Compromised Spindle Assembly Checkpoint due to Altered Expression of Ubch10 and Cdc20 in Human Papillomavirus Type 16 E6 and E7-Expressing Keratinocytes

Cells expressing human papillomavirus type 16 (HPV-16) E6 and E7 proteins exhibit deregulation of G(2)/M genes, allowing bypass of DNA damage arrest signals. Normally, cells with DNA damage that override the G(2) damage checkpoint would precociously enter mitosis and ultimately face mitotic catastrophe and apoptotic cell death. However, E6/E7-expressing cells (E6/E7 cells) have the ability to enter and exit mitosis in the presence of DNA damage and continue with the next round of the cell cycle. Little is known about the mechanism that allows these cells to gain entry into and exit from mitosis. Here, we show that in the presence of DNA damage, E6/E7 cells have elevated levels of cyclin B, which would allow entry into mitosis. Also, as required for exit from mitosis, cyclin B is degraded in these cells, permitting initiation of the next round of DNA synthesis and cell cycle progression. Proteasomal degradation of cyclin B by anaphase-promoting complex/cyclosome (APC/C) is, in part, due to elevated levels of the E2-conjugating enzyme, Ubch10, and the substrate recognition protein, Cdc20, of APC/C. Also, in E6/E7 cells with DNA damage, while Cdc20 is complexed with BubR1, indicating an active checkpoint, it is also present in complexes free of BubR1, presumably allowing APC/C activity and slippage through the checkpoint.

Local Conentration of Waves due to Abrupt Alongshore Variation of Nearshore Bathymetry

Small-scale physical and numerical experiments were conducted to investigate the local concentration of waves (monochromatic and group) due to abrupt change of nearshore bathymetry in alongshore direction. Wave run-up motions along the shoreline were measured using an image analysis technique to compare localized concentration of wave energy, when waves propagate a over bathymetry composing rhythmic patterns of mild/steep slope bottom configurations. Measured alongshore variation of maximum wave run-up heights showed significant peak near the boundary, which has sudden alongshore change of depth, both under monochromatic and group wave trains. This phenomenon is found to be due to interaction of waves with neashore currents, which is further enhanced by excitation of long wave components by breaking of group waves. Furthermore, this paper discusses results of preliminary experiments carried out to test the effectiveness of several shore protection structure layouts in mitigating such wave concentrations. Numerical simulations were performed by using a model developed based on Nwogu (1993) Boussinesq-type equations; coupled with a transport equation to model energy dissipation due to wave breaking.

Residual stress due to curing can initiate damage in porous bone cement: experimental and theoretical evidence

Residual stress due to shrinkage of polymethylmethacrylate bone cement after polymerisation is possibly one factor capable of initiating cracks in the mantle of cemented hip replacements. No relationship between residual stress and observed cracking of cement has yet been demonstrated. To investigate if any relationship exists, a physical model has been developed which allows direct observation of damage in the cement layer on the femoral side of total hip replacement. The model contains medial and lateral cement layers between a bony surface and a metal stem; the tubular nature of the cement mantle is ignored. Five specimens were prepared and examined for cracking using manual tracing of stained cracks, observed by transmission microscopy: cracks were located and measured using image analysis. A mathematical approach for the prediction of residual stress due to shrinkage was developed which uses the thermal history of the material to predict when stress-locking occurs, and estimates subsequent thermal stress. The residual stress distribution of the cement layer in the physical model was then calculated using finite element analysis. Results show maximum tensile stresses normal to the observed crack directions, suggesting a link between residual stress and preload cracking. The residual stress predicted depends strongly on the definition of the reference temperature for stress-locking. The highest residual stresses (4-7 MPa) are predicted for shrinkage from maximum temperature, in this case, magnitudes are sufficiently high to initiate cracks when the influence of stress raisers such as pores or interdigitation at the bone/cement interface are taken into account (up to 24 MPa when calculating stress around a pore according to the method of Harrigan and Harris (J. Biomech. 24(11) (1991) 1047-1058)). We conclude that the damage accumulation failure scenario begins before weight-bearing due to cracking induced by residual stress around pores or stress raisers. (C) 2002 Elsevier Science Ltd. All rights reserved.

Domain annihilation due to temperature and thickness gradients in single-crystal BaTiO3

The manner in which 90? ferroelectric-ferroelastic domains respond to changes in temperature has been mapped in BaTiO3 single crystals using atomic force microscopy. Domain periodicity remains unaltered until approximately 2 ? C below the Curie temperature (TC ), whereupon domains coarsened dramatically. This behavior was successfully rationalized by considering the temperature dependence of the parameters associated with standard models of ferroelastic domain formation. However, while successful in describing the expected radical increase in equilibrium period with temperature, the model did not predict the unusual mechanism by which domain coarsening occurred; this was not continuous at a local level but instead involved discrete domain annihilation events. Subsequent insights from a combination of free energy analysis for the system and further experimental data from an analogous situation, in which domain period increases with increasing crystal thickness, suggested that domain annihilation is inevitable whenever a component of the relevant gradient that affects domain period is orientated parallel to the domain walls. Consistent with this thesis, we note that, for the observations presented herein, the thermal gradient possessed a significant component parallel to the domain walls. We suggest that domain annihilation is a general feature of domain structures in gradient fields.

Erythrocytosis due to a mutation in the erythropoietin receptor gene

Familial erythrocytosis, associated with high haemoglobin levels and low serum erythropoietin (Epo), has been shown to co-segregate with a sequence repeat polymorphism at the 5' region of the erythropoietin receptor (EpoR) in a large Finnish family. We have investigated the cause of erythrocytosis in an English boy. Sequencing of the cytoplasmic region of the EpoR detected a de novo transition mutation of G to A at nucleotide 6002. This mutation resulted in the formation of a stop codon at amino acid 439 with the loss of 70 amino acids from the carboxy terminus. The mutation (G6002A) has arisen independently in a Finnish family and de novo in this English boy. Patients with unexplained erythrocytosis and low serum Epo levels should be investigated for EpoR mutations.

Enhancement of positron annihilation on molecules due to vibrational Feshbach resonances

The zero-range potential model is used to investigate positron collisions and annihilation with molecules. The Kr dimer is considered as an example. It is shown that (i) although positrons do not bind to individual Kr atoms, they do form bound states with Kr. (ii) A sequence of vibrationally excited states of the positron-molecule complex extends into the positron continuum, where it manifests as vibrational Feshbach resonances. (iii) These resonances give a very large contribution to the positron annihilation rate. Even after averaging over the thermal positron energy distribution, the contribution of the lowest Feshbach resonance exceeds that of the non-resonant background by an order of magnitude. © 2002 Elsevier Science B.V. All rights reserved.