999 resultados para variational characterisation
Resumo:
Melt-textured YBCO samples processed with added Y2O3 and depleted uranium oxide (DU) contain nano-particles, which have been identified previously as Y2Ba4CuUOx (U-411). This phase has a cubic unit cell, which is clearly distinct from the orthorhombic Y-123 and Y-211 phases within the YBCO system. In samples with a high amount of DU addition (0.8 wt-% DU), U-2411 particles have sizes between 200 nm and several νm, so identification of the Kikuchi patterns of this phase becomes possible. Together with a parallel EDX analysis, the particles embedded in the Y-123 matrix can be identified unambiguously. In this way, a three-phase EBSD scan becomes possible, allowing also the identification of nanometre-sized particles in the sample microstructure. © 2006 IOP Publishing Ltd.
Resumo:
The heterogeneous nature of the subsurface and associated DNAPL morphologies often poses the greatest limitation to source zone clean-up strategies. Hence, detailed site characterisation techniques are required. The data presented in this paper has been collected from a series of laboratory 2-D tank experiments and numerical simulations of Partitioning Interwell Tracer Tests (PITT) in a wide range of aquifer conditions and DNAPL morphologies. Alternative uses of tracer breakthrough data have been developed In order to characterise the mass flux generated from the DNAPL source. By combining the laboratory and numerical data, a relationship between normalised mass flux and tracer-based average source zone DNAPL saturation has been established. Knowledge of such a relationship allows remediation targets to be identified, clean-up efficiencies to be evaluated, and increases the accuracy of any risk assessment.
Resumo:
Attempts have been made to characterize and purify immunoglobulins from the serum of Clarias gariepinus, which has been immunized with bovine serum albumen. Initially, the proteins in the serum were chromatographed successively by affinity chromatography column. The affinity-purified fraction was concentrated and checked in SDS-PAGE, two bands of heavy chain and two bands of light chain were observed. Since teleost immunoglobulins have been shown to belong to a single class, the extra bands in light and heavy chains in the present study might be the breakdown of immunoglobulin or some unpurified contaminants. The affinity-purified fraction was also subjected to gel filtration chromatography column.
Resumo:
Laser-assisted Cold Spray (LCS) is a new coating and fabrication process which combines the supersonic powder beam found in Cold Spray (CS) with laser heating of the deposition zone. LCS retains the advantages of CS; solid-state deposition, high build rate and the ability to deposit onto a range of substrates, while reducing operating costs by removing the need to use gas heating and helium as the process gas. Recent improvements in powder delivery and laser energy coupling to workpiece have been undertaken to improve deposition efficiency (DE) and build rate, while real-time temperature logging allows greater management of deposition conditions and deposit characteristics.
Resumo:
To characterise central neurons in the pedal ganglia of both male and female green lipped mussel, Perna canaliculus immunohistochemical techniques were used. Mollusc antibodies were used against neuropeptides and neurotansmitters known to control reproduction and spawning. Anti-ELH and anti-APGWamide showed very strong immunoreactivity in small type of neurons. Anti-5-HT and anti-DA immunoreactivity was mostly in large type of neurons. The labelled neurons are consistent with descriptions of neurosecretory cells implicated in the control of reproduction and spawning on the basis of earlier histological staining techniques used in this species. The use of selective immunological markers for peptides and amines appears to be a, promising tool for further characterisation of neurosecretory cells, and to isolate an'tl characterise neuropeptides and other biologically active materials involved in the control of reproduction in Perna canaliculus.
Resumo:
Accurate simulation of rolling-tyre vibrations, and the associated noise, requires knowledge of road-surface topology. Full scans of the surface types in common use are, however, not widely available, and are likely to remain so. Ways of producing simulated surfaces from incomplete starting information are thus needed. In this paper, a simulation methodology based solely on line measurements is developed, and validated against a full two-dimensional height map of a real asphalt surface. First the tribological characteristics-asperity height, curvature and nearest-neighbour distributions-of the real surface are analysed. It is then shown that a standard simulation technique, which matches the (isotropic) spectrum and the probability distribution of the height measurements, is unable to reproduce these characteristics satisfactorily. A modification, whereby the inherent granularity of the surface is enforced at the initialisation stage, is introduced, and found to produce simulations whose tribological characteristics are in excellent agreement with the measurements. This method will thus make high-fidelity tyre-vibration calculations feasible for researchers with access to line-scan data only. In addition, the approach to surface tribological characterisation set out here provides a template for efficient cataloguing of road textures, as long as the resulting information can subsequently be used to produce sample realisations. A third simulation algorithm, which successfully addresses this requirement, is therefore also presented. © 2011 Elsevier B.V.
Resumo:
Zinc oxide (ZnO) thin films were deposited at high rates ( > 50 nm min-1) using a unique technique known as high target utilisation sputtering (HiTUS). The films obtained possess good crystallographic orientation, low surface roughness, very low stress and excellent piezoelectric properties. We have utilised the films to develop highly sensitive biosensors based on thickness longitudinal mode (TLM) thin film bulk acoustic resonators (FBARs). The FBARs have the fundamental TLM at a frequency near 1.5 GHz and quality factor Q higher than 1,000, which is one of the largest values ever reported for ZnO-based FBARs. Bovine Serum Albumin (BSA) solutions with different concentrations were placed on the top of different sets of identical FBARs and their responses to mass-loading from physically adsorbed protein coatings were investigated. These resonators demonstrated a high sensitivity and thus have a great potential as gravimetric sensors for biomedical applications. © 2011 Inderscience Enterprises Ltd.
Resumo:
Phosphorylase from muscle of tilapia (Tilapia mosambica) was extracted by water and purified by ammonium sulphate precipitation, centrifugation and repeated recrystallisation. Electro-phorogram of the enzyme preparation showed a single band near origin. The enzyme showed optimum pH and temperature at 6.1 and 37°C respectively. Glucose and glucose-6-phosphate were found to be competitive inhibitors of the enzyme. Maltose and starch acted as primers for the phosphorylase reaction like glycogen.
Resumo:
Pituitary growth hormone (GH), like several other protein hormones, shows an unusual episodic pattern of molecular evolution in which sustained bursts of rapid change are imposed on long periods of very slow evolution (near-stasis). A marked period of rap
Resumo:
The goals of the workshop were to: present verified data, draft a report containing visual descriptors and information on the structure and function of BOBLME ecosystems; identify information gaps and transboundary issues and develop capacity of national scientists on data integration techniques.
Resumo:
The workshop's aim was to consolidate and validate the information collected by the CSIRO project during the first regional ecosystem characterisation workshop held in February. This information includes; descriptions of broad scale biophysical drivers of ecological systems in the region; and descriptive narratives and illustrations of each ecosystem sub-region in the Bay of Bengal.
Resumo:
The goals of the workshop were to: conduct an interactive workshop for characterizing Indian coastal ecosystems; verification of the ecosystem characterisation report for the East coast of India; and development of ecosystem characterisation for the west coast of India based on ecological/biophysical systems.
Resumo:
This study summarises the high level drivers on ecological systems of the BOBLME. The ecological characterisation resulted in the identification of 29 subsystems. The report recommends the development of fully integrated approaches that considers human needs and the ecological system, involving stakeholders in a transparent way.