Neogen carbonate and stable isotope record of ODP Hole 120-751A

Lower Miocene through upper Pleistocene benthic foraminifer assemblage records from Ocean Drilling Program Site 751 on the Southern Kerguelen Plateau (57°44'S, water depth 1634 m) were combined with benthic and planktonic foraminifer oxygen and carbon isotope records and high-resolution CaCO3 data from the same site. Implications for the Neogene productivity and paleoceanography of the southern Indian Ocean are discussed. We used distinctive features of the Miocene d18O and d13C curves for stratigraphic correlation. Coinciding with a lower middle Miocene hiatus from 14.2 to 13.4 Ma, there was a rapid increase in benthic d18O values by 1.2 per mil. This distinct increase occurs in middle Miocene benthic foraminifer oxygen isotope curves from all oceans. No major change, however, in benthic foraminifer faunal composition occurred in this period of growth of the Antarctic ice cap and cooling of deep ocean waters (14.9-14.2 Ma). A drastic change in benthic foraminifer faunas coincided with a hiatus from 8.4 to 5.9 Ma. Shortly after this hiatus, in the latest Miocene, the CaCO3 content of the sediments dropped from 75% to 0%. From that time ( 5.8 Ma) through the early Pliocene, Site 751 has been situated beneath a high biogenic siliceous productivity zone. Carbonate contents of upper Pliocene and Pleistocene sediments vary between 20% and 70%. The benthic foraminifer faunas in the uppermost Pliocene and lower Pleistocene reflect strong bottom current conditions, in contrast to those in the upper Pleistocene, which indicate calm sedimentation and high food supply. High d13C values of planktonic foraminifers compared with low values of benthic foraminifers suggest high primary productivity in the late Pleistocene. The changes in productivity were probably a result of latitudinal migration and meandering of the Polar Frontal Zone.

Grain-size, carbona and calcium carbonate at DSDP Leg 58 Holes

Sand-silt-clay distribution was determined on 10-cm**3 sediment samples collected at the time the cores were split and described. The sediment classification used here is that of Shepard (1954), with the sand, silt, and clay boundaries based on the Wentworth (1922) scale. Thus the sand, silt, and clay fractions are composed of particles whose diameters are 2000 to 62.5 µm, 62.5 to 3.91 µm, and less than 3.91 µm, respectively. This classification is applied without regard to sediment type and origin; therefore, the sediment names used in this table may differ from those used elsewhere in this volume; e.g., a silt composed of nannofossils may be called a nannofossil ooze in a site chapter.

(Table T1) Calcium carbonate content of sediments from ODP Leg 172 sites

Visual-domain diffuse reflectance data collected aboard the JOIDES Resolution with the Minolta spectrometer CM-2002 during Ocean Drilling Program Leg 172 have been used to estimate successfully the carbonate content of sediments. Calibration equations were developed for each site and for each lithostratigraphic unit (or subunit at Site 1063) using multiple linear regression on raw as well as pretreated reflectance spectra (i.e., first-order derivation and squaring of raw reflectance spectra) for a total of 4141 direct carbonate measurements. The root-mean-square errors of 4% to 7% are within the range of previous estimates using diffuse reflectance data and are acceptable for the general extensive range of carbonate contents (i.e., 0-70 wt%) that characterize sedimentation at Leg 172 sites.

(Appendix B) Carbonate fraction geochemistry at DSDP Hole 72-516F

This paper presents data on trace elements (Sr, Mg, Na, K, Mn, Fe, Ni, Cr) and isotopes (13C, 18O) on the carbonate fraction of bulk sediments from the Coniacian to Paleocene samples of Hole 516F. Relationships of trace elements to mineralogy and stratigraphic position are discussed at length, with special emphasis on 1) the differences between Hole 516F and other oceanic sites, and 2) the transitions observed at the Cretaceous/Tertiary boundary. Isotope data are compared to those obtained in other localities of the same age. The sections show the same major 13C variations at the Cretaceous/Tertiary boundary, indicating that this event is a planetary phenomenon.

Diagenetic development of deep-sea carbonate sediments from DSDP Holes 30-228, 30-289 and 33-316

Laboratory measurements of ultrasonic velocity (VP, VS) and attenuation (QP**-1, QS**-1) in deep-sea carbonate sequences at DSDP Sites 288, 289 and 316 in the equatorial Pacific were made in conjunction with studies of sediment density, porosity and pore geometry in order to investigate the role of diagenesis in the development of physical properties. Bulk porosity decrease appears to be related more significantly to depth of burial than to age of strata. Both depth of burial and age, however, are important factors controlling the modal pore diameter. In deep-burial diagenesis the modification of pore geometry is influenced by the presence of silica during diagenesis. In carbonate sequences at the three DSDP sites studied, shear wave attenuation anisotropy (QSHH**-1/QSHV**-1) correlates with the shear wave velocity anisotropy. Pore orientation, resulting from overburden pressure and other deep-burial diagenetic processes, is an important factor controlling the increase of VP anisotropy with age and depth of burial. On the basis of observed minor changes in anisotropy values with increasing pressure for some samples, other contributions to VP anisotropy such as grain orientation and bedding lamination cannot be ruled out.

Foraminifer, coarse fraction and carbonate characteristics of sediments from ODP Leg 198 sites on Shatsky Rise

Holes 1209A and 1211A on Southern High, Shatsky Rise contain expanded, nearly continuous records of carbonate-rich sediment deposited in deep water of the equatorial Pacific Ocean during the Paleocene and Eocene. In this study, we document intervals of carbonate dissolution in these records by examining temporal changes in four parameters: carbonate content, coarse size fraction (>38 µm), benthic foraminiferal abundance, and planktonic foraminiferal fragmentation ratio. Carbonate content is not a sensitive indicator of carbonate dissolution in the studied sections, although rare intervals of low carbonate may reflect times of relatively high dissolution. The proportion of coarse size fraction does not accurately record carbonate dissolution either because the relative abundance of nannofossils largely determines the grain-size distribution. Benthic abundance and fragmentation covary (r**2 = 0.77) and are probably the best indicators for carbonate dissolution. For both holes, records of these parameters indicate two episodes of prominent dissolution. The first of these occurs in the upper Paleocene (~59-58 Ma) and the second in the middle to upper Eocene (~45-33.7 Ma). Other intervals of enhanced carbonate dissolution are located in the upper Paleocene (~56 Ma) and in the upper lower Eocene (~51 Ma). Enhanced preservation of planktonic foraminiferal assemblages marks the start of both the Paleocene and Eocene epochs.

Authigenic carbonate of ODP SIte 104-643

Different generations of complex authigenic carbonates formed in siliceous muds (lithologic Unit IV) and hemipelagic clays (lithologic Unit V) of ODP Site 643, Leg 104 Norwegian Sea. The dominant phase in Unit IV is an early diagenetic Mn, Fe-calcite with a strong negative d13C ( -14 to -16 per mil) signature, and slightly negative d180 values. The strong negative d13C results from extensive incorporation of 12C-enriched CO2 derived from bacterial degradation of marine organic matter into early Mn, Fe - calcite cements. Concomitant framboidal pyrite precipitation and abundant SEM microtextures showing excellent preservation of delicate structures of fragile diatom valves by outpourings with early Mn-calcites strongly support their shallow burial formation before the onset of compaction. Later generations of authigenic mineralizations in lithologic Unit IV include minor amounts of a second generation of calcite with platy crystals, possibly precipitated along with opal-A dissolution, and finally opal-CT crystallization in deeper seated environments overgrowing earlier precipitates with films and lepispheres. The last mineralization is collophane (fluor apatite) forming amorphous aggregates and tiny hexagonal crystals. Authigenic mineral assemblages in lithologic Unit V consist of rhodochrosites, transitional rhodochrosite/manganosiderites, and apatite. A negative d13C ( -7.1 to -15.6 per mil) and a fluctuating d18O signal indicates that the micritic to sparitic rhodochrosites, transitional rhodochrosites/manganosiderites were formed at various burial depths. CO2 resulted from organic matter degradation in the lowermost sulfate reduction zone and from biogenic methane generation in the lowermost sediments, resulting in variable and negative d13C signals. The change in carbonate mineralogy reflects major compositional differences compared to sediments in Unit IV. Most prominent is an increase in altered ash as a primary sediment component and a sudden decrease of siliceous microfossils. Upward diffusion of cations, lowered salinities in pore waters, and elevated temperatures provide diagenetic environments favoring increased remobilization processes.

Chemical and isotope composition of carbonate nodules and host bottom sediments from Core DM9-666, Gulf of California

Results of mineralogical and isotopic analyzes of sulfur and carbon in carbonate nodules and host bottom sediments and results of 14C measurement in carbonate nodules are reported. It is proved that the carbonate nodules formed 11-22 thousand years ago in anaerobic diagenesis of bottom sediments rich in organic matter. Isotopic light metabolic carbon dioxide was a source of carbonate for nodules. It formed during microbial degradation of organic matter of bottom sediments.

Calcium carbonate and organic carbon at DSDP Leg 62 Holes

Percent CaCO3 was determined in selected samples aboard the ship by the carbonate-bomb technique (Müller and Gastner, 1971). Results of these analyses are listed in Table 1 and plotted in Figures 1, 3, 4, and 5 as plus signs (+). Samples collected specifically for analyses of CaCO3 and organic carbon were analyzed at three shore-based laboratories. Concentrations of total carbon, organic carbon, and CaCO3 were determined in some samples at the DSDP sediment laboratory, using a Leco carbon analyzer, by personnel of the U.S. Geological Survey, under the supervision of T. L. Valuer. Most of these samples were collected from lithologic units containing relatively high concentrations of organic carbon. Sample procedures are outlined in Boyce and Bode (1972). Precision and accuracy are both ±0.3% absolute for total carbon, ±0.06% absolute for organic carbon, and ±3% absolute for CaCO3.

Sediment texture, carbonate content, and carbonate mineralogy of ODP Holes 182-1130A and 182-1132B

At Sites 1130 and 1132 of Ocean Drilling Program Leg 182 in the Great Australian Bight, we recovered an expanded Pleistocene section dominated by packstone and wackestone, deposited at unusually high rates of >20 cm/k.y. Shipboard observations detected an intermittent meter-scale alternation of light gray intervals with olive-gray intervals. Meter-scale samples were collected from the upper 250 m at both sites and decimeter-scale samples from four selected 2.5- to 4.0-m intervals in order to determine the texture and composition of sediments deposited along the upper slope throughout the Quaternary. Detailed textural and compositional data are presented from a total of 540 samples collected from both sites. Results indicate a general coarsening upward at both sites, with an accompanying upcore increase in high-Mg calcite (HMC) and aragonite and a decrease in low-Mg calcite (LMC). Samples collected at decimeter-scale intervals substantiate that the alternating light gray and olive-gray units detected on board ship are lithologically distinct. Light gray units consist of an LMC-rich silt, whereas olive-gray units consist of an aragonite and HMC-rich sand and silt. Sediment sources as well as timing and controls of this cyclic depositional pattern will be the subject of further investigations.