Vertical structure and horizontal gradients of aerosol extinction coefficients over coastal India inferred from airborne lidar measurements during the Integrated Campaign for Aerosol, Gases and Radiation Budget (ICARB) field campaign

Quantitative estimates of the vertical structure and the spatial gradients of aerosol extinction coefficients have been made from airborne lidar measurements across the coastline into offshore oceanic regions along the east and west coasts of India. The vertical structure revealed the presence of strong, elevated aerosol layers in the altitude region of similar to 2-4 km, well above the atmospheric boundary layer (ABL). Horizontal gradients also showed a vertical structure, being sharp with the e(-1) scaling distance (D-0H) as small as similar to 150 km in the well-mixed regions mostly under the influence of local source effects. Above the ABL, where local effects are subdued, the gradients were much shallower (similar to 600-800 km); nevertheless, they were steep compared to the value of similar to 1500-2500 km reported for columnar AOD during winter. The gradients of these elevated layers were steeper over the east coast of India than over the west coast. Near-simultaneous radio sonde (Vaisala, Inc., Finland) ascents made over the northern Bay of Bengal showed the presence of convectively unstable regions, first from surface to similar to 750-1000 m and the other extending from 1750 to 3000 m separated by a stable region in between. These can act as a conduit for the advection of aerosols and favor the transport of continental aerosols in the higher levels (> 2 km) into the oceans without entering the marine boundary layer below. Large spatial gradient in aerosol optical and hence radiative impacts between the coastal landmass and the adjacent oceans within a short distance of < 300 km (even at an altitude of 3 km) during summer and the premonsoon is of significance to the regional climate.

Axially homogeneous, zero mean flow buoyancy-driven turbulence in a vertical pipe

We report an experimental study of a new type of turbulent flow that is driven purely by buoyancy. The flow is due to an unstable density difference, created using brine and water, across the ends of a long (length/diameter = 9) vertical pipe. The Schmidt number Sc is 670, and the Rayleigh number (Ra) based on the density gradient and diameter is about 10(8). Under these conditions the convection is turbulent, and the time-averaged velocity at any point is `zero'. The Reynolds number based on the Taylor microscale, Re-lambda, is about 65. The pipe is long enough for there to be an axially homogeneous region, with a linear density gradient, about 6-7 diameters long in the midlength of the pipe. In the absence of a mean flow and, therefore, mean shear, turbulence is sustained just by buoyancy. The flow can be thus considered to be an axially homogeneous turbulent natural convection driven by a constant (unstable) density gradient. We characterize the flow using flow visualization and particle image velocimetry (PIV). Measurements show that the mean velocities and the Reynolds shear stresses are zero across the cross-section; the root mean squared (r.m.s.) of the vertical velocity is larger than those of the lateral velocities (by about one and half times at the pipe axis). We identify some features of the turbulent flow using velocity correlation maps and the probability density functions of velocities and velocity differences. The flow away from the wall, affected mainly by buoyancy, consists of vertically moving fluid masses continually colliding and interacting, while the flow near the wall appears similar to that in wall-bound shear-free turbulence. The turbulence is anisotropic, with the anisotropy increasing to large values as the wall is approached. A mixing length model with the diameter of the pipe as the length scale predicts well the scalings for velocity fluctuations and the flux. This model implies that the Nusselt number would scale as (RaSc1/2)-Sc-1/2, and the Reynolds number would scale as (RaSc-1/2)-Sc-1/2. The velocity and the flux measurements appear to be consistent with the Ra-1/2 scaling, although it must be pointed out that the Rayleigh number range was less than 10. The Schmidt number was not varied to check the Sc scaling. The fluxes and the Reynolds numbers obtained in the present configuration are Much higher compared to what would be obtained in Rayleigh-Benard (R-B) convection for similar density differences.

Examining novice education: What can we learn from a compulsory program delivered to both mature-age and young pre-learner licence drivers?

This paper reports results from a qualitative evaluation of a compulsory pre-Learner driver education program within the Australian Capital Territory(ACT), Australia. Two methods were used to obtain feedback from those involved in the delivery of the program as well as those who participated in programs. The first, semi-structured interviews, was undertaken with class room teachers who run the program in their schools, group facilitators running the program with more mature-age students at private facilities (n = 15 in total), and former participants in both school-based and private-based versions of the program (n = 19). The second method used an on-line survey for students (n = 79). Results from both methods were consistent with each other, indicating that strengths of the program were perceived as being its interactive components and the high level of engagement of the target audience. There was strong support from young and mature-age students for the program to remain compulsory. However, consistent with other findings on novice driver education, mature-age participants identified that the program was less relevant to them. It may be that to have greater relevance to mature-age learners, content could address and challenge perceptions about behaviours other than intentional high-risk behaviours (e.g. low level speeding, fatigue) as well as encourage planning/strategies to avoid them. While a longer term, outcome focussed, evaluation of the pre-learner education program is needed, this study suggests that the program is well received by pre-licence drivers and that teachers and facilitators perceive it as both effective and beneficial.

Pre-operative nutritional support in children with end-stage liver disease accepted for liver transplantation: An approach to management

Pre-operative nutritional support was studied in 28 children with end-stage liver disease awaiting orthotopic liver transplantation. Nasogastric supplemental administration of a standard semi-elemental enteral nutritional formula was compared with a similar formula enriched with branched chain amino acids, and with a group receiving oral nutrition only. The duration of treatment in all groups was similar (mean 90 days). Energy intakes in the supplemented groups were 120-150% of recommended daily intakes (RDI), whereas ad libitum intakes in the oral group ranged 58-100% RDI. A significant improvement in mean Z-score for body weight (denoting catch-up) was noted only in those children who received nasogastric supplements enriched with branched-chain amino acids. The standard enterally-fed group maintained their body weight and Z-scores did not change significantly. In contrast, body weight Z-scores in those fed orally declined significantly. Nutritional supportive therapy of malnourished children with end-stage liver disease can minimize or improve nutritional status in children awaiting liver transplantation. The use of nutritional formulae rich in branche-chain amino acids may have nutritional advantages in children with chronic liver disease which require further study and evaluation.

Natural convection from a vertical cone in a porous medium due to the combined effects of heat and mass diffusion with non-uniform wall temperature/concentration or heat/mass flux and suction/injection

An analysis has been carried out to study the non-Darcy natural convention flow of Newtonian fluids on a vertical cone embedded in a saturated porous medium with power-law variation of the wall temperature/concentration or heat/mass flux and suction/injection with the streamwise distance x. Both non-similar and self-similar solutions have been obtained. The effects of non-Darcy parameter, ratio of the buoyancy forces due to mass and heat diffusion, variation of wall temperature/concentration or heat/mass flux and suction/injection on the Nusselt and Sherwood numbers have been studied.

How to develop an online community for pre-service and early career teachers

This paper contributes a number of design principles for developing large-scale online communities of pre-service and early career teachers (PS&ECTs). It presents the paradigms of connected learning, networked learning and communities of practice and contrasts them. It describes the potential for online communities to meet the needs of PS&ECTs and it identifies gaps that exist within certain types of existing online communities that currently support PS&ECTs. The paper proposes design principles for a new type of online community for PS&ECTs. These principles are drawn from the literature and from the preliminary outcomes of a pilot study.

Alfven surface waves along cylindrical plasma columns

The properties of Alfven surface waves along a cylindrical plasma column surrounded by vacuum or by another plasma medium are discussed. Both symmetric (m=0) and asymmetric (m=+or-1) modes are found to be dispersive in nature. The interfacial symmetric modes propagate in a certain frequency window ( omega A1, omega As), where omega As is the Alfven surface wave frequency along the interface of two semi-infinite media; when nu A1> nu A2 these modes propagate as backward waves and when nu A1< nu A2 as forward waves. The asymmetric modes change from backward to forward waves at a critical wave number kTr approximately=1.59/a when nu A1< nu A2 or vice versa when nu A1> nu A2.

Nonlinear analysis for the pre- and post-yield behaviour of a composite structure with the refined plastic hinge approach

The computational technique of the full ranges of the second-order inelastic behaviour evaluation of steel-concrete composite structure is not always sought forgivingly, and therefore it hinders the development and application of the performance-based design approach for the composite structure. To this end, this paper addresses of the advanced computational technique of the higher-order element with the refined plastic hinges to capture the all-ranges behaviour of an entire steel-concrete composite structure. Moreover, this paper presents the efficient and economical cross-section analysis to evaluate the element section capacity of the non-uniform and arbitrary composite section subjected to the axial and bending interaction. Based on the same single algorithm, it can accurately and effectively evaluate nearly continuous interaction capacity curve from decompression to pure bending technically, which is the important capacity range but highly nonlinear. Hence, this cross-section analysis provides the simple but unique algorithm for the design approach. In summary, the present nonlinear computational technique can simulate both material and geometric nonlinearities of the composite structure in the accurate, efficient and reliable fashion, including partial shear connection and gradual yielding at pre-yield stage, plasticity and strain-hardening effect due to axial and bending interaction at post-yield stage, loading redistribution, second-order P-δ and P-Δ effect, and also the stiffness and strength deterioration. And because of its reliable and accurate behavioural evaluation, the present technique can be extended for the design of the high-strength composite structure and potentially for the fibre-reinforced concrete structure.

Characteristics of Alfven surface waves along moving cylindrical plasma columns

The dispersive and stability characteristics of Alfven surface waves (ASW) along the boundary of the moving cylindrical plasma column, surrounded by a stationary medium embedded in a parallel magnetic field is studied. The nature of the symmetric and asymmetric modes on the interface parameters is also discussed.

Work Stress and Early Atherosclerosis: Do Genetic Background and Pre-Employment Risk Factors Explain Conflicting Findings?

According to the models conceptualizing work stress, increased risk of health problems arise when high job demands co-occur with low job control (the demand-control model) or the efforts invested by the employee are disproportionately high compared to the rewards received (effort-reward imbalance model). This study examined the association between work stress and early atherosclerosis with particular attention to the role of pre-employment risk factors and genetic background in this association. The subjects were young healthy adults aged 24-39 who were participating in the 21-year follow-up of the ongoing prospective "Cardiovascular Risk in Young Finns" study in 2001-2002. Work stress was evaluated with questionnaires on demand-control model and on effort-reward model. Atherosclerosis was assessed with ultrasound of carotid artery intima-media thickness (IMT). In addition, risk for enhanced atherosclerotic process was assessed by measuring with heart rate variability and heart rate. Pre-employment risk factors, measured at age 12 to 18, included such as body mass index, blood lipids, family history of coronary heart disease, and parental socioeconomic position. Variants of the neuregulin-1 were determined using genomic DNA. The results showed that higher work stress was associated with higher IMT in men. This association was not attenuated by traditional risk factors of atherosclerosis and coronary heart disease or by pre-employment risk factors measured in adolescence. Neuregulin-1 gene moderated the association between work stress and IMT in men. A significant association between work stress and IMT was found only for the T/T genotype of the neuregulin-1 gene but not for other genotypes. Among women an association was found between higher work stress and lower heart rate variability, suggesting higher risk for developing atherosclerosis. These associations could not be explained by demographic characteristics or coronary risk factors. The present findings provide evidence for an association between work stress and atherosclerosis in relatively young population. This association seems to be modified by genetic influences but it does not appear to be confounded by pre-employment adolescent risk factors.

Mechanical performances of track-shaped rebar stiffened concrete-filled steel tubular (SCFRT) stub columns under axial compression

This paper presents a combined experimental, numerical, and theoretical study on the mechanical behaviors of track-shaped concrete-filled steel tubular (SCFRT) stub columns stiffened by rebars under compressive load. A total of 18 track-shaped concrete-filled steel tubular specimens including 12 specimens stiffened by rebars and 6 non-stiffened counterparts are tested, with consideration of parameters including flakiness ratio, concrete strength, and stiffeners. Failure pattern, bearing capacity, and ductility are all analyzed and discussed based on the experimental results. The numerical simulation by finite element (FE) software ABAQUS is also conducted. Based on both experimental and numerical results, theoretical formula to predict the load-bearing capacity of SCFRT stub columns subjected to axial compression loading is established according to the superposition principle of ultimate load-bearing capacity with rational simplification. The proposed theoretical method provides accurate predictions on the load bearing capacity by comparing with experimental results from 18 groups of specimens.

CFD Analysis of conjugate natural convection in a vertical annulus

Conjugate natural convection in a vertical annulus with a centrally located vertical heat generating rod is studied numerically. The governing equations are discretized on a staggered mesh and are solved using a pressure-correction algorithm. A parametric study is performed by varying the Grashof number, aspect ratio, and the solid-to-fluid thermal conductivity ratio over wide ranges with the Prandtl number fixed at 0.7. Results are presented for the variation of several quantities of interest such as the local Nusselt numbers on the inner and outer boundaries, the axial variation of the centerline and interface temperatures, maximum solid, average solid and average interface temperature variations with Grashof number, and the average Nusselt number variation for the inner and outer boundaries with Grashof number. The average Nusselt number from the conjugate analysis is found to be between the Nusselt numbers of the isothermal and the isoflux cases. The average Nusselt numbers on the inner and outer boundaries show an increasing trend with the Grashof number. Correlations are presented for the Nusselt number and the dimensionless temperatures of interest in terms of the parameters of the problem.