Development of bacterial and archaeal communities in erupted subsurface muds at the Håkon Mosby mud volcano

The microbial oxidation of methane controls the emission of the greenhouse gas methane from the ocean floor. However, some seabed structures such as mud volcanoes have leaky microbial methane filters and can be important sources of methane. We investigated the disturbance and recovery of a methanotrophic mud volcano microbiome (Håkon Mosby mud volcano, 1250 m water depth), to assess time scales of community succession and function in the natural deep-sea environment. We analyzed 10 surface and 5 subsurface sediment samples across HMMV mud flows from most recently discharged subsurface muds towards old consolidated muds as well as one reference site (REF) located approximately 0.5 km outside of the HMMV. Surface samples were obtained in 2003, 2009 and 2010. The surface of the new mud flows at the geographical center was sampled in 2009 and 2010. Around 100 m south of the center, we sampled more consolidated aged muds in 2003 and 2010. Old mud flows were sampled around 300 m southeast and 100 m north of the geographical center in 2003, 2009 and 2010. Surface sediment samples (0-20 cm) were recovered either by TV-guided Multicorer or by push cores using the remotely operated vehicle Quest (Marum, University Bremen). Subsurface sediments of all zones (>2 m below sea floor) were obtained in 2003 by gravity corer. After recovery, sediments were immediately subsampled in a refrigerated container (0°C) and further processed for biogeochemical analyses or preserved at -20°C for later DNA analyses. Our study show that freshly erupted muds hosted heterotrophic deep subsurface communities, which were replaced by surface communities within a few years of exposure. Aerobic methanotrophy was established at the top surface layer within less than a year, followed by anaerobic methanotrophy, sulfate reduction and finally thiotrophy. Our data indicate that it takes decades in cold environments before efficient methanotrophic communities establish to control methane emission. The observed succession provides insights to the response time of complex deep-sea communities to seafloor disturbances.

Pore water geochemistry of arctic deep sea sediments measured at station MSM16/2_809-1 (REF, Reference)

Pore water and turnover rates were determined for surface sediment cores obtained in 2009 and 2010. The pore water was extracted with Rhizons (Rhizon CSS: length 5 cm, pore diameter 0.15 µm; Rhizosphere Research Products, Wageningen, Netherlands) in 1 cm-resolution and immediately fixed in 5% zinc acetate (ZnAc) solution for sulfate, and sulfide analyses. The samples were diluted, filtered and the concentrations measured with non-suppressed anion exchange chromatography (Waters IC-Pak anion exchange column, waters 430 conductivity detector). The total sulfide concentrations (H2S + HS- + S**2-) were determined using the diamine complexation method (doi:10.4319/lo.1969.14.3.0454). Samples for dissolved inorganic carbon (DIC) and alkalinity measurements were preserved by adding 2 µl saturated mercury chloride (HgCl2) solution and stored headspace-free in gas-tight glass vials. DIC and alkalinity were measured using the flow injection method (detector VWR scientific model 1054) (doi:10.4319/lo.1992.37.5.1113). Dissolved sulfide was eliminated prior to the DIC measurement by adding 0.5 M molybdate solution (doi:10.4319/lo.1995.40.5.1011). Nutrient subsamples (10 - 15 ml) were stored at - 20 °C prior to concentration measurements with a Skalar Continuous-Flow Analyzer (doi:10.1002/9783527613984).

(Table 1) Porewater analysis with respect to gypsum from different ODP holes

The stability of gypsum in marine sediments has been investigated through the calculation of its saturation index at the sediment in situ temperature and pressure, using the entire ODP/IODP porewater composition database (14416 samples recovered from sediments collected during 95 ODP and IODP Legs). Saturation is reached in sediment porewaters of 26 boreholes drilled at 23 different sites, during 12 ODP/IODP Legs. As ocean bottom seawater is largely undersaturated with respect to gypsum, the porewater Ca content or its SO4 concentration, or both, must increase in order to reach equilibrium. At several sites equilibrium is reached either through the presence of evaporitic gypsum layers found in the sedimentary sequence, and/or through a salinity increase due to the presence of evaporitic brines with high concentrations of Ca and SO4. Saturation can also be reached in porewaters of seawater-like salinity (~ 35 per mil), provided sulfate reduction is limited. In this case, saturation is due to the alteration of volcanogenic material which releases large amounts of Ca to the porewaters, where the Ca concentration can reach 55 times its seawater value as for example at ODP Leg 134 site 833. At a few sites, saturation is reached in hydrothermal environments, or as a consequence of the alteration of the basaltic basement. In addition to the well known influence of brines on the formation of gypsum, these results indicate that the alteration of sediments rich in volcanogenic material is a major process leading to gypsum saturation in marine sediment porewaters. Therefore, the presence of gypsum in ancient and recent marine sediments should not be systematically interpreted as due to hypersaline waters, especially if volcanogenic material is present.