Ash deposition during the co-firing of bituminous coal with pine sawdust and olive stones in a laboratory furnace

This article describes an experimental study on ash deposition during the co-firing of bituminous coal with pine sawdust and olive stones in a laboratory furnace. The main objective of this study was to relate the ash deposit rates with the type of biomass burned and its thermal percentage in the blend. The thermal percentage of biomass in the blend was varied between 10% and 50% for both sawdust and olive stones. For comparison purposes, tests have also been performed using only coal or only biomass. During the tests, deposits were collected with the aid of an air-cooled deposition probe placed far from the flame region, where the mean gas temperature was around 640 degrees C. A number of deposit samples were subsequently analyzed on a scanning electron microscope equipped with an energy dispersive X-ray detector. Results indicate that blending sawdust with coal decreases the deposition rate as compared with the firing of unblended coal due to both the sawdust low ash content and its low alkalis content. The co-firing of coal and sawdust yields deposits with high levels of silicon and aluminium which indicates the presence of ashes with high fusion temperature and, thus, with less capacity to adhere to the surfaces. In contrast, in the co-firing of coal with olive stones the deposition rate increases as compared with the firing of unblended coal and the deposits produced present high levels of potassium, which tend to increase their stickiness.

Hydroisomerization of n-decane over SAPO-11 catalysts synthesized with methylamine as co-template

The present work deals with preliminary studies concerning a new synthesis approach to prepare SAPO materials with AEL structure and evaluate their catalytic behavior in the hydroisomerization of long paraffins. The new SAPO-11 catalysts were synthesized with the help of a small amine (methylamine, MA) added during the preparation of the initial gel. As MA incorporates into the structure of the final materials, it contributes, together with DPA (dipropylamine), to an increase in Si incorporation as isolated species, which results in Bronsted acid sites. Thus, this new and original synthesis strategy allows to obtain materials with enhanced Bronsted acidity when compared with free MA materials. The catalysts were tested in n-decane hydroisomerization (n-decane was used as a model molecule) and confirmed the effect of MA on the acidic properties of the catalysts. The samples synthesized with MA present a higher number of acid sites that increase the catalytic conversion but have a negative effect in the isomerization selectivity, i.e. a more significant amount of cracking products is formed.

Riscos da co-incineração ou co-incineração dos riscos? Análise das controvérsias sobre resíduos industriais perigosos

A co-incineração constitui um método de tratamento de resíduos industriais, introduzido em diversos países e proposto também em Portugal, como alternativa à construção de centrais de incineração “dedicada”. A co-incineração consiste na queima de resíduos, incluindo resíduos industriais perigosos, em fornos de fábricas cimenteiras, onde são utilizados como combustível. Motivos de ordem ambiental, assim como de ordem económica, têm sido invocados em defesa do recurso a esse método como parte de estratégias de gestão dos resíduos industriais.

HIV/tuberculosis co-infection: a request for a better surveillance

The increasing endemicity of tuberculosis resulting from causes such as immigration, poverty, a declining public health infrastructure and co-infection by HIV/Mycobacterium tuberculosis, is leading to a change in tuberculosis control programmes. One of the main reasons for the resurgence of tuberculosis is HIV infection - the risk of tuberculosis is greater in HIV patients than in the majority of the population as can be seen from numerous research projects. The need for systematic testing for HIV infection in all tuberculosis patients by undertaking confidential HIV tests on admission to a tuberculosis programme is brought out. This measure would increase the number of cases diagnosed and provide data for better surveillance of the co-infection.

Sistemas de informação: message integration bus

O trabalho apresentado por este documento aborda os problemas que advêm da necessidade de integração de aplicações, desenvolvidas em diferentes instantes no tempo, por diferentes equipas de trabalho, que para enriquecer os processos de negócio necessitam de comunicar entre si. A integração das aplicações tem de ser feita de forma opaca para estas, sendo disponibilizada por uma peça de software genérica, robusta e sem custos para as equipas desenvolvimento, na altura da integração. Esta integração tem de permitir que as aplicações comuniquem utilizando os protocolos que desejarem. Este trabalho propõe um middleware orientado a mensagens como solução para o problema identificado. A solução apresentada por este trabalho disponibiliza a comunicação entre aplicações que utilizam diferentes protocolos, permite ainda o desacoplamento temporal, espacial e de sincronismo na comunicação das aplicações. A implementação da solução tem base num sistema publish/subscribe orientado ao conteúdo e tem de lidar com as maiores exigências computacionais que este tipo de sistema acarta, sendo que a utilização deste se justifica com o enriquecimento da semântica de subscrição de eventos. Esta implementação utiliza uma arquitectura semi-distribuída, com o objectivo de aumentar a escalabilidade do sistema. A utilização da arquitectura semi-distribuída implica que a implementação da solução tem de lidar com o encaminhamento de eventos e divulgação das subscrições, pelos vários servidores de eventos. A implementação da solução disponibiliza garantias de persistência, processamento transaccional e tolerância a falhas, assim como transformação de eventos entre os diversos protocolos. A extensibilidade da solução é conseguida à custa de um sistema de pluggins que permite a adição de suporte a novos protocolos de comunicação. Os protocolos suportados pela implementação final do trabalho são RestMS e TCP.

Ferromagnetic order in aged Co-doped TiO2 anatase nanopowders

Oxide based diluted magnetic semiconductor (DMS) materials have been a subject of increasing interest due to reports of room temperature ferromagnetism in several systems and their potential use in the development of spintronic devices. However, concerns on the stability of the magnetic properties of different DMS systems have been raised. Their magnetic moment is often unstable, vanishing with a characteristic decay time of weeks or months, which precludes the development of real applications. This paper reports on the ferromagnetic properties of two-year-aged Ti1-xCoxO2-δ reduced anatase nanopowders with different Co contents (0.03≤x≤0.10). Aged samples retain rather high values of magnetization, remanence and coercivity which provide strong evidence for a quite preserved long-range ferromagnetic order. In what concern Co segregation, some degree of metastability of the diluted Co doped anatase structure could be inferred in the case of the sample with the higher Co content.

A new chemical route to synthesise TM-doped (TM = Co, Fe) TiO2 nanoparticles

Since the discovery of ferromagnetism well above room temperature in the Co-doped TiO2 system, diluted magnetic semiconductors based on TiO2 doped with transition metals have generated great interest because of their potential use in the development of spintronic devices. The purpose of this paper is to report on a new and swift chemical route to synthesise highly stable anatase single-phase Co- and Fe-doped TiO2 nanoparticles, with dopant concentrations of up to 10 at.-% and grain sizes that range between 20 and 30 nm. Complementary structural, microstructural and chemical analyses of the different nanopowders synthesised strongly support the hypothesis that a homogeneous distribution of the dopant element in the substitutional sites of the anatase structure has been achieved. Moreover, UV/Vis diffuse reflectance spectra of powder samples show redshifts to lower energies and decreasing bandgap energies with increasing Co or Fe concentration, which is consistent with n-type doping of the TiO2 anatase matrix. Films of Co-doped TiO2 were successfully deposited onto Si (100) substrates by the dip-coating method, with suspensions of Ti1-xCOxO2 nanoparticles in ethylene glycol. ((C)Wiley-VCH Verlag GmbH & Co. KGaA, 69451 Weinheim, Germany, 2008).

Magnetic properties of Co-doped TiO(2) anatase nanopowders

This letter reports on the magnetic properties of Ti(1-x)Co(x)O(2) anatase phase nanopowders with different Co contents. It is shown that oxygen vacancies play an important role in promoting long-range ferromagnetic order in the material studied in addition to the transition-metal doping. Furthermore, the results allow ruling out the premise of a strict connection between Co clustering and the ferromagnetism observed in the Co:TiO(2) anatase system.

KrP laser CVD of chromium oxide by photodissociation of Cr(CO)(6)

This work reports on the synthesis of chromium oxide thin films prepared by photodissociation of Cr(CO)(6) in an oxidizing atmosphere, using a pulsed UV laser (KrF, lambda = 248 nm). The experimental conditions, which should enable the synthesis of CrO2, are discussed and results on the deposition of CrxOy films on Al2O3 (0001) substrates are presented.

New challenges in mathematics for the european higher education

In this paper we will talk about a math project submitted to the Lifelong Learning Programme. European higher education needs a reform in order to play its full role in the Europe of Knowledge. Modernisation of higher education is necessary in the areas of curricula (Bologna process), funding and governance so that higher education institutions can face the challenges posed by globalisation and contribute more effectively to the training and retraining of the European workforce. On the other hand Mathematics is an essential component of all educational systems. Mathematical literacy is being scrutinized in assessment efforts such as the OCDE Programme for International Student Assessment (PISA). This showed a low level in Europe. Due to the Bologna Process, which brought several didactical implications for Higher Education (HE) institutions, there is the need of lifelong learning. This evolution is in conflict with the earlier mentioned lack of competencies on basic sciences, such as Mathematics. Forced by this duality, efforts are combined to share expertise in the Math field and the integration of pedagogical methodologies becomes a necessity. Thus, several European countries have proposed an International Project to the Lifelong Learning Programme, Action ERASMUS Modernisation of Higher Education, to make institutions more attractive and more responsive to the needs of the labour market, citizens and society at large. One of the main goals of the project is to attract students to math through high-quality instructional units in an understandable, exciting and attractive way.

Grid Integration of Offshore Wind Farms Using Modular Marx Multilevel Converters

This paper proposes the use of a Modular Marx Multilevel Converter, as a solution for energy integration between an offshore Wind Farm and the power grid network. The Marx modular multilevel converter is based on the Marx generator, and solves two typical problems in this type of multilevel topologies: modularity and dc capacitor voltage balancing. This paper details the strategy for dc capacitor voltage equalization. The dynamic models of the converter and power grid are presented in order to design the converter ac output voltages and the dc capacitor voltage controller. The average current control is presented and used for power flow control, harmonics and reactive power compensation. Simulation results are presented in order to show the effectiveness of the proposed (MC)-C-3 topology.

Fabrication of Three-Dimensional Dendritic Ni-Co Films By Electrodeposition on Stainless Steel Substrates

Co-deposition of nickel and cobalt was carried out on austenitic stainless steel (AISI 304) substrates by imposing a square waveform current in the cathodic region. The innovative procedure applied in this work allows creating a stable, fully developed, and open porous three-dimensional (3D) dendritic structure, which can be used as electrode for redox supercapacitors. This study investigates in detail the influence of the applied current density on the morphology, mass, and chemical composition of the deposited Ni-Co films and the resulting 3D porous network dendritic structure. The morphology and the physicochemical composition were studied by scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS) and X-ray diffraction (W). The electrochemical behavior of the materials was evaluated by cyclic voltammetry (CV). The results highlight the mechanism involved in the coelectrodeposition process and how the lower limit current density tailors the film composition and morphology, as well as its electrochemical activity.

A Service Integration Platform for Collaborative Networks

Integrated manufacturing constitutes a complex system made of heterogeneous information and control subsystems. Those subsystems are not designed to the cooperation. Typically each subsystem automates specific processes, and establishes closed application domains, therefore it is very difficult to integrate it with other subsystems in order to respond to the needed process dynamics. Furthermore, to cope with ever growing marketcompetition and demands, it is necessary for manufacturing/enterprise systems to increase their responsiveness based on up-to-date knowledge and in-time data gathered from the diverse information and control systems. These have created new challenges for manufacturing sector, and even bigger challenges for collaborative manufacturing. The growing complexity of the information and communication technologies when coping with innovative business services based on collaborative contributions from multiple stakeholders, requires novel and multidisciplinary approaches. Service orientation is a strategic approach to deal with such complexity, and various stakeholders' information systems. Services or more precisely the autonomous computational agents implementing the services, provide an architectural pattern able to cope with the needs of integrated and distributed collaborative solutions. This paper proposes a service-oriented framework, aiming to support a virtual organizations breeding environment that is the basis for establishing short or long term goal-oriented virtual organizations. The notion of integrated business services, where customers receive some value developed through the contribution from a network of companies is a key element.

Virtual power producers integration into MASCEM

All over the world Distributed Generation is seen as a valuable help to get cleaner and more efficient electricity. Under this context distributed generators, owned by different decentralized players can provide a significant amount of the electricity generation. To get negotiation power and advantages of scale economy, these players can be aggregated giving place to a new concept: the Virtual Power Producer. Virtual Power Producers are multi-technology and multi-site heterogeneous entities. Virtual Power Producers should adopt organization and management methodologies so that they can make Distributed Generation a really profitable activity, able to participate in the market. In this paper we address the integration of Virtual Power Producers into an electricity market simulator –MASCEM – as a coalition of distributed producers.

Balancing market integration in MASCEM electricity market simulator

With the restructuring of the energy sector in industrialized countries there is an increased complexity in market players’ interactions along with emerging problems and new issues to be addressed. Decision support tools that facilitate the study and understanding of these markets are extremely useful to provide players with competitive advantage. In this context arises MASCEM, a multi-agent simulator for competitive electricity markets. It is essential to reinforce MASCEM with the ability to recreate electricity markets reality in the fullest possible extent, making it able to simulate as many types of markets models and players as possible. This paper presents the development of the Balancing Market in MASCEM. A key module to the study of competitive electricity markets, as it has well defined and distinct characteristics previously implemented.