Hydrogen purification for fuel cell using CuO/CeO(2)-Al(2)O(3) catalyst

CuO/CeO(2), CuO/Al(2)O(3) and CuO/CeO(2)-Al(2)O(3) catalysts, with CuO loading varying from 1 to 5 wt.%, were prepared by the citrate method and applied to the preferential oxidation of carbon monoxide in a reaction medium containing large amounts of hydrogen (PROX-CO). The compounds were characterized ex situ by X-ray diffraction, specific surface area measurements, temperature-programmed reduction and temperature-programmed reduction of oxidized surfaces; XANES-PROX in situ experiments were also carried out to study the copper oxidation state under PROX-CO conditions. These analyses showed that in the reaction medium the Cu(0) is present as dispersed particles. On the ceria, these metallic particles are smaller and more finely dispersed, resulting in a stronger metal-support interaction than in CuO/Al(2)O(3) or CuO/CeO(2)-Al(2)O(3) catalysts, providing higher PROX-CO activity and better selectivity in the conversion of CO to CO(2) despite the greater BET area presented by samples supported on alumina. It is also shown that the lower CuO content, the higher metal dispersion and consequently the catalytic activity. The redox properties of the ceria support also contributed to catalytic performance. (C) 2010 Elsevier B.V. All rights reserved.

Potential oscillations in a proton exchange membrane fuel cell with a Pd-Pt/C anode

We report in this paper the occurrence of potential oscillations in a proton exchange membrane fuel cell (PEMFC) with a Pd-Pt/C anode, fed with H(2)/100 ppm CO, and operated at 30 degrees C. We demonstrate that the use of Pd-Pt/C anode enables the emergence of dynamic instabilities in a PEMFC. Oscillations are characterized by the presence of very high oscillation amplitude, ca. 0.8 V. which is almost twice that observed in a PEMFC with a Pt-Ru/C anode under similar conditions. The effects of the H(2)/CO flow rate and cell current density on the oscillatory dynamics were investigated and the mechanism rationalized in terms of the CO oxidation and adsorption processes. We also discuss the fundamental aspects concerning the operation of a PEMFC under oscillatory regime in terms of the benefit resulting from the higher average power output. (c) 2010 Elsevier B.V. All rights reserved.

The effects of hydrogen sulfide on the polymer electrolyte membrane fuel cell anode catalyst: H(2)S-Pt/C interaction products

The performance of a polymer electrolyte membrane fuel cell (PEMFC) operating on a simulated hydrocarbon reformate is described. The anode feed stream consisted of 80% H(2),similar to 20% N(2), and 8 ppm hydrogen sulfide (H(2)S). Cell performance losses are calculated by evaluating cell potential reduction due to H(2)S contamination through lifetime tests. It is found that potential, or power, loss under this condition is a result of platinum surface contamination with elemental sulfur. Electrochemical mass spectroscopy (EMS) and electrochemical techniques are employed, in order to show that elemental sulfur is adsorbed onto platinum, and that sulfur dioxide is one of the oxidation products. Moreover, it is demonstrated that a possible approach for mitigating H(2)S poisoning on the PEMFC anode catalyst is to inject low levels of air into the H(2)S-contaminated anode feeding stream. (C) 2011 Elsevier B.V. All rights reserved.

Fluoxetine and norfluoxetine analysis by direct injection of human plasma in a column switching liquid chromatographic system

A column switching LC method is presented for the analysis of fluoxetine (FLU) and norfluoxetine (NFLU) by direct injection of human plasma using a lab-made restricted access media (RAM) column. A RAM-BSA-octadecyl silica (C-18) column (40 min x 4.6 mm, 10 mu m) is evaluated in both backflush and foreflush elution modes and coupled with a C-18 lab-made (50 mm x 4.6 mm, 3 pm) analytical column in order to perform online sample preparation. Direct injection of 100 mu L, of plasma samples is possible with the developed approach. In addition, reduction of sample handling is obtained when compared with traditional liquid-liquid extraction (LLE) and SPE. The total analysis time is around 20 min. A LOQ of 15 ng/mL is achieved in a concentration range of 15-500 ng/mL, allowing the therapeutic drug monitoring of clinical samples. The precision values achieved are lower than 15% for all the evaluated points with adequate recovery and accuracy. Furthermore, no matrix interferences are found in the analysis and the proposed method shows to be an adequate alternative for analysis of FLU in plasma.

In Bio-Fuel We Trust

In bio-fuel we trust. Or do we? In this chapter, ethnographic material from Sweden is used to discuss ways sin which trust may influence the choice of bio-fuel for heating purposes. The meaning and substance of trust or distrust, as well as the very conditions for trust, are elaborated on in relation to solar and bio-pellet systems, district heating with bio-fuel, and traditional fireplaces. An important conclusion of this chapter is that the degree to which people perceive others as being like themselves or not tends to be decisive for whether these others are to be trusted, and therefore worth listening to. The context and situation in which a certain heating system is being chosen does not only involve trust in individuals, however, but in companies and the authorities, as well as in the arterfacts themselves. An example is given on how distrust of district heating companies led house owners to reject an offer of district heating despite the comfort and environmental benefit this could have provided. it is shown how this distrust might be resolved by making the rhythm of households and sitrict heating companies more in step with one another. The strong emotional attachment to and deep-felt trust in the traditional fireplace is also analysed, and a question is put forward as to whether these feelings could be transferred to modern bio-pellet stoves. Finally, our great and assured trust in bio-fuel as a main solution to global climate change is shortly commented upon and partly questioned.

Emissions from realistic operation of residential wood pellets heating systems

Emissions from residential combustion appliances vary significantly depending on the firing behaviours and combustion conditions, in addition to combustion technologies and fuel quality. Although wood pellet combustion in residential heating boilers is efficient, the combustion conditions during start-up and stop phases are not optimal and produce significantly high emissions such as carbon monoxide and hydrocarbon from incomplete combustion. The emissions from the start-up and stop phases of the pellet boilers are not fully taken into account in test methods for ecolabels which primarily focus on emissions during operation on full load and part load. The objective of the thesis is to investigate the emission characteristics during realistic operation of residential wood pellet boilers in order to identify when the major part of the annual emissions occur. Emissions from four residential wood pellet boilers were measured and characterized for three operating phases (start-up, steady and stop). Emissions from realistic operation of combined solar and wood pellet heating systems was continuously measured to investigate the influence of start-up and stop phases on total annual emissions. Measured emission data from the pellet devices were used to build an emission model to predict the annual emission factors from the dynamic operation of the heating system using the simulation software TRNSYS. Start-up emissions are found to vary with ignition type, supply of air and fuel, and time to complete the phase. Stop emissions are influenced by fan operation characteristics and the cleaning routine. Start-up and stop phases under realistic operation conditions contribute 80 – 95% of annual carbon monoxide (CO) emission, 60 – 90% total hydrocarbon (TOC), 10 – 20% of nitrogen oxides (NO), and 30 – 40% particles emissions. Annual emission factors from realistic operation of tested residential heating system with a top fed wood pelt boiler can be between 190 and 400 mg/MJ for the CO emissions, between 60 and 95 mg/MJ for the NO, between 6 and 25 mg/MJ for the TOC, between 30 and 116 mg/MJ for the particulate matter and between 2x10-13 /MJ and 4x10-13 /MJ for the number of particles. If the boiler has the cleaning sequence with compressed air such as in boiler B2, annual CO emission factor can be up to 550 mg/MJ. Average CO, TOC and particles emissions under realistic annual condition were greater than the limits values of two eco labels. These results highlight the importance of start-up and stop phases in annual emission factors (especially CO and TOC). Since a large or dominating part of the annual emissions in real operation arise from the start-up and stop sequences, test methods required by the ecolabels should take these emissions into account. In this way it will encourage the boiler manufacturers to minimize annual emissions. The annual emissions of residential pellet heating system can be reduced by optimizing the number of start-ups of the pellet boiler. It is possible to reduce up to 85% of the number of start-ups by optimizing the system design and its controller such as switching of the boiler pump after it stops, using two temperature sensors for boiler ON/OFF control, optimizing of the positions of the connections to the storage tank, increasing the mixing valve temperature in the boiler circuit and decreasing the pump flow rate. For 85 % reduction of start-ups, 75 % of CO and TOC emission factors were reduced while 13% increase in NO and 15 % increase in particle emissions was observed.

Claude Elwood Shannon e a symbolic analysis of relay and switching circuits: tornando o computador uma máquina semiótica.

O nome de Claude Elwood Shannon não é totalmente estranho aos pesquisadores de Comunicação Social. No entanto, parte de sua importância para a história da comunicação no século XX é pouco conhecida. Sua dissertação de mestrado e o artigo dela derivado (A Symbolic Analysis of Relay and Switching Circuits) foram essenciais para que o computador se tornasse uma máquina de comunicação e, conseqüentemente, penetrasse em nossa sociedade na forma como ocorre hoje. Este artigo revisa o primeiro grande trabalho de Shannon e explicita sua participação no contexto atual da comunicação.

Improving mutual fund market timing measures: a markov switching approach

Market timing performance of mutual funds is usually evaluated with linear models with dummy variables which allow for the beta coefficient of CAPM to vary across two regimes: bullish and bearish market excess returns. Managers, however, use their predictions of the state of nature to deÞne whether to carry low or high beta portfolios instead of the observed ones. Our approach here is to take this into account and model market timing as a switching regime in a way similar to Hamilton s Markov-switching GNP model. We then build a measure of market timing success and apply it to simulated and real world data.

Correcting the fixed-effect estimator for endogenous switching

In this paper, we propose a two-step estimator for panel data models in which a binary covariate is endogenous. In the first stage, a random-effects probit model is estimated, having the endogenous variable as the left-hand side variable. Correction terms are then constructed and included in the main regression.

Posicionamento estratégico com switching costs e lock-in na economia da informação

Apresenta uma perspectiva de análise de posicionamento estratégico utilizando-se os princípios econômicos de switching costs e lock-in. Aborda as diferentes fontes de switching costs e analisa as estratégias de lock-in. Apresenta um caso prático com aplicação destes conceitos no segmento de ERP no Brasil.

Fuel ethanol price drivers in the Atlantic basin : Brazil & the U.S. traders perspectives

Como a oportunidade de exportação de etanol combustível é muito recente, o agronegócio carece de literatura para formação de gestores e estrategistas. Este trabalho tem como objetivo descrever o mecanismo de formação de preços de etanol tanto no Brasil como nos Estados Unidos da America. Decupei as variáveis que impactam na formação de preços, custo de produção de etanol de cana-de-açúcar, custo da logística e desidratação no Caribe, custo do etanol de milho e fiz algumas análises de cenários de formação de preços das principais variáveis e consegui organizar este conhecimento em um gráfico que contém no eixo superior preço do etanol hidratado na usina no Brasil e no eixo inferior o preço do bushel de milho em Chicago cujas interceções nas retas da taxa do dólar e do preço do gás natural, fornecem no eixo Y o preço do produto no porto de Nova York, ficando uma visualização simples das possibilidades da janela de exportação. A metodologia permite assumir diferentes cenários de oferta, demanda e preços e estabelecer diferentes estratégias de comercialização.

Um modelo "time-varying markov-Switching" para crescimento econômico e algoritmo de estimação

Este trabalho elabora um modelo para investigação do padrão de variação do crescimento econômico, entre diferentes países e através do tempo, usando um framework Markov- Switching com matriz de transição variável. O modelo desenvolvido segue a abordagem de Pritchett (2003), explicando a dinâmica do crescimento a partir de uma coleção de diferentes estados – cada qual com seu sub-modelo e padrão de crescimento – através dos quais os países oscilam ao longo do tempo. A matriz de transição entre os diferentes estados é variante no tempo, dependendo de variáveis condicionantes de cada país e a dinâmica de cada estado é linear. Desenvolvemos um método de estimação generalizando o Algoritmo EM de Diebold et al. (1993) e estimamos um modelo-exemplo em painel com a matriz de transição condicionada na qualidade das instituições e no nível de investimento. Encontramos três estados de crescimento: crescimento estável, ‘milagroso’ e estagnação - virtualmente coincidentes com os três primeiros de Jerzmanowski (2006). Os resultados mostram que a qualidade das instituições é um importante determinante do crescimento de longo prazo enquanto o nível de investimento tem papel diferenciado: contribui positivamente em países com boa qualidade de instituições e tem papel pouco relevante para os países com instituições medianas ou piores.

A dynamic model of price competition with switching and search costs

Em modelos de competição de preços, somente um custo de procura positivo por parte do consumidor não gera equilíbrio com dispersão de preços. Já modelos dinâmicos de switching cost consistentemente geram este fenômeno bastante documentado para preços no varejo. Embora ambas as literaturas sejam vastas, poucos modelos tentaram combinar as duas fricções em um só modelo. Este trabalho apresenta um modelo dinâmico de competição de preços em que consumidores idênticos enfrentam custos de procura e de switching. O equilíbrio gera dispersão nos preços. Ainda, como os consumidores são obrigados a se comprometer com uma amostra fixa de firmas antes dos preços serem definidos, somente dois preços serão considerados antes de cada compra. Este resultado independe do tamanho do custo de procura individual do consumidor.

A time-varying markov-switching model for economic growth

This paper investigates economic growth’s pattern of variation across and within countries using a Time-Varying Transition Matrix Markov-Switching Approach. The model developed follows the approach of Pritchett (2003) and explains the dynamics of growth based on a collection of different states, each of which has a sub-model and a growth pattern, by which countries oscillate over time. The transition matrix among the different states varies over time, depending on the conditioning variables of each country, with a linear dynamic for each state. We develop a generalization of the Diebold’s EM Algorithm and estimate an example model in a panel with a transition matrix conditioned on the quality of the institutions and the level of investment. We found three states of growth: stable growth, miraculous growth, and stagnation. The results show that the quality of the institutions is an important determinant of long-term growth, whereas the level of investment has varying roles in that it contributes positively in countries with high-quality institutions but is of little relevance in countries with medium- or poor-quality institutions.