Image Analysis for the Characterization of Materials for Highway Construction : Phase I, Progress Report, HR-346, 1992

The major objective of this project is to evaluate image analysis for characterizing air voids in Portland cement contract (PCC) and asphalt concrete (AC) and aggregate gradation in asphalt concrete. Phase 1 of this project has concentrated on evaluation and refinement of sample preparation techniques, evaluation of methods and instruments for conducting image analysis, and finally, analysis and comparison of a select portion of samples. Preliminary results suggest a strong correlation between the results obtained from the linear traverse method and image analysis methods for determining percent air voids in concrete. Preliminary work with asphalt samples has shown that damage caused by a high vacuum of the conventional scanning electron microscope (SEM) may too disruptive. Alternative solutions have been explored, including confocal microscopy and low vacuum electron microscopy. Additionally, a conventional high vacuum SEM operating at a marginal operating vacuum may suffice.

Granular Base Materials for Flexible Pavements, HR-131, 1970

The coefficients of relative strength (CORS) of base courses for use in the American association state highway officials (AASHO) interim guide for the design of flexible pavements are determined here. Based on (1) volumetric strain--axial strain relationships at minimum volume, and (2) effective stress ratio-cohesion relationships at maximum effective stress ratio, CORS were determined from the results of laboratory triaxial tests on both asphalt-treated and untreated aggregate base course materials. The researchers conclude that volumetric strain-axial strain at minimum volume appear to be appropriate parameters for determining CORS.

Geologic and Engineering Properties of Pleistocene Materials in Iowa, Iowa Highway Research Board Bulletin No. 20, 1960

This bulletin is a compilation of the reports on completed research done for the Iowa State Highway Research Board Project HR-1, "The Loess and Glacial Till Materials of Iowa; an Investigation of Their Physical and Chemical Properties and Techniques for Processing Them to Increase Their All-Weather Stability for Road Construction.” The research, started in 1950, was done by the Iowa Engineering Experiment Station under its project 283-S. The project was supported by funds from the Iowa State Highway Commission.

Provision of supplementary materials in Library and Information Science scholarly journals

Purpose This study seeks to analyse the policies of library and information science (LIS) journals regarding the publication of supplementary materials, the number of journals and articles that include this feature, the kind of supplementary materials published with regard to their function in the article, the formats employed and the access provided to readers. Design/methodology/approach The study analysed the instructions for authors of LIS journals indexed in the ISI Journal Citation Reports, as well as the supplementary materials attached to the articles published in their 2011 online volumes. Findings Large publishers are more likely to have a policy regarding the publication of supplementary materials, and policies are usually homogeneous across all the journals of a given publisher. Most policies state the acceptance of supplementary materials, and even journals without a policy also publish supplementary materials. The majority of supplementary materials provided in LIS articles are extended methodological explanations and additional results in the form of textual information in PDF or Word files. Some toll-access journals provide open access to any reader to these files. Originality/value This study provides new insights into the characteristics of supplementary materials in LIS journals. The results may be used by journal publishers to establish a policy on the publication of supplementary materials and, more broadly, to develop data sharing initiatives in academic settings.

New trends in the kitchen: propellants assessment of edible food aerosol sprays used on food.

New products available for food creations include a wide variety of "supposed" food grade aerosol sprays. However, the gas propellants used cannot be considered as safe. The different legislations available did not rule any maximum residue limits, even though these compounds have some limits when used for other food purposes. This study shows a preliminary monitoring of propane, butane and dimethyl ether residues, in cakes and chocolate after spraying, when these gases are used as propellants in food aerosol sprays. Release kinetics of propane, butane and dimethyl ether were measured over one day with sprayed food, left at room temperature or in the fridge after spraying. The alkanes and dimethyl ether analyses were performed by headspace-gas chromatography-mass spectrometry/thermal conductivity detection, using monodeuterated propane and butane generated in situ as internal standards. According to the obtained results and regardingthe extrapolations of the maximum residue limits existing for these substances, different delays should be respected according to the storage conditions and the gas propellant to consume safely the sprayed food.

Els materials arqueològics del jaciment ibèric de la Serra de l’Espasa (Capçanes, Priorat) dipositats al Museu d’Arqueologia Salvador Vilaseca de Reus: evidències d’un santuari?

En aquest treball presentem una revisió del jaciment ibèric de la Serra de l’Espasa (Capçanes, Priorat) a partir de l’estudi, amb criteris actualitzats, del material conservat en el Museu Salvador Vilaseca de Reus. Els resultats són contrastats amb les darreres investigacions arqueològiques desenvolupades en el curs inferior de l’Ebre. A l’últim, s’analitzen les possibles interpretacions d’aquest conjunt, en particular la hipotètica existència d’un santuari, i les seves implicacions en el procés de romanització en aquesta zona.

Nou portal d'accés als materials en obert de la UdG : DUGi 2.0

La Biblioteca de la Universitat de Girona és l'encarregada de coordinar els repositoris digitals de la Universitat. A l'inici el repositori neix de la necessitat de difondre i preservar tota la recerca de la Universitat, però mica en mica el projecte va creixent i es creen diferents repositoris per a diferents tipus de continguts. Així es creen els repositoris DUGiDocs, DUGiMedia i DUGiFonsEspecials.L'objectiu d'aquest PFC és desenvolupar un portal web amb un sistema d'indexació que permeti la cerca per diferents criteris com, per exemple, autor, matèria i títol. L'entorn ha de tenir un disseny agradable per a l'usuari final i ha de permetre obtenir les dades del repositori que se li indiquin. També ha de ser capaç de detectar els possibles duplicats en els criteris de cerca i notificar-ho a l'administrador

Nou portal d'accés als materials en obert de la UdG : DUGi 2.0

La Biblioteca de la Universitat de Girona és l'encarregada de coordinar els repositoris digitals de la Universitat. A l'inici el repositori neix de la necessitat de difondre i preservar tota la recerca de la Universitat, però mica en mica el projecte va creixent i es creen diferents repositoris per a diferents tipus de continguts. Així es creen els repositoris DUGiDocs, DUGiMedia i DUGiFonsEspecials.L'objectiu d'aquest PFC és desenvolupar un portal web amb un sistema d'indexació que permeti la cerca per diferents criteris com, per exemple, autor, matèria i títol. L'entorn ha de tenir un disseny agradable per a l'usuari final i ha de permetre obtenir les dades del repositori que se li indiquin. També ha de ser capaç de detectar els possibles duplicats en els criteris de cerca i notificar-ho a l'administrador

Analysis of thermal properties of phase change materials (PCM) using differential scanning calorimeter (DSC)

Commercially available PCM RT 20, RT 27, SP 22, A17 and SP 25 A8. Were analyzed using dynamic and step method of heat flux DSC. The results of the dinamic and step method were compared with commercial valures. It was found that RT 20 & RT 27 showed good conforming of results with commercial values while SP 22 A17 & SP 25 A8 did not show conformity.

Improvement of the thermal performance of commercial freezers using phase change materials (PCM)

The aim of this work is to improve the thermal performance of commercial freezers using phase change materials (PCM) and the prove the importance of the correct PCM selection (melting temperature) for each application. To do this a vertical freezer with and without macro encapsulation PCM are used to assess the benefits of using PCM in minimizing temperature fluctuations and to maintain at the lowest possible temperature the freezer under heat of losses.

Theoretical Analysis and Simulations of Vertically Vibrated Granular Materials

The dynamical properties ofshaken granular materials are important in many industrial applications where the shaking is used to mix, segregate and transport them. In this work asystematic, large scale simulation study has been performed to investigate the rheology of dense granular media, in the presence of gas, in a three dimensional vertical cylinder filled with glass balls. The base wall of the cylinder is subjected to sinusoidal oscillation in the vertical direction. The viscoelastic behavior of glass balls during a collision, have been studied experimentally using a modified Newton's Cradle device. By analyzing the results of the measurements, using numerical model based on finite element method, the viscous damping coefficient was determinedfor the glass balls. To obtain detailed information about the interparticle interactions in a shaker, a simplified model for collision between particles of a granular material was proposed. In order to simulate the flow of surrounding gas, a formulation of the equations for fluid flow in a porous medium including particle forces was proposed. These equations are solved with Large Eddy Simulation (LES) technique using a subgrid-model originally proposed for compressible turbulent flows. For a pentagonal prism-shaped container under vertical vibrations, the results show that oscillon type structures were formed. Oscillons are highly localized particle-like excitations of the granular layer. This self-sustaining state was named by analogy with its closest large-scale analogy, the soliton, which was first documented by J.S. Russell in 1834. The results which has been reportedbyBordbar and Zamankhan(2005b)also show that slightly revised fluctuation-dissipation theorem might apply to shaken sand, which appears to be asystem far from equilibrium and could exhibit strong spatial and temporal variations in quantities such as density and local particle velocity. In this light, hydrodynamic type continuum equations were presented for describing the deformation and flow of dense gas-particle mixtures. The constitutive equation used for the stress tensor provides an effective viscosity with a liquid-like character at low shear rates and a gaseous-like behavior at high shear rates. The numerical solutions were obtained for the aforementioned hydrodynamic equations for predicting the flow dynamics ofdense mixture of gas and particles in vertical cylindrical containers. For a heptagonal prism shaped container under vertical vibrations, the model results were found to predict bubbling behavior analogous to those observed experimentally. This bubbling behavior may be explained by the unusual gas pressure distribution found in the bed. In addition, oscillon type structures were found to be formed using a vertically vibrated, pentagonal prism shaped container in agreement with computer simulation results. These observations suggest that the pressure distribution plays a key rolein deformation and flow of dense mixtures of gas and particles under vertical vibrations. The present models provide greater insight toward the explanation of poorly understood hydrodynamic phenomena in the field of granular flows and dense gas-particle mixtures. The models can be generalized to investigate the granular material-container wall interactions which would be an issue of high interests in the industrial applications. By following this approach ideal processing conditions and powder transport can be created in industrial systems.

Transport i emmagatzematge de les àmfores en l'antiguitat:l'aportació de les ciències dels materials

[spa]Las ánforas son ejemplos claros de cerámicas utilitarias que requieren de unas características técnicas necesarias para cumplir su funcionalidad: servir de envase de almacenamiento y transporte. En este trabajo se propone el estudio del comportamiento funcional de estos envases a través de la evaluación de las propiedades mecánicas de resistencia y tenacidad a la fractura. Propiedades mecánicas, ámforas ibéricas, ámforas romanas, tecnología, funcionalidad.

Comparison of fatty acid profiles of edible meat, adipose tissues and muscles between cocks and capons

The effect of caponisation on fat composition by parts (wing, breast, thigh, and drumstick) and tissues (skin, subcutaneous adipose tissue, intermuscular adipose tissue and muscle) was examined in the present study and fatty acid profiles of abdominal fat and edible meat by parts and tissue components were determined. The sample was made up of twenty-eight castrated and twenty male Penedesenca Negra chicks reared under free-range conditions and slaughtered at 28 wk of age; the birds were castrated at four or eight weeks. Caponisation significantly increased (P < 0.01) the chemical fat content in all parts (16.31% to 37.98% in breast; 21.98% to 34.13% in wing; 21.09% to 49.57% in thigh; 14.33% to 24.82% in drumstick) and led to minor modifications in fat haracteristics, particularly in the thigh and the drumstick, where the unsaturated vs. saturated fatty acid ratio increased from 1.31 to 1.76 ( P < 0.01) and from 1.48 to 2.07 (P < 0.01), respectively. Delaying the age of castration from 4 to 8 weeks increased this ratio by 0.35 in the edible meat. Even though the profile of the abdominal fat is less saturated in capons, all changes occurring on fat quality after caponisation indicate that increased fatness after castration does not imply worse fat nutritional properties.

Revegetació de talussos d'una explotació carbonífera mitjançant materials de rebuig

En aquest treball s'avalua la rehabilitació dels talussos d'una explotació minera carbonífera utilitzant materials de rebuig de la pròpia explotació i provinents d'activitats ramaderes (purins de porc) o urbanes (llots de depuradora), en un ambient àrid del Baix Segre. Les variables analitzades foren el tipus i recobriment vegetals, la penetromia i la salinitat del substrat, i la salinitat, els nitrats i els sediments dels efluents. Els resultats indiquen que és possible rehabilitar els runams en aquests medis, assolint recobriments vegetals fins al 50 % sense que se'n derivin efectes ambientals negatius importants. Taxes altes puntuals d'erosió poden controlar-se amb un disseny adient dels talussos. L'aplicació superficial de purí no té efectes antiencrostants. La moderada salinitat dels substrats condiciona l'establiment de vegetació halòfila.