Sensitivity of angler benefit estimates from a model of recreational demand to the definition of the substitute sites considered by the angler

Fishery managers are mandated to understand the effects that environmental damage, fishery regulations, and habitat improvement projects have on the net benefits that recreational anglers derive from their sport. Since 1994, the National Marine Fisheries Service (NMFS) has worked to develop a consistent method for estimating net benefits through site choice models of recreational trip demand. In estimating net benefits with these models, there is a tradeoff between computational efficiency and angler behavior in reality. This article examines this tradeoff by considering the sensitivity of angler-welfare estimates for an increase in striped bass (Morone saxatalis) angling quality across choice sets with five travel distance cutoffs and compares those estimates to a model with an unrestricted choice set. This article shows that 95% confidence intervals for welfare estimates of an increase in the striped bass catch and keep rate overlap for all distance-based choice sets specified here.

Sensitivity of wear rates in the micro-scale abrasion test to test conditions and material hardness

Micro-scale abrasion (ball cratering) tests were performed with different combinations of ball and bulk specimen materials, under different test conditions, such as load and abrasive slurry concentration. Wear modes were classified into two types: with rolling particle motion and with grooving particle motion. Wear rates observed with rolling particle motion were relatively insensitive to test conditions, whereas with grooving motion they varied much more. It is suggested that rolling abrasion is therefore a more appropriate mode if reproducible test results are desired. The motion of the abrasive particles can be reliably predicted from the knowledge of hardnesses and elastic properties of the ball and the specimen, and from the normal load and the abrasive slurry concentration. General trends in wear resistance measured in the micro-scale abrasion test with rolling particle motion are similar to those reported in tests with fixed abrasives with sliding particle motion, although the variation in wear resistance with hardness is significantly smaller. © 2004 Published by Elsevier B.V.