Syntheses of biphenyl polyimides via nickel-catalyzed coupling polymerization of bis(chlorophthalimide)s

A facile method for the synthesis of biphenyl polyimides, which involves the nickel-catalyzed coupling of aromatic dichlorides containing imide structure in the presence of zinc and triphenylphosphine, has been developed. The polymerizations proceeded smoothly under mild conditions and produced biphenyl polyimides with inherent viscosities of 0.13-0.98 dL/g. The polymerizations of bis(4-chlorophthalimide)s with bulky side substituents gave high molecular weight polymers. Low molecular weight polymers from bis(4-chlorophthalimide)s containing rigid diamine moieties and bis(3-chlorophthalimide)s were obtained because of the formations of polymer precipitate and cyclic oligoimides, respectively. The effects of various factors, such as amount of catalyst, solvent volume, ligand, reaction temperature, and time, on the polymerization were studied. The random copolymerization of two bis(chlorophthalimide)s in varying proportions produced medium molecular weight material. The TgS of prepared polyimides were observed at 245-311 degreesC, and the thermogravimetry of polymers showed 10% weight loss in nitrogen at 470-530 degreesC.

Using triazine as coupling unit for intramolecular ferromagnetic coupling of multiradicals

Novel high spin tri-, tetra-, pentaradicals, composed of triazine coupling units and cationic amino radical spin centers (+ . NH) under various configurations and linkages, are predicted from AM1-CI calculations. It is found that for charged planar multiradicals the stability of high spin ground states depends on both the molecular configuration and the number of end groups. Generally, cyclic 1,3-bridged charged multiradicals (S less than or equal to 5/2) possess more stable high spin ground states than their isomers under the branched 1,3,5,-bridged configuration. Therefore, it is suggested that in the design of planar high spin molecules with stable high spin ground states, less end groups and all the supposed spin centers and/or the coupling units should be under the same structural situation. (C) 1999 Elsevier Science B.V. All rights reserved.

The intermolecular coupling through space for stacked high spin molecules

Intermolecular ferromagnetic interactions in two stacking models for the dimer of high spin molecules are investigated by means of AM1-CI approach. It is shown that the stability of high spin ground state versus low spin state can be simply traced back to the number and the extent of atoms with reversed signs of pi-spin density in neighboring molecules coupled to each other in shortest distance.

Application of coupling model for stress relaxation of phenolphthalein polyether ketone

According to stress relaxation curves of phenolphthalein polyether ketone (PEK-C) at different temperatures and the principle of the time-temperature equivalence, the master curve of PEK-C at arbitrary reference temperature is obtained. A coupling model is applied to explain quantitatively stress relaxation behaviour of PEK-C at different temperatures. The parameters obtained from the coupling model have important physical meaning. Copyright (C) 1996 Elsevier Science Ltd.

STUDIES ON THE PEROVSKITE-TYPE MIXED CATALYSTS OF TITANIUM SYSTEM FOR OXIDATIVE COUPLING OF METHANE - THE INFLUENCE OF CALCINATION TEMPERATURE

The correlations of the calcination temperature, structure and catalytic activity for the oxidative coupling of methane on the LiLa0.5Ti0.5O2+lambda catalysts whose main phase and major active phase is Perovskite-type ternary complex oxide LaTi1-yLiyO3-lambda have been studied. The surface and bulk structures of the catalysts were characterized by means of XRD, XPS, IR, BET and so on, The results cleary indicated that the effect of calcination temperature on the activity for the oxidative coupling of methane is twofold. On one hand, it is favorable for Li+ substitution for Ti3+ to enter into the lattice of LaTiO3 and produce more oxygen vacancies in which active oxygens are formed; however, excessively high calcination temperature make the amount of Li+ substitution for Ti3+ lower, due to a little change of structure or phases for the catalyst. On the other hand, the conversion of CH4 drops because of the decrease of surface area, when the calcination temperature is raised.

A STUDY OF SURFACE OXYGEN SPECIES FROM LA-ME-O (ME=MG, CA, SR, BA) CATALYSTS FOR METHANE OXIDATIVE COUPLING

CO2-TPD was used to study the surface basicity of La-Me-O mixed oxides and O-2-TPD, CH4-TPD were employed to study the surface active oxygen species. Comparing the CO2-TPD with O-2-TPD, we can see that the basicity of catalyst is in parallel with the catalystic activity. The stronger basicity is more profitable for the catalyst to adsorb oxygen to form active oxygen species and to activate CH4 by breaking a C-H bond, By comparing the catalytic activity, the results showed that La-Ba-O(La/Ba=7/3) catalyst had the strongest basicity, and it gave the highest CH4 conversion and C-2 selectivity, The results from the pulse reaction showed that the lattice oxygen participated in the OCM reaction without gas oxygen, and it was the selective oxygen species.

Study of Methane Oxidative Coupling over Ti-La-Li Mixed Oxides

The composition and structures of Li-Ti-La mixed oxides as well as their catalytic activity for methane oxidative coupling have been studied by means of XRD XPS, IR, SEM and so on. The results indicate that by changing x value in Li-La1-xTixO2 oxides phas

Role of Lithium in Multicomponent Oxide Catalysts for Oxidative Coupling of Methane

The effect of Li content in a series of multicomponent oxides LixLa0.5Ti0.5 For methane oxidative coupling has been studied. The catalytic activities of LiLa0.5Ti0.5 catalyst before and after washing with boiling water have been compared. The surface and

STUDY ON THE ACTIVE-CENTERS OF METHANE COUPLING CATALYSTS BY MEANS OF FLUORESCENCE EMISSION OF EU3+

Eu3+ ion was adopted as a probe to detect the probability of entrance of alkali elements into the crystal lattice of MgO, CaO and La2O3 by means of its characteristic emission. Based on the experimental data it is concluded that Li+ and Na+ ions can substitute Mg2+ and Ca2+ ions and only a small amount of K+ ion can enter into the lattice of CaO. Whilst Li+ ion can not enter into the lattice of lanthana. The conclusion of this investigation is in good agreement with that obtained by Lunsford by ESR studies.

THE ACTIVE OXYGEN ON THE LI/LA2O3 CATALYST SURFACE AND ITS CATALYTIC BEHAVIOR IN THE OXIDATIVE COUPLING OF METHANE

The coupling selectivity was greatly enhanced by adding Li to La2O3, compared with the single La2O3. The O2- species was found on the Li/La2O3 but not on the single La2O3. In low-temperature desorption, ethane desorbed from the Li/La2O3 but was not detected with the single La2O3. It is considered that the addition of Li gave rise to some basic sites which are favorable for the coupling reaction.

Close coupling between phytoplankton growth and microzooplankton grazing in the western South China Sea

We conducted 28 dilution experiments during August-September 2007 to investigate the coupling of growth and microzooplankton grazing rates among ultraphytoplankton populations and the phytoplankton community and their responses to habitat variability (open-ocean oligotrophy, eddy-induced upwelling, and the Mekong River plume) in the western South China Sea. At the community level, standing stocks, growth, and grazing rates were strongly and positively correlated, and were related to the higher abundance of larger phytoplankton cells (diatoms) at stations with elevated chlorophyll concentration. Phytoplankton growth rates were highest (> 2 d(-1)) within an eastward offshore jet at 13 degrees N and at a station influenced by the river plume. Among ultraphytoplankton populations, Prochlorococcus dominated the more oceanic and oligotrophic stations characterized by generally lower biomass and phytoplankton community growth, whereas Synechococcus became more important in mesotrophic areas (eddies, offshore jet, and river plume). The shift to Synechococcus dominance reflected, in part, its higher growth rates (0.87 +/- 0.45 d(-1)) compared to Prochlorococcus (0.65 +/- 0.29 d(-1)) or picophytoeukaryotes (0.54 +/- 0.50 d(-1)). However, close coupling of microbial mortality rates via common predators is seen to play a major role in driving the dominance transition as a replacement of Prochlorococcus, rather than an overprinting of its steady-state standing stock.

PCBs and its coupling with eco-environments in Southern Yellow Sea surface sediments

In this paper, the spatial distribution and source of the PCBs in surface sediments of the Southern Yellow Sea (SYS) and influencing factors, such as the sediment characteristics (components, relative proportions and total organic carbon contents), and hydrodynamic conditions were analyzed. PCB concentrations in the surface sediments ranged from 518-5848 pg/g, with average values of 1715 pg/g decreasing sharply compared to last year. In the study area, the PCB pollution level in the middle area was the highest, followed by that of the east coast and the west coast, respectively. Although the PCB level in the coastal areas was lower than that in the middle areas, it was proven in our study that the Yellow Sea obtained PCBs by virtue of river inputs. There was a positive and pertinent correlation between the clay proportion and PCB concentrations, and the increase of the PCB concentrations was directly proportional to the increase of TOC contents, with r = 0.61, but it was contrary to the sediment grain size. Consequently, the factors controlling PCB distribution had direct or indirect relationships with sediment grain size; moreover, the hydrodynamic conditions determined the sediment components and grain size. In conclusion, hydrodynamic conditions of the Yellow Sea were the most important influencing factors effecting the distribution of PCBs in the surface sediments of the SYS. (C) 2007 Elsevier Ltd. All rights reserved.

Influence of filtering and biodeposition by the cultured scallop Chlamys farreri on benthic-pelagic coupling in a eutrophic bay in China

In coastal ecosystems, suspension-cultured bivalve filter feeders may exert a strong impact on phytoplankton and other suspended particulate matter and induce strong pelagic-benthic coupling via intense filtering and biodeposition. We designed an in situ method to determine spatial variations in the filtering-biodeposition process by intensively suspension-cultured scallops Chlamys farreri in summer in a eutrophic bay (Sishili Bay, China), using cylindrical biodeposition traps directly suspended from longlines under ambient environmental conditions. Results showed that bivalve filtering-biodeposition could substantially enhance the deposition of total suspended material and the flux of C, N and P to the benthos, indicating that the suspended filter feeders could strongly enhance pelagic-benthic coupling and exert basin-scale impacts in the Sishili Bay ecosystem. The biodeposition rates of 1-yr-old scallops varied markedly among culture sites (33.8 to 133.0 mg dry material ind.(-1) d(-1)), and were positively correlated with seston concentrations. Mean C, N and P biodeposition rates were 4.00, 0.51, 0.11 mg ind.-1 d-1, respectively. The biodeposition rates of 2-yr-old scallops were almost double these values. Sedimentation rates at scallop culture sites averaged 2.46 times that at the reference site. Theoretically, the total water column of the bay could be filtered by the cultured scallops in 12 d, with daily seston removal amounting to 64%. This study indicated that filtering-biodeposition by suspension-cultured scallops could exert long-lasting top-down control on phytoplankton biomass and other suspended material in the Sishili Bay ecosystem. In coastal waters subject to anthropogenic N and P inputs, suspended bivalve aquaculture could be advantageous, not only economically, but also ecologically, by functioning as a biofilter and potentially mitigating eutrophication pressures. Compared with distribution-restricted wild bivalves, suspension-cultured bivalves in deeper coastal bays may be more efficient in processing seston on a basin scale.