg(HCO₃)₂ virial coefficients are estimated based on these results and the temperature variations of the virial coefficients of 40 other electrolytes.</p> <p>Finally, the Ion Interaction Model is utilized to solve various problems of water chemistry where bicarbonate is present in solution.</p>

A new method of measuring the waveguide dispersion factor and the thermo-optic coefficient of long-period fiber gratings

Based on the Mach-Zehnder effect between the core mode and the cladding modes, the interference fringes are formed by a pair of cascaded long-period fiber gratings (CLPFGs). Theoretical analyses show that the spectral spacing and the wavelength of these fringes are functions of the waveguide dispersion factor gamma, which is a characterizing parameter to LPFG and with theoretical and applicational significance. By measuring the characteristics of the transmission spectra of CLPFGs, the absolute value of gamma can be obtained. At the same time, the thermo-optic coefficient of effective refractive index difference between core and cladding modes, p, can also be obtained by measured the temperature sensitivity of these fringes. In the experiments, \gamma\ and mu were measured by this method to be 0.874 and 4.08 x 10(-5) degreesC(-1), respectively, for LPFGs with period of 450 mum and with a HE14 resonant peak at 1554 nm. (C) 2004 Elsevier B.V. All rights reserved.