935 resultados para Homogeneous regions
Resumo:
Direct Numerical Simulations (DNS) of turbulent n-heptane sprays autoigniting at high pressure (P=24bar) and intermediate air temperature (Tair=1000K) have been performed to investigate the physical mechanisms present under conditions where low-temperature chemistry is expected to be important. The initial turbulence in the carrier gas, the global equivalence ratio in the spray region, and the initial droplet size distribution of the spray were varied. Results show that spray ignition exhibits a spotty nature, with several kernels developing independently in those regions where the mixture fraction is close to its most reactive value ξMR (as determined from homogeneous reactor calculations) and the scalar dissipation rate is low. Turbulence reduces the ignition delay time as it promotes mixing between air and the fuel vapor, eventually resulting in lower values of scalar dissipation. High values of the global equivalence ratio are responsible for a larger number of ignition kernels, due to the higher probability of finding regions where ξ=ξMR. Spray polydispersity results in the occurrence of ignition over a wider range of mixture fraction values. This is a consequence of the inhomogeneities in the mixing field that characterize these sprays, where poorly mixed rich spots are seen to alternate with leaner ones which are well-mixed. The DNS simulations presented in this work have also been used to assess the applicability of the Conditional Moment Closure (CMC) method to the simulation of spray combustion. CMC is found to be a valid method for capturing spray autoignition, although care should be taken in the modelling of the unclosed terms appearing in the CMC equations. © 2013 The Combustion Institute.
Resumo:
Partially premixed compression ignition (PPCI) engines operating with a low temperature highly homogeneous charge have been demonstrated previously using conventional diesel fuel. The short ignition delay of conventional diesel fuel requires high fuel injection pressures to achieve adequate premixing along with high levels of EGR (exhaust gas recirculation) to achieve low NOx emissions. Low load operating regions are typified by substantial emissions of CO and HC and there exists an upper operating load limitation due to very high rates of in-cylinder gas pressure rise. In this study mixtures of gasoline and diesel fuel were investigated using a multi-cylinder light duty diesel engine. It was found that an increased proportion of gasoline fuel reduced smoke emissions at higher operating loads through an increase in charge premixing resulting from an increase in ignition delay and higher fuel volatility. The results of this investigation confirm that a combination of fuel properties, exhibiting higher volatility and increased ignition delay, would enable a widening of the low emission operating regime, but that consideration must be given to combustion stability at low operating loads. Copyright © 2007 SAE International.
Resumo:
The present paper considers distributed consensus algorithms for agents evolving on a connected compact homogeneous (CCH) manifold. The agents track no external reference and communicate their relative state according to an interconnection graph. The paper first formalizes the consensus problem for synchronization (i.e. maximizing the consensus) and balancing (i.e. minimizing the consensus); it thereby introduces the induced arithmetic mean, an easily computable mean position on CCH manifolds. Then it proposes and analyzes various consensus algorithms on manifolds: natural gradient algorithms which reach local consensus equilibria; an adaptation using auxiliary variables for almost-global synchronization or balancing; and a stochastic gossip setting for global synchronization. It closes by investigating the dependence of synchronization properties on the attraction function between interacting agents on the circle. The theory is also illustrated on SO(n) and on the Grassmann manifolds. ©2009 IEEE.
Resumo:
A duality transformation principle was proposed for converting a positive order homogeneous vectorfield into a negative order homogeneous vectorfield. The principle also converted a uniformly locally asymptotically stable differential equation into a uniformly bounded differential equation. The duality transformations included the geometric framework for homogeneity and the removal of origin from the state space.
Resumo:
The homogeneous ThO2-UO2 fuel cycle option for a pressurized water reactor (PWR) of current technology is investigated. The fuel cycle assessment was carried out by calculating the main performance parameters: natural uranium and separative work requirements, fuel cycle cost, and proliferation potential of the spent fuel. These performance parameters were compared with a corresponding slightly enriched (all-U) fuel cycle applied to a PWR of current technology. The main conclusion derived from this comparison is that fuel cycle requirements and fuel cycle cost for the mixed Th/U fuel are higher in comparison with those of the all-U fuel. A comparison and analysis of the quantity and isotopic composition of discharged Pu indicate that the Th/U fuel cycle provides only a moderate improvement of the proliferation resistance. Thus, the overall conclusion of the investigation is that there is no economic justification to introduce Th into a light water reactor fuel cycle as a homogeneous ThO2-UO2 mixture.
Resumo:
The proliferation potential of the present light water reactor (LWR) fuel cycle is related primarily to the quantity and the quality of the residual Pu contained in the spent-fuel stockpile, although other potentially “weapons usable” materials are also a concern. Thorium-based nuclear fuel produces much smaller amounts of Pu in comparison with standard LWR fuel, and consequently, it is more proliferation resistant than conventional slightly enriched all-U fuel; the long-term toxicity of the spent-fuel stockpile is also reduced
Resumo:
The dithiophene donor-acceptor copolymers that are bridged either with carbon (C-PCPDTBT) or silicon atoms (Si-PCPDTBT) belong to a promising family of materials for use in photoactive layers for organic photovoltaic cells (OPVs). In this work, we implement the non-destructive Spectroscopic Ellipsometry technique in the near infrared to the far ultraviolet spectral region in combination with advanced theoretical modeling to investigate the vertical distribution of the C-PCPDTBT and Si-PCPDTBT polymer and fullerene ([6,6]-phenyl C71-butyric acid methyl ester - PC70BM) phases in the blend, as well as the effect of the polymer-to-fullerene ratio on the distribution mechanism. It was found that the C-PCPDTBT:PC70BM blends have donor-enriched top regions and acceptor-enriched bottom regions, whereas the donor and acceptor phases are more homogeneously intermixed in the Si-PCPDTBT:PC70BM blends. We suggest that the chemical incompatibility of the two phases as expressed by the difference in their surface energy, may be a key element in promoting the segregation of the lower surface phase to the top region of the photoactive layer. We found that the increase of the photoactive layer thickness reduces the polymer enrichment at the cathode, producing a more homogeneous phase distribution of donor and acceptor in the bulk that leads to the increase of the OPV efficiency. © 2014 Elsevier B.V.
Resumo:
As a relatively isolated and unique freshwater population, the Yangtze finless porpoise (Neophocaena phocaenoides asiaeorientalis) is the most endangered subpopulation of this species. The objective of this study was to improve our understanding of their reproductive endocrinology by measuring (radioimmunoassay) serum concentrations of FSH, LH, estradiol (E-2), progesterone (P-4) and testosterone (T-2) in free-ranging animals. Blood samples were collected from 66 Yangtze finless porpoises (41 males and 25 females) captured in the middle and lower reaches of the Yangtze River. Based on significant variation of serum T-2 concentrations in males with body length (BL) > 138 cm, we inferred that they were mature; in these animals, there were significant seasonal variations in serum T-2 concentrations, with the highest concentrations in March and April (502.0 +/- 319.8 ng/dL, mean +/- S.D.) and the lowest in December (79.4 +/- 83.2 ng/dL). Serum T-2 concentrations positively correlated with serum concentrations of LH and weakly correlated with serum concentrations of E-2, whereas there was a significant negative correlation between serum LH and FSH concentrations in males > 138 cm. The smallest apparently pregnant female porpoise had a BL of 130 cm. Serum P-4 concentrations ranged from 13.2 to 112.4 ng/mL (43.9 +/- 28.3 ng/mL) in pregnant females, and fluctuated under 1.0 ng/mL in non-pregnant females with BL > 130 cm. Serum LH concentrations were significantly higher in non-pregnant females > 130 cm versus those females < 130 cm. To our knowledge, this is the first study of endocrine-related maturity and seasonal breeding characteristics of the Yangtze finless porpoise. (c) 2006 Elsevier Inc. All rights reserved.
Resumo:
In human and animal running spring-like leg behavior is found, and similar concepts have been demonstrated by various robotic systems in the past. In general, a spring-mass model provides self-stabilizing characteristics against external perturbations originated in leg-ground interactions and motor control. Although most of these systems made use of linear spring-like legs. The question addressed in this paper is the influence of leg segmentation (i.e. the use of rotational joint and two limb-segments) to the self-stability of running, as it appears to be a common design principle in nature. This paper shows that, with the leg segmentation, the system is able to perform self-stable running behavior in significantly broader ranges of running speed and control parameters (e.g. control of angle of attack at touchdown, and adjustment of spring stiffness) by exploiting a nonlinear relationship between leg force and leg compression. The concept is investigated by using a two-segment leg model and a robotic platform, which demonstrate the plausibility in the real world. ©2008 IEEE.
Resumo:
Microbial crusts are attracting much interest in view of their possible uses in environmental conservation and ecological restoration of the and and semiarid regions. Because algae play an irreplaceable important role in the early formation and the strengthening of microbial crusts, they are paid much more attention to than other cryptogams. In this paper, an overview of the current knowledge on the fine structure and development of microbial crust, focusing on the algal biomass, vertical distribution, succession, influential factors on algae, cohesion of soil stabilization, cementing mechanism for soil particles and the microalgal extracellular polymers is given, with particular emphasis on the authors' researches, and some prospects are put forward as well.
Resumo:
Small fish communities were compared between the vegetated and vegetation-free regions of the Liangzi Lake, a shallow lake along the middle reach of the Yangtze River, China. Fish were sampled using 10 x 10 m(2) block nets and poisoning. Three samples were taken from either the near shore area or lake centre of each region. A total of 19 fish species were collected; all species occurred in the vegetated region but only 12 occurred in the vegetation-free region. The dominant small fish were Carassius auratus auratus in the vegetated region and Ctenogobius giurinus in the vegetation-free region. Diversity, density and biomass of small fishes were significantly higher in the vegetated region than in the vegetation-free region in both near shore and lake centre areas. In the vegetated region, density and biomass of small fishes was significantly higher, while species diversity significantly lower in the near shore area than in the lake centre. In the vegetation-free region, density of small fishes was significantly higher in the near shore area than in the lake centre area, but species diversity or biomass was unaffected by location.
Resumo:
GaAs (001) substrates are patterned by electron beam lithography and wet chemical etching to control the nucleation of InAs quantum dots (QDs). InAs dots are grown on the stripe-patterned substrates by solid source molecular beam epitaxy, A thick buffer layer is deposited on the strip pattern before the deposition of InAs. To enhance the surface diffusion length of the In atoms, InAs is deposited with low growth rate and low As pressure. The AFM images show that distinct one-dimensionally ordered InAs QDs with homogeneous size distribution are created, and the QDs preferentially nucleate along the trench. With the increasing amount of deposited InAs and the spacing of the trenches, a number of QDs are formed beside the trenches. The distribution of additional QDs is long-range ordered, always along the trenchs rather than across the spacing regions.