Deposição eletrolítica catódica e anódica simultâneas para minimizar interferências de cobre e chumbo na determinação espectrofotométrica de cádmio em água e alimentos via reação com Verde de Malaquita e iodeto

Simultaneous electrolytic deposition is proposed for minimization of Cu2+ and Pb2+ interferences on automated determination of Cd2+ by the Malachite Green-iodide reaction. During electrolysis of sample in a cell with two Pt electrodes and a medium adjusted to 5% (v/v) HNO3 + 0.1% (v/v) H2SO4 + 0.5 mol L-1 NaCl, Cu2+ is deposited as Cu on the cathode, Pb2+ is deposited as PbO2 on the anode while Cd2+ is kept in solution. With 60 s electrolysis time and 0.25 A current, Pb2+ and Cu2+ levels up to 50 and 250 mg L-1 respectively, can be tolerated without interference. With on-line extraction of Cd2+ in anionic resin minicolumn, calibration graph in the 5.00 - 50.0 µg Cd L-1 range is obtained, corresponding to twenty measurements per hour, 0.7 mg Malachite Green and 500 mg KI and 5 mL sample consumed per determination. Results of the determination of Cd in certified reference materials, vegetables and tap water were in agreement with certified values and with those obtained by GFAAS at 95% confidence level. The detection limit is 0.23 µg Cd L-1 and the RSD for typical samples containing 13.0 µg Cd L-1 was 3.85 % (n= 12).

A quimiluminescência como ferramenta analítica: do mecanismo a aplicações da reação do luminol em métodos cinéticos de análise

Relevant aspects of proposed mechanisms of the chemiluminescent reaction of luminol are presented and commented to emphasize its perspectives for kinetic analysis. A careful search for analytical applications of this reaction is discussed in order to point out new trends of the studies. Kinetic analysis using the luminol reaction is proposed to be a very attractive due to the good performance of the reaction in analytical applications and the positive characteristics of kinetic analysis, such as low cost and sensibility. It is pointed out that kinetic analysis using the chemiluminescent reaction of luminol should be encouraged.

Reação de bis-inserção de 1,2-difenilacetileno na ligação Pd-C de ciclometalados

The present paper deals with the bis-insertion reactions of 1,2-diphenylacetylene into Pd-C bond of the cyclopalladated complexes [Pd(dmba)(µ-NCO)]2 (1) and [Pd(dmba)(MeCN)2](NO3) (2) (dmba = N,N-dimethylbenzylamine, MeCN = acetonitrile). Two new complexes [Pd{PhC=CPh-CPh=CPhC6H4CH2N(CH 3)2}(NCO)] (3) and [Pd{PhC=CPh-CPh=CPhC6H4CH2N(CH 3)2}(NO3 )] (4) were obtained and characterized by IR and NMR spectroscopy and elemental analysis.

Catalisadores Ni/Al2O3 promovidos com molibdênio para a reação de reforma a vapor de metano

Mo-promoted Ni/Al2O3 catalysts for the methane steam reforming reaction were studied in this work. The Ni/Al2O3 catalysts were prepared by precipitation and molibdenum was added by impregnation up to 2%wt. The solids were tested using a micro-reactor under two H2Ov/C conditions and were characterized by ICP-OES, XRD, N2 adsoption, H2 chemisorption and TPR. NiO and NiAl2O4 phases were observed and the metallic area decreased with the increase of the Mo content. From the catalytic tests high stability was verified for H2Ov/C=4.0. On the other hand, only the catalyst containing 0,05% Mo stayed stable during 30 hours of the test at H2Ov/C=2.0.

Estudo do coeficiente de partição octanol-água de bifenilas policloradas (PCBs) utilizando parâmetros topológicos

A model based on chemical structure was developed for the accurate prediction of octanol/water partition coefficient (K OW) of polychlorinated biphenyls (PCBs), which are molecules of environmental interest. Partial least squares (PLS) was used to build the regression model. Topological indices were used as molecular descriptors. Variable selection was performed by Hierarchical Cluster Analysis (HCA). In the modeling process, the experimental K OW measured for 30 PCBs by thin-layer chromatography - retention time (TLC-RT) has been used. The developed model (Q² = 0,990 and r² = 0,994) was used to estimate the log K OW values for the 179 PCB congeners whose K OW data have not yet been measured by TLC-RT method. The results showed that topological indices can be very useful to predict the K OW.

Híbridos inorgânico-orgânicos derivados da reação de filossicatos com organossilanos

Silylation reactions involving hydroxylated surfaces are an important route for synthesis of new materials that could present selected properties, for application in different areas such as catalysis, chromatography, adsorption and electrochemistry. An overview of many synthetic routes, comprising organosilanes to yield phyllosilicates is now presented.

Qual o sítio de reação? Um experimento computacional

A computational quantum chemistry experiment is described on the determination of the most reactive atom in a molecule for a reaction. The reaction studied was the S N2 of 4-(dimethylamino)pyridine and methyl iodide. Several indexes (HOMO coefficent, (c), charges, (q), nucleophilic softness, (s+), and Fukui index, (f+)) were employed to verify which correctly describe what nitrogen will react. The calculations were made by AM1 and HF/STO-3G methods. The correct reactivity order is only reproduced by s+ and f+. The lack of agreement of FMO based indexes was discussed.

An energy efficient vertical handover decision algorithm

As wireless communications evolve towards heterogeneousnetworks, mobile terminals have been enabled tohandover seamlessly from one network to another. At the sametime, the continuous increase in the terminal power consumptionhas resulted in an ever-decreasing battery lifetime. To that end,the network selection is expected to play a key role on howto minimize the energy consumption, and thus to extend theterminal lifetime. Hitherto, terminals select the network thatprovides the highest received power. However, it has been provedthat this solution does not provide the highest energy efficiency.Thus, this paper proposes an energy efficient vertical handoveralgorithm that selects the most energy efficient network thatminimizes the uplink power consumption. The performance of theproposed algorithm is evaluated through extensive simulationsand it is shown to achieve high energy efficiency gains comparedto the conventional approach.

Efeito do teor metálico em catalisadores Co/Al2O3 aplicados à reação de reforma a vapor de etanol

The development of cobalt catalysts to produce hydrogen from ethanol is the goal of this investigation. Co/Al2O3 catalysts were prepared by impregnation and characterized by atomic absorption, nitrogen adsorption, X-ray diffraction, Raman spectroscopy, temperature programmed reduction and carbon analysis. The catalysts contained Co3O4 oxide and Co3+ and Co2+ species interacting with alumina. The cobalt load affects the crystal size and the crystalline structure and higher Co loads influence the reaction mechanism, changing the selectivity of the catalysts, decreasing the amount of CO produced and avoiding the formation of products catalyzed by the support. The ethanol conversion was 50-70% with 10-<1% of CO in the hydrogen.

Otimização da reação de interesterificação química do óleo de palma

The Brazilian market has been showing a growing concern with nutritional values of oil components of foods. Chemical interesterification is a promising alternative to the current processes of modifying the consistency of oils. Chemical interesterification of deodorized palm oil was studied on a laboratory scale. The best results were obtained with 0.4% MeONa and heating for 20 min at 100 &deg;C. These conditions are based on the largest variation in triacylglycerols as compared to a control. The trisaturated values varied from 6.2 to 9.9%, showing that the consistency of the oil improved for it to be used in margarines, without the formation of trans isomers.

A reação de metátese de olefinas: reorganização e ciclização de compostos orgânicos

The olefin metathesis reaction allows the exchange of complex alkyl units between two olefins, with the formation of a new olefinic link and a sub-product olefin usually ethylene. This reaction has found extensive application in the last ten years with the development of the Grubbs and Schrock catalysts, in total synthesis of complex organic molecules, as opposed to the very important use in the petrochemical industry with relatively simple molecules. This review intends to trace a historical and mechanistic pathway from industry to academy, before illustrating the more recent advances.

Parâmetros termodinâmicos da reação de adsorção de boro em solos tropicais altamente intemperizados

The driving force of boron adsorption on some tropical soils was evaluated by means of thermodynamic parameters. The batch method was employed, and the reaction was monitored at different pH values. The Langmuir equation successfully fitted the experimental results and provided reasonable isotherm parameters. Boron adsorption increased as a function of the pH of the soil solution and the concentration of added boron. The reaction was favorable and proceeded spontaneously, being strongly exoergic, as indicated by a negative free energy (deltaG) and a separation factor (K R) < 1. The boron adsorption phenomenon and the soil-solution interface were thermodinamically described using a theoretical model.

Síntese de aliloxi-orto-iodobenzamida derivada de d-glicose e reação de ciclização radicalar mediada por hidreto de tri-n-butilestanho

Methyl 6-O-allyl-2,3-di-O-benzyl-4-deoxy-4-(2 -iodobenzoylamine)-alpha-D-glucopyranoside was synthesized in nine conventional steps from methyl alpha-D-glucopyranoside. Its Bu3SnH-mediated aryl radical cyclization provided a benzomacrolactam, resulting from 11-endo aryl radical cyclization and the reduced uncyclized product methyl 6-O-allyl-4-benzoylamine-2,3-di-O-benzyl-4-deoxy- alpha-D-glucopyranoside. The structures of the three new products were supported by ¹H and 13C NMR spectroscopy and DEPT, COSY and HMQC experiments.

Determinação do coeficiente de distribuição (Kd) de benzo(a)pireno em solo por isotermas de sorção

Leaking of diesel oil from gas stations is frequent in Brazil. The presence of polycyclic aromatic hydrocarbons (PAHs), which are highly toxic is an indication of contamination by heavy hydrocarbons from diesel oil. Here were present the determination of the distribution coefficient (Kd) of benzo(a)pyrene (the most carcinogenic of the PAHs) in tropical soils using the sorption isotherm model. The sorption curves acquired for benzo(a)pyrene were of the S-type, probably due to the water/methanol experimental conditions. The sorption curves allowed calculation of the distribution coefficient (Kd). The experimental Kd values were lower than those calculated from literature Koc values (partition coefficient normalized by organic carbon), due mainly to the cosolvency effect and the percentage of organic matter and clay in soil.

A reação de ciclização de prins: uma estratégia eficiente para síntese estereosseletiva de anéis tetraidropirânicos substituídos

The Prins cyclization reaction has significantly advanced in the last years as demonstrated by a number of applications described in the literature. The objective of this report is to introduce this powerful synthetic methodology to the undergraduate and graduated student, since it is rarely presented in an organic synthesis formal course. This reaction is, in some cases, the methodology of choice for the preparation of natural products or drugs that present the tetrahydropyrane moiety in their structures. In this report we show some aspects of this reaction, including mechanism, scope and limitations.