Urea-Based Synthesis of Zinc Oxide Nanostructures at Low Temperature

The preparation of nanometer-sized structures of zinc oxide (ZnO) from zinc acetate and urea as raw materials was performed using conventional water bath heating and a microwave hydrothermal (MH) method in an aqueous solution. The oxide formation is controlled by decomposition of the added urea in the sealed autoclave. The influence of urea and the synthesis method on the final product formation are discussed. Broadband photoluminescence (PL) behavior in visible-range spectra was observed with a maximum peak centered in the green region which was attributed to different defects and the structural changes involved with ZnO crystals which were produced during the nucleation process.

Acid and fermented silage characterization and determination of apparent digestibility coefficient of crude protein for pacu Piaractus mesopotamicus

Three types of raw materials including commercial waste from saltwater (SW), freshwater fish (FW) and tilapia fillet residue (FR) were used to produce fish silage by either acid digestion (2% formic acid and 2% sulfuric acid) or anaerobic fermentation (5% of Lactobacillus plantarum and 15% sugar cane molasses). Six test diets were used in digestibility trials prepared with 70% reference diet and 30% of each experimental silage. These diets were fed to juvenile pacu Piaractus mesopotamicus (146 g average weight) in triplicate. Fish were kept in 500-L tanks and feces collected by manual extrusion. It was observed for both processes that SW waste always had the highest moisture content and lowest fat and ash. Highest crude protein levels were found in silages from commercial fish waste (SW and FW) made from whole fish unfit for human consumption. However, apparent digestibility coefficients did not vary among diets (P > 0.05). Although values did not differ statistically, fermented silage consistently displayed higher digestibility coefficients compared to acid silage. The silages exhibited relatively high protein digestibility (72.5-80.0%), thus suggesting the feasibility of using fish industry by-products in aquaculture feeds.

Protocolo para ensaios físico-químicos de estabilidade de fitocosméticos

The growing demand for stable, safe and effective cosmetics has required increasingly complex studies by the scientific community and the use of more efficient techniques to determine the stability of these products. The use of active principles from the Brazilian flora has led to the development of numerous products, in the most varied pharmaceutical forms, making it, even more difficult to standardize experimental protocols to certify the stability of cosmetic preparations. While in Brazil there is no one protocol that standardizes the tests that should be carried out to determine product stability, several studies have been conducted in academic laboratories to determine the stability of specific raw materials. The rheological properties of topical use products have to be taken into account in their manufacture, storage and application. The determination of the rheological behavior of a formulation helps in evaluating the physicochemical nature of the vehicle, allowing early signs of physical instability to be detected and thus enabling quality control of the constituents, test formulations and final products. Thermal analysis has also been used to assist in the study of cosmetic stability and differential scanning calorimetry to guide the development of new products. Other tools, such as fluorimetry and laser granulometry can be used to help the study and development of both emulsified and non-emulsified systems. The aim of the present study is to develop a protocol for the investigation of the physical and chemical stability of phytocosmetics - systems containing active compounds extracted from the Brazilian biodiversity.

Meta-heuristic approaches for a soft drink industry problem

The present paper evaluates meta-heuristic approaches to solve a soft drink industry problem. This problem is motivated by a real situation found in soft drink companies, where the lot sizing and scheduling of raw materials in tanks and products in lines must be simultaneously determined. Tabu search, threshold accepting and genetic algorithms are used as procedures to solve the problem at hand. The methods are evaluated with a set of instance already available for this problem. This paper also proposes a new set of complex instances. The computational results comparing these approaches are reported. © 2008 IEEE.

Evaluating genetic algorithms with different population structures on a lot sizing and scheduling problem

This paper studies the use of different population structures in a Genetic Algorithm (GA) applied to lot sizing and scheduling problems. The population approaches are divided into two types: single-population and multi-population. The first type has a non-structured single population. The multi-population type presents non-structured and structured populations organized in binary and ternary trees. Each population approach is tested on lot sizing and scheduling problems found in soft drink companies. These problems have two interdependent levels with decisions concerning raw material storage and soft drink bottling. The challenge is to simultaneously determine the lot sizing and scheduling of raw materials in tanks and products in lines. Computational results are reported allowing determining the better population structure for the set of problem instances evaluated. Copyright 2008 ACM.

Farmacovigilância no Brasil: A relação entre polimorfismo de fármacos, efetividade e segurança dos medicamentos

In spite of the stated Brazilian policy on medicines that their quality, effectiveness and safety should be ensured at reasonable cost, hospitals in the ANVISA Surveillance Network have been receiving notifications of technical complaints, adverse reactions and suspected therapeutic ineffectiveness (STI) of medicines. The purpose of this study was to identify the medicines notified for suspicion of therapeutic ineffectiveness, at a university hospital participating in the national Surveillance Network, and to investigate the existence of polymorphs of any of the drugs involved, by examining the literature. There were 31 notifications of STI in a period of 18 months, concerning 11 different drugs, all of which were 'similar' drugs (neither original nor licensed by originator); five of these could contain polymorphs, according to the literature. However, this does not mean that the other drugs could not contain some unknown polymorphs, more studies being needed on polymorphism, especially in the cases of reported therapeutic ineffectiveness. Therefore, tests of polymorphism should be made part of the routine quality control of the raw materials during the development of medicines and in the studies of pharmaceutical equivalence to 'reference' medicines (innovative brands). The stability test should also involve a study of polymorphism, in order to confirm the solid state stability of the drug. All these measures will assure the effectiveness of medicines, since the reproducibility in the quality of pharmaceutical products could be monitored, as well as the equivalence of each production batch with the batch selected to determine the bioequivalence with the reference brand.

Alternative to peat for Agaricus brasiliensis yield

Casing layer is one of the most important components of Agaricus spp. production and it directly affects mushroom productivity, size and mass. The aim of this study was to evaluate potential raw materials as a casing layer and their effect on Agaricus brasiliensis productivity. Raw materials from Brazil with potential use were selected and characterized, and the most promising ones were tested as casing layers for mushroom yield. Evaluated raw materials included lime schist, vermiculite, eucalyptus sawdust, sand, São Paulo peat, Santa Catarina peat, subsoil and charcoal. Particle size, porosity and water absorption in relation to mushroom yield for casing layers were determined. Lime schist, an alternate casing layer to peat, is presented and the effects of the casing layer on the mushroom yield are discussed. © 2009 Elsevier Ltd. All rights reserved.

The People's Republic of China and Latin America and the Caribbean: towards a strategic relationship

Includes bibliography

People's Republic of China and Latin America and the Caribbean: ushering in a new era in the economic and trade relationship

Spanish and chinese versions available at the Library

The Chilean earthquake of 27 February 2010 an overview

Includes bibliography

Estudos de medicamentos biosimilares

In Brazil, the registration of new drugs is carried out only when the regulatory agency (Anvisa, acronym in Portuguese) is fully satisfied with the evidence of their quality, efficacy and safety, presented by a pharmaceutical industry that strive for this registration. With the patent expiration, pharmaceutical companies are attracted to produce biological medicines called biosimilar or biogenerics or simply generics, whose approval may result in reduced treatment costs. But it is necessary that the biosimilar be, at least, equally efective and safe and without contaminants in relation to the original. Recent consensus guidelines aim to establish criteria for efcacy and safety of these medicines. Preclinical studies in vitro and in vivo, the origin of raw materials and clinical studies phase I, II and III are recommended for biosimilar medicine registration in the international market. Low molecular weight heparins are found in this situation. In this review we specifcally addressed this type of medicine, which could serve as a benchmark for other biosimilar medicines.

Biofuels potential in Guyana

Includes bibliography

La economía cubana desde el siglo XVI al XX: del colonialismo al socialismo con mercado

Incluye Bibliografía

Microstructure, crystalline phase, and dielectric property analyses of TiO2 composition with ZrO2 addition

For microwave applications, including mobile and satellite communications, ceramic resonators should have a high dielectric constant, low dielectric losses, and high frequency stability. In this sense, TiO2-ZrO 2 ceramics have been investigated as a function of sintering behavior, phase composition, and microstructure. The ceramics were densified reaching a value of about 86% of theoretical density at 1400°C sintering temperature. The ceramics are prepared by mixing raw materials with the following TiO2-ZrO2 weight % ratio: 100 to 0, 90 to 10, and 80 to 20, respectively. The measured dielectric constants are between 79 and 88 values, while the quality factor due to dielectric losses are between 2820 and 5170. These results point out the influence of Ti/Zr ratio on controlling the dielectric properties. © (2010) Trans Tech Publications.

High-yield direct synthesis of Mg 2FeH 6 from the elements by reactive milling

Magnesium complex hydrides as Mg 2FeH 6 are interesting phases for hydrogen storage in the solid state, mainly due to its high gravimetric and volumetric densities of H2. However, the synthesis of this hydride is not trivial because the intermetallic phase Mg2Fe does not exist and Mg and Fe are virtually immiscible under equilibrium conditions. In this study, we have systematically studied the influence of the most important processing parameters in reactive milling under hydrogen (RM) for Mg 2FeH 6 synthesis: milling time, ball-to-powder weight ratio (BPR), hydrogen pressure and type of mill. Low cost 2Mg-Fe mixtures were used as raw materials. An important control of the Mg 2FeH 6 direct synthesis by RM was attained. In optimized combinations of the processing parameters, very high proportions of the complex hydride could be obtained. © (2011) Trans Tech Publications.