Temperature and common-ion effect on magnesium oxide (MgO) hydration

MgO based refractory castables draw wide technological interest because they have the versatility and installation advantages of monolithic refractories with intrinsic MgO properties, such as high refractoriness and resistance to basic slag corrosion. Nevertheless, MgO easily reacts with water to produce Mg(OH)(2), which is followed by a large volumetric expansion, limiting its application in refractory castables. In order to develop solutions to minimize this effect, a better understanding of the main variables involved in this reaction is required. In this work, the influence of temperature, as well as the impact of the chemical equilibrium shifting (known as the common-ion effect), on MgO hydration was evaluated. Ionic conductivity measurements at different temperatures showed that the MgO hydration reaction is accelerated with increasing temperature. Additionally, different compounds were added to evaluate their influence on the reaction rate. Among them, CaCl(2) delayed the reaction, whereas KOH showed an opposite behavior. MgCl(2) and MgSO(4) presented similar results and two other distinct effects, reaction delay and acceleration, which depended on their concentration in the suspensions. The results were evaluated by considering the kinetics and the thermodynamics of the reaction, and the mechanical damages in the samples that was caused by the hydration reaction. (C) 2009 Elsevier Ltd and Techna Group S.r.l. All rights reserved.

Influence of Reaction Conditions on Synthesis of PAni/MnO(2) Composites

An investigation of the parameters as aniline: MnO(2) and temperature on synthesis of polyaniline/MnO(2) composites was performed. The composites were chemically prepared in H(2)SO(4) media using different aniline: MnO(2) ratios at 0 degrees C. After the ratio optimization, the syntheses were performed at 20 degrees C. The polyaniline/MnO(2) composites were characterized by scanning electron microscopy (SEM), ultraviolet-visible, near infrared and infrared spectroscopic techniques. Composites obtained with a uniform, homogeneous and thicker coating of polyaniline films under oxide was considered as the best condition for synthesis.

Methane conversion reactions on Ni catalysts promoted with Rh: Influence of support

Ni catalysts supported on gamma-Al(2)O(3) and Mg(Al)O were prepared with and without Rh as a promoter and tested in the reforming of methane in the presence of excess methane, simulating a model biogas. The effects of adding synthetic air on the methane conversion and the formation of carbon were assessed. The catalysts were characterized by X-ray spectroscopy (EDS), surface area (BET), X-ray diffraction (XRD), Temperature-programmed reduction (TPR), X-ray absorption near-edge structure (XANES) and XPD. The results showed that in catalysts without Rh, the Ni interacts strongly with the supports, showing high reduction temperatures in TPR tests. The addition of Rh increased the amount of reducible Ni and facilitated the reduction of the species interacting strongly with the support. In the catalytic tests, the samples promoted with Rh suffered higher carbon deposition. The in situ XPD suggested that on the support gamma-Al(2)O(3), the presence of Rh probably led to a segregation of Ni species with time on stream, leading to carbon deposition. On the support MgAlO, the presence of Rh improved the dispersion of Ni, by reducing the Ni(0) crystallite size, suggesting that in this case the carbon deposition was due to a favoring of CH(4) decomposition by Rh. (C) 2011 Elsevier B.V. All rights reserved.

Influence of hydraulics and control of thermal storage in solar assisted heat pump combisystems

This paper studies the influence of hydraulics and control of thermal storage in systems combined with solar thermal and heat pump for the production of warm water and space heating in dwellings. A reference air source heat pump system with flat plate collectors connected to a combistore was defined and modeled together with the IEA SHC Task 44 / HPP Annex 38 (T44A38) “Solar and Heat Pump Systems” boundary conditions of Strasbourg climate and SFH45 building. Three and four pipe connections as well as use of internal and external heat exchangers for DHW preparation were investigated as well as sensor height for charging of the DHW zone in the store. The temperature in this zone was varied to ensure the same DHW comfort was achieved in all cases. The results show that the four pipe connection results in 9% improvement in SPF compared to three pipe and that the external heat exchanger for DHW preparation leads to a 2% improvement compared to the reference case. Additionally the sensor height for charging the DHW zone of the store should not be too low, otherwise system performance is adversely affected

Radiation properties of coil-coated steel in building envelope surfaces and the influence on building thermal performance

Recent studies have shown that the optical properties of building exterior surfaces are important in terms of energy use and thermal comfort. While the majority of the studies are related to exterior surfaces, the radiation properties of interior surfaces are less thoroughly investigated. Development in the coil-coating industries has now made it possible to allocate different optical properties for both exterior and interior surfaces of steel-clad buildings. The aim of this thesis is to investigate the influence of surface radiation properties with the focus on the thermal emittance of the interior surfaces, the modeling approaches and their consequences in the context of the building energy performance and indoor thermal environment. The study consists of both numerical and experimental investigations. The experimental investigations include parallel field measurements on three similar test cabins with different interior and exterior surface radiation properties in Borlänge, Sweden, and two ice rink arenas with normal and low emissive ceiling in Luleå, Sweden. The numerical methods include comparative simulations by the use of dynamic heat flux models, Building Energy Simulation (BES), Computational Fluid Dynamics (CFD) and a coupled model for BES and CFD. Several parametric studies and thermal performance analyses were carried out in combination with the different numerical methods. The parallel field measurements on the test cabins include the air, surface and radiation temperatures and energy use during passive and active (heating and cooling) measurements. Both measurement and comparative simulation results indicate an improvement in the indoor thermal environment when the interior surfaces have low emittance. In the ice rink arenas, surface and radiation temperature measurements indicate a considerable reduction in the ceiling-to-ice radiation by the use of low emittance surfaces, in agreement with a ceiling-toice radiation model using schematic dynamic heat flux calculations. The measurements in the test cabins indicate that the use of low emittance surfaces can increase the vertical indoor air temperature gradients depending on the time of day and outdoor conditions. This is in agreement with the transient CFD simulations having the boundary condition assigned on the exterior surfaces. The sensitivity analyses have been performed under different outdoor conditions and surface thermal radiation properties. The spatially resolved simulations indicate an increase in the air and surface temperature gradients by the use of low emittance coatings. This can allow for lower air temperature at the occupied zone during the summer. The combined effect of interior and exterior reflective coatings in terms of energy use has been investigated by the use of building energy simulation for different climates and internal heat loads. The results indicate possible energy savings by the smart choice of optical properties on interior and exterior surfaces of the building. Overall, it is concluded that the interior reflective coatings can contribute to building energy savings and improvement of the indoor thermal environment. This can be numerically investigated by the choice of appropriate models with respect to the level of detail and computational load. This thesis includes comparative simulations at different levels of detail.

Influence of the bipartite scrotum on the testicular and scrotal temperatures in goats

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Influence of stocking densities in the nursery phase on the growth of Macrobrachium amazonicum reared in net pens

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Influence of early quantitative food restriction on long bone growth at different environmental temperatures in broiler chickens

1. This investigation was carried out to study the influence of early quantitative food restriction (40% of ad libitum intake from 7 to 14 d of age) and environmental rearing temperature (thermoneutral, cold and hot) on long bone (tibia, femur and humerus) development in broiler chickens.2. Tibia, femur and humerus were obtained at the ages of 14, 21, 28, 35 and 42 d; and the variables studied were: length and width (mm, expressed as absolute values), bone breaking strength (kgf) and bone weight/bone length index (BW/BL, mg/mm).3. All bone variables increased with bird age. Food restriction reduced bone length and width but did not affect bone weight. High environmental rearing temperature reduced bone length and width at 42 d of age. Bone strength was not affected by environmental temperature but the calculated BW/BL index was reduced by heat exposure.4. The findings suggest that food restriction and high environmental rearing temperature reduce long bone growth; bone breaking strength was affected by bird age but not by food restriction nor rearing ambient temperature.

Effect of environmental temperature on immune response of broilers

Several studies demonstrate that environmental temperature can influence the immune response of poultry. The objective of this research was to determine at which stage in the life of a bird this effect is greatest. In experiment 1, broiler breeder eggs were incubated at three different temperatures (36.8+/-0.2, 37.8+/-0.2, and 38.8+/-0.2degreesC from the 13th day of incubation to hatching. After hatching, birds were raised in thermoneutral temperature. In experiment 2, 144 1-d-old broiler chicks were distributed into three environmental chambers with different temperatures (18+/-2, 24+/-2, and 32+/-2degreesC). In both experiments, the humoral immune responses to Newcastle disease virus (NDV) and infectious bursal disease (IBDV) were evaluated. NDV and IBDV antibody titers were not significantly different (P > 0.05) among treatments.

INFLUENCE of ASCORBIC ACID on EGG QUALITY

A qualidade dos ovos pode ser influenciada por alguns nutrientes adicionados à dieta das aves e entre esses nutrientes se inclui o ácido ascórbico, que segundo alguns pesquisadores, além de melhorar a qualidade, pode aumentar a produção e o peso dos ovos e diminuir a quantidade de ovos trincados e o consumo de ração. Com a finalidade de tentar contribuir com mais algumas informações, desenvolveu esse experimento com o objetivo de avaliar a influência do ácido ascórbico sobre a qualidade de ovos brancos e marrons mantidos sob condições de ambiente (26,7 ± 2,2°C e 60 ± 5%UR), por um período de 28 dias. Foram utilizados 1440 ovos, sendo 720 de casca branca e 720 de casca marrom. Foram adicionadas à ração de aves, durante 60 dias, concentrações de 100, 150 e 200mg/kg de ácido ascórbico. A qualidade dos ovos foi determinada de 7 em 7 dias, avaliando-se a unidade Haugh e o índice gema. Os dados obtidos permitiram concluir que a suplementação com o ácido ascórbico não foi suficiente para diminuir a perda de qualidade dos ovos. Independentemente dos níveis de vitaminas utilizados, os ovos marrons mostraram-se qualitativamente superiores aos brancos.

Morphomolecular characterization of Pleurotus ostreatus (Jacq. Fr.) kummer strains in relation to luminosity and temperature of frutification

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Photoluminescence of SrTiO3: Influence of Particle Size and Morphology

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Influence of the single or combined administration of cocaine and testosterone in autonomic and neuroendocrine responses to acute restraint stress

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Influence of pH of Colloidal Suspension on the Electrical Conductivity of SnO2 thin Films Deposited Via Sol-Gel-Dip-Coating

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Influence of Tungsten Dopant on Sintering and Curie Temperatures of Ba(Zr0.10Ti0.90)O-3 Ceramics

Ba(Zr0.10Ti0.90)O3 (BZT10) and W+ 6 substituted BZT ceramics (BZT10:W) were prepared by mixed oxide method. The effect of W+ 6 addition in the BZT was evaluated by X-ray diffraction (XRD), dilatometer analysis, microstructural and dielectrical properties. When tungsten is introduced in the BZT lattice, a decrease in the grain size and shift on Curie temperature to lower value besides broadening of dielectric permittivity is evident. This is due repulsion between tungsten and their nearest neighbors leading to a structure which is tetragonal distorted. The sintering temperature is reduced when tungsten is introduced in the BZT lattice.