A review and simplification of the in vitro incubation medium

The requirement to rapidly and efficiently evaluate ruminant feedstuffs places increased emphasis on in vitro systems. However, despite the developmental work undertaken and widespread application of such techniques, little attention has been paid to the incubation medium. Considerable research using in vitro systems is conducted in resource-poor developing countries that often have difficulties associated with technical expertise, sourcing chemicals and/or funding to cover analytical and equipment costs. Such limitations have, to date, restricted vital feed evaluation programmes in these regions. This paper examines the function and relevance of the buffer, nutrient, and reducing solution components within current in vitro media, with the aim of identifying where simplification can be achieved. The review, supported by experimental work, identified no requirement to change the carbonate or phosphate salts, which comprise the main buffer components. The inclusion of microminerals provided few additional nutrients over that already supplied by the rumen fluid and substrate, and so may be omitted. Nitrogen associated with the inoculum was insufficient to support degradation and a level of 25 mg N/g substrate is recommended. A sulphur inclusion level of 4-5 mg S/g substrate is proposed, with S levels lowered through omission of sodium sulphide and replacement of magnesium sulphate with magnesium chloride. It was confirmed that a highly reduced medium was not required, provided that anaerobic conditions were rapidly established. This allows sodium sulphide, part of the reducing solution, to be omitted. Further, as gassing with CO2 directly influences the quantity of gas released, it is recommended that minimum CO, levels be used and that gas flow and duration, together with the volume of medium treated, are detailed in experimental procedures. It is considered that these simplifications will improve safety and reduce costs and problems associated with sourcing components, while maintaining analytical precision. (c) 2005 Elsevier B.V. All rights reserved.

Acid dissociation of 2,2 '-dipyridylamine in non-aqueous medium when chelated to some Ru(II)N-4 cores

[Ru(2,2'-bipyridine)(2)(Hdpa)](BF4)(2) center dot 2H(2)O (1), [Ru(1,10-phenanthroline)(2)(Hdpa)] (PF6)(2) center dot CH2Cl2 (2) and [Ru(4,4,4',4'-tetramethyl-2,2'- bisoxazoline)(2)(Hdpa)] (PF6)(2) (3) are synthesized where Hdpa is 2,2'-dipyridylamine. The X-ray crystal structures of 1 and 2 have been determined. Hdpa in 1 and 2 is found to bind the metal via the two pyridyl N ends. Comparing the NMR spectra in DMSO-d(6), it is concluded that 3 has a similar structure. The pK(a) values (for the dissociation of the NH proton in Hdpa) of free Hdpa and its complexes are determined in acetonitrile by exploiting molar conductance. These correlate linearly with the chemical shift of the NH proton in the respective entities. (C) 2007 Elsevier B.V. All rights reserved.

Synthesis of fused cyclic systems containing medium-sized rings through tandem ROM-RCM of norbornene derivatives embedded in a carbohydrate template

A general approach for the synthesis of fused cyclic systems containing medium-sized rings (7-9) has been developed. The key steps involve a diastereoface-selective Diels-Alder reaction of the dienophiles 4a-d attached to a furanosugar with cyclopentadiene and ring opening (ROM)-ring closing metathesis (RCM) of the resulting norbornene derivatives 10a-d and 11a-d. Diels-Alder reaction of the dienophiles 4a-d with cyclopentadiene in the absence of a catalyst produced 10a-d as the major product arising through addition of the diene to the unhindered Si-face. The most interesting and new aspect of the Diels-Alder reaction of these dienophiles is the accessibility of the Re-face that was blocked by the alkenyl chains under Lewis acid catalysis producing the diastereoisomers 11a-d exclusively. The reversal of facial selectivity from an uncatalyzed reaction to a catalyzed one is unprecedented. The observed stereochemical dichotomy is attributed to rotation of the enone moiety along the or bond linking the sugar moiety during formation of the chelate 13. This makes the Re-face of the enone moiety in 4a-d unhindered. Diels-Alder reaction of the carbocyclic analogue 15 under Lewis acid catalysis produced a 1: 1 mixture of the adducts 16 and 17 confirming the participation of sugar ring oxygen in chelate formation. Finally ROM-RCM of 10a-d and 11a-d with Grubbs' catalyst afforded the cis-syn-cis and cis-anti-cis bicyclo-annulated sugars 21a-d and 23a-d, respectively, containing 7-9 membered rings.

Effect of culture medium and cryoprotectants on the growth and survival of probiotic lactobacilli during freeze drying

To investigate the effects of the medium and cryoprotective agents used on the growth and survival of Lactobacillus plantarum and Lactobacillus rhamnosus GG during freeze drying. A complex medium was developed consisting primarily of glucose, yeast extract and vegetable-derived peptone. Trehalose, sucrose and sorbitol were examined for their ability to protect the cells during freeze drying. Using standardized amount of cells and the optimized freeze drying media, the effect of the growth medium on cell survival during freeze drying was investigated. The results showed that glucose and yeast extract were the most important growth factors, while sucrose offered better protection than trehalose and sorbitol during freeze drying. When the cells were grown under carbon limiting conditions, their survival during freeze drying was significantly decreased. A clear relationship was observed between cell growth and the ability of the cells to survive during the freeze drying process. The survival of probiotic strains during freeze drying was shown to be dependent on the cryoprotectant used and the growth medium.

An enhanced relay-enabled medium access control protocol for wireless ad hoc networks

In this paper we propose an enhanced relay-enabled distributed coordination function (rDCF) for wireless ad hoc networks. The idea of rDCF is to use high data rate nodes to work as relays for the low data rate nodes. The relay helps to increase the throughput and lower overall blocking time of nodes due to faster dual-hop transmission. rDCF achieves higher throughput over IEEE 802.11 distributed coordination function (DCF). The protocol is further enhanced for higher throughput and reduced energy. These enhancements result from the use of a dynamic preamble (i.e. using short preamble for the relay transmission) and also by reducing unnecessary overhearing (by other nodes not involved in transmission). We have modeled the energy consumption of rDCF, showing that rDCF provides an energy efficiency of 21.7% at 50 nodes over 802.11 DCF. Compared with the existing rDCF, the enhanced rDCF (ErDCF) scheme proposed in this paper yields a throughput improvement of 16.54% (at the packet length of 1000 bytes) and an energy saving of 53% at 50 nodes.

Students' assessment of immersive virtual reality as a pedagogic medium

Over the past few years a number of research studies, mainly involving desktop-based or head-mounted Virtual Reality (VR) systems, have been undertaken to determine what VR can contribute to the education process. In our study we have used the findings from a number of these studies to help in formulating a new study into the perceived merits and limitations of using VR in general, and immersive CAVE-like systems in particular, as an education tool. We conducted our study with a group of final year undergraduate students who were registered on a module that described VR in terms of the scientific issues, application areas, and strengths and weaknesses of the technology.

Polymer − surfactant vesicular complexes in aqueous medium

The introduction of ionic single-tailed surfactants to aqueous solutions of EO18BO10 [EO = poly(ethylene oxide), BO = poly(1,2-butylene oxide), subscripts denote the number of repeating units] leads to the formation of vesicles, as probed by laser scanning confocal microscopy. Dynamic light scattering showed that the dimensions of these aggregates at early stages of development do not depend on the sign of the surfactant head group charge. Small-angle X-ray scattering (SAXS) analysis indicated the coexistence of smaller micelles of different sizes and varying polymer content in solution. In strong contrast to the dramatic increase of size of dispersed particles induced by surfactants in dilute solution, the d-spacing of corresponding mesophases reduces monotonically upon increasing surfactant loading. This effect points to the suppression of vesicles as a consequence of increasing ionic strength in concentrated solutions. Maximum enhancements of storage modulus and thermal stability of hybrid gels take place at different compositions, indicating a delicate balance between the number and size of polymer-poor aggregates (population increases with surfactant loading) and the number and size of polymer−surfactant complexes (number and size decrease in high surfactant concentrations).

The surface geometries of the medium and high coverage carbon monoxide structures c(2 × 4)–(2CO) and p(root7- x root7)R19°–(4CO) structure

The surface geometries of the p (root7- x root7)R19degrees-(4CO) and c(2 x 4)-(2CO) layers on Ni {111} and the clean Ni {111} surface were determined by low energy electron diffraction structure analysis. For the clean surface small but significant contractions of d(12) and d(23) (both 2.02 Angstrom) were found with respect to the bulk interlayer distance (2.03 Angstrom). In the c(2 x 4)-(2CO) structure these distances are expanded, with values of d(12) = 2.08 Angstrom and d(23) = 2.06 Angstrom and buckling of 0.08 and 0.02 Angstrom, respectively, in the first and second layer. CO resides near hcp and fcc hollow sites with relatively large lateral shifts away from the ideal positions leading to unequal C-Ni bond lengths between 1.76 and 1.99 Angstrom. For the p(root7- x root7-)R19'-(4CO) layer two best fit geometries were found, which agree in most of their atomic positions, except for one out of four CO molecules, which is either near atop or between bridge and atop. The remaining three molecules reside near hcp and fcc sites, again with large lateral deviations from their ideal positions. The average C Ni bond length for these molecules is, however, the same as for CO on hollow sites at low coverage. The average CNi bond length at hollow sites, the interlayer distances, and buckling in the first Ni layer are similar to the c(2 x 4)(2CO) geometry, only the buckling in the second layer (0.08 Angstrom) is significantly larger. Lateral and vertical shifts of the Ni atoms in the first layer lead to unsymmetric environments for the CO molecules, which can be regarded as an imprint of the chiral p(root7- x root7-)R19degrees lattice geometry onto the substrate.