Temperature observation of CORK installation during ODP Leg 168

Four boreholes, drilled a few tens of meters into igneous basement on the eastern flank of the Juan de Fuca Ridge during ODP Leg 168, were sealed and instrumented for long-term monitoring to observe the hydrologic state of young sediment-sealed oceanic crust. The thermal regime is dominated by the effects of rapid fluid circulation in uppermost igneous basement driven by very small non-hydrostatic pressure gradients. Upper basement temperatures are uniform laterally between pairs of holes over distances of hundreds of meters to kilometers. In the case of two holes drilled into a sediment-buried basement ridge and adjacent valley, basement temperatures differ by less than 2 K despite the 2.2 km lateral separation of the sites and the 2.5:1 contrast in sediment cover thickness. Under conductive conditions, upper basement temperatures would differ by roughly 50 K. By comparison with modeling results, the observed degree of isothermality suggests a fluid flux of at least 10**-6 m/s (30 m/yr), and an effective permeability in the range of 10**-10 to 10**-9 m**2 in the uppermost igneous crust. The pressure difference available to drive this rapid flux between the ridge and valley, estimated by comparing the observed pressures via the isothermal upper basement hydrostat that is inferred to connect the two sites, is small (~2 kPa) and also suggests high permeability. Relative to the hydrostats defined by the local conductive sediment geotherms, substantial super-hydrostatic pressure (+18 kPa) is present within the buried basement ridge, and sub-hydrostatic pressure is present in the adjacent valley (-26 kPa). Such pressure differentials are the direct consequence of the advection-dominated thermal regime and small pressure losses in high-permeability basement, and are available to drive fluid seepage through sediment sections vertically up above and horizontally away from buried ridges, and down above valleys. No constraints are provided by any of the observations on the depth in the crust to which thermally or chemically significant flow might extend, although just as in the overlying sediments, the pattern of deep flow may be affected by the near-isothermal and near-hydrostatic conditions present in the permeable uppermost crustal section.

Lithologic, mineral, chemical and isotopic compositions of altered rocks with increasing distance across the eastern flank of the Juan de Fuca Ridge, ODP Leg 168 data

During ODP Leg 168, 10 sites were drilled across the eastern flank of the Juan de Fuca Ridge (JdFR), to examine the conditions of fluid-rock interaction in three distinct hydrothermal regimes (referred to as the Hydrothermal Transition (HT), Buried Basement (BB) and Rough Basement (RB) transects), extending over a ~120 km linear transect perpendicular to the spreading ridge. This was carried out in an attempt to constrain the conditions and processes that control the location, style and magnitude of low temperature (<150°C) fluid-rock interaction within this setting. This paper presents new data on the petrology, mineral chemistry and whole rock strontium and oxygen isotopic compositions of basalts from the eastern flank of the JdFR, in order to investigate the extent, style and sequence of low-temperature hydrothermal alteration and to establish how the hydrothermal regime evolved with time. Throughout the flank, a progressive sequence of low-temperature hydrothermal alteration has been identified, marked by changes in the dominant secondary mineral assemblage, changing from: chlorite+chlorite/smectite; to iron oyxhydroxide+celadonite; to saponite+/-pyrite; culminating at present with Ca- to CaMg(+/-Fe,Mn)-carbonate. The changes in secondary mineralogy have been used to infer a series of systematic shifts in the conditions of alteration that occurred as the basement moved off-axis and was progressively buried by sediment. In general, hydrothermal alteration of the uppermost oceanic crust commenced under open, oxidative conditions, with interaction between unmodified to slightly modified seawater and basaltic crust, to a regime in which circulation of a strongly modified seawater-derived fluid was more restricted, and alteration occurred under non-oxidative conditions. Across the flank, petrological observations and microprobe analyses indicate that the observed ranges in secondary mineral composition are directly related to changes in the geochemical and textural characteristics of the basement, as well as to interaction between fluids and phases from the four stages of alteration. This is suggestive of an increase in fluid-rock increased with time. Whole rock 87Sr/86Sr and d18O analyses of basalts from across the eastern flank of the JdFR reinforce petrological observations, with 87Sr/86Sr and d18O values slightly elevated above accepted pristine MORB values for this region. These results are consistent with an increase in the amount of fluid-rock interaction with time. Across the flank, enrichment in the 87Sr/86Sr and d18O relative to MORB, is influenced by a number of factors, including: local and regional variations in the crustal lithology and structure; the age of the crust; the extent of bulk rock alteration; and theoretically, the relative abundance of different isotopically-enriched secondary mineral phases in the crust.

(Table T1) Trace element concentration and isotopic composition of pore waters from ODP Leg 168 sites

Pore water was collected from each of 10 sites during Ocean Drilling Program (ODP) Leg 168 on the eastern flank of the Juan de Fuca Ridge. These ten sites delineate a transect perpendicular to the present ridge axis and span a crustal age of 0.86-3.59 Ma. At nine of the ten sites the entire sediment section, which ranged from 41.3 to 613.8 m thick, was cored and attempts were made to recover at least one whole round of sediment per section of core for extraction of pore water. Several (2-5) whole-round sediment samples were taken from the uppermost and lowermost cores to constrain the chemical gradient near the sediment/water and sediment/basalt interfaces, respectively. Pore water was extracted from whole-round sediment core sections by squeezing only the most pristine sediment in a titanium squeezer designed by Manheim and Sayles (1974). Two additional water samples were collected in situ using the water-sampler temperature probe (WSTP; Barnes, 1988, doi:10.2973/odp.proc.ir.110.104.1988). Both of these samples were collected in the cased section of the open borehole from ODP Hole 1026B. Formation fluids were flowing up the cased hole into the overlying deep seawater (Fisher et al., 1997, doi:10.1029/97GL01286). Detailed descriptions of the sampling methods that were used to collect fluids are given by the Shipboard Scientific Party (Davis, Fisher, Firth, et al., 1997, doi:10.2973/odp.proc.ir.168.1997).

Strontium and boron geochemistry of ODP sites at Hydrate Ridge, eastern Pacific Ocean

ODP Leg 204, which drilled at Hydrate Ridge, provides unique insights into the fluid regime of an accretionary complex and delineates specific sub-seafloor pathways for fluid transport. Compaction and dewatering due to smectite-illite transition increase with distance from the toe of the accretionary prism and bring up fluids from deep within the accretionary complex to sampled depths (<= 600 mbsf). These fluids have a distinctly non-radiogenic strontium isotope signature indicating reaction with the oceanic basement. Boron isotopes are also consistent with a deep fluid source that has been modified by desorption of heavy boron as clay minerals change from smectite to illite. One of three major horizons serves as conduit for the transport of mainly fluid. Our results enable us to evaluate fluid migration pathways that play important roles on massive gas hydrate accumulations and seepage of methane-rich fluids on southern Hydrate Ridge.

Biochemical and structural characterization of a beta-1,3-1,4-glucanase from Bacillus subtilis 168

beta-1,3-1,4-Glucanases (E.C. 3.2.1.73) hydrolyze linked beta-D-glucans, such as lichenan and barley beta-glucan. Recombinant beta-1,3-1,4-glucanase from Bacillus subtilis expressed in Escherichia coil and purified by Ni-NTA chromatography exhibited optimum activity at 50 degrees C and pH 6.0. The catalytic half-life at 60 degrees C decreased from 90 to 5 min when the enzyme was incubated in the presence and absence of Ca(2+) respectively. The kinetic parameters of lichenan hydrolysis were 2695, 3.1 and 1220 for V(max) (mu mol/min/mg), K(m) (mg mL(-1)) and K(cat) (s(-1)), respectively. Analysis by DLS, AUC and SAXS demonstrated the enzyme is monomeric in solution. Chemical denaturation monitored by ITFE and far-UV CD yielded Delta G(H2O) values of 9.6 and 9.1 kcal/mol, respectively, showing that the enzyme has intermediate stability when compared with other Bacillus beta-1,3-1,4-glucanases. The crystal structure shows the anti-parallel jelly-roll beta-sheet conserved in all GH16 beta-1,3-1,4-glucanases, with the amino acid differences between Bacillus sp. enzymes that are likely determinants of stability being distributed throughout the protein. (C) 2011 Elsevier Ltd. All rights reserved.

Recensão de: Ignacio Ramonet, Guerres du XXI siécle – Peurs et menaces nouvelles trad. José Martins, Porto, Campo das Letras, 2002, 168 pp.

Revista Lusófona de Ciências Sociais

Teichuronic acid operon of Bacillus subtilis 168.

Sequence analysis reveals that the Bacillus subtilis 168 tuaABCDEFGH operon encodes enzymes required for the polymerization of teichuronic acid as well as for the synthesis of one of its precursors, the UDP-glucuronate. Mutants deficient in any of the tua genes, grown in batch cultures under conditions of phosphate limitation, were characterized by reduced amounts of uronate in their cell walls. The teichuronic acid operon belongs to the Pho regulon, as phosphate limitation induces its transcription. Placing the tuaABCDEFGH operon under the control of the inducible Pspac promoter allowed its constitutive expression independently of the phosphate concentration in the medium; the level of uronic acid in cell walls was dependent on the concentration of the inducer. Apparently, owing to an interdependence between teichoic and teichuronic acid incorporation into the cell wall, in examined growth conditions, the balance between the two polymers is maintained in order to insure a constant level of the wall negative charge.