988 resultados para 1050°
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
Precipitation of FeTiP is reported to occur in Ti-added IF steels containing high P during thermomechanical processing. An ultra-low carbon (ULC) Nb-added steel ingot containing a higher P content (< 0.8 wt-%) was produced via aluminothermic reduction of Fe2O3 followed by double electron beam melting (EBM). FeNbP coarse precipitates were observed in the as-cast microstructure. After soaking at 1050
Resumo:
Due to the increasing search for alternative sources of natural rubber (NR) whose properties are similar to Hevea brasiliesis, several sources have been studied in the past few years. Among them, Mangabeira (Hancornia speciosa Gomes), which is native to Amazon rainforest and other regions of Brazil, has a potential as another viable rubber source. As a continuation of a series of comparative studies between Hancornia and Hevea (clone RRIM 600) these two species by our research team, their thermal behavior was analyzed by thermogravimetry (TG) using Flynn-Wall-Ozawa's approach in order to obtain kinetic parameters (reaction order, pre-exponential factor and activation energy) of the decomposition process. Results indicated that the thermal behavior of NR from Hancornia was comparable to Hevea with some differences observed as follows: reaction order for Hancornia was higher than for Hevea at the beginning of degradation and very close for temperatures over 350 A degrees C; activation energy and pre-exponential factor had the same trend, i.e., increased with increasing degree of conversion remaining almost constant between 20 and 70% and then increasing for higher degrees, although Hevea was slightly more thermally stable than Hancornia. These major influences in the degradation process in the early stage are attributed to differences in non-rubber constituents present in these two species.
Resumo:
Different compositions of Ni0,5-xCuxZn0,5Fe2O4 and Ni0,5-xCoxZn0,5Fe2O4 0 ≤ x ≤ 0.3 were synthesized ferrite y the citrate precursor method. The stoichiometric compositions were calcined in air at 350°C and then pressed into pellets and toroids. The pressed samples were sintered at temperatures of 1000, 1050 and 1100°C/3h in air control at the speed of heating and cooling. The calcined powders were characterized by XRD, TGA / DTG, FTIR, SEM and vibrating sample magnetometry (VSM) and the sintered samples by XRD, SEM, MAV, density and measurements of permeability and magnetic losses. There was pure phase formation ferrimagnetism applied at all temperatures except for A-I composition at all sintering temperatures and A-II only at a temperature of 1100°C. Crystallite sizes were obtained by Rietveld analysis, nanometer size from 11 to 20 nm for the calcined powders. For SEM, the sintered samples showed grain size between 1 and 10 micrometers. Bulk density (ρ) of sintered material presented to the Families almost linear behavior with increasing temperature and a tendency to decrease with increasing concentration of copper, different behavior of the B Family, where the increase in temperature decreased the density. The magnetic measurements revealed the powder characteristics of a soft ferrimagnetic material. Two processes of magnetization were considered, the superparamagnetism at low temperatures (350°C) and the formation of magnetic domains at higher temperatures. Obtaining the best parameters for P and B-II magnetic ferrites at high temperatures. The sintered material at 1000°C showed a relative permeability (μ) from 50 to 800 for the A Family and from 10 to 600 for the B Family. The samples sintered at 1100°C, B Family showed a variation from 10 to 1000 and the magnetic loss (tan δ) of A and B Families, around of 1. The frequency response of the toroidal core is in the range of 0.3 kHz. Several factors contribute to the behavior of microstructure considering the quantities μ and tan δ, such as the grain size, inter-and intragranular porosity, amount of grain boundary and the aspects of the dynamics of domain walls at high frequencies.
Resumo:
This study analyses the blink reflex in 20 adult male patients with terminal chronic renal failure undergoing hemodialysis. Abnormalities were found in ten patients (50%), eight of them with conduction studies showing axonal peripheral neuropathy. Dialysis time was longer for patients with blink reflex alterations (median 55.1 months) than for patients with normal blink reflex (median 36.3 months). Different types of early R1 and late R2 component abnormalities were recorded. The late response abnormalities may indicate subclinical functional or anatomical impairment of the low brainstem reticular formation in patients with chronic renal failure. (C) 2002 Elsevier B.V. Ltd. All rights reserved.
Resumo:
The participation of the superior belly of the omohyoid muscle and anterior belly of the digastric muscle in tongue and head movements was studied eletromyographically in 20 normal young volunteers. A pair of monopolar electrodes was used in each muscle for simultaneous recording of their actions. The muscles act in the following tongue movements: protrusion, right and left lateral movements, placement of the tip of the tongue on soft and hard palates and on the floor of the mouth. The strongest levels of activity of the superior belly of the omohyoid muscle were observed in the placement of the tip of the tongue on the soft palate, coincidentally with a greater dislocation of hyoid bone. Both of the muscles studied did not participate in the head's kinesiology. (C) 1999 Elsevier B.V. Ltd. All rights reserved.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Avaliou-se nível de lisina digestível para 1050 frangos de corte dos 12 aos 22 dias de idade. O delineamento experimental foi inteiramente ao acaso, com cinco tratamentos, sete repetições e 30 aves por unidade experimental. Os tratamentos foram: 1,05; 1,10; 1,15; 1,20 e 1,25% de lisina digestível. Avaliaram-se ganho de peso, consumo de ração, conversão alimentar, composição e deposição de nutrientes corporais. Foram constatados efeitos quadráticos de lisina digestível no consumo de ração e resposta linear ascendente no peso da carcaça. Na composição química da carcaça, houve resposta quadrática do nível de lisina na concentração de proteína. As taxas de deposição proteica, deposição de água, da carcaça e do corpo total tiveram aumento linear em resposta ao acréscimo de lisina na dieta. O aumento da concentração de lisina, todavia, coincidiu com a redução da matéria mineral nas vísceras e sangue e no corpo total. Considerado o desempenho, o nível 1,1% de lisina digestível atendeu às necessidades do frango de corte entre o 12º e o 22º dia de idade. Consideradas a composição química e as taxas de deposição dos nutrientes corporais, a demanda pelo aminoácido digestível torna-se igual ou maior que 1,25%
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Com objetivo de avaliar as estratégias de polinização de espécies de Bignoniaceae, foram estudados a biologia floral e os visitantes florais de cinco espécies, três arbustivas do cerrado (Arrabidaea brachypoda (DC.) Bor., Jacaranda decurrens Cham. e Jacaranda oxyphylla Cham.) e duas lianas da orla da floresta estacional semidecidual (Arrabidaea samydoides (Cham.) Sandw. e Arrabidaea triplinervia H. Baill.), na região de Botucatu (22º52'20 S e 48(0)26'37 W), estado de São Paulo, sudeste do Brasil. Os períodos de florescimento, principalmente entre espécies do mesmo habitat, apresentaram sobreposição parcial. Observou-se que as cinco espécies são alogâmicas funcionais, melitófilas, nototríbicas, polinizadas principalmente por abelhas grandes de língua comprida. Algumas abelhas coletoras de pólen de tamanho médio e pequeno atuaram como polinizadoras ocasionais, enquanto outros visitantes foram pilhadores. Cada uma das Bignoniaceae apresentou um conjunto particular de polinizadores havendo apenas duas espécies comuns a mais de uma delas. Não houve partilha de polinizadores mesmo entre bignoniáceas que, no mesmo habitat, apresentaram períodos de florescimento simultâneo.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Running exercises are frequently related to muscular injuries, which may be a result of muscular imbalance. The present study aimed to verify the effects of heavy-intensity continuous running exercise on the functional and conventional hamstrings: quadriceps ratios, and also in the knee flexors and extensors EMG activity in active non-athletic individuals. Sixteen active males performed maximal isokinetic concentric and eccentric knee flexions and extensions at 60 degrees s(-1) and 180 degrees s(-1). In another session, the same procedure was conducted after a continuous running exercise at 95% onset of blood lactate accumulation. Torque and electromyographic ratios were calculated from peak torque and integrated electromyographic activity (knee flexor and extensors). Creatine kinase was measured before and 24 h after running exercise. Eccentric torque (knee flexion and extension) decreased significantly after running only at 180 degrees s(-1) (p < 0.05). No differences were found for the conventional torque ratios (p > 0.05), however, the functional torque ratios at 180 degrees s(-1) decreased significantly after running (p < 0.05). No effects on the electromyographic activity and electronnyographic ratios were found (p > 0.05). Creatine kinase increased slightly 24 h after running (p < 0.05). Heavy-intensity continuous running exercise decreased knee flexor and extensor eccentric torque, and functional torque ratios under fast velocities (180 degrees s(-1)), probably as result of peripheral fatigue. (C) 2008 Elsevier Ltd. All rights reserved.
Resumo:
The aim of this study was to evaluate the EMG activity of lumbar multifidus (MU), longissimus thoracis (LT) and iliocostalis (IC) muscles during an upper limb resistance exercise (biceps curl). Ten healthy males performed maximal voluntary isometric contraction (MVC) of the trunk extensors, after this, the biceps curl exercise was executed at 25%, 30%, 35% and 40% one repetition maximum during 1 min, with 10 min rest between them. EMG root mean square (RMS) and median frequency (MFreq) were calculated for each lifting and lowering of the bar during the exercise bouts, to calculate slopes and intercepts. The results showed increases in the RMS and decreases in the MFreq slopes. RMS slopes were no different between muscles, indicating similar fatigue process along the exercise irrespective of the load level. MU and LT presented higher RMS irrespective of the load level, which can be related to the specific function during the standing position. on the other hand, IC and MU presented higher MFreq intercepts compared to LT, demonstrating possible differences in the muscle fiber conduction velocity of these muscles. These findings suggest that trunk muscles are differently activate during upper limb exercises, and the fatigue process affects the lumbar muscles similarly. (C) 2008 Elsevier Ltd. All rights reserved.