Mud, algae or seagrass: An assessment of remote sensing techniques for mapping inter-tidal seagrass cover and composition in turbid tropical environments

Large areas of tropical sub- and inter-tidal seagrass beds occur in highly turbid environments and cannot be mapped through the water column. The purpose of this project was to determine if and how airborne and satellite imaging systems could be used to map inter-tidal seagrass properties along the wet-tropics coast in north Queensland, Australia. The work aimed to: (1) identify the minimum level of seagrass foliage cover that could be detected from airborne and satellite imagery; and (2) define the minimum detectable differences in seagrass foliage cover in exposed intertidal seagrass beds. High resolution spectral-reflectance data (2040 bands, 350 – 2500nm) were collected over 40cm diameter plots from 240 sites on Magnetic Island, Pallarenda Beach and Green Island in North Queensland at spring low tides in April 2006. The seagrass species sampled were: Thalassia hemprechii, Halophila ovalis, Halodule uninerivs; Syringodium isoetifolium, Cymodocea serrulata, and Cymodoea rotundata. Digital photos were captured for each plot and used to derive estimates of seagrass species cover, epiphytic growth, micro- and macro-algal cover, and substrate colour. Sediment samples were also collected and analysed to measure the concentration of Chlorophyll-a associated with benthic micro-algae. The field reflectance spectra were analysed in combination with their corresponding seagrass species foliage cover levels to establish the minimum foliage projective cover required for each seagrass to be significantly different from bare substrate and substrate with algal cover. This analysis was repeated with reflectance spectra resampled to the bandpass functions of Quickbird, Ikonos, SPOT 5 and Landsat 7 ETM. Preliminary results indicate that conservative minimum detectable seagrass cover levels across most the species sampled were between 30%- 35% on dark substrates. Further analysis of these results will be conducted to determine their separability and satellite images and to assess the effects epiphytes and algal cover.

Counting Koalas from space: Integrating remote sensing, GIS and traditional ecological survey techniques

Proceedings of the 11th Australasian Remote Sensing and Photogrammetry Conference

Evaluation of remote sensing for the detection of landfill gas and leachate in an urban environment

The technique of remote sensing provides a unique view of the earth's surface and considerable areas can be surveyed in a short amount of time. The aim of this project was to evaluate whether remote sensing, particularly using the Airborne Thematic Mapper (ATM) with its wide spectral range, was capable of monitoring landfill sites within an urban environment with the aid of image processing and Geographical Information Systems (GIS) methods. The regions under study were in the West Midlands conurbation and consisted of a large area in what is locally known as the Black Country containing heavy industry intermingled with residential areas, and a large single active landfill in north Birmingham. When waste is collected in large volumes it decays and gives off pollutants. These pollutants, landfill gas and leachate (a liquid effluent), are known to be injurious to vegetation and can cause stress and death. Vegetation under stress can exhibit a physiological change, detectable by the remote sensing systems used. The chemical and biological reactions that create the pollutants are exothermic and the gas and leachate, if they leave the waste, can be warmer than their surroundings. Thermal imagery from the ATM (daylight and dawn) and thermal video were obtained and used to find thermal anomalies on the area under study. The results showed that vegetation stress is not a reliable indicator of landfill gas migration, as sites within an urban environment have a cover too complex for the effects to be identified. Gas emissions from two sites were successfully detected by all the thermal imagery with the thermal ATM being the best. Although the results were somewhat disappointing, recent technical advancements in the remote sensing systems used in this project would allow geo-registration of ATM imagery taken on different occasions and the elimination of the effects of solar insolation.

Remote sensing applied to land use and erosion hazard studies in Jamaica

The northern half of the parish of St. Catherine in Jamaica was selected as a test area to study, by means of remote sensing, the problems of soil erosion in a tropical environment. An initial study was carried out to determine whether eroded land within this environment could be successfully interpreted and mapped from the available 1: 25,000 scale aerial photographs. When satisfied that a sufficiently high percentage of the eroded land could be interpreted on the aerial photographs the main study was initiated. This involved interpreting the air photo cover of the study area for identifying and classifying land use and eroded land, and plotting the results on overlays on topographic base maps. These overlays were then composited with data on the soils and slopes of the study area. The areas of different soil type/slope/land use combinations were then measured, as was the area of eroded land for each of these combinations. This data was then analysed in two ways. The first way involved determining which of the combinations of soil type, slope and land use were most and least eroded and, on the basis of this, to draw up recommendations concerning future land use. The second analysis was aimed at determining which of the three factors, soil type, slope and land use, was most responsible for determining the rate of erosion. Although it was possible to show that slope was not very significant in determining the rate of erosion, it was much more difficult to separate the effects of land use and soil type. The results do, however, suggest that land use is more significant than soil type in determining the rate of erosion within the study area.

Remote sensing applied to slope stability in mountainous roads in Iran

The Alborz Mountain range separates the northern part of Iran from the southern part. It also isolates a narrow coastal strip to the south of the Caspian Sea from the Central Iran plateau. Communication between the south and north until the 1950's was via two roads and one rail link. In 1963 work was completed on a major access road via the Haraz Valley (the most physically hostile area in the region). From the beginning the road was plagued by accidents resulting from unstable slopes on either side of the valley. Heavy casualties persuaded the government to undertake major engineering works to eliminate ''black spots" and make the road safe. However, despite substantial and prolonged expenditure the problems were not solved and casualties increased steadily due to the increase in traffic using the road. Another road was built to bypass the Haraz road and opened to traffic in 1983. But closure of the Haraz road was still impossible because of the growth of settlements along the route and the need for access to other installations such as the Lar Dam. The aim of this research was to explore the possibility of applying Landsat MSS imagery to locating black spots along the road and the instability problems. Landsat data had not previously been applied to highway engineering problems in the study area. Aerial photographs are better in general than satellite images for detailed mapping, but Landsat images are superior for reconnaissance and adequate for mapping at the 1 :250,000 scale. The broad overview and lack of distortion in the Landsat imagery make the images ideal for structural interpretation. The results of Landsat digital image analysis showed that certain rock types and structural features can be delineated and mapped. The most unstable areas comprising steep slopes, free of vegetation cover can be identified using image processing techniques. Structural lineaments revealed from the image analysis led to improved results (delineation of unstable features). Damavand Quaternary volcanics were found to be the dominant rock type along a 40 km stretch of the road. These rock types are inherently unstable and partly responsible for the difficulties along the road. For more detailed geological and morphological interpretation a sample of small subscenes was selected and analysed. A special developed image analysis package was designed at Aston for use on a non specialized computing system. Using this package a new and unique method for image classification was developed, allowing accurate delineation of the critical features of the study area.

Remote sensing applications to flood hydrology in Belize

The research compares the usefullness of four remote sensing information sources, these being LANDSAT photographic prints, LANDSAT computer compatible tapes, Metric Camera and SIR-A photographic prints. These sources provide evaluations of the catchment characteristics of the Belize and Sibun river basins in Central America. Map evaluations at 1:250,000 scale are compared to the results of the same scale, remotely sensed information sources. The values of catchment characteristics for both maps and LANDSAT prints are used in multiple regression analysis, providing flood flow formulae, after investigations to provide a suitable dependent variable discharge series are made for short term records. The use of all remotely sensed information sources in providing evaluations of catchment characteristics is discussed. LANDSAT prints and computer compatible tapes of a post flood scene are used to estimate flood distributions and volumes. These are compared to values obtained from unit hydrograph analysis, using the dependent discharge series and evaluate the probable losses from the Belize river to the floodplain, thereby assessing the accuracy of LANDSAT estimates. Information relating to flood behaviour is discussed in terms of basic image presentation as well as image processing. A cost analysis of the purchase and use of all materials is provided. Conclusions of the research indicate that LANDSAT print material may provide information suitable for regression analysis at levels of accuracy as great as those of topographic maps, that the differing information sources are uniquely applicable and that accurate estimates of flood volumes may be determined even by post flood imagery.

The application of remote sensing to water resources

Techniques are developed for the visual interpretation of drainage features from satellite imagery. The process of interpretation is formalised by the introduction of objective criteria. Problems of assessing the accuracy of maps are recognized, and a method is developed for quantifying the correctness of an interpretation, in which the more important features are given an appropriate weight. A study was made of imagery from a variety of landscapes in Britain and overseas, from which maps of drainage networks were drawn. The accuracy of the mapping was assessed in absolute terms, and also in relation to the geomorphic parameters used in hydrologic models. Results are presented relating the accuracy of interpretation to image quality, subjectivity and the effects of topography. It is concluded that the visual interpretation of satellite imagery gives maps of sufficient accuracy for the preliminary assessment of water resources, and for the estimation of geomorphic parameters. An examination is made of the use of remotely sensed data in hydrologic models. It is proposed that the spectral properties of a scene are holistic, and are therefore more efficient than conventional catchment characteristics. Key hydrologic parameters were identified, and were estimated from streamflow records. The correlation between hydrologic variables and spectral characteristics was examined, and regression models for streamflow were developed, based solely on spectral data. Regression models were also developed using conventional catchment characteristics, whose values were estimated using satellite imagery. It was concluded that models based primarily on variables derived from remotely sensed data give results which are as good as, or better than, models using conventional map data. The holistic properties of remotely sensed data are realised only in undeveloped areas. In developed areas an assessment of current land-use is a more useful indication of hydrologic response.