Crop coefficient and water consumption of eggplant in no-tillage system and conventional soil preparation

Under organic management in Seropédica-RJ, Brazil, using a weighing lysimeter, the crop coefficients (kc), the maximum evapotranspiration and the productivity of eggplant cultivation under two cropping systems (no tillage with straw plus soil with conventional preparation) were determined. A whole randomized layout with two treatments (no tillage and conventional) and five replicates during 134 days of cultivation were adopted. There were no significant differences in the eggplant cultivation in the two cropping systems, with a maximum commercial productivity obtained from 47.42 Mg ha-1 for the no-tillage system, and 47.91 Mg ha-1 for the conventional tillage. The accumulated ETc was 285.15 and 323.44 mm for the no-tillage and conventional, respectively. The crop coefficients value for the phases: 1 - transplanting, flowering, 2 - flowering-fruiting, 3 - fruit- first harvesting, 4- first harvesting of the final crop cycle was 0.83, 0.77, 0.90 and 0.97 in no-tillage system for the respective phases and for the conventional one 0.81, 1.14, 1.17 and 1.05 for the same steps described above.

Evapotranspiration and crop coefficient for potato in organic farming

The aim of this study was to quantify the water consumption and the crop coefficients (Kc) for the potato (Solanum tuberosum L.), in Seropédica, Rio de Janeiro (RJ), Brazil, under organic management, and to simulate the crop evapotranspiration (ETc) using the Kc obtained in the field and the ones recommended by the Food and Agriculture Organization (FAO). The water consumption was obtained through soil water balance, using TDR probes installed at 0.15m and 0.30m deep. At the different stages of development, the Kc was determined by the ratio of ETc and reference evapotranspiration, obtained by Penman-Monteith FAO 56. The crop coefficients obtained were 0.35, 0.45, 1.29 and 0.63. The accumulated ETc obtained in the field was 109.6 mm, while the ETc accumulated from FAO's Kc were 142.2 and 138mm, respectively, considering the classical values and the values adjusted to the local climatic conditions. The simulation of water consumption based on meteorological data of historical series from 1961 to 2007 provided higher value of ETc when compared with the one obtained in the field. From the meteorological data of historical series, it was observed that the use of Kc recommended by FAO may overestimate the amount of irrigation water by 9%, over the same growing season.

Georeferenced database generation with the purpose of hydrologic molding in reservoirs of the hydrographic basin of Jaguaribe river in the state of Ceará, Brazil

The edafoclimatic conditions of the Brazilian semiarid region favor the water loss by surface runoff. The state of Ceará, almost completely covered by semiarid, has developed public policies for the construction of dams in order to attend the varied water demand. Several hydrological models were developed to support decisive processes in the complex management of reservoirs. This study aimed to establish a methodology for obtaining a georeferenced database suitable for use as input data in hydrological modeling in the semiarid of Ceará. It was used images of Landsat satellite and SRTM Mission, and soil maps of the state of Ceará. The Landsat images allowed the determination of the land cover and the SRTM Mission images, the automatic delineation of hydrographic basins. The soil type was obtained through the soil map. The database was obtained for Jaguaribe River hydrographic basin, in the state of Ceará, and is applicable to hydrological modeling based on the Curve Number method for estimating the surface runoff.

Generation and Characterization of Knockout Mice and Analysis of Patient Material Demonstrates a Role for Tissue Inhibitor of Metalloproteinases 4 (Timp4) in the Cardiovascular System and Tumor Metastasis

This thesis focuses on tissue inhibitor of metalloproteinases 4 (TIMP4) which is the newest member of a small gene and protein family of four closely related endogenous inhibitors of extracellular matrix (ECM) degrading enzymes. Existing data on TIMP4 suggested that it exhibits a more restricted expression pattern than the other TIMPs with high expression levels in heart, brain, ovary and skeletal muscle. These observations and the fact that the ECM is of special importance to provide the cardiovascular system with structural strength combined with elasticity and distensibility, prompted the present molecular biologic investigation on TIMP4. In the first part of the study the murine Timp4 gene was cloned and characterized in detail. The structure of murine Timp4 genomic locus resembles that in other species and of the other Timps. The highest Timp4 expression was detected in heart, ovary and brain. As the expression pattern of Timp4 gives only limited information about its role in physiology and pathology, Timp4 knockout mice were generated next. The analysis of Timp4 knockout mice revealed that Timp4 deficiency has no obvious effect on the development, growth or fertility of mice. Therefore, Timp4 deficient mice were challenged using available cardiovascular models, i.e. experimental cardiac pressure overload and myocardial infarction. In the former model, Timp4 deficiency was found to be compensated by Timp2 overexpression, whereas in the myocardial infarct model, Timp4 deficiency resulted in increased mortality due to increased susceptibility for cardiac rupture. In the wound healing model, Timp4 deficiency was shown to result in transient retardation of re-epithelialization of cutaneous wounds. Melanoma tumor growth was similar in Timp4 deficient and control mice. Despite of this, lung metastasis of melanoma cells was significantly increased in Timp4 null mice. In an attempt to translate the current findings to patient material, TIMP4 expression was studied in human specimens representing different inflammatory cardiovascular pathologies, i.e. giant cell arteritis, atherosclerotic coronary arteries and heart allografts exhibiting signs of chronic rejection. The results showed that cardiovascular expression of TIMP4 is elevated particularly in areas exhibiting inflammation. The results of the present studies suggest that TIMP4 has a special role in the regulation of tissue repair processes in the heart, and also in healing wounds and metastases. Furthermore, evidence is provided suggesting the usefulness of TIMP4 as a novel systemic marker for vascular inflammation.

En generation intellektuella i uppror

Kirjallisuusarvostelu

A survey of the generation of ocean waves in a test basin

At present stage the analytical design of wave tolerance for floating structures and vessels is still imperfect due to the mutually complex and nonlinear phenomena between structures and waves. Wave tolerance design is usually carried out through iterative evaluations of results from model tests in a wave basin, and this is done in order to reach a final structural design. The wave generation has then become an important technology in the field of the coastal and ocean engineering. This paper summarizes the facilities of a test basin and a wave maker in Japan and also surveys the methodology of the generation of ocean waves in a test basin.

Investigation on diamond turning of silicon crystal - generation mechanism of surface cut with worn tool

This paper discusses the effect of tool wear on surface finish in single-point diamond turning of single crystal silicon. The morphology and topography of the machined surface clearly show the type of cutting edge wear reproduced onto the cutting grooves. Scanning electron microscopy is used in order to correlate the cutting edge damage and microtopography features observed through atomic force microscopy. The possible wear mechanisms affecting tool performance and surface generation during cutting are also discussed. The zero degree rake angle single point diamond tool presented small nicks on the cutting edge. The negative rake angle tools presented more a type of crater wear on the rake face. No wear was detected on flank face of the diamond tools.

Legal challenges for next generation science

Presentation at the Nordic Perspectives on Open Access and Open Science seminar, Helsinki, October 15, 2013

Building Next Generation Consortium Services – part 3: The National Metadata Repository, Discovery Service Finna, and the New Library System

Kristiina Hormia-Poutasen esitys CBUC-konferenssissa Barcelonassa 12.4.2013.

Building Next Generation Consortium Services – part 1: Background for Change

Kristiina Hormia-Poutasen esitys CBUC-konferenssissa Barcelonassa 12.4.2013.

Building Next Generation Consortium Services – part 2: Next Generation IT-services – Why, What, When?

Kristiina Hormia-Poutasen esitys CBUC-konferenssissa Barcelonassa 12.4.2013.

Building Next Generation Consortium Services – Introduction to the seminar

Kristiina Hormia-Poutasen esitys CBUC-konferenssissa 12.4.2013 Barcelonassa.

Creating generation Y sources of motivation for enhanced performance

New challenges have been created in the modern work environment as the diversity of the workforce is greater than ever in terms of generations. There will become a large demand of generation Y employees as the baby boomer generation employees retire at an accelerated rate. The purpose of this study is to investigate Y generation specific characteristics and to identify motivational systems to enhance performance. The research questions are: 1. What are Y generation characteristics? 2. What motivational systems organizations can form to motivate Y generation employees and in turn, create better performance? The Y generation specific characteristics identified from the literature include; achievement oriented; confident; educated; multitasking; having a need for feedback; needing management support; sociable and tech savvy. The proposed motivational systems can be found in four areas of the organization; HRM, training and development, communication and decision making policies. Three focus groups were held to investigate what would motivate generation Y employees to achieve better performance. Two of these focus groups were Finnish natives and the third consisted of international students. The HRM systems included flexibility and a culture of fun. It was concluded that flexibility within the workplace and role was a great source of motivation. Culture of fun was not responded to as favorably although most focus group participants rated enjoyableness as one of their top motivating factors. Training and development systems include training programs and mentoring as sources of potential motivation. Training programs were viewed as a mode to gain a better position and were not necessarily seen as motivational systems. Mentoring programs were not concluded to have a significant effect on motivation. Communication systems included keeping up with technology, clarity and goals as well as feedback. Keeping up with technology was seen as an ineffective tool to motivate. Clarity and goal setting was seen as very important to be able to perform but not necessarily motivating. Feedback had a highly motivating effect on these focus groups. Decision making policies included collaboration and teamwork as well as ownership. Teams were familiar and meet the social needs of Y generation employees and are motivating. Ownership was equated with trust and responsibility and was highly valued as well as motivating to these focus group participants.

Reaching influential early adopters effectively in Finland : Rock Science – new generation board game

Innovations diffuse at different speed among the members of a social system through various communication channels. The group of early adopters can be seen as the most influential reference group for majority of people to base their innovation adoption decisions on. Thus, the early adopters can often accelerate the diffusion of innovations. The purpose of this research is to discover means of diffusion for an innovative product in Finnish market through the influential early adopters in respect to the characteristics of the case product. The purpose of the research can be achieved through the following sub objectives:  Who are the potential early adopters for the case product and why?  How the potential early adopters of the case product should be communicated with?  What would be the expectations, preferences, and experiences of the early adopters of the case product? The case product examined in this research is a new board game called Rock Science which is considered to be incremental innovation bringing board gaming and hard rock music together in a new way. The research was conducted in two different parts using both qualitative and quantitative research methods. This mixed method research began with expert interviews of six music industry experts. The information gathered from the interviews enabled researcher to compose the questionnaire for the quantitative part of the study. Internet survey that was sent out resulted with a sample of 97 responses from the targeted population. The key findings of the study suggest that (1) the potential early adopters for the case product are more likely to be young adults from the capital city area with great interest in rock music, (2) the early adopters can be reached effectively through credible online sources of information, and (3) the respondents overall product feedback is highly positive, except in the case of quality-price ratio of the product. This research indicates that more effective diffusion of Rock Science board game in Finland can be reached through (1) strategic alliances with music industry and media partnerships, (2) pricing adjustments, (3) use of supporting game formats, and (4) innovative use of various social media channels.

Selection of Grids for Weed Mapping

This study aimed to assess the degree of similarity presented by thematic maps generated by different sampling grids of weed plants in a commercial agricultural area of 7.95 hectares. Monocotyledons and dicotyledons were counted on the 2012/2013 and 2013/2014 harvests, before soybean planting, in the fallow period after wheat harvest, in both years. A regular grid of 10 x 10 m was produced to sample the invasive plants, used as reference, and the counting was done in 1 m² of each sample point, totaling 795 samples in each year, compared to regular grids of 30 and 50 m, generated from the data exclusion of the standard grid. Twenty-two composite soil samples were taken at a depth of 0-20 cm to correlate soil properties with weeds occurrence. For the generation of the thematic maps, the Inverse Distance Weighting (IDW) for interpolation was used; when comparing the maps generated from each grid with the reference map, the kappa coefficient was used to assess the loss of quality of the maps as the number of sample points was reduced. It was observed that the map quality loss was lower in 2013 compared to 2012 when the sampling density of the points was reduced. The 30 x 30 m grids have satisfactorily described the infestation data of the dicotyledons and the 50 x 50 m grids have adequately described the monocotyledon weeds infestation, compared to the standard 10 x 10 m grids.