Novel experiment on in-cylinder desorption of fuel from the oil layer

A technique has been developed to measure the desorption and subsequent oxidation of fuel in the oil layer by spiking the oil with liquid fuel and firing the engine on gaseous fuel or motoring with air. Experiments suggest that fuel desorption is not diffusion limited above 50°C and indicated that approximately two to four percent of the cylinder oil layer is fresh oil from the sump. The increase in hydrocarbon emissions is of the order of 100 ppmC1 per 1% liquid fuel introduced into the fresh oil in a methane fired engine at mid-speed and light load conditions. Calculations indicate that fuel desorbing from oil is much more likely to produce hydrocarbon emissions than fuel emerging from crevices. © Copyright 1994 Society of Automotive Engineers, Inc.

Simulations of thermal upgrading methods for oil shale reservoirs

This paper analyzes reaction and thermal front development in porous reservoirs with reacting flows, such as those encountered in shale oil extraction. A set of dimensionless parameters and a 3D code are developed in order to investigate the important physical and chemical variables of such reservoirs when heated by in situ methods. This contribution builds on a 1D model developed for the precursor study to this work. Theory necessary for this study is presented, namely shale decomposition chemical mechanisms, governing equations for multiphase flow in porous media and necessary closure models. Plotting the ratio of the thermal wave speed to the fluid speed allows one to infer that the reaction wave front ends where this ratio is at a minimum. The reaction front follows the thermal front closely, thus allowing assumptions to be made about the extent of decomposition solely by looking at thermal wave progression. Furthermore, this sensitivity analysis showed that a certain minimum permeability is required in order to ensure the formation of a traveling thermal wave. It was found that by studying the non-dimensional governing parameters of the system one can ascribe characteristic values for these parameters for given initial and boundary conditions. This allows one to roughly predict the performance of a particular method on a particular reservoir given approximate values for initial and boundary conditions. Channelling and flow blockage due to carbon residue buildup impeded each method's performance. Blockage was found to be a result of imbalanced heating. Copyright 2012, Society of Petroleum Engineers.

Relating monolithic and granular leaching from contaminated soil treated with different cementitious binders.

This work employed a clayey, silty, sandy gravel contaminated with a mixture of metals (Cd, Cu, Pb, Ni and Zn) and diesel. The contaminated soil was treated with 5 and 10% dosages of different cementitious binders. The binders include Portland cement, cement-fly ash, cement-slag and lime-slag mixtures. Monolithic leaching from the treated soils was evaluated over a 64-day period alongside granular leachability of 49- and 84-day old samples. Surface wash-off was the predominant leaching mechanism for monolithic samples. In this condition, with data from different binders and curing ages combined, granular leachability as a function of monolithic leaching generally followed degrees 4 and 6 polynomial functions. The only exception was for Cu, which followed the multistage dose-response model. The relationship between both leaching tests varied with the type of metal, curing age/residence time of monolithic samples in the leachant, and binder formulation. The results provide useful design information on the relationship between leachability of metals from monolithic forms of S/S treated soils and the ultimate leachability in the eventual breakdown of the stabilized/solidified soil.

Factor analysis and structural equation modelling of sustainable behaviour in contaminated land remediation

Contaminated land remediation has traditionally been viewed as sustainable practice because it reduces urban sprawl and mitigates risks to human being and the environment. However, in an emerging green and sustainable remediation (GSR) movement, remediation practitioners have increasingly recognized that remediation operations have their own environmental footprint. The GSR calls for sustainable behaviour in the remediation industry, for which a series of white papers and guidance documents have been published by various government agencies and professional organizations. However, the relationship between the adoption of such sustainable behaviour and its underlying driving forces has not been studied. This study aims to contribute to sustainability science by rendering a better understanding of what drives organizational behaviour in adopting sustainable practices. Factor analysis (FA) and structural equation modelling (SEM) were used to investigate the relationship between sustainable practices and key factors driving these behaviour changes in the remediation field. A conceptual model on sustainability in the environmental remediation industry was developed on the basis of stakeholder and institutional theories. The FA classified sustainability considerations, institutional promoting and impeding forces, and stakeholder's influence. Subsequently the SEM showed that institutional promoting forces had significant positive effects on adopting sustainability measures, and institutional impeding forces had significant negative effects. Stakeholder influences were found to have only marginal direct effect on the adoption of sustainability; however, they exert significant influence on institutional promoting forces, thus rendering high total effect (i.e. direct effect plus indirect effect) on the adoption of sustainability. This study suggests that sustainable remediation represents an advanced sustainable practice, which may only be fully endorsed by both internal and external stakeholders after its regulatory, normative and cognitive components are institutionalized. © 2014 Elsevier Ltd. All rights reserved.

Comparisons of operating envelopes for contaminated soil stabilised/solidified with different cementitious binders

This work initiated the development of operating envelopes for stabilised/solidified contaminated soils. The operating envelopes define the range of operating variables for acceptable performance of the treated soils. The study employed a soil spiked with 3,000 mg/kg each of Cd, Cu, Pb, Ni and Zn, and 10,000 mg/kg of diesel. The binders used for treatment involved Portland cement (CEMI), pulverised fuel ash (PFA), ground granulated blast furnace slag (GGBS) and hydrated lime (hlime). The specific binder formulations were CEMI, CEMI/PFA = 1:4, CEMI/GGBS = 1:9 and hlime/GGBS = 1:4. The water contents employed ranged from 13 % to 21 % (dry weight), while binder dosages ranged from 5 % to 20 % (w/w). We monitored the stabilised/solidified soils for up to 84 days using different performance tests. The tests include unconfined compressive strength (UCS), hydraulic conductivity, acid neutralisation capacity (ANC) and pH-dependent leachability of contaminants. The water content range resulted in adequate workability of the mixes but had no significant effect on leachability of contaminants. We produced design charts, representing operating envelopes, from the results generated. The charts establish relationships between water content, binder dosage and UCS; and binder dosage, leachant pH and leachability of contaminants. The work also highlights the strengths and weaknesses of the different binder formulations. © 2013 Springer-Verlag Berlin Heidelberg.

Headspace solid-phase microextraction with novel sol-gel permethylated-beta-cyclodextrin/hydroxyl-termination silicone oil fiber for determination of polybrominated diphenyl ethers by gas chromatography-mass spectrometry in soil

A simple, sensitive, and accurate method for determination of polybrominated diphenyl ethers (PBDEs) in soil has been developed based on headspace solid-phase microextraction (HS-SPME) followed by gas chromatography-mass spectrometry (GC-MS). Permethylated-beta-cyclodextrin/hydroxyl-termination silicone oil (PM-beta-CD/OH-TSO) fiber was first prepared by sol-gel technology and employed in SPME procedure. By exploiting the superiorities of sot-gel coating technique and the advantages of the high hydrophobic doughnut-shaped cavity of PM-beta-CD, the novel fiber showed desirable operational stability and extraction ability. After optimization on extraction conditions like water addition, extraction temperature, extraction time, salts effect, and solvents addition, the method was validated in soil samples, achieving good linearity (r>0.999), precision (R.S.D. < 10%), accuracy (recovery>78%), and detection limits (S/N =3) raging from 13.0 to 78.3 pg/g. (c) 2007 Published by Elsevier B.V.

Sustainability: A new imperative in contaminated land remediation

Land is not only a critical component of the earth's life support system, but also a precious resource and an important factor of production in economic systems. However, historical industrial operations have resulted in large areas of contaminated land that are only slowly being remediated. In recent years, sustainability has drawn increasing attention in the environmental remediation field. In Europe, there has been a movement towards sustainable land management; and in the US, there is an urge for green remediation. Based on a questionnaire survey and a review of existing theories and empirical evidence, this paper suggests the expanding emphasis on sustainable remediation is driven by three general factors: (1) increased recognition of secondary environmental impacts (e.g., life-cycle greenhouse gas emissions, air pollution, energy consumption, and waste production) from remediation operations, (2) stakeholders' demand for economically sustainable brownfield remediation and "green" practices, and (3) institutional pressures (e.g., social norm and public policy) that promote sustainable practices (e.g., renewable energy, green building, and waste recycling). This paper further argues that the rise of the "sustainable remediation" concept represents a critical intervention point from where the remediation field will be reshaped and new norms and standards will be established for practitioners to follow in future years. This paper presents a holistic view of sustainability considerations in remediation, and an integrated framework for sustainability assessment and decision making. The paper concludes that "sustainability" is becoming a new imperative in the environmental remediation field, with important implications for regulators, liability owners, consultants, contractors, and technology vendors. © 2014 Elsevier Ltd.

Composition of volatile oil of Primula obconica in Central China

Primula obconica was introduced to Europe from Hubei, China in 1880, and has been cultivated worldwide as one of popular ornamental plants. The volatile oil of wild P. obconica collected from its original place, Yichang, Hubei was first investigated. A total of 43 compounds constituting 93.49% of the oil were identified by using GC and GC-MS. The major compounds were methyl 2,4-dihydroxy-5-methyl benzoate (30.41%), methyl 2,6-dihydroxy-4-methyl benzoate (29.27%), and hypnone (8.92%) etc. In comparison with the published data of some European cultivars, the native P. obconica seems to be allergen-free due to absence of primin and miconidin.

Influence of dioxin and metal-contaminated sediment on phase I and II biotransformation enzymes in silver crucian carp

Several biochemical responses were measured in silver crucian carp (Carassius auratus gibelio) after exposure to sediments obtained from contaminated Ya-Er Lake, No, 1 pond, and an unpolluted reference site, Honglian Lake. After 1 week of exposure, a significant induction of the phase I biotransformation enzyme (ethoxylresorufin-o-deethylase, EROD) was found (83-fold of control), whereas the phase II biotransformation enzyme (glutathione S-transferase, GST) exhibited a slight, but significant induction (1,4-fold of control) after 4 weeks of exposure. The level of cellular glutathione in the liver was also slightly elevated after 4 weeks of exposure. The delayed response of GST to the contaminants indicates that the phase I and phase II biotransformation enzymes are regulated differently in fish. The results suggest that EROD is a sensitive bioindicator to assess the toxicity of dioxin-contamined sediment in the laboratory, (C) 1998 Academic Press.

Oil-immersion or solid-immersion power enhancement of very-small-aperture lasers

An analysis of the enhancement of light transmission through a sub-wavelength aperture by oil- or solid-immersion is presented in this letter. An output power enhancement phenomenon related to the oil-immersion or solid-immersion mechanism is realized experimentally and reported for a very small aperture laser, which is an agreement with simulation analysis. This phenomenon could be useful for future optical data storage, microscopy and lithography.