EMISSIONS CHARACTERISTICS OF A RESIDENTIAL PELLET BOILER AND A STOVE

Gaseous and particulate emissions from a residential pellet boiler and a stove are measured at a realistic 6-day operation sequence and during steady state operation. The aim is to characterize the emissions during each phase in order to identify when the major part of the emissions occur to enable actions for emission reduction where the savings can be highest. The characterized emissions comprised carbon monoxide (CO), nitrogen oxide (NO), total organic carbon (TOC) and particulate matter (PM 2.5). In this study, emissions were characterised by mass concentration and emissions during start-up and stop phases were also presented in accumulated mass. The influence of start-up and stop phases on the emissions, average emission factors for the boiler and stove were analysed using the measured data from a six-days test. The share of start-up and stop emissions are significant for CO and TOC contributing 95% and 89% respectively at the 20kW boiler and 82% and 89% respectively at the 12 kW stove. NO and particles emissions are shown to dominate during stationary operation.

Energy efficient and economic renovation of residential buildings with low-temperature heating and air heat recovery

With the building sector accounting for around 40% of the total energy consumption in the EU, energy efficiency in buildings is and continues to be an important issue. Great progress has been made in reducing the energy consumption in new buildings, but the large stock of existing buildings with poor energy performance is probably an even more crucial area of focus. This thesis deals with energy efficiency measures that can be suitable for renovation of existing houses, particularly low-temperature heating systems and ventilation systems with heat recovery. The energy performance, environmental impact and costs are evaluated for a range of system combinations, for small and large houses with various heating demands and for different climates in Europe. The results were derived through simulation with energy calculation tools. Low-temperature heating and air heat recovery were both found to be promising with regard to increasing energy efficiency in European houses. These solutions proved particularly effective in Northern Europe as low-temperature heating and air heat recovery have a greater impact in cold climates and on houses with high heating demands. The performance of heat pumps, both with outdoor air and exhaust air, was seen to improve with low-temperature heating. The choice between an exhaust air heat pump and a ventilation system with heat recovery is likely to depend on case specific conditions, but both choices are more cost-effective and have a lower environmental impact than systems without heat recovery. The advantage of the heat pump is that it can be used all year round, given that it produces DHW. Economic and environmental aspects of energy efficiency measures do not always harmonize. On the one hand, lower costs can sometimes mean larger environmental impact; on the other hand there can be divergence between different environmental aspects. This makes it difficult to define financial subsidies to promote energy efficiency measures.

Emissions from realistic operation of residential wood pellets heating systems

Emissions from residential combustion appliances vary significantly depending on the firing behaviours and combustion conditions, in addition to combustion technologies and fuel quality. Although wood pellet combustion in residential heating boilers is efficient, the combustion conditions during start-up and stop phases are not optimal and produce significantly high emissions such as carbon monoxide and hydrocarbon from incomplete combustion. The emissions from the start-up and stop phases of the pellet boilers are not fully taken into account in test methods for ecolabels which primarily focus on emissions during operation on full load and part load. The objective of the thesis is to investigate the emission characteristics during realistic operation of residential wood pellet boilers in order to identify when the major part of the annual emissions occur. Emissions from four residential wood pellet boilers were measured and characterized for three operating phases (start-up, steady and stop). Emissions from realistic operation of combined solar and wood pellet heating systems was continuously measured to investigate the influence of start-up and stop phases on total annual emissions. Measured emission data from the pellet devices were used to build an emission model to predict the annual emission factors from the dynamic operation of the heating system using the simulation software TRNSYS. Start-up emissions are found to vary with ignition type, supply of air and fuel, and time to complete the phase. Stop emissions are influenced by fan operation characteristics and the cleaning routine. Start-up and stop phases under realistic operation conditions contribute 80 – 95% of annual carbon monoxide (CO) emission, 60 – 90% total hydrocarbon (TOC), 10 – 20% of nitrogen oxides (NO), and 30 – 40% particles emissions. Annual emission factors from realistic operation of tested residential heating system with a top fed wood pelt boiler can be between 190 and 400 mg/MJ for the CO emissions, between 60 and 95 mg/MJ for the NO, between 6 and 25 mg/MJ for the TOC, between 30 and 116 mg/MJ for the particulate matter and between 2x10-13 /MJ and 4x10-13 /MJ for the number of particles. If the boiler has the cleaning sequence with compressed air such as in boiler B2, annual CO emission factor can be up to 550 mg/MJ. Average CO, TOC and particles emissions under realistic annual condition were greater than the limits values of two eco labels. These results highlight the importance of start-up and stop phases in annual emission factors (especially CO and TOC). Since a large or dominating part of the annual emissions in real operation arise from the start-up and stop sequences, test methods required by the ecolabels should take these emissions into account. In this way it will encourage the boiler manufacturers to minimize annual emissions. The annual emissions of residential pellet heating system can be reduced by optimizing the number of start-ups of the pellet boiler. It is possible to reduce up to 85% of the number of start-ups by optimizing the system design and its controller such as switching of the boiler pump after it stops, using two temperature sensors for boiler ON/OFF control, optimizing of the positions of the connections to the storage tank, increasing the mixing valve temperature in the boiler circuit and decreasing the pump flow rate. For 85 % reduction of start-ups, 75 % of CO and TOC emission factors were reduced while 13% increase in NO and 15 % increase in particle emissions was observed.

Assessing the physical environment of older people’s residential care facilities: development of the Swedish version of the Sheffield Care Environment Assessment Matrix (S-SCEAM)

Background There is emerging evidence that the physical environment is important for health, quality of life and care, but there is a lack of valid instruments to assess health care environments. The Sheffield Care Environment Assessment Matrix (SCEAM), developed in the United Kingdom, provides a comprehensive assessment of the physical environment of residential care facilities for older people. This paper reports on the translation and adaptation of SCEAM for use in Swedish residential care facilities for older people, including information on its validity and reliability. Methods SCEAM was translated into Swedish and back-translated into English, and assessed for its relevance by experts using content validity index (CVI) together with qualitative data. After modification, the validity assessments were repeated and followed by test-retest and inter-rater reliability tests in six units within a Swedish residential care facility that varied in terms of their environmental characteristics. Results Translation and back translation identified linguistic and semantic related issues. The results of the first content validity analysis showed that more than one third of the items had item-CVI (I-CVI) values less than the critical value of 0.78.  After modifying the instrument, the second content validation analysis resulted in I-CVI scores above 0.78, the suggested criteria for excellent content validity. Test-retest reliability showed high stability (96% and 95% for two independent raters respectively), and inter-rater reliability demonstrated high levels of agreement (95% and 94% on two separate rating occasions). Kappa values were very good for test-retest (κ= 0.903 and 0.869) and inter-rater reliability (κ= 0.851 and 0.832). Conclusions Adapting an instrument to a domestic context is a complex and time-consuming process, requiring an understanding of the culture where the instrument was developed and where it is to be used. A team, including the instrument’s developers, translators, and researchers is necessary to ensure a valid translation and adaption. This study showed preliminary validity and reliability evidence for the Swedish version (S-SCEAM) when used in a Swedish context. Further, we believe that the S-SCEAM has improved compared to the original instrument and suggest that it can be used as a foundation for future developments of the SCEAM model.

Predator Survival Tactics and Use of Habitat Cover in Rana Catesbeiana.

Predator-prey relationships are an important aspect of the natural world, and, because of its relevance to survival and natural selection, is an interesting relationship to study. In amphibian larvae, level of activity and landscape use are often what determines the survival as prey. I studied the anti-predator behavior of the North American bullfrog (Rana catesbeiana) tadpoles when presented with dragonfly (Aeshna) larvae, a known predator of tadpoles. Tadpoles were acclimated to four different habitats with varying degrees of habitat cover, and were transferred to a new habitat with a degree of cover equal to one of the acclimation tanks. A restrained predator, and thus its chemical cue, was introduced, and the behavior, particularly the use of the habitat cover to hide from the perceived risk of predation was observed. A significantly higher frequency of inactivity was found in tank I than in II and III, and inactivity followed a general trend of decreasing with increasing habitat cover. Difference in tank cover was not found to have a significant effect on swimming behavior, but did have a significant effect on hiding behavior, which increased with higher availability. Foraging decreased significantly with the addition of a predator, but did not vary significantly with different levels of cover. Hiding behavior and reducing conspicuous behaviors (like foraging) are probably the behaviors that afford the tadpole the most success at eluding a predator in their natural environment.

Atlantic Salmon Habitat and Dams in Maine

http://digitalcommons.colby.edu/atlasofmaine2009/1020/thumbnail.jpg

Atlantic Salmon Habitat on Maine's Rivers and Streams

http://digitalcommons.colby.edu/atlasofmaine2006/1007/thumbnail.jpg

Wildlife Habitat of Maine

http://digitalcommons.colby.edu/atlasofmaine2005/1009/thumbnail.jpg

EVALUATION OF THE CONSERVATION LANDS OF MAINE BASED ON PRESENCE OF HABITAT SUITABLE FOR LISTED SPECIES

http://digitalcommons.colby.edu/atlasofmaine2009/1028/thumbnail.jpg

HABITAT SUITABILITY ANALYSIS OF THE CRITICALLY ENDANGERED FLORIDA PANTHER

http://digitalcommons.colby.edu/atlasofmaine2008/1019/thumbnail.jpg

A PRELIMINARY HABITAT SUITABILITY ANALYSIS FOR THE RESTORATION OF SOUTH CHINA TIGERS IN THE HUPINGSHAN RESERVE, CHINA

http://digitalcommons.colby.edu/atlasofmaine2005/1021/thumbnail.jpg

A GIS SUITABILITY ANALYSIS OF WOLF HABITAT IN MAINE

http://digitalcommons.colby.edu/atlasofmaine2005/1024/thumbnail.jpg

MODELING POTENTIAL TIGER HABITAT IN HUPINGSHAN-HOUHE ANDMANGSHAN-NANLING NATIONAL NATURE RESERVES, CHINA

http://digitalcommons.colby.edu/atlasofmaine2008/1017/thumbnail.jpg

A GIS Suitability Analysis of Wolf Habitat in Maine

The range of the Gray Wolf (Canis lupus), once covering most of North America, has been drastically reduced by an estimated 95% due to habitat loss and extermination by humans. The wolf was extirpated from Maine in the 1800’s. Wolf reintroductions have been suggested for Maine, but there is some debate about how much land is suitable for wolves. I developed a wolf habitat suitability analysis using ArcGIS and data from the Maine Office of GIS and the United States National Atlas. The model incorporates land cover, presence of major roads and railways, conservation land, industrial, non-industrial, and public woodlot ownership, distance from major points of population, deer population, and slope. The model results show areas of high and low wolf suitability in Maine. The model suggests that the best potential habitat for wolves in Maine is situated in the northwest of the state. Possible future reintroductions or natural colonization from other areas would have the highest likelihood of survival in these areas.

Evaluation of the Conservation Lands of Maine Based on Presence of Habitat Suitable for Listed Species

“Conservation Lands” include both public and private lands that are devoted to the protection of wildlife and natural resources. “Listed Species” include federally and state endangered and threatened animals that are in danger of extermination in the state of Maine. The purpose of this study is to determine how well conservation lands are protecting the habitats of listed species. GAP data was used for 13 terrestrial vertebrate species indicating the presence or absence of suitable habitats. This data was compiled in GIS, generating a layer showing the number of listed species an area is suitable for. The areas that were suitable for at least one habitat were compared to answer three questions: (1) Is there is a difference between the presence and absence of listed species on protected lands and lands that are not protected? (2) Is there is a difference between the presence and absence of listed species on public lands managed by the state and the federal government and private land? (3) Is there is a difference between the presence and absence of listed species on lands protected under easements and lands that are protected fee simple? We found significant differences between all three categories. Conservation lands, private lands, and lands held under easement protect the habitat of listed species most effectively. We believe that this is due to the large number of private land trusts in the state of Maine and the effective management strategies of state lands.