Vergleichende Texturuntersuchungen an Filets von Kliesche (Limanda limanda) und Scholle (Pleuronectes platessa) in Abhängigkeit von Eislagerzeit post mortem, TK-Lagerung und Erhitzen

Instrumental investigations of texture have been performed using texture profile analysis. The following textural parameters have been assessed: hardness, gumminess, chewiness, springiness, cohesiveness and adhesiveness. The fillets of both species have been prepared from deep frozen headed and gutted raw material without fins after frozen storage of 0, 23 and 34 weeks, respectively. Deep freezing of fishes has been performed on board immediately after hauling or after 6 day’s storage in ice. Before texture measurement the raw material has been thawed and the measurement was carriedout on both thawed and microwave-heated fillets. In general, it can be concluded that both fish species are comparable in their texture parameters. The hardness of heated dab has been slightly higher comparing with that one of plaice. All other texture parameters showed a fairly good conformity between both species. While the hardness of dab increased during heating, it was decreasing in plaice. This was the only one significant difference between both fishes during heating. Adhesiveness as well as cohesiveness increased remarkably during heating. Changes effected by ice storage were only slight. Frozen storage, in contrast, caused a significant decrease of adhesiveness measured after heating the fillets of both species.

Klassifizierung von Echogrammanzeigen

The information in the echosignal of marine scattering objects is only partially used up to now. This signal contains also informations on the biological properties of the objects. Some possibilities are described to estimate these properties from the echosignal.

Leistungsmessung an Bord von Fischereifahrzeugen zur Kontrolle der 300-PS-Begrenzung in der Schollenbox

For monitoring of the engine power of fishing vessels permitted for fishery in the plaice box with engine power of 300 HP or less at sea three different portable power measurement systems are developed and tested. A system measuring the twist of the propeller shaft by two divisible gearwheels mounted on the shaft worked well at shafts with roller bearing at both sides of the measured interval of 100–300 mm length. Only at a very few fishing vessels this system is applicable and therefore for monitoring purposes not suitable. The application of a commercial available system measuring the stress at the surface of the shaft was simplified for application by non experts. The torque is measured by strain gauges. The calibration of the system, measuring and recording of the power is done by a PC automatically. A small polished facet on the shaft protected against oxidation is needed for easy and quick application. In this case the system can be used by technical personnel of supervision boats for monitoring of the engine power at sea in a short time. A third power measurement system determinates the torque by measuring the displacement of two supports clamped on the shaft at a distance of 100 mm. The displacement is measured by a micrometer gauge mounted on one of the supports. Readout of the rotating gauge display is possible taking advantage of stroboscopic effect. The system needs no conditioning of the shaft and can be used by non technicians. The development is not finished until now and some additional investigations and tests are required. Additional measures for monitoring of the power on fishing vessels by self recording power measurement systems and sealed fuel racks with limited injection are reported and discussed.

Toxische Wirkung von Schadstoffen auf Fischzellen. Bestimmung von DNA-Strangbrüchen mit dem Comet-Assay

The alkaline comet assay is a method of detecting DNA strand breaks and alkali labile sites in individual cells. The method was used to detect DNA strand breaks in isolated blood cells (leukocytes) of carp (Cyprius carpio). DNA damage have been induced by exposure of the cells to sediment extract. Therefore comet assay can be applied as in vitro bioassay for investigations on toxicity of marine sediments.

Laichen von Dorschen in Gefangenschaft. Teil 1: Verlauf der Laichaktivitäten

Individuals of the western stock of Baltic cod were kept at captivity with different temperatures and salinities until natural spawning. Spawning activities up to 16 weeks were observed between February and June. This time interval agrees weIl with the spawning season of the wild cod stock. Also as in in-situ observations larger individuals started earlier with the spawning process than smaller ones and had significantly larger periods of spawning. Larger cods produced more batches and more eggs than smaller cods within this time interval. The comparison between the actual and potential absolut fecundity showed large differences. Only apart of the potential absolut fecundity, estimated in the phase of prespawning development of ovaries, was developed until their release. These analyses showed that larger cod were able to develop a larger part of the eggs within the ovaries up to the complete development. This result should be considered in the future during estimations of the population fecundity of the western Baltic spawning stock.

Bestimmung von künstlichen Radionukliden in Konsumfisch

The identification of artificial radionuclides in fish involves some diffculties, because the quantities of these nuclides are very low (10-16 to 10-10 g/kg). The procedures have to be done very carefully. The sample preparation, the radiochemical analyses and the final preparation of the samples for the detection of the radioactivity of strontium-90, plutonium-238, -239, -240 and americium-241 are briefly described. The levels of artificial radioactivity in some species of fish from the North Sea are shown. The additional exposure to radiation by artificial radionuc1ides by ingestion of fish amounts only to about 0,02 % of the mean exposure to natural radiation. Nevertheless further monitoring of radioactivity should be continued in order to ensure that changes can be detected in time.

Erster Einsatz von Trenngittern in der kommerziellen Garnelenfischerei

Comparative fishing trials were conducted in the river Elbe estuary using 9 m commercial brown shrimp beam trawls. To avoid the bycatch of fish a metal sorting grid of the Nordmöre type was used. The elliptical grid was constructed of 6 mm stainless steel bar with a spacing of 20 mm between the bars and housed in a cylindrical frame of 800 mm diameter. It was installed in the extension piece just in front of the codend. The inclination of the grid was 45 degrees. A fish outlet was provided in the upper panel of the trawl at the upper edge of the grid. A series of 8 tows of 15 min duration at a towing speed of 3 kns was done. For evaluation the catch of the main codend was compared to the portion of the catch escaped through the grid. The presence of the grid caused a 97.4 % reduction of the catch of lump sucker, a 90.6 % reduction of the catch of sea scorpion, a 79.3 % reduction of the catch of cod, a 58.8 % reduction of the catch of armed bullhead, a 39.6 % reduction of the catch of dab, a 34.7 % reduction of the catch of flounder, a 32.3 % reduction of the catch of smelt, a 19.8 % reduction of the catch of plaice and a 14.5 % reduction of the catch of brown shrimp.

Fischartbestimmung von Caviar durch Protein- und DNA-Analyse

Deutscher Caviar, made from roe of lumpfish or capelin, gives species specific patterns in protein electrophoresis. The same techniques can be used to differentiate caviar from salmon and trout. The differentiation of sturgeon caviar (beluga, osietra, sevruga) is possible by isoelectric focusing, but not by SDS-PAGE. PCR-based methods of DNA-analysis for identification of the origin of sturgeon caviar are under development.

Einfluß von Eis- und Tiefgefrierlagerung/Auftauen auf die Länge von Seefischfilets

The objective was to study the influence of biological and processing conditions on the evaluation of a conversion factor between fillet length and fish size. This paper presents changes of the length and weight of skinless fillets from various marine fish species in relation to the ice storage time and to the deep freezing / thawing process. The biochemical changes during rigor mortis lead to considerable reduction in length of skinless fillets during ice storage and deep freezing / thawing of fillet blocks. The investigations were undertaken during various cruises of the FFS „Walther Herwig III“.

Dokumentation eines Einstroms von warmem salzhaltigem Wasser in das Bornholmbecken im Oktober 1996

The Institute for Baltic Fisheries, Rostock, performed three research cruises with different aims in autumn (September - November) 1996. The area of investigation ranged from the southern Kattegat, the Belts, the Arkona Sea to the Bornholm Basin. With a CTD memory probe hydrographical data were sampled after many trawl stations from the surface to the bottom. These data document a saltwater inflow in the deeper water of the Bornholm Basin at the beginning of November.

Vergleich von Ausbeutefaktoren und Eislagerqualität zwischen Kliesche (Limanda limanda) und Scholle (Pleuronectes platessa) aus der Nordsee

North Sea plaice (Pleuronectes platessa) and dab (Limanda limanda) were experimentally stored in ice for 6 days during the 181th cruise of the FRV “Wather Herwig III”. It could be demonstrated that both flat fish species showed the same storage properties and were of a comparable quality until the end of the storage experiment. The quality of both species was determined by sensory assessment of the quality grade, by measuring of the impedance using the German Fischtester VI and the Icelandic RT- tester and pH- and TVB- N- measurements. The average length of North Sea dab is generally small (female: 18,5 ± 3,9 cm; male: 17 ± 2,9 cm), therefore it seemed to be more efficient to process fish portions (eviscerated, head, tail, fins and part of belly flaps removed). The yield by manually processed filets or fish portions from dab is about 30 or 62 %, respectively

Die Verwendung von Zusatzstoffen bei Krebstieren unter besonderer Berücksichtigung von Phosphaten. Eine Literaturübersicht

Die Krebstiere erfreuen sich sowohl national als auch international wachsender Beliebtheit bei den Verbrauchern. Mit der Intensivierung von Aufzucht- und Fangmethoden sowie mit der Anpassung der Verarbeitungstechnologien an die Erfordernisse des Exports und der dafür notwendigen Sicherung einer gleichmäßigen, möglichst hohen Qualität der Krebstiererzeugnisse gelangen in verstärktem Umfang Zusatzstoffe zum Einsatz, denen die Überwachungsorgane, Verbraucher und ihre Schutzorganisationen immer häufiger kritisch begegnen (Hermes 1995). Im folgenden soll versucht werden, in einem kurzen Überblick den gegenwärtigen Sachstand darzustellen.

Erste Ergebnisse zum Verlauf der Laichsaison von Dorschen in der westlichen Ostsee 1997

Investigations concerning the intensity and duration of spawning seasons of cod stocks are parts of the work of the reproductions ecology of commercial fish stocks in the Baltic Sea. The Institute of Baltic Fisheries Rostock has sampled and analysed data for this goal since 1992. The first data analyses for the spawning season 1997, sampled in the areas Kiel Bay, Mecklenburg Bay and Arkona Sea showed that the process of the spawning season is different compared to the years before. The spawning process starts earlier than the other years in Kiel Bay and Mecklenburg Bay. The results show that a high proportion of the spawning stock was part of the spawning process in this area. The Arkona Sea cod are regarded by ICES definition as belonging to the western cod stock. In this ICES sub-division only a low number of spawned cod was observed in March, the main spawning time of the western cod stock. Opposite to the theory of the stock units intensive spawning activities were observed in June as in the years before in the Arkona Sea.

Ursachen für wechselnde Selektionseigenschaften von Schleppnetzsteerten - Bericht über das EU-Forschungsprogramm VARSEL

Die Hoffnung, daß sich Fischbestände mit Hilfe von technischen Maßnahmen, wie der Festsetzung einer Mindeststeertmaschenöffnung, in Größe und Zusammensetzung regulieren lassen, ist in Kreisen der ischereiadministration und -wissenschaft weit verbreitet. Irritierend wirkt aber die Tatsache, daß von zwei oder mehr unabhängigen Untersuchern selten oder nie identische Ausleseeigenschaften bei der gleichen Maschenöffnung festgestellt werden. Bereits bei der Untersuchung eines einzigen Steerts, hinter dem gleichen Schleppnetz an einem Fangplatz eingesetzt, ergeben sich für die einzelnen Hols erhebliche Unterschiede, die nur durch die mehrfache Wiederholung des gleichen Experiments einigermaßen auszugleichen sind. Das bedingt einen erheblichen Aufwand für Selektionsuntersuchungen, bzw. bedingt die Varianz ihrer Ergebnisse. Während einer Forschungsschiffsreise können selten mehr als zwei oder drei verschiedene Konfigurationen geprüft werden. Für die eigentlich notwendige Wiederholung zu anderer Zeit und an anderem Ort fehlen in der Regel die Mittel.