928 resultados para Irrigation system design
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
In the experimental area of the Department of Environmental Sciences (21.85° S; 48.43° W; 786 m), in the School of Agronomical Sciences, UNESP, Botucatu, SP, an experiment was carried out using peanut (Arachis hypogaea L), cv. IAC-TATU-ST, to quantify the crop daily water requirements. During the peanut crop cycle, the environmental variables, such as rainfall, air temperature, air relative humidity, soil matric potential, soil heat flux and radiation balance, have been registered continually. These measurements were used to calculate the daily crop evapotranspiration, by the Bowen ratio method. The water replacement required by the peanut crop was done the dripping irrigation system, oriented by a dynamic agrometeorological model that computes the entrance and exit of water in the soil. During the peanut crop cycle, 9.0 mm of water was used from sowing to emergence; 67.0 mm of water, in the growth stage; 166.0 mm, in the flowering stage; 124.0 mm in the final stage and 46.0 mm from physiological maturity to harvest. Oot of 412.0 mm of the total consumption, 246.0 mm of water was supplied by irrigation and 166.0 mm by the rain. The grain yield was 3.15 t ha-1 for 15% of humidity, and the water use efficiency was 0.764 kg m-3.
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
The aims of this work were to show the pasture irrigation system by center pivot with Brazilian cattle and to discuss the economic feasibility of this technique in different regions of the country. Important parameters to dry matter production of tropical forage plants, as temperature, solar radiation, fertilization, and water requirement were shown Also, the system advantages and disadvantages and a discussion about economic feasibility of this technique were presented. It was concluded that pasture irrigation is a feasible and economical technique to some specific Brazilian regions, depending on appropriated parameters. This work also concludes that just water supply is not enough to assure forage production avoiding reduction in dry production in the winter.
Resumo:
The aim of this study was to evaluate the physico chemical characteristics of water quality for irrigation purposes in the micro basin of Coqueiro, a tributary on the right bank of the São José dos Dourados river, located between the municipalities of Jales, São Francisco, Palmeira d'Oeste and Dirce Reis, in the state of São Paulo, Brazil. Water samples were collected at five geo-referenced points along the stocam and analysed monthly for one year. The parameters analysed were: suspended and dissolved solids, turbidity, electrical conductivity, pH, calcium, magnesium, hardness and total iron. The result showed that the physico chemical parameters had the classification of medium potential for damage to the irrigation system, except total iron, which was classified as having medium to high potential for damage by clogging for localized irrigation systems.
Resumo:
We discuss dynamics of a vibro-impact system consisting of a cart with an piecewise-linear restoring force, which vibrates under driving by a source with limited power supply. From the point of view of dynamical systems, vibro-impact systems exhibit a rich variety of phenomena, particularly chaotic motion. In our analyzes, we use bifurcation diagrams, basins of attractions, identifying several non-linear phenomena, such as chaotic regimes, crises, intermittent mechanisms, and coexistence of attractors with complex basins of attraction. © 2009 by ASME.
Resumo:
Reliability is a key aspect in power system design and planning. Maintaining a reliable power system is a very important issue for their design and operation. Under the new competitive framework of the electricity sector, power systems find ever more and more strained to operate near their limits. Under this new scenario, it is crucial for the system operator to use tools that facilitate an energy dispatch that minimizes possible power cuts. This paper presents a mathematical model to calculate an energy dispatch that considers security constraints (single contingencies in transmission lines and transformers). The model involves pool markets and fixed bilateral contracts. Traditional methodologies that include security constraints are usually based in multistage dispatch processes. In this case, we propose a single-stage model that avoids the economic inefficiencies which result when conventional multi-stage dispatch approaches are applied. The proposed model includes an AC representation of the transport system and allows calculating the cost overruns incurred in due to reliability restrictions. We found that complying with fixed bilateral contracts, when they go above certain levels, might lead to congestion problems in transmission lines.
Resumo:
The objective of this work was to analyze the consumption, electric energy cost, and economic results of irrigated citrus (Citrus sinensis). The treatments consisted of a dripping irrigation system with one and two lateral distribution lines, a micro sprinkler irrigation system and a treatment without irrigation. For each irrigation system, three water depths were used: 100%, 75% and 50% of Etc (citrus evapotranspiration). The electric energy cost for two tariff groups, Group A and Group B, was studied. For Group A, the expenses with energy were determined for the Conventional Binomial Structure tariff, the Hour-seasonal tariff (green and blue) and the special tariff for nocturnal irrigation. The kWh cost for the tariff systems were obtained from the website of CPFL (São Paulo State Power and Light Company, Brazil). The best relation between the electric energy consumption (kWh.ha -1) and productivity (t.ha -1) occurred in the treatment irrigated with 50% of the Etc. The irrigated treatments increased productivity. The biggest productivity was observed in the irrigation treatments with 50% of the Etc when compared to the ones with 100% of the Etc. The blue and green Hour-seasonal tariff system of Group A (nocturnal irrigation) was the best option. A biggest economic turnover occurred in the treatments irrigated with 50% of the Etc.
Resumo:
In order to calculate the daily stress degree of a bean crop submitted to four water regime applications, cover crop and air daily measurements temperatures were accomplished by using a hand-held infrared thermometer. The treatments did not present crop water stress except the control (without irrigation). The highest yield was obtained by the treatment that received less irrigation frequency, and among the treatments that had the same number of irrigation. The largest yield was obtained with the one that received larger amount of applied water. The largest irrigation frequency did not result in larger productivity. The methodologies used for the irrigation planning were efficient for the replacement of soil water. The daily stress degree index was effective in determining crop water stress; and it was reliable presenting negative values in good water soil condition.
Resumo:
The work was realized at the Laboratório de Ensaio de Equipamentos de Irrigação do Departamento de Engenharia Rural da Universidade Estadual Paulista FCA- UNESP de Botucatu - SP, it aims evaluated in bench, the flow of a microsprinkler flow with dynamic nominal 43L h-1, before and after the use of gray water. In the first phase were 25 new emitters were separated and performed tests with clean water, at pressures from 50 to 300 kPa. In a second phase the emitters have been submitted 1000h operating with gray water. At the end of this time, the emitters were submitted again into conditions of initial essay, to evaluate the new costume water effect on medium flow from microsprinkler. At the end we can see that the average flow of the emitters, after use, has declined compared to the emitters discharge before use in 6,6%, the coefficient of variation after use was 5,1%, increased in proportion the coefficient of initial production was 4,3%, the R 2 fell from 0.9946 to 0.9898 and the microsprinkler continued with a high rating, according to the ABNT and ASAE.
Resumo:
Este artigo mostra a dinâmica da água após ser aplicada sobre a superfície de um solo cultivado com alface, num sistema fechado de um ambiente protegido. A aplicação de água se deu por meio de um sistema de irrigação por gotejamento, com o CUD ( Coeficiente de Uniformidade de Distribuição ) igual a 97,06 %, o que garantiu uma ótima uniformidade de distribuição, desconsiderando como possíveis causas das variações de umidade do solo, a aplicação de lâminas variadas. Fazendo uso de técnicas de geoestatística, interpolando sessenta pontos amostrais de evaporação, umidade do solo e produtividade da alface, com as mesmas sessenta coordenadas para os três atributos, verificou-se que a umidade do solo, mesmo momentos após a irrigação, não permanece uniforme ao longo do sistema de irrigação, constatando-se que a evaporação local exerce influência de forma predominante sobre a dinâmica da água na superfície do solo. Concluiu-se que as regiões no interior da estufa de maiores evaporações, foram as de maiores variações de umidade do solo e na produção de massa verde da alface.
Resumo:
The irrigation scheduling is basically the adoption of pre-established criteria to define the time and the amount of water to be applied through irrigation systems. Hence, the objective of this work was to develop and test a spreadsheet of easy comprehension, handling and interpretation by growers, which uses as inputs the physical-hydric soil attributes and tensiometer readings to the determination of irrigation depth and time. The spreadsheet enables the grower to make reading and to know in a fast way how much water to apply into the soil. The test of the spreadsheet was performed in an irrigated orchard of grapevines in Petrolina, State of Pernambuco, Brazil. Soil water retention curves and tensiometer readings from the effective rooting depth were used as a basis for obtaining the soil water matric potential, soil water content, water availability, soil water content to be replaced, net and gross irrigation depth and irrigation time. The analysis of the use of the irrigation scheduling spreadsheet resulted in a shorter time for irrigation in relation to the irrigation scheduling based only on the crop evapotranspiration. The spreadsheet can be helpful to growers adjust irrigation depth when irrigation scheduling is based only on crop evapotranspiration.
Resumo:
The objective of this work was to analyze the most appropriate management to achieve higher productivity for carioca beans (phaseolus vulgaris) and pearll cultivar. The research was developed in the Demonstrative and Experimental Area of Irrigation (ADEI) of FCAV/UNESP, Campus of Jaboticabal, SP. Four treatments were used: T1- irrigation with base in ETo estimated by the method of Class A pan; T2- irrigations based on the readings of tensiometers installed at 0,20 m and 0,40 m of depth; T3- irrigations carried out with base in ETo estimated by the method of Penman-Monteith and T4- witness. The results were submitted to analysis of variance. To compare the averages the test Turkey was used at 5% of probability. The treatment T3 had smaller applied water depth than the treatments T1 and T2, and also smaller productivity. The conclusion is that the treatments irrigated with larger frequency showed higher production of grains.
Resumo:
The soybean culture is part of crop rotation used by irrigators from the southwestern region of São Paulo State that perform no-tillage soil management as a form of sustainable soil use. The objective of this work was to evaluate the effect of this conservationist practice on physicalhydric properties, soil compaction, root development, and soybean culture production components in relation to the conventional management. The experiment was conducted at the Buriti-Mirim Farm, Angatuba, SP, in Brazil, using an area irrigated by a center pivot system divided into two types of soil management: conventional and no-tillage. Although the no-tillage management presented higher soil density, lower water available and lower soil resistance to penetration, both soil managements showed no difference in relation to root development.
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)