Effects of Inhaled Nitric Oxide on Oxidative Stress and Histopathological and Inflammatory Lung Injury in a Saline-Lavaged Rabbit Model of Acute Lung Injury

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Early administration of inhaled nitric oxide to children with acute respiratory distress syndrome and its effects on oxygenation and ventilator settings: prospective preliminary report of ten patients

Aim. To establish a protocol for the early introduction of inhaled nitric oxide (iNO) therapy in children with acute respiratory distress syndrome (ARDS) and to assess its acute and sustained effects on oxygenation and ventilator settings.Patients and Methods. Ten children with ARDS, aged 1 to 132 months (median, 11 months), with arterial saturation of oxygen <88% while receiving a fraction of inspired oxygen (FiO(2)) 0.6 and a positive end-expiratory pressure of greater than or equal to 10 cm H2O were included in the study. The acute response to iNO was assessed in a 4-hour dose-response test, and positive response was defined as an increase in the PaO2/FiO(2) ratio of 10 mmHg above baseline values. Conventional therapy was not changed during the test. In the following days, patients who had shown positive response continued to receive the lowest iNO dose. Hemodynamics, PaO2/FiO(2), oxygenation index, gas exchange, and methemoglobin levels were obtained when needed. Inhaled nitric oxide withdrawal followed predetermined rules.Results. At the end of the 4-hour test, all the children showed significant improvement in the PaO2/FiO(2) ratio (63.6%) and the oxygenation index (44.9%) compared with the baseline values. Prolonged treatment was associated with improvement in oxygenation, so that FiO(2) and peak inspiratory pressure could be quickly and significantly reduced., No toxicity from methemoglobin or nitrogen dioxide was observed.Conclusion. Administration of iNO to children is safe. iNO causes rapid and sustained improvement in oxygenation without adverse effects. Ventilator settings can safely be reduced during iNO treatment.

High-Frequency Oscillatory Ventilation Associated With Inhaled Nitric Oxide Compared to Pressure-Controlled Assist/Control Ventilation and Inhaled Nitric Oxide in Children: Randomized, Non-Blinded, Crossover Study

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

An in vitro evaluation of apicoectomies and retropreparations using different methods

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Tumor Necrosis Factor alpha and Interleukin-1 beta Modulate Calcium and Nitric Oxide Signaling in Mechanically Stimulated Osteocytes

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Local and cardiorenal effects of periodontitis in nitric oxide-deficient hypertensive rats

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

iNOS-Derived Nitric Oxide Stimulates Osteoclast Activity and Alveolar Bone Loss in Ligature-Induced Periodontitis in Rats

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

EFFECT of METAL PRIMERS on BOND STRENGTH of RESIN CEMENTS TO BASE METALS

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Endodontic Chelators Induce Nitric Oxide Expression by Murine-cultured Macrophages

Introduction: Endodontic chelators may extrude to apical tissues during instrumentation activating cellular events on periapical tissues. This study assessed in vitro the expression of nitric oxide (NO) concentrations by murine peritoneal macrophages after contact with MTAD (Dentsply/Tulsa, Tulsa, OK), Tetraclean (Ogna Laboratori Farmaceutici, Muggio, Italy), Smear Clear (Sybron Endo, Orange, CA), and EDTA (Biodinamica, Ibipora, PR, Brazil). Methods: Macrophage cells were obtained from Swiss mice after peritoneal lavage. Chelators were diluted in distilled water obtaining 12 concentrations, and MTT assay identified the concentrations, per group, displaying the highest cell viability (analysis of variance, p < 0.01). Selected concentrations were tested for NO expression using Griess reaction. Culture medium and lipopolysaccharide (LPS) were used as controls. Results: Analysis of variance and Tukey tests showed that all chelators displayed elevated NO concentrations compared with the negative control (p < 0.01). MTAD induced the lowest NO expression, followed by Tetraclean, EDTA, and Smear Clear. No difference was observed between MTAD and Tetraclean (p > 0.01), Tetraclean and EDTA (p > 0.01), and EDTA and Smear Clear (p > 0.01). LPS ranked similar to both EDTA and Smear Clear (p > 0.01). Conclusion: The tested endodontic chelators displayed severe proinflammatory effects on murine-cultured macrophages. Citric acid-based solutions induce lower No release than EDTA-based irrigants. (J Endod 2009;35:824-828)

Gastroprotective effect of Cissus sicyoides (Vitaceae): Involvement of microcirculation, endogenous sulfhydryls and nitric oxide

Aim of the study: Cissus sicyoides L. is a medicinal plant popularly known in Brazil against various diseases and the research interest in this plant is justifiable because of its potential medicinal value in stomachache and gastric ulcer.Materials and methods: The methanolic extract obtained from the leaves of Cissus sicyoides (Cc) was evaluated for the ability to protect the gastric mucosa against injuries caused by necrotizing agents (0.3 M HCl/60% EtOH, absolute ethanol, piroxicam and pylorus ligature) in rodents. We also evaluated microcirculation, antioxidant action and participation of NO (nitric oxide) and sulfhydryls (SH) groups in the Cc gastroprotective action.Results: Administration of Cc significantly reduced gastric lesions induced by different ulcerogenic agents in rodents. This extract administered by oral route significantly increased gastric volume without exerting antisecretory effect. The Cc effect involved an increase of the defense mechanism of the gastrointestinal mucosa such as NO and SH groups that prevent and attenuate the ulcer process. The Cc also has antioxidant property against oxidative stress but does not modify microcirculation response in gastric mucosa.Conclusions: These results confirmed the traditional use of Cissus sicyoides for the treatment of gastric ulcer. (C) 2008 Elsevier B.V. All rights reserved.

Coagglutination for viral DNA preparation of canine parvovirus for molecular diagnosis

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

V2O5/TiO2 catalyst xerogels: Method of preparation and characterization

This work describes a modified sol-gel method for the preparation of V2O5/TiO2 catalysts. The samples have been characterized by N-2 adsorption at 77 K, X-ray Diffractometry (XRD), Scanning Electronic Microscopy (SEM/EDX) and Fourier Transform Infrared Spectroscopy (FT-IR). The surface area increases with the vanadia loading from 24 m(2) g(-1) for pure TiO2 to 87 m(2) g(-1) for 9 wt% of V2O5. The rutile form is predominant for pure TiO2 but becomes enriched with anatase phase when vanadia loading is increased. No crystalline V2O5 phase was observed in the diffractograms of the catalysts. Analysis by SEM showed heterogeneous granulation of particles with high vanadium dispersion. Two species of surface vanadium were observed by FT-IR spectroscopy: a monomeric vanadyl and polymeric vanadates. The vanadyl/vanadate ratio remains practically constant. Ethanol oxidation was used as a catalytic test in a temperature range from 350 to 560 K. The catalytic activity starts around 380 K. For the sample with 9 wt% of vanadia, the conversion of ethanol into acetaldehyde as the main product was approximately 90% at 473 K.

Comparison of polyamine, phenol and flavonoid contents in plants grown under conventional and organic methods

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Phase transition in dioctadecyldimethylammonium bromide and chloride vesicles prepared by different methods

The gel to liquid crystalline phase transition of the double-chained cationic dioctadecyldimethylammonium chloride and bromide (DODAX, X = Cl- or Br-) in aqueous vesicle dispersions prepared by non-sonication, sonication and extrusion has been investigated using high-sensitivity differential scanning calorimetry (DSC). The transition temperature (T-m) is a function of the preparation method, amphiphile concentration, vesicle curvature and nature of the counterion. DSC thermograms for DODAB and DODAC non-sonicated vesicle dispersions exhibit a single endothermic peak at T-m roughly independent of concentration up to 10 mM. Extrusion broadens the transition peak and shifts T-m downwards. Sonication, however, broadens slightly the transition peak and tends to shift T-m upwards suggesting that extrusion and sonication form vesicles with different characteristics. DODAC always exhibits higher T-m than DODAB irrespective of the preparation method. T-m changes as follows: T-m (sonicated) greater than or equal to T-m (non-sonicated) > T-m (extruded). Hysteresis of about 7 degrees C was observed for DODAB vesicle dispersions. (C) 2000 Elsevier B.V. Ireland Ltd. All rights reserved.

The Influence of Cutting Speed and Cutting Initiation Location in Specimen Preparation for the Microtensile Bond Strength Test

Purpose: This study evaluated the effect of cutting initiation location and cutting speed on the bond strength between resin cement and feldspathic ceramic.Materials and Methods: Thirty-six blocks (6.4 x 6.4 x 4.8 mm) of ceramic (Vita VM7) were produced. The ceramic surfaces were etched with 10% hydrofluoric acid gel for 60 s and then silanized. Each ceramic block was placed in a silicon mold with the treated surface exposed. A resin cement (Variolink II) was injected into the mold over the treated surface and polymerized. The resin cement-ceramic blocks were divided into two groups according to experimental conditions: a) cutting initiation location - resin cement, ceramic and interface; and b) cutting speed - 10,000, 15,000, and 20,000 rpm. The blocks were sectioned to achieve non-trimmed bar specimens. The microtensile test was performed in a universal testing machine (1 mm/min). The failure modes were examined using an optical light microscope and SEM. Bond strength results were analyzed using one-way ANOVA and Tukey's test (alpha = 0.05).Results: Significant influences of cutting speed and initiation location on bond strength (p < 0.05) were observed. The highest mean was achieved for specimens cut at 15,000 rpm at the interface (15.12 +/- 5.36 MPa). The lowest means were obtained for specimens cut at the highest cutting speed in resin cement (8.50 +/- 3.27 MPa), and cut at the lowest cutting speed in ceramic (8.60 +/- 2.65MPa). All groups showed mainly mixed failure (75% to 100%).Conclusion: The cutting speed and initiation location are important factors that should be considered during specimen preparation for microtensile bond strength testing, as both may influence the bond strength results.