Adhesively-bonded repair proposal for wood members damaged by horizontal shear using carbon-epoxy patches

In this work, a repair technique with adhesively bonded carbon-epoxy patches is proposed for wood members damaged by horizontal shear and under bending loads. This damage is characterized by horizontal crack growth near the neutral plane of the wood beam, normally originating from checks and shakes. The repair consists of adhesively bonded carbon-epoxy patches on the vertical side faces of the beam at the cracked region to block sliding between the beam arms. An experimental and numerical parametric analysis was performed on the patch length. The numerical analysis used the finite element method (FEM) and cohesive zone models (CZMs), with an inverse modelling technique for the characterization of the adhesive layer. Trapezoidal cohesive laws in each pure mode were used to account for the ductility of the adhesive used. To fully reproduce the tests, horizontal damage propagation within the wood beam was also simulated. A good correlation with the experiments was found. Regarding the effectiveness of the repair, for the conditions selected for this work, a full strength recovery was achieved for the bigger value of patch length tested.

Aliphatic bio-oils from corks: a Py-Gc/MS study

Cork samples from Betula pendula, Quercus suber and Quercus cerris were submitted to Py-GC-MS/FID at temperatures between 550 degrees C and 900 degrees C and the pyrolysis-derived compounds (py-products) were identified and quantified. Corks were compared with wood samples. Py-products include suberin, lignin and carbohydrates derivatives. Suberin py-products are dominated by unsaturated aliphatics. Corks pyrolysis yield and composition were dramatically influenced by temperature in contrast to wood that showed stable results across temperatures. At 850-900 degrees C the peaks area of cork pyrograms were approximately two times higher than at 550 degrees C, for which yield was about half of the woods, and cork py-products were dominated by suberin-derived short chain aliphatics, namely 1-alkenes, while at 550 degrees C composition was dominated by lignin derivatives. Lignin and carbohydrate derived products decreased dramatically over 750 degrees C while the opposite was observed for unsaturated aliphatics. Cork materials show a high potential as feedstock for production of aliphatic-rich pyrolytic biofuels or as a source of olefins. (C) 2014 Elsevier B.V. All rights reserved.

Design and optimization of na ultra wideband and compact microwave antenna for radiometric monitoring of brain temperature

We present the modeling efforts on antenna design and frequency selection to monitor brain temperature during prolonged surgery using noninvasive microwave radiometry. A tapered log-spiral antenna design is chosen for its wideband characteristics that allow higher power collection from deep brain. Parametric analysis with the software HFSS is used to optimize antenna performance for deep brain temperature sensing. Radiometric antenna efficiency (eta) is evaluated in terms of the ratio of power collected from brain to total power received by the antenna. Anatomical information extracted from several adult computed tomography scans is used to establish design parameters for constructing an accurate layered 3-D tissue phantom. This head phantom includes separate brain and scalp regions, with tissue equivalent liquids circulating at independent temperatures on either side of an intact skull. The optimized frequency band is 1.1-1.6 GHz producing an average antenna efficiency of 50.3% from a two turn log-spiral antenna. The entire sensor package is contained in a lightweight and low-profile 2.8 cm diameter by 1.5 cm high assembly that can be held in place over the skin with an electromagnetic interference shielding adhesive patch. The calculated radiometric equivalent brain temperature tracks within 0.4 degrees C of the measured brain phantom temperature when the brain phantom is lowered 10. C and then returned to the original temperature (37 degrees C) over a 4.6-h experiment. The numerical and experimental results demonstrate that the optimized 2.5-cm log-spiral antenna is well suited for the noninvasive radiometric sensing of deep brain temperature.

Characterization of the volatile fraction emitted by phloems of four pinus species by solid-phase microextraction and gas chromatography–mass spectrometry

Pine forests constitute some of the most important renewable resources supplying timber, paper and chemical industries, among other functions. Characterization of the volatiles emitted by different Pinus species has proven to be an important tool to decode the process of host tree selection by herbivore insects, some of which cause serious economic damage to pines. Variations in the relative composition of the bouquet of semiochemicals are responsible for the outcome of different biological processes, such as mate finding, egg-laying site recognition and host selection. The volatiles present in phloem samples of four pine species, P. halepensis, P. sylvestris, P. pinaster and P. pinea, were identified and characterized with the aim of finding possible host-plant attractants for native pests, such as the bark beetle Tomicus piniperda. The volatile compounds emitted by phloem samples of pines were extracted by headspace solid-phase micro extraction, using a 2 cm 50/30 mm divinylbenzene/carboxen/polydimethylsiloxane table flex solid-phase microextraction fiber and its contents analyzed by high-resolution gas chromatography, using flame ionization and a non polar and chiral column phases. The components of the volatile fraction emitted by the phloem samples were identified by mass spectrometry using time-of-flight and quadrupole mass analyzers. The estimated relative composition was used to perform a discriminant analysis among pine species, by means of cluster and principal component analysis. It can be concluded that it is possible to discriminate pine species based on the monoterpenes emissions of phloem samples.

Pentagonal parch-excited sectorized antenna for localization systems

A pentagonal patch-excited sectorized antenna (SA) suitable for 2.4-2.5 GHz localization systems was studied and developed. The integration of six patch-excited structures converges into a sectorized antenna called Hive5 that provides gain improvement compared to a patch antenna, maximum variation of 3 dB beam width over the radiation pattern and circular polarization (CP). This antenna is presented and analyzed taking into account the tap length and the flare angle. The proposed antenna in combination with a RF-Switch provides a cost effective solution for localization based on Wireless Sensor Networks (WSN) and will be used for implementing angle of arrival (AoA) techniques combined with RF fingerprinting techniques.

Urban land use change analysis and modelling: a case study of Setubal-Sesimbra, Portugal

Dissertation submitted in partial fulfilment of the requirements for the Degree of Master of Science in Geospatial Technologies

Study of thermochemical treatments of cork in the 150-400ºC range using colour analysis and Ftir spectroscopy

A study of chemical transformations of cork during heat treatments was made using colour variation and FTIR analysis. The cork enriched fractions from Quercus cerris bark were subjected to isothermal heating in the temperature range 150–400 ◦C and treatment time from 5 to 90 min. Mass loss ranged from 3% (90 min at 150 ◦C) to 71% (60 min at 350 ◦C). FTIR showed that hemicelluloses were thermally degraded first while suberin remained as the most heat resistant component. The change of CIE-Lab parameters was rapid for low intensity treatments where no significant mass loss occurred (at 150 ◦C L* decreased from the initial 51.5 to 37.3 after 20 min). The decrease in all colour parameters continued with temperature until they remained substantially constant with over 40% mass loss. Modelling of the thermally induced mass loss could be made using colour analysis. This is applicable to monitoring the production of heat expanded insulation agglomerates.

Quantitative description of the self-assembly of patchy particles into chains and rings

We numerically study a simple fluid composed of particles having a hard-core repulsion complemented by two patchy attractive sites on the particle poles. An appropriate choice of the patch angular width allows for the formation of ring structures which, at low temperatures and low densities, compete with the growth of linear aggregates. The simplicity of the model makes it possible to compare simulation results and theoretical predictions based on the Wertheim perturbation theory, specialized to the case in which ring formation is allowed. Such a comparison offers a unique framework for establishing the quality of the analytic predictions. We find that the Wertheim theory describes remarkably well the simulation results.

The ecology of Triatoma sordida in natural environments in two different regions of the state of Minas Gerais, Brazil

A study was undertaken about T. sordida in the natural environment in two different regions of the state of Minas Gerais: Itapagipe (Triângulo), an area of cerrado modified by the formation of fields of pasture and agriculture, and Mato Verde (north) an area of transition between caatinga and cerrado with profound deforestation in the last years due to the expansion of cotton cultivation. In both regions the principal ecotopes identified were hollow trees and the bark of live or dead trees, where the occurrence of a food source is not frequent. In this environment, the triatomines utilize various food sources; opposums appear to represent an important source of infection. In the north of Minas, a greater concentration of reservoirs and vectors was observed than in the Triángulo which could explain the higher level of infection of the triatomines in the north. Close attention to the process of domiciliation of T. sordida in the north of Minas is recommended where an extensive intervention by man in the natural environment has occurred and where a rise in the population of triatomines in the peridomestic environment has been observed in recent years.

Strap repairs using embedded patches: numerical analysis and experimental results

Adhesively bonded repairs offer an attractive option for repair of aluminium structures, compared to more traditional methods such as fastening or welding. The single-strap (SS) and double-strap (DS) repairs are very straightforward to execute but stresses in the adhesive layer peak at the overlap ends. The DS repair requires both sides of the damaged structures to be reachable for repair, which is often not possible. In strap repairs, with the patches bonded at the outer surfaces, some limitations emerge such as the weight, aerodynamics and aesthetics. To minimize these effects, SS and DS repairs with embedded patches were evaluated in this work, such that the patches are flush with the adherends. For this purpose, in this work standard SS and DS repairs, and also with the patches embedded in the adherends, were tested under tension to allow the optimization of some repair variables such as the overlap length (LO) and type of adhesive, thus allowing the maximization of the repair strength. The effect of embedding the patch/patches on the fracture modes and failure loads was compared with finite elements (FE) analysis. The FE analysis was performed in ABAQUS® and cohesive zone modelling was used for the simulation of damage onset and growth in the adhesive layer. The comparison with the test data revealed an accurate prediction for all kinds of joints and provided some principles regarding this technique.

Energy evaporation: the new concept of indoor systems for WPT and EH embedded into the floor

This work introduces a novel idea for wireless energy transfer, proposing for the first time the unit-cell of an indoor localization and RF harvesting system embedded into the floor. The unit-cell is composed by a 5.8 GHz patch antenna surrounded by a 13.56 MHz coil. The coil locates a device and activate the patch which, connected to a power grid, radiates to wirelessly charge the localized device. The HF and RF circuits co-existence and functionality are demonstrated in this paper, the novelty of which is also in the adoption of low cost and most of all ecofriendly materials, such as wood and cork, as substrates for electronics.

Nickel Contact Dermatitis in Fortaleza, Ceará, Brazil: 1993-1994

This work consists in an evaluation of the occurrence of nickel contact dermatitis, its distribution between sexes and in which parts of the body the dermatitis usually occurs. It was accomplished a two year (1994-1995) retrospective study of 404 patch-tested patients which had previous clinical diagnosis of contact dermatitis. The occurrence of nickel sensitisation was 19,8%. 88,8% of these 19,8% were women and the rest, 11,2%, were men. The lesions were present predominantly on hands, forearms, earlobes and feet. The authors comment about possible variations of occurrence of nickel contact dermatitis in rural areas and/or tropical countries

Estudo de reparações adesivas pela técnica de remendo embebido com reforços exteriores para aumento da resistência

As ligações adesivas têm sido utilizadas em áreas como a indústria aeroespacial, aeronáutica, de defesa, automóvel, da construção civil e das madeiras. As juntas adesivas têm vindo a substituir métodos como a soldadura, e ligações parafusadas e rebitadas, devido à facilidade de fabricação, maiores cadências de produção, menores custos, facilidade em unir materiais diferentes, melhor resistência à fadiga, entre outras razões. Como tal, também se utilizam reparações adesivas para restituição da resistência de estruturas danificadas, cujas técnicas mais comuns são a sobreposição simples, sobreposição dupla e remendo embebido. As reparações por remendo embebido, que são as mais eficientes, consistem na realização de um furo cónico na zona danificada e colagem de um remendo com a forma complementar do furo, de tal forma que não é alterada a forma inicial do componente. Neste trabalho pretende-se estudar experimental e numericamente reparações adesivas por remendo embebido, nomeadamente o efeito da utilização de reforços exteriores (em um ou nos dois lados da estrutura), para diferentes ângulos de inclinação. Foi considerado um adesivo dúctil (Araldite® 2015) e outro frágil (Araldite® AV138), o que permitiu abranger processos de rotura bastante distintos. O estudo experimental é acompanhado por outro numérico no software ABAQUS®, usando modelos coesivos para a previsão numérica da resistência das reparações. O trabalho numérico permitiu o estudo das distribuições de tensões, o que possibilitou a análise detalhada dos resultados obtidos. Foi também realizado um estudo numérico de otimização das reparações por alteração da espessura dos reforços e utilização de chanfro nas extremidades dos mesmos. Nos resultados obtidos, constatou-se a adequabilidade do método numérico na previsão fiável da resistência, e também que a utilização dos reforços aumenta consideravelmente o rendimento das reparações (até 530 % e 340 % para os adesivos Araldite® 2015 e AV138, respetivamente), o que poderá justificar a sua utilização em aplicações industriais em que a perturbação aerodinâmica causada por esta alteração não seja relevante.

Dynamics of cork mycobiota throughout stopper manufacturing process: from diversity to metabolite

Dissertation presented to obtain the Ph.D degree in Biology

Pustulose Generalizada Exantemática Aguda Associada ao Diltiazem

Acute generalized exanthematous pustulosis (AGEP) usually presents with the acute appearance of oedematous and erythematous lesions, on which multiple sterile pustules appear, associated with fever. Almost 90% of cases are associated with drugs, with antibiotics (penicillins and macrolides) being the most frequent causative agents. We describe a 36-year-old female patient, which started diltiazem 120mg/day for hypertension. After 6 days of therapy, multiple erythematous and oedematous lesions appeared, with associated multiple small non-follicular pustules. Oral corticosteroids were started, with progressive and complete improvement. Patch-tests were performed, which revealed positivity for diltiazem. Although a rare entity, AGEP must be considered in cases of acute eruptions with disseminated pustules and fever. The use of patch tests in this disease may be useful as positive reactions are frequent.