Individual and combined additions of calcium and antimony on microstructure and mechanical properties of squeeze-cast AZ91D magnesium alloy

The effects of combined additions of Ca and Sb on the microstructure and tensile properties of AZ91D alloy fabricated by squeeze-casting have been investigated. For comparison, the same has also been studied with and without individual additions of Ca and Sb. The results indicate that both individual and combined additions refine the grain size and beta-Mg17Al12 phase, which is more pronounced with combined additions. Besides alpha-Mg and beta-Mg17Al12 phases, a new reticular Al2Ca and rod-shaped Mg3Sb2 phases are formed following individual additions of Ca and Sb in the AZ91D alloy. With combined additions, an additional Ca2Sb phase is formed suppressing Mg3Sb2 phase. Additions of both Ca and Sb increase yield strength (YS) at both ambient and elevated temperatures up to 200 degrees C. However, both ductility and ultimate tensile strength (UTS) decrease first up to 150 degrees C and then increase at 200 degrees C. The increase in YS is attributed to the refinement of grain size, whereas, ductility and UTS are deteriorated by the presence of brittle Al2Ca, Mg3Sb2 and Ca2Sb phases. The best tensile properties are obtained in the AZXY9110 alloy owing to the presence of lesser amount of brittle Al2Ca and Ca2Sb phases resulted from the optimum content of 1.0Ca and 0.3Sb (wt%). The fracture surface of the tensile specimen tested at ambient temperature reveals cleavage failure that changes to quasi-cleavage at 200 degrees C. The squeeze-cast alloys exhibited better tensile properties as compared to that of the gravity-cast alloys nullifying the detrimental effects of Ca and/or Sb additions. (C) 2014 Elsevier B.V. All rights reserved.

Piezoelectric properties of individual nanocrystallites of Ba0.85Ca0.15Zr0.1Ti0.9O3 obtained by oxalate precursor route

Nanocrystalline Ba0.85Ca0.15Zr0.1Ti0.9O3 (BCZT) powder was synthesized via the complex oxalate precursor route at a relatively low temperature (800 degrees C/5 h). The phase formation temperature of BCZT at nanoscale was confirmed by thermogravimetric (TG), differential thermal analysis (DTA) followed by X-ray powder diffraction (XRD) studies. Fourier transform infrared (FTIR) spectroscopy was carried out to confirm the complete decomposition of oxalate precursor into BCZT phase. The XRD and profile fitting revealed the coexistence of cubic and tetragonal phases and was corroborated by Raman study. Transmission electron microscopy (TEM) carried out on 800 degrees C and 1000 degrees C/5 h heat treated BCZT powder revealed the crystallite size to be in the range of 20-50 nm and 40-200 nm respectively. The optical band gap for BCZT nanocrystalline powder was obtained using Kubelka Munk function and was found to be around 3.12 +/- 0.02 eV and 3.03 +/- 0.02 eV respectively for 800 degrees C (20-50 nm) and 1000 degrees C/5 h (40-200 nm) heat treated samples. The piezoelectric properties were studied for two different crystallite sizes (30 and 70 nm) using a piezoresponse force microscope (PFM). The d(33) coefficients obtained for 30 nm and 70 nm sized crystallites were 4 pm V-1 and 47 pm V-1 respectively. These were superior to that of BaTiO3 nanocrystal (approximate to 50 nm) and promising from a technological/industrial applications viewpoint.

Magnitude and Origin of Electrical Noise at Individual Grain Boundaries in Graphene

Grain boundaries (GBs) are undesired in large area layered 2D materials as they degrade the device quality and their electronic performance. Here we show that the grain boundaries in graphene which induce additional scattering of carriers in the conduction channel also act as an additional and strong source of electrical noise especially at the room temperature. From graphene field effect transistors consisting of single GB, we find that the electrical noise across the graphene GBs can be nearly 10 000 times larger than the noise from equivalent dimensions in single crystalline graphene. At high carrier densities (n), the noise magnitude across the GBs decreases as proportional to 1/n, suggesting Hooge-type mobility fluctuations, whereas at low n close to the Dirac point, the noise magnitude could be quantitatively described by the fluctuations in the number of propagating modes across the GB.

Relationship between prion propensity and the rates of individual molecular steps of fibril assembly.

Peptides and proteins possess an inherent propensity to self-assemble into generic fibrillar nanostructures known as amyloid fibrils, some of which are involved in medical conditions such as Alzheimer disease. In certain cases, such structures can self-propagate in living systems as prions and transmit characteristic traits to the host organism. The mechanisms that allow certain amyloid species but not others to function as prions are not fully understood. Much progress in understanding the prion phenomenon has been achieved through the study of prions in yeast as this system has proved to be experimentally highly tractable; but quantitative understanding of the biophysics and kinetics of the assembly process has remained challenging. Here, we explore the assembly of two closely related homologues of the Ure2p protein from Saccharomyces cerevisiae and Saccharomyces paradoxus, and by using a combination of kinetic theory with solution and biosensor assays, we are able to compare the rates of the individual microscopic steps of prion fibril assembly. We find that for these proteins the fragmentation rate is encoded in the structure of the seed fibrils, whereas the elongation rate is principally determined by the nature of the soluble precursor protein. Our results further reveal that fibrils that elongate faster but fracture less frequently can lose their ability to propagate as prions. These findings illuminate the connections between the in vitro aggregation of proteins and the in vivo proliferation of prions, and provide a framework for the quantitative understanding of the parameters governing the behavior of amyloid fibrils in normal and aberrant biological pathways.

Electrical and field emission investigation of individual carbon nanotubes from plasma enhanced chemical vapour deposition

Plasma enhanced chemical vapour deposition (PECVD) is a controlled technique for the production of vertically aligned multiwall carbon nanotubes for field emission applications. In this paper, we investigate the electrical properties of individual carbon nanotubes which is important for designing field emission devices. PECVD nanotubes exhibit a room temperature resistance of 1-10 kΩ/μm length (resistivity 10-6 to 10-5 Ω m) and have a maximum current carrying capability of 0.2-2 mA (current density 107-108 A/cm2). The field emission characteristics show that the field enhancement of the structures is strongly related to the geometry (height/radius) of the structures and maximum emission currents of ∼ 10 μA were obtained. The failure of nanotubes under field emission is also discussed. © 2002 Elsevier Science B.V. All rights reserved.

Self-aligned, gated arrays of individual nanotube and nanowire emitters

We demonstrate the production of integrated-gate nanocathodes which have a single carbon nanotube or silicon nanowire/whisker per gate aperture. The fabrication is based on a technologically scalable, self-alignment process in which a single lithographic step is used to define the gate, insulator, and emitter. The nanotube-based gated nanocathode array has a low turn-on voltage of 25 V and a peak current of 5 μA at 46 V, with a gate current of 10 nA (i.e., 99% transparency). These low operating voltage cathodes are potentially useful as electron sources for field emission displays or miniaturizing electron-based instrumentation.

Sistemas eleitorais, quotas e representação feminina

Consultoria Legislativa - Área XIX - Ciência Política, Sociologia Política, História, Relações Internacionais.

Individual notions of distributive justice and relative economic status

We present two experiments designed to investigate whether individuals’ notions of distributive justice are associated with their relative (within-society) economic status. Each participant played a specially designed four-person dictator game under one of two treatments, under one initial endowments were earned, under the other they were randomly assigned. The first experiment was conducted in Oxford, United Kingdom, the second in Cape Town, South Africa. In both locations we found that relatively well-off individuals make allocations to others that reflect those others’ initial endowments more when those endowments were earned rather than random; among relatively poor individuals this was not the case.

Endogenous fisheries management in a stochastic model: Why do fishery agencies use TAC

The aim of this paper is to explain under which circumstances using TACs as instrument to manage a fishery along with fishing periods may be interesting from a regulatory point of view. In order to do this, the deterministic analysis of Homans and Wilen (1997)and Anderson (2000) is extended to a stochastic scenario where the resource cannot be measured accurately. The resulting endogenous stochastic model is numerically solved for finding the optimal control rules in the Iberian sardine stock. Three relevant conclusions can be highligted from simulations. First, the higher the uncertainty about the state of the stock is, the lower the probability of closing the fishery is. Second, the use of TACs as management instrument in fisheries already regulated with fishing periods leads to: i) An increase of the optimal season length and harvests, especially for medium and high number of licences, ii) An improvement of the biological and economic variables when the size of the fleet is large; and iii) Eliminate the extinction risk for the resource. And third, the regulator would rather select the number of licences and do not restrict the season length.

Proceedings of the International Workshop responding to HIV and AIDS in the fishery sector in Africa, Lusaka, Zambia, 21-22 February 2006

The purpose of the workshop was to enable professionals and organizations working with fishing communities in response to HIV and AIDS in Africa to share experiences, appraise the efficacy of their approaches and identify actions in research and development that will further improve their impact. The workshop pursued and achieved the following objectives: 1)Review and compare research findings and approaches applied in response to HIV and AIDS in fishing communities and the wider fishery sector. 2)Identify good practice examples for wider application. 3)Identify next steps in development and research to scale up these examples. 4)Initiate a network of practitioners in Africa for capacity building, scaling-up and further development of approaches. The range of papers presented at the conference reveals the diversity of responses to HIV and AIDS in the fishery sector at all levels. The papers discussed a range of issues within this broad remit, from community level impacts of disease to policy implementation, from spatial mapping to theatre as a mode of communication. (Document contains 92 pages)

Review of California halibut trawl fishery in the California halibut trawl grounds

(Document pdf contains 44 pages)

Subcutaneous fat composition of youthful and mature Canadian beef: emphasis on individual conjugated linoleic acid and trans-18:1 isomers

[EN]A comprehensive evaluation of the fatty acid composition of subcutaneous adipose tissue from beef cattle produced in western Canada was undertaken to determine if the current Canadian grading system is able to distinguish classes of animals with value added potential due to their fatty acid composition. Grades included youthful Canadian Yield Grade 1 A/AA beef, under (YUTM) and over (YOTM) 30 mo of age and the four mature grades (D1, D2, D2 and D4). Subcutaneous fat between the 12th and 13th ribs over the longissimus muscle was obtained from 18_21 animals per grade. Fatty acids were analyzed using a combination of silver-ion HPLC and GC with a highly polar 100 m column. There were no differences in total trans-18:1 content amongst grades, but adipose tissue from grade D1, D2 and D4 had more 11t-18:1 than YUTM (PB0.05), whereas adipose tissue from YUTM carcasses had more 10t-18:1 than all other grades (PB0.05). Adipose tissue from YUTM carcasses also had less total CLA (PB0.05) than the D grades, mainly due to a lower level of 9c,11t-CLA, but they had slightly more 7t,9c-CLA and 10t,12c-CLA (PB0.05). Adipose tissue from YOTM and D grades contained more n-3 fatty acids relative to YUTM (0.56% vs. 0.29%; PB0.05) and lower n-6:n-3 ratios (PB0.05). Overall, older animals (YOTM and D grades) had adipose tissue compositions with higher levels of fatty acids with reported health benefits. Taken together, these higher levels may provide opportunities for value added marketing if regulatory authorities allow claims for their enrichment based on demonstrated health benefits. Higher concentrations of beneficial fatty acids, however, need to be considered within the context of the complete fatty acid profile and it would be important to demonstrate their advantages in the presence of relatively high levels of saturated fatty acids.