Seeing a hard country : Lawrence’s Australian landscape

In 1944 Australian author Eleanor Dark wrote that Australia is a hard country for an outsider to see, citing, in evidence, the writing of the “strange, foreign-looking little man with the beard” -- the self-described by D. H. Lawrence. According to Dark, Lawrence was bewildered by Australia because what his eyes saw was not what they were accustomed to seeing. Kangaroo, she wrote, suggests one long, tormented effort to see. Lawrence appears, for Dark, to be half-blind, struggling, and irritated almost beyond belief with his visit to New South Wales. Eleanor Dark wrote this critique in 1944, long after Lawrence’s 1922 visit, but for her, as for other Australian writers, Kangaroo continued to register as an important book, even if the content rankled. Katharine Susannah Prichard and Christina Stead, both advocates in general of Lawrence, likewise rejected the tenor of Kangaroo, although Lawrence would not have been worried about the response. In 1929 he referred to his irritation with Australia in letters to P.R. “Inky” Stephensen, the Australian nationalist and publisher, and he does not seem to have changed his opinions since writing Kangaroo. Yet the novel continued to be significant for Australian writers, even if as a provocation. My discussion traces the responses of the women authors to Kangaroo, and refers to Lawrence’s letters to Stephensen, as a way of emphasizing this significance, seen especially in relation to ideas about ‘seeing’ and the Australian landscape.

Vibrational spectroscopic study of the minerals nekoite Ca3Si6O15•7H2O and okenite Ca10Si18O46•18H2O : implications for the molecular structure

Nekoite Ca3Si6O15•7H2O and okenite Ca10Si18O46•18H2O are both hydrated calcium silicates found respectively in contact metamorphosed limestone and in association with zeolites from the alteration of basalts. The minerals form two-Dimensional infinite sheets with other than six-membered rings with 3-, 4-, or 5-membered rings and 8-membered rings. The two minerals have been characterised by Raman, near-infrared and infrared spectroscopy. The Raman spectrum of nekoite is characterised by two sharp peaks at 1061 and 1092 cm-1 with bands of lesser intensity at 974, 994, 1023 and 1132 cm-1. The Raman spectrum of okenite shows an intense single Raman band at 1090 cm-1 with a shoulder band at 1075 cm-1.These bands are assigned to the SiO stretching vibrations of Si2O5 units. Raman water stretching bands of nekoite are observed at 3071, 3380, 3502 and 3567 cm-1. Raman spectrum of okenite shows water stretching bands at 3029, 3284, 3417, 3531 and 3607 cm-1. NIR spectra of the two minerals are subtly different inferring water with different hydrogen bond strengths. By using a Libowitzky empirical formula, hydrogen bond distances based upon these OH stretching vibrations. Two types of hydrogen bonds are distinguished: strong hydrogen bonds associated with structural water and weaker hydrogen bonds assigned to space filling water molecules.

Towards an effective IT governance structure for organizations in developing economies

The pervasive use of IT is prominent amongst organizations in developing economies. However, there is growing evidence that these economies fail to capitalize on their IT investment to transform their organizations to be competitive both locally and globally. IT-related benefits are possible with appropriate governance of the IT-related resources, and we need to broaden our understanding on the IT governance mechanics suitable for organizations in the developing economies. In this study, we adopted an initial interpretive design to obtain a deeper understanding of the IT governance (ITG) environment and conceptions of the stakeholders on effective IT governance structures for the developing economies. We found that the presence of an IT Strategic Planning Committee, Multiple level of authority, and a Forum for informal discussions as the crucial components of an ITG structure in developing economies.

The unfinished landscape fractal geometry and the aesthetics of ecological design

During the late 20th century it was proposed that a design aesthetic reflecting current ecological concerns was required within the overall domain of the built environment and specifically within landscape design. To address this, some authors suggested various theoretical frameworks upon which such an aesthetic could be based. Within these frameworks there was an underlying theme that the patterns and processes of Nature may have the potential to form this aesthetic — an aesthetic based on fractal rather than Euclidean geometry. In order to understand how fractal geometry, described as the geometry of Nature, could become the referent for a design aesthetic, this research examines the mathematical concepts of fractal Geometry, and the underlying philosophical concepts behind the terms ‘Nature’ and ‘aesthetics’. The findings of this initial research meant that a new definition of Nature was required in order to overcome the barrier presented by the western philosophical Nature¯culture duality. This new definition of Nature is based on the type and use of energy. Similarly, it became clear that current usage of the term aesthetics has more in common with the term ‘style’ than with its correct philosophical meaning. The aesthetic philosophy of both art and the environment recognises different aesthetic criteria related to either the subject or the object, such as: aesthetic experience; aesthetic attitude; aesthetic value; aesthetic object; and aesthetic properties. Given these criteria, and the fact that the concept of aesthetics is still an active and ongoing philosophical discussion, this work focuses on the criteria of aesthetic properties and the aesthetic experience or response they engender. The examination of fractal geometry revealed that it is a geometry based on scale rather than on the location of a point within a three-dimensional space. This enables fractal geometry to describe the complex forms and patterns created through the processes of Wild Nature. Although fractal geometry has been used to analyse the patterns of built environments from a plan perspective, it became clear from the initial review of the literature that there was a total knowledge vacuum about the fractal properties of environments experienced every day by people as they move through them. To overcome this, 21 different landscapes that ranged from highly developed city centres to relatively untouched landscapes of Wild Nature have been analysed. Although this work shows that the fractal dimension can be used to differentiate between overall landscape forms, it also shows that by itself it cannot differentiate between all images analysed. To overcome this two further parameters based on the underlying structural geometry embedded within the landscape are discussed. These parameters are the Power Spectrum Median Amplitude and the Level of Isotropy within the Fourier Power Spectrum. Based on the detailed analysis of these parameters a greater understanding of the structural properties of landscapes has been gained. With this understanding, this research has moved the field of landscape design a step close to being able to articulate a new aesthetic for ecological design.

Regulation of proteasome structure and function

Proteasomes are cylindrical particles made up of a stack of four heptameric rings. In animal cells the outer rings are made up of 7 different types of alpha subunits and the inner rings are composed of 7 out of 10 possible different beta subunits. Regulatory complexes can bind to the ends of the cylinder.We have investigated aspects of the assembly, activity and subunit composition of core proteasome particles and 26S proteasomes, the localization of proteasome subpopulations, and the possible role of phosphorylation in determining proteasome localization, activities and association with regulatory components.

Updating and verification for multi-scale finite element model of structure behavior

The method on concurrent multi-scale model of structural behavior (CMSM-of-SB) for the purpose of structural health monitoring including model updating and validating has been studied. The detailed process of model updating and validating is discussed in terms of reduced scale specimen of the steel box girder in longitudinal stiffening truss of a long span bridge. Firstly, some influence factors affecting the accuracy of the CMSM-of-SB including the boundary restraint regidity, the geometry and material parameters on the toe of the weld and its neighbor are analyzed using sensitivity method. Then, sensitivity-based model updating technology is adopted to update the developed CMSM-of-SB and model verification is carried out through calculating and comparing stresses on different locations under various loading from dynamic characteristic and static response. It can be concluded that the CMSM-of-SB based on the substructure method is valid.

Dimensions of the third sector : comparative perspectives on structure and change

Cross-nationally, the introduction of New Public Management coincides with a significant growth phase of the nonprofit or third sector. This growth has disproportionately been an expansion of the economic dimensions (employment, turnover) and basically involved the greater use of third sector organisations as service providers. Such provision uses complex contract regimes, and typically takes place in some form of public-private partnership with either public or private funding agencies. Other parts of the third sector such as membership, volunteering and giving have generally grown less. The paper suggests that the sector is becoming qualitatively different, although the nature and strength of this change depends on the nonprofit regime type in a given country. Generally, however, third sector growth has led to differentiation processes that involve new organisational forms, and changes in activities and overall composition. The paper explores the measurement aspects of the quantitative-qualitative jump in third sector development by trying to "map" changes in core facts or dimensions over time. In closing, the paper suggests to examine recombination and refunctionality processes in the third sector.

Reading in the Australian curriculum English : describing the effects of structure and organisation on multimodal texts

The recently introduced Australian Curriculum: English Version 3.0 (Australian Curriculum, Assessment and Reporting Authority [ACARA], 2012) requires students to ‘read’ multimodal text and describe the effects of structure and organisation. We begin this article by tracing the variable understandings of what reading multimodal text might entail through the Framing Paper (National Curriculum Board, 2008), the Framing Paper Consultation Report (National Curriculum Board, 2009a), the Shaping Paper (National Curriculum Board, 2009b) and Version 3.0 of the Australian Curriculum English (ACARA, 2012). Our findings show that the theoretical and descriptive framework for doing so is implicit. Drawing together multiple but internally coherent theories from the field of semiotics, we suggest one way to work towards three Year 5 learning outcomes from the reading/writing mode. The affordances of assembling a broad but explicit technical metalanguage for an informed reading of the integrated design elements of multimodal texts are noted.

Speed enforcement in Australia : a changing policy landscape shaped by public opinion

- Speeding and crash involvement in Australia - Speed management in Australia - Jurisdictional differences - National Road Safety Strategy (2011-2020) - Auditor-General reviews of speed camera programs - The role of public opinion/feedback - Implications for speed management

Tooth fracture risk analysis based on a new finite element dental structure models using micro-CT data

The finite element (FE) analysis is an effective method to study the strength and predict the fracture risk of endodontically-treated teeth. This paper presents a rapid method developed to generate a comprehensive tooth FE model using data retrieved from micro-computed tomography (μCT). With this method, the inhomogeneity of material properties of teeth was included into the model without dividing the tooth model into different regions. The material properties of the tooth were assumed to be related to the mineral density. The fracture risk at different tooth portions was assessed for root canal treatments. The micro-CT images of a tooth were processed by a Matlab software programme and the CT numbers were retrieved. The tooth contours were obtained with thresholding segmentation using Amira. The inner and outer surfaces of the tooth were imported into Solidworks and a three-dimensional (3D) tooth model was constructed. An assembly of the tooth model with the periodontal ligament (PDL) layer and surrounding bone was imported into ABAQUS. The material properties of the tooth were calculated from the retrieved CT numbers via ABAQUS user's subroutines. Three root canal geometries (original and two enlargements) were investigated. The proposed method in this study can generate detailed 3D finite element models of a tooth with different root canal enlargements and filling materials, and would be very useful for the assessment of the fracture risk at different tooth portions after root canal treatments.

Molecular structure of the mineral svanbergite SrAl3(PO 4,SO4)2(OH)6 - A vibrational spectroscopic study

The mineral svanbergite SrAl 3(PO 4,SO 4) 2(OH) 6 is a hydroxy phosphate-sulphate mineral belonging to the beudantite subgroup of alunites and has been characterised by vibrational spectroscopy. Bands at various wavenumbers were assigned to the different vibrational modes of svanbergite, which were then associated with the structure of the mineral. Bands were primarily assigned to phosphate and sulphate stretching and bending modes. Two symmetric stretching modes for both phosphate and sulphate supported the concept of non-equivalent phosphate and sulphate units in the mineral structure. Bands in the OH stretching region enabled hydrogen bond distances to be calculated. Comparison of the hydrogen bond distances and the calculated hydrogen bond distances from the structure models indicates that hydrogen bonding in svanbergite occurs between the two OH units rather than OH to SO42- units.

Zoledronic acid preserves bone structure and increases survival but does not limit tumour incidence in a prostate cancer bone metastasis model

Background The bisphosphonate, zoledronic acid (ZOL), can inhibit osteoclasts leading to decreased osteoclastogenesis and osteoclast activity in bone. Here, we used a mixed osteolytic/osteoblastic murine model of bone-metastatic prostate cancer, RM1(BM), to determine how inhibiting osteolysis with ZOL affects the ability of these cells to establish metastases in bone, the integrity of the tumour-bearing bones and the survival of the tumour-bearing mice. Methods The model involves intracardiac injection for arterial dissemination of the RM1(BM) cells in C57BL/6 mice. ZOL treatment was given via subcutaneous injections on days 0, 4, 8 and 12, at 20 and 100 µg/kg doses. Bone integrity was assessed by micro-computed tomography and histology with comparison to untreated mice. The osteoclast and osteoblast activity was determined by measuring serum tartrate-resistant acid phosphatase 5b (TRAP 5b) and osteocalcin, respectively. Mice were euthanased according to predetermined criteria and survival was assessed using Kaplan Meier plots. Findings Micro-CT and histological analysis showed that treatment of mice with ZOL from the day of intracardiac injection of RM1(BM) cells inhibited tumour-induced bone lysis, maintained bone volume and reduced the calcification of tumour-induced endochondral osteoid material. ZOL treatment also led to a decreased serum osteocalcin and TRAP 5b levels. Additionally, treated mice showed increased survival compared to vehicle treated controls. However, ZOL treatment did not inhibit the cells ability to metastasise to bone as the number of bone-metastases was similar in both treated and untreated mice. Conclusions ZOL treatment provided significant benefits for maintaining the integrity of tumour-bearing bones and increased the survival of tumour bearing mice, though it did not prevent establishment of bone-metastases in this model. From the mechanistic view, these observations confirm that tumour-induced bone lysis is not a requirement for establishment of these bone tumours.