Nanofibrillar micelles and entrapped vesicles from biodegradable block copolymer/polyelectrolyte complexes in aqueous media

Here we report a viable route to fibrillar micelles and entrapped vesicles in aqueous solutions. Nanofibrillar micelles and entrapped vesicles were prepared from complexes of a biodegradable block copolymer poly(ethylene oxide)-block-poly(lactide) (PEO-b-PLA) and a polyelectrolyte poly(acrylic acid) (PAA) in aqueous media and directly visualized using cryogenic transmission electron microscopy (cryo-TEM). The self-assembly and the morphological changes in the complexes were induced by the addition of PAA/water solution into the PEO-b-PLA in tetrahydrofuran followed by dialysis against water. A variety of morphologies including spherical wormlike and fibrillar micelles, and both unilamellar and entrapped vesicles, were observed, depending on the composition, complementary binding sites of PAA and PEO, and the change in the interfacial energy. Increasing the water content in each [AA]/[EO] ratio led to a morphological transition from spheres to vesicles, displaying both the composition- and dilution-dependent micellar-to-vesicular morphological transitions.

Systematic approach to the quantitative voltammetric analysis of the Fe III /Fe II component of the [α 2 -Fe(OH 2 )P 2 W 17 O 61 ] 7-/8- reduction process in buffered and unbuffered aqueous media

The one-electron reduction of [α2-FeIII(OH2)P2W17O61]7- at a glassy carbon electrode was investigated using cyclic and rotating-disk-electrode voltammetry in buffered and unbuffered aqueous solutions over the pH range 3.45−7.50 with an ionic strength of approximately 0.6 M maintained. The behavior is well-described by a square-scheme mechanism P + e- ↔ Q (E10/ = −0.275 V, k10/ = 0.008 cm s-1, and α1 = 1/2), PH+ + e- ↔ QH+ (E20/ = −0.036 V, k20/ = 0.014 cm s-1, and α2 = 1/2), PH+ ↔ P + H+ (KP = 3.02 × 10-6 M), and QH+ ↔ Q + H+ (KQ = 2.35 × 10-10 M), where P, Q, PH+, and QH+ correspond to [α2-FeIII(OH)P2W17O61]8-, [α2-FeII(OH)P2W17O61]9-, [α2-FeIII(OH2)P2W17O61]7-, and [α2-FeII(OH2)P2W17O61]8-, respectively; E10‘ and E20‘ are the formal potentials, k10‘ and k20‘ are the formal (standard) rate constants, and KP and KQ are the acid dissociation constants for the relevant reactions. The analysis for the buffered media is based on the approach of Laviron who demonstrated that a square scheme with fully reversible protonations, reversible or quasi reversible electron transfers with the assumption that α1 = α2, can be well-described by the behavior of a simple redox couple, ox + e- ↔ red, whose formal potential, Eapp0‘, and standard rate constant, kapp0‘, are straightforwardly derived functions of pH, as are the values of E10‘, k10‘, E20‘, k20‘, and KP (only three of the four thermodynamic parameters in a square scheme can be specified). It was assumed that αapp = 1/2, and the simulation program DigiSim was used to determine the values of Eapp0‘ and kapp0‘, which are required to describe the cyclic voltammograms obtained in buffered media in the pH range from 3.45 to 7.52 (buffer-related reactions which effect general acid−base catalysis are included in the simulations). DigiSim simulations of cyclic voltammograms obtained in unbuffered media yielded the values of E10‘ and k10‘; KQ was then directly computed from thermodynamic constraints. These simulations included additional reactions between the redox species and H2O. The value of the diffusion coefficient of the [α2-FeIII(OH2)P2W17O61]7-, 2.92 × 10-6 cm2 s-1, was determined using DigiSim simulations of voltammograms at a rotating disk electrode in buffered and unbuffered media at pH 3.45. The diffusion coefficients of all redox species were assumed to be identical. When the pH is greater than 6, instability of P (i.e., [α2-FeIII(OH)P2W17O61]8-) led to the loss of the reactant and precluded lengthy experimentation.

A theoretical study on cytosine tautomers in aqueous media by using continuum models

B3LYP/6-31 + + G** and MP2/6-31 + + G** calculations have been carried out to study six tautomers of the nucleic acid base cytosine in aqueous media. Solvent effects have been analyzed using the self-consistent reaction field theory with two continuum methods. Relative stabilities and optimized geometries have been calculated for the tautomers and compared with experimental data. The present results show the importance of electrostatic solvent effects in determining observable properties of the cytosine tautomers. The amino-oxo form (C1) is the most abundant tautomer in aqueous media while the other amino-oxo form (C4) is the most energetically favored when solvent effects are included. These results can be justified by the larger values of the dipole moments for both C1 and C4 tautomers. Theoretical and experimental results of the harmonic vibrational frequencies and rotational constants show good agreement. (C) 2000 Elsevier B.V. B.V. All rights reserved.

Photodegradation of sulfamethoxazole in various aqueous media: Persistence, toxicity and photoproducts assessment

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Spectrophotometric Evaluation of the Behavior of Disperse Red 1 Dye in Aqueous Media and its Interaction with Calf Thymus ds-DNA

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Adsorption of dihydrogen phosphate ion on platinum electrodes in aqueous media monitored by probe-beam deflection

Probe-beam deflection (PBD) was used to monitor concentration gradients of anions adjacent to the surface of a platinum electrode in acidic aqueous media containing H3PO4. PBD can measure the potential-dependent extent of adsorption of H2PO4- on the Pt electrode surface and permits the Langmuir isotherm to be fitted to the experimental data. The value thus obtained for the surface concentration was 1.3 × 10-11 mol mm -2, or 1.7 atoms of Pt per H2PO4-. Also, the electron transfer number obtained was 0.24, signifying an incomplete transfer of charge, and the equilibrium constant is 1.80 suggesting a reversible adsorption process. © 2005 Elsevier B.V. All rights reserved.

Heterogeneous photocatalytic treatment of organic dyes in air and aqueous media

This review focuses on the heterogeneous photocatalytic treatment of organic dyes in air and water. Representative studies spanning approximately three decades are included in this review. These studies have mostly used titanium dioxide (TiO2) as the inorganic semiconductor photocatalyst of choice for decolorizing and decomposing the organic dye to mineralized products. Other semiconductors such as ZnO, CdS, WO3, and Fe2O3 have also been used, albeit to a much smaller extent. The topics covered include historical aspects, dark adsorption of the dye on the semiconductor surface and its role in the subsequent photoreaction, semiconductor preparation details, photoreactor configurations, photooxidation kinetics/mechanisms and comparison with other Advanced Oxidation Processes (e.g., UV/H2O2, ozonation, UV/O3, Fenton and photo-Fenton reactions), visible light-induced dye decomposition by sensitization mechanism, reaction intermediates and toxicity issues, and real-world process scenarios. © 2008 Elsevier B.V. All rights reserved.

Cassava root husks as a sorbent material for the uptake and pre-concentration of cadmium(II) from aqueous media

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Magnetic nanoparticles supported oxime palladacycle as a highly efficient and separable catalyst for room temperature Suzuki–Miyaura coupling reaction in aqueous media

A novel magnetic nanoparticle-supported oxime palladacycle catalyst was successfully prepared and characterized. The magnetically recoverable catalyst was evaluated in the room temperature Suzuki–Miyaura cross-coupling reaction of aryl iodides and bromides in aqueous media. The catalyst was shown to be highly active under phosphine-free and low Pd loading (0.3 mol%) conditions. The catalyst could be easily separated from the reaction mixture using an external magnet and reused for six consecutive runs without significant loss of activity.

Hg2+ -selective fluorescent probe based on rhodamine 6G and its application in aqueous media

Based on rhodamine 6G, a highly sensitive and selective fluorescent sensor R6G1 for Hg2+ detection had been designed and prepared. It was synthesized through the well-known reaction that thiourea derivatives with amine could easily be transformed into guanidine derivatives with the promotion of Hg2+. By coordination with Hg2+, R6G1 exhibited high sensitivity and selectivity over other metal ions in aqueous systems. Furthermore, fluorescence titration experiments established the well-fitted linearity function of the fluorescent intensity with the concentration of Hg2+ in aqueous solution. The results showed that R6G1 provided high water solubility and high selectivity toward Hg2+ but no significant response toward other competitive cations and anions. It was suggested that the chemosensor would find its application in environmental field requiring rapid and accurate Hg2+ ion analysis.

Occurrence of anodic current and corrosion of steel in aqueous media under fluctuating cathodic protection potentials

Excursion of cathodic protection (CP) potential from the designed "safe" CP level resulting from various forms of electrical interference signals are observed rather frequently in industrial applications, in particular in the pipeline industry; however, the influence of such potential fluctuations on the corrosion behavior of steel under CP conditions does not yet appear to be fully understood. In this work, the effects of anodic transients that periodically shift the potential of a CP protected steel electrode from-1,200 mVAg/AgCl to-750 mVAg/AgCl on the corrosion of a steel electrode in aqueous media was investigated using square wave polarization. Anodic currents were measured that lasted for significant periods of time upon stepping the CP potential up to a less cathodic potential at various frequencies (1 h, 30 s, 10 s, 5 s, and 1 s). Part of such anodic currents is found to cause steel corrosion, and this is explained on the basis of understanding the Fe/H2O equilibrium.

Effect of absorption in aqueous and hygrothermal media on the compressive properties of glass fiber reinforced syntactic foam

Absorption due to immersion in aqueous media consisting of either saline or seawater or due to exposure to water vapor conditions and the attendant effect on the compressive properties of syntactic foam reinforced with E-glass fibers in the form of chopped strands were studied. Whereas the compressive strength decreased in samples exposed to water vapor, the saline or seawater immersed samples showed increase when compared to the dry sample. The decrease in strength in the vapor-exposed case is ascribed to higher absorption of water and to debonding and damaged features for interfaces. The enhancement of strength values for the samples immersed in saltish media is traced to the larger size of the chloride ion and resultant changes in the stress state around the fiber-bearing regions. Recourse to an analysis of scanning electron microscopic pictures of the compression-failed samples is taken to explain the observed trends.