Produtos têxteis inteligentes incorporando filamentos compósitos com nanotubos de carbono

Programa Doutoral em Engenharia Têxtil.

A hybrid MAC Scheme to improve the transmission performance in body sensor networks

Wireless body sensor networks (WBSNs) constitute a key technology for closing the loop between patients and healthcare providers, as WBSNs provide sensing ability, as well as mobility and portability, essential characteristics for wide acceptance of wireless healthcare technology. However, one important and difficult aspect of WBSNs is to provide data transmissions with quality of service, among other factors due to the antennas being small size and placed close to the body. Such transmissions cannot be fully provided without the assumption of a MAC protocol that solves the problems of the medium sharing. A vast number of MAC protocols conceived for wireless networks are based on random or scheduled schemes. This paper studies firstly the suitability of two MAC protocols, one using CSMA and the other TDMA, to transmit directly to the base station the signals collected continuously from multiple sensor nodes placed on the human body. Tests in a real scenario show that the beaconed TDMA MAC protocol presents an average packet loss ratio lower than CSMA. However, the average packet loss ratio is above 1.0 %. To improve this performance, which is of vital importance in areas such as e-health and ambient assisted living, a hybrid TDMA/CSMA scheme is proposed and tested in a real scenario with two WBSNs and four sensor nodes per WBSN. An average packet loss ratio lower than 0.2 % was obtained with the hybrid scheme. To achieve this significant improvement, the hybrid scheme uses a lightweight algorithm to control dynamically the start of the superframes. Scalability and traffic rate variation tests show that this strategy allows approximately ten WBSNs operating simultaneously without significant performance degradation.

Quantifying, generating and mitigating radio interference in Low-Power Wireless Networks

Doctoral Programme in Telecommunication - MAP-tele

Thermal technologies in food processing

[Excerpt] Introduction: Thermal processing is probably the most important process in food industry that has been used since prehistoric times, when it was discovered that heat enhanced the palatability and the life of the heat-treated food. Thermal processing comprehends the heating of foods at a defined temperature for a certain length of time. However, in some foods, the high thermotolerance of certain enzymes and microorganisms, their physical properties (e.g.,highviscosity),ortheircomponents(e.g.,solidfractions) require the application of extreme heat treatments that not only are energy intensive, but also will adversely affect the nutritional and organoleptic properties of the food. Technologies such as ohmic heating, dielectric heating (which includes microwave heating and radiofrequency heating), inductive heating, and infrared heating are available to replace, or complement, the traditional heat-dependent technologies (heating through superheated steam, hot air, hot water, or other hot liquid, being the heating achieved either through direct contact with those agents – mostly superheated steam – or through contact with a hot surface which is in turn heated by such agents). Given that the “traditional” heatdependent technologies are thoroughly described in the literature, this text will be mainly devoted to the so-called “novel” thermal technologies. (...)

Influence of Jitter on Reliable Multicast Data Transmission Rate in Terms of CDN Networks

This paper devotes to evaluation of performance bottlenecks and algorithm deficiencies in the area of contemporary reliable multicast networking. Hereby, the impact of packet delay jitter on the end-to-end performance of multicast IP data transport is investigated. A series of tests with two most significant open-source implementations of reliable multicast is performed and analyzed. These are: UDP-based File Transfer Protocol (UFTP) and NACK-oriented Reliable multicast (NORM). Tests were targeted to simulate scenario of content distribution in WAN – sized Content Delivery Networks (CDN). Then, results were grouped and averaged, by round trip time and packet losses. This enabled us to see jitter influence independently on round trip time(RTT) and packet loss rates. Revealed jitter influence for different network conditions. Confirmed, that appearance of even small jitter causes significant data rate reduction.

Improving TCP Performance on CSMA/CA Connections

In IP networks, most of packets, that have been dropped, are recovered after the expiration of retransmission timeouts. These can result in unnecessary retransmissions and needless reduction of congestion window. An inappropriate retransmission timeout has a huge impact on TCP performance. In this paper we have proved that CSMA/CA mechanism can cause TCP retransmissions due to CSMA/CA effects. For this we have observed three wireless connections that use CSMA/CA: with good link quality, poor link quality and in presence of cross traffic. The measurements have been performed using real devices. Through tracking of each transmitted packet it is possible to analyze the relation between one-way delay and packet loss probability and the cumulative distribution of distances between peaks of OWDs. The distribution of OWDs and the distances between peaks of OWDs are the most important parameters of tuning TCP retransmission timeout on CSMA/CA networks. A new perspective through investigating the dynamical relation between one-way delay and packet loss ratio depending on the link quality to enhance the TCP performance has been provided.

A Model of Video Traffic Transmission in IP Networks

Telecommunications and network technology is now the driving force that ensures continued progress of world civilization. Design of new and expansion of existing network infrastructures requires improving the quality of service(QoS). Modeling probabilistic and time characteristics of telecommunication systems is an integral part of modern algorithms of administration of quality of service. At present, for the assessment of quality parameters except simulation models analytical models in the form of systems and queuing networks are widely used. Because of the limited mathematical tools of models of these classes the corresponding parameter estimation of parameters of quality of service are inadequate by definition. Especially concerning the models of telecommunication systems with packet transmission of multimedia real-time traffic.

Comparison of Contemporary Protocols for High-speed Data Transport via 10 Gbps WAN Connections

This work is dedicated to comparison of open source as well as proprietary transport protocols for highspeed data transmission via IP networks. The contemporary common TCP needs significant improvement since it was developed as general-purpose transport protocol and firstly introduced four decades ago. In nowadays networks, TCP fits not all communication needs that society has. Caused of it another transport protocols have been developed and successfully used for e.g. Big Data movement. In scope of this research the following protocols have been investigated for its efficiency on 10Gbps links: UDT, RBUDP, MTP and RWTP. The protocols were tested under different impairments such as Round Trip Time up to 400 ms and packet losses up to 2%. Investigated parameters are the data rate under different conditions of the network, the CPU load by sender andreceiver during the experiments, size of feedback data, CPU usage per Gbps and the amount of feedback data per GiByte of effectively transmitted data. The best performance and fair resources consumption was observed by RWTP. From the opensource projects, the best behavior is showed by RBUDP.

Modelo de pérdida de paquetes para redes híbridas

El objetivo de este proyecto es la predicción de la pérdida de paquete. Para ello necesitaremos el modelado del canal. De esta manera, podremos determinar cuando una transmisión llega con éxito o no. En primer lugar, se han estudiado los algoritmos de adaptación de la tasa. Estos algoritmos mejoran el rendimiento de la comunicación. Por este motivo, el programa de simulación se basa en algunos de estos algoritmos. En paralelo, se han capturado medidas del canal terrestre para realizar el modelado. Finalmente, con un programa mucho más completo se ha simulado el comportamiento de una transmisión con el modelado del canal físico, y se han asumido algunas consideraciones, como las colisiones. Por lo tanto, se ha obtenido un resultado más realista, con el cual se ha analizado teóricamente las posibilidades de un enlace entre el canal terrestre y el canal satélite, para crear una red híbrida.

Arquitectura wormhole per a una NoC 2D-Mesh

Aquest projecte presenta la implementació d'un disseny, i la seva posterior síntesi en una FPGA, d'una arquitectura de tipus wormhole packet switching per a una infraestructura de NetWork-On-Chip amb una topologia 2D-Mesh. Agafant un router circuit switching com a punt de partida, s'han especificat els mòduls en Verilog per tal d'obtenir l'arquitectura wormhole desitjada. Dissenyar la màquina de control per governar els flits que conformen els paquets dins la NoC,i afegir les cues a la sortida del router (outuput queuing) són els punts principals d'aquest treball. A més, com a punt final s'han comparat ambdues arquitectures de router en termes de costos en àrea i en memòria i se n’han obtingut diverses conclusions i resultats experimentals.

Codificación a nivel de paquete para comunicaciones móviles por satélite

Una de les opcions que es contemplen per transmetre continguts multimèdia i proporcionar accés a Internet a grups de usuaris mòbils és fer servir satèl·lits. Les condiciones de propagació del canal mòbil impliquen que d'una manera o altra haurem de garantir la qualitat de servei. Això té fins i tot més importància si tenim en compte que, en el cas d'accés a Internet, no es té la capacitat d'assumir cert percentatge de pèrdua de dades que tenim, per exemple, en la transmissió de so o vídeo (rebaixant la qualitat). Entre les principals alternatives per a aquesta classe d’entorns es troba la inclusió de codificacions a nivell de paquet. El funcionament d'aquesta tècnica es basa en incloure a la transmissió paquets redundants, obtinguts mitjançant un determinat algoritme. El receptor podrà recuperar la informació original que es volia enviar, sempre que hagi rebut una certa quantitat de paquets, similar a la quantitat de paquets originals. A aquest mecanisme se'l coneix com Forward Error Correction (FEC) a nivell de paquet. En aquesta memòria es valoren breument les alternatives existents i s'expliquen algunes de les codificacions per a FEC més importants. A continuació es realitza un estudi compartiu d’algunes d'elles: les variants de LDPC (Low Density Parity Check) conegudes com LDGM (Low Density Generator Matrix), i la codificació Raptor

Label Space Reduction in All-Optical Label Switchiing Networks

Report for the scientific sojourn at the Department of Information Technology (INTEC) at the Ghent University, Belgium, from january to june 2007. All-Optical Label Swapping (AOLS) forms a key technology towards the implementation of All-Optical Packet Switching nodes (AOPS) for the future optical Internet. The capital expenditures of the deployment of AOLS increases with the size of the label spaces (i.e. the number of used labels), since a special optical device is needed for each recognized label on every node. Label space sizes are affected by the wayin which demands are routed. For instance, while shortest-path routing leads to the usage of fewer labels but high link utilization, minimum interference routing leads to the opposite. This project studies and proposes All-Optical Label Stacking (AOLStack), which is an extension of the AOLS architecture. AOLStack aims at reducing label spaces while easing the compromise with link utilization. In this project, an Integer Lineal Program is proposed with the objective of analyzing the softening of the aforementioned trade-off due to AOLStack. Furthermore, a heuristic aiming at finding good solutions in polynomial-time is proposed as well. Simulation results show that AOLStack either a) reduces the label spaces with a low increase in the link utilization or, similarly, b) uses better the residual bandwidth to decrease the number of labels even more.

Cooperative strategies for imperfect CSI scenarios based on distributed Alamouti

Les comunicacions cooperatives estan guanyant un gran interès en les comunicacions modernes degut a que permeten millorar la transmissió dʼinformació entre un emissor i un receptor utilitzant una sèrie de terminals situats entre ells. Aquest projecte és un estudi complet del sistemes cooperatius, analitzant el seu rendiment i comparant lʼús dʼun sol dʼaquests terminals amb lʼús del codi Alamouti, que utilitza dos terminals. Primer hi ha una introducció als sistemes cooperatius i a la teoria de la informació. Després hem estudiat un sistema cooperatiu amb la teoria de la informació com a base, en termes de probabilitat de fallada del sistema, i posteriorment lʼhem adaptat a un sistema cooperatiu real utilitzant una modulació QPSK, estudiant la seva probabilitat dʼerror de paquet. Finalment es proposen diversos protocols que permeten millorar el rendiment del sistema cooperatiu estudiat.

Modelització i control d'un reactor de producció d'hidrogen per a l'alimentació de piles de combustible

Les piles de combustible permeten la transformació eficient de l’energia química de certs combustibles a energia elèctrica a través d’un procés electroquímic. De les diferents tecnologies de piles de combustible, les piles de combustible de tipus PEM són les més competitives i tenen una gran varietat d’aplicacions. No obstant, han de ser alimentades únicament per hidrogen. Per altra banda, l’etanol, un combustible interessant en el marc dels combustibles renovables, és una possible font d’hidrogen. Aquest treball estudia la reformació d’etanol per a l’obtenció d’hidrogen per a alimentar piles de combustible PEM. Només existeixen algunes publicacions que tractin l’obtenció d’hidrogen a partir d’etanol, i aquestes no inclouen l’estudi dinàmic del sistema. Els objectius del treball són el modelat i l’estudi dinàmic de reformadors d’etanol de baixa temperatura. Concretament, proposa un model dinàmic d’un reformador catalític d’etanol amb vapor basat en un catalitzador de cobalt. Aquesta reformació permet obtenir valors alts d’eficiència i valors òptims de monòxid de carboni que evitaran l’enverinament d’una la pila de combustible de tipus PEM. El model, no lineal, es basa en la cinètica obtinguda de diferents assaigs de laboratori. El reformador modelat opera en tres etapes: deshidrogenació d’etanol a acetaldehid i hidrogen, reformat amb vapor d’acetaldehid, i la reacció WGS (Water Gas Shift). El treball també estudia la sensibilitat i controlabilitat del sistema, caracteritzant així el sistema que caldrà controlar. L’anàlisi de controlabilitat es realitza sobre la resposta de dinàmica ràpida obtinguda del balanç de massa del reformador. El model no lineal és linealitzat amb la finalitat d’aplicar eines d’anàlisi com RGA, CN i MRI. El treball ofereix la informació necessària per a avaluar la possible implementació en un laboratori de piles de combustibles PEM alimentades per hidrogen provinent d’un reformador d’etanol.