Prospective system analysis of stationary battery systems under the frame of Constructive Technology Assessment

Based on the report for the unit “Project IV” of the PhD programme on Technology Assessment under the supervision of Dr.-Ing. Marcel Weil and Prof. Dr. António Brandão Moniz. The report was presented and discussed at the Doctorate Conference on Technologogy Assessment in July 2013 at the University Nova Lisboa, Caparica campus.

Spatial analysis of new cases of leprosy in the State of Espírito Santo, Brazil, between 2004 and 2009

INTRODUCTION: Leprosy in Brazil is a public health issue, and there are many regions in the State of Espírito Santo with high endemic incidence levels of leprosy, characterizing this state as a priority for leprosy programs. The aim of this study was to determine the spatial distribution of coefficients of new cases of leprosy in the State of Espírito Santo, Brazil. METHODS: We conducted a descriptive and ecologic study based on the spatial distribution of leprosy in the State of Espírito Santo between 2004 and 2009. Data were gathered from the available records of the Espírito Santo State Health Secretary. The global and local Bayesian empirical methods were used to produce an estimate of leprosy risk, smoothing the fluctuation effects of the detection coefficients. RESULTS: The study resulted in a coefficient adjustment of new cases in 10 towns that changed their classification, among which, 2 went from low to medium, 4 from medium to high, 3 from high to very high, and 1 from very high to hyper-endemic. An average variation of 1.02, fluctuating between 0 and 12.39 cases/100,000 inhabitants, was found in a comparative calculation between the Local Ebest value and the average coefficient of new leprosy cases in the State of Espírito Santo. CONCLUSIONS: The spatial analysis of leprosy favors the establishment of control strategies with a better cost-benefit relationship since it reveals specific and priority regions, thereby enabling the development of actions that can interfere in the transmission chain.

Microlaparoscopy in gynecology: analysis of 16 cases and review of literature

Microlaparoscopy represents the development of endoscopic surgery towards a minimally invasive surgical procedure. The advantages include fewer surgical complications, faster return to daily activities, more comfortable postoperative recovery, and satisfactory aesthetic results. The possibility of performing surgery under sedation may result in shorter hospitalization, lower hospital costs, and easier anesthetic procedures. The authors report their preliminary experience with the use of microlaparoscopy, using optics and 2mm instruments, as well as a review of the literature since the introduction of this new technique. The report of these 16 cases demonstrates that microlaparoscopy is a feasible technique with satisfactory results. On the other hand, this new technique requires precise indications and a training period for the development of the skills necessary for performing these surgeries.

Healthcare- Associated infections: An analysis of costs in a Portuguese Hospital

Hospital-acquired infections (HAIs) delay healing, prolong Hospital stay, and increase both Hospital costs and risk of death. This study aims to estimate the extra length of stay and mortality rate attributable to each of the following HAIs: wound infection (WI); bloodstream infection (BSI); urinary infections (UI); and Hospital-acquired pneumonia (HAP). The study population consisted of patients discharged in CHLC in 2014. Data was collected to identify demographic information, surgical operations, development of HAIs and its outputs. The study used regressions and a matched strategy to compare cases (infected) and controls (uninfected). The matching criteria were: age, sex, week and type of admission, number of admissions, major diagnostic category and type of discharge. When compared to matched controls, cases with HAI had a higher mortality rate and greater length of stay. WI related to hip or knee surgery, increased mortality rate by 27.27% and the length of stay by 74.97 days. WI due to colorectal surgery caused an extra mortality rate of 10.69% and an excess length of stay of 20.23 days. BSI increased Hospital stay by 28.80 days and mortality rate by 32.27%. UI caused an average additional length of stay of 19.66 days and risk of death of 12.85%. HAP resulted in an extra Hospital stay of 25.06 days and mortality rate of 24.71%. This study confirms the results of the previous literature that patients experiencing HAIs incur in an excess of mortality rates and Hospital stay, and, overall, it presents worse results comparing with other countries.

Analysis of a controversial decision process: the case of the pumped hydro storage power plant Atdorf in Germany

Based on the report for the unit “Métodos Interactivos de Participação e Decisão A” (Interactive methods of participation and decision A), coordinated by Prof. Lia Maldonado Teles de Vasconcelos and Prof. Nuno Miguel Ribeiro Videira Costa. This unit was provided for the PhD Program in Technology Assessment in 2015/2016.

Experimental analysis of new interfaces for connections by adhesion, interlocking and friction.

The authors thank the federal agency CAPES and the Foundation for Research Support of the state of Sao Paulo, Brazil (FAPESP) for providing a PhD scholarship, and the University of Minho, in Portugal, for the international collaboration.

Analysis of polydicyclopentadiene-metal hybrid adhesive joints for automotive exterior body applications

An exterior body panel solution containing a polydicyclopentadiene skin attached to an interior metallic reinforcement through adhesive bonding is being studied to be applied in the MobiCar bonnet. With this solution is expected to achieve lightness, adequate structural integrity and cost-efficiency. However, there is uncertainty regarding to the bonnet adhesiveness since different metallic materials and adhesive types are being considered for its development. Thus, in this paper, several samples are tested through shear loading with the aim of understanding the loading magnitude expected by using polydicyclopentadiene, steel DC04+ZE and aluminum alloy AW5754-H111 as substrates adhesively bonded by an epoxy or a methacrylate. Methacrylate adhesive have shown greater shear strength in all types of adhesive joints. PDCPD joints presented the highest displacements. Surface degradation was considered adequate over abrading once none strength difference was seen between the different surface treatments. Steel treated by cataphoresis has shown the highest joint interface strength.

Development and psychometric properties of ECPICID-AVC to measure informal caregivers’ skills when caring for older stroke survivors at home

Introduction: Informal caregivers provide a significant part of the total care needed by dependent older people poststroke. Although informal care is often the preferred option of those who provide and those who receive informal care, informal caregivers often report lack of preparation to take care of older dependent people. This article outlines the development and psychometric testing of informal caregivers’ skills when providing care to older people after a stroke – ECPICID-AVC. Design: Prospective psychometric instrument validation study. Methods: Eleven experts participated in a focus group in order to delineate, develop and validate the instrument. Data were gathered among adult informal caregivers (n = 186) living in the community in Northern Portugal from August 2013 to January 2014. Results: The 32-item scale describes several aspects of informal caregiver’s skills. The scale has eight factors: skill to feed/hydrate by nasogastric feeding, skill to assist the person in personal hygiene, skill to assist the person for transferring, skill to assist the person for positioning, skill to provide technical aids, skill to assist the person to use the toilet, skill to feed/hydrate and skill to provide technical aids for dressing/undressing. Analysis demonstrated adequate internal consistency (Cronbach’s alpha = 0.83) and good temporal stability 0.988 (0.984–0.991). Conclusion: The psychometric properties of the measurement tool showed acceptable results allowing its implementation in clinical practice by the nursing community staff for evaluating practical skills in informal caregivers when providing care to older stroke survivors living at home.

Puberty in male collared peccary (Pecari tajacu) determined by quantitative analysis of spermatogenic cells

Biological studies are necessary for the management of wildlife in captivity, and knowledge of reproduction is one of the important features for increasing production. The objective of the research was to determine the age at which male collared peccaries reach puberty. Testicular samples of 15 animals, aged 7 to 16 months, distributed into five groups (G1, G2, G3, G4 and G5) were used. The testes showed considerably increased weight, length and width (p < 0.05) from G1 to G3, whereas, from this group onward, the development of this organ was slower. There was positive correlation (p < 0.001) between the following testicular parameters: weight and length (r = 0.97), weight and width (r = 0.88), length and width (r = 0.92). Regarding the diameter of seminiferous tubules, an increase was observed (p < 0.05) from G1 to G4. The total number of spermatogenic cells increased significantly (p < 0.05) until G3 and then it stabilized. There was also positive correlation between testis weight and tubular diameter (r = 0.99, p < 0.001), and testis weight and spermatogenic cells (r = 0.98, p < 0.001). The number of Sertoli cells decreased significantly (p < 0.05) from G1, when they were undifferentiated as support cells, to G5, when they occurred together with the complete line of spermatic cells. The results demonstrate that the reproductive development of peccaries can be classified into the following stages: impuberty (G1, 7-8 months); pre-pubertal (G2, 9-10 months); pubertal (G3, 11-12 months); post-pubertal 1 (G4, 13-14 months); and post-pubertal 2 (G5, 15-16 months). Based on the histological analyses, puberty in the male collared peccary was determined to occur between 11 and 12 months of age.

Dynamic modelling and analysis of hydraulic forces in radial blood pumps

Dissertação de mestrado integrado em Biomedical Engineering Biomaterials, Biomechanics and Rehabilitation

RNA-seq analysis of the Quercus suber root response to drought

Dissertação de mestrado em Plant Molecular Biology, Biotechnology and Bioentrepreneurship

Analysis of the risk factors for allograft vasculopathy in asymptomatic patients after cardiac transplantation

OBJECTIVE: To study the influence of immune and nonimmune risk factors on the development of allograft vasculopathy after cardiac transplantation. METHODS: We studied 39 patients with a mean age of 46±12 years. The following variables were analyzed: weight (kg), body mass index (kg/m²), donor's age and sex, rejection episodes in the first and second years after transplantation, systolic and diastolic blood pressures (mmHg), total cholesterol and fractions (mg/dL), triglycerides (mg/dL), diabetes, and cytomegalovirus infection. The presence of allograft vasculopathy was established through coronary angiography. RESULTS: Allograft vasculopathy was observed in 15 (38%) patients. No statistically significant difference was observed between the two groups in regard to hypertension, cytomegalovirus infection, diabetes, donor's sex and age, rejection episodes in the first and second years after transplantation, and cholesterol levels. We observed a tendency toward higher levels of triglycerides in the group with disease. Univariate and multivariate analyses showed statistically significant differences between the two groups when we analyzed the body mass index (24.53±4.3 versus 28.11±4.6; p=0.019). CONCLUSION: Body mass index was an important marker of allograft vasculopathy in the population studied.

An R package for the integrated analysis of metabolomics and spectral data

Recently, there has been a growing interest in the field of metabolomics, materialized by a remarkable growth in experimental techniques, available data and related biological applications. Indeed, techniques as Nuclear Magnetic Resonance, Gas or Liquid Chromatography, Mass Spectrometry, Infrared and UV-visible spectroscopies have provided extensive datasets that can help in tasks as biological and biomedical discovery, biotechnology and drug development. However, as it happens with other omics data, the analysis of metabolomics datasets provides multiple challenges, both in terms of methodologies and in the development of appropriate computational tools. Indeed, from the available software tools, none addresses the multiplicity of existing techniques and data analysis tasks. In this work, we make available a novel R package, named specmine, which provides a set of methods for metabolomics data analysis, including data loading in different formats, pre-processing, metabolite identification, univariate and multivariate data analysis, machine learning, and feature selection. Importantly, the implemented methods provide adequate support for the analysis of data from diverse experimental techniques, integrating a large set of functions from several R packages in a powerful, yet simple to use environment. The package, already available in CRAN, is accompanied by a web site where users can deposit datasets, scripts and analysis reports to be shared with the community, promoting the efficient sharing of metabolomics data analysis pipelines.

Acoustic emission analysis of the effect of a 2D wedge shaped blade on the compact bone cutting process

Surgeons may use a number of cutting instruments such as osteotomes and chisels to cut bone during an operative procedure. The initial loading of cortical bone during the cutting process results in the formation of microcracks in the vicinity of the cutting zone with main crack propagation to failure occuring with continued loading. When a material cracks, energy is emitted in the form of Acoustic Emission (AE) signals that spread in all directions, therefore, AE transducers can be used to monitor the occurrence and development of microcracking and crack propagation in cortical bone. In this research, number of AE signals (hits) and related parameters including amplitude, duration and absolute energy (abs-energy) were recorded during the indentation cutting process by a wedge blade on cortical bone specimens. The cutting force was also measured to correlate between load-displacement curves and the output from the AE sensor. The results from experiments show AE signals increase substantially during the loading just prior to fracture between 90% and 100% of maximum fracture load. Furthermore, an amplitude threshold value of 64dB (with approximate abs-energy of 1500 aJ) was established to saparate AE signals associated with microcracking (41 – 64dB) from fracture related signals (65 – 98dB). The results also demonstrated that the complete fracture event which had the highest duration value can be distinguished from other growing macrocracks which did not lead to catastrophic fracture. It was observed that the main crack initiation may be detected by capturing a high amplitude signal at a mean load value of 87% of maximum load and unsteady crack propagation may occur just prior to final fracture event at a mean load value of 96% of maximum load. The author concludes that the AE method is useful in understanding the crack initiation and fracture during the indentation cutting process.

Endemism analysis of Neotropical Pentatomidae (Hemiptera, Heteroptera)

The definition of areas of endemism is central to studies of historical biogeography, and their interrelationships are fundamental questions. Consistent hypotheses for the evolution of Pentatomidae in the Neotropical region depend on the accuracy of the units employed in the analyses, which in the case of studies of historical biogeography, may be areas of endemism. In this study, the distribution patterns of 222 species, belonging to 14 Pentatomidae (Hemiptera) genera, predominantly neotropical, were studied with the Analysis of Endemicity (NDM) to identify possible areas of endemism and to correlate them to previously delimited areas. The search by areas of endemism was carried out using grid-cell units of 2.5° and 5° latitude-longitude. The analysis based on groupings of grid-cells of 2.5° of latitude-longitude allowed the identification of 51 areas of endemism, the consensus of these areas resulted in four clusters of grid-cells. The second analysis, with grid-cells units of 5° latitude-longitude, resulted in 109 areas of endemism. The flexible consensus employed resulted in 17 areas of endemism. The analyses were sensitive to the identification of areas of endemism in different scales in the Atlantic Forest. The Amazonian region was identified as a single area in the area of consensus, and its southeastern portion shares elements with the Chacoan and Paraná subregions. The distribution data of the taxa studied, with different units of analysis, did not allow the identification of individual areas of endemism for the Cerrado and Caatinga. The areas of endemism identified here should be seen as primary biogeographic hypotheses.