Brazilian fruit pulps as functional foods and additives: Evaluation of bioactive compounds

Eight tropical fruit pulps from Brazil were simultaneously characterised in terms of their antioxidant and antimicrobial properties. Antioxidant activity was screened by DPPH radical scavenging activity (126–3987 mg TE/100 g DW) and ferric reduction activity power (368–20819 mg AAE/100 g DW), and complemented with total phenolic content (329–12466 mg GAE/100 g DW) and total flavonoid content measurements (46–672 mg EE /100 g DW), whereas antimicrobial activity was tested against the most frequently found food pathogens. Acerola and açaí presented the highest values for the antioxidant-related measurements. Direct correlations between these measurements could be observed for some of the fruits. Tamarind exhibited the broadest antimicrobial potential, having revealed growth inhibition of Pseudomonas aeruginosa. Escherichia coli, Listeria monocytogenes, Salmonella sp. and Staphylococcus aureus. Açaí and tamarind extracts presented an inverse relationship between antibacterial and antioxidant activities, and therefore, the antibacterial activity cannot be attributed (only) to phenolic compounds.

Validation of QuEChERS method for organochlorine pesticides analysis in tamarind (Tamarindus indica) products: Peel, fruit and commercial pulp

In this study a citrate-buffered version of QuEChERS (Quick, Easy, Cheap, Effective, Rugged and Safe) method for determination of 14 organochlorine pesticides (OCPs) residues in tamarind peel, fruit and commercial pulp was optimized using gas chromatography (GC) coupled with electron-capture detector (ECD) and confirmation by GC tandem mass spectrometry (GC–MS/MS). Five procedures were tested based on the original QuEChERS method. The best one was achieved with increased time in ultrasonic bath. For the extract clean-up, primary secondary amine (PSA), octadecyl-bonded silica (C18) and magnesium sulphate (MgSO4) were used as sorbents for tamarind fruit and commercial pulp and for peel was also added graphitized carbon black (GCB). The samples mass was optimized according to the best recoveries (1.0 g for peel and fruit; 0.5 g for pulp). The method results showed the matrix-matched calibration curve linearity was r2 > 0.99 for all target analytes in all samples. The overall average recoveries (spiked at 20, 40 and 60 μg kg−1) have been considered satisfactory presenting values between 70 and 115% with RSD of 2–15 % (n = 3) for all analytes, with the exception of HCB (in peel sample). The ranges of limits of detection (LOD) and quantification (LOQ) for OCPs were for peel (LOD: 8.0–21 μg kg−1; LOQ: 27–98 μg kg−1); for fruit (LOD: 4–10 μg kg−1; LOQ: 15–49 μg kg−1) and for commercial pulp (LOD: 2–5 μg kg−1; LOQ: 7–27 μg kg−1). The method was successfully applied in tamarind samples being considered a rapid, sensitive and reliable procedure.

Cation transporters/channels in plants: Tools for nutrient biofortification

Cation transporters/channels are key players in a wide range of physiological functions in plants, including cell signaling, osmoregulation, plant nutrition and metal tolerance. The recent identification of genes encoding some of these transport systems has allowed new studies toward further understanding of their integrated roles in plant. This review summarizes recent discoveries regarding the function and regulation of the multiple systems involved in cation transport in plant cells. The role of membrane transport in the uptake, distribution and accumulation of cations in plant tissues, cell types and subcellular compartments is described. We also discuss how the knowledge of inter- and intra-species variation in cation uptake, transport and accumulation as well as the molecular mechanisms responsible for these processes can be used to increase nutrient phytoavailability and nutrients accumulation in the edible tissues of plants. The main trends for future research in the field of biofortification are proposed.

In vitro antimalarial activity and cytotoxicity of some selected cuban medicinal plants

Terrestrial plants have been demonstrated to be sources of antimalarial compounds. In Cuba, little is known about antimalarial potentials of plant species used as medicinals. For that reason, we evaluated the antimalarial activity of 14 plant species used in Cuba as antimalarial, antipyretic and/or antiparasitic. Hydroalcoholic extracts were prepared and tested in vitro for the antimalarial activity against Plasmodium falciparum Ghana strain and over human cell line MRC-5 to determine cytotoxicity. Parasite multiplication was determined microscopically by the direct count of Giemsa stained parasites. A colorimetric assay was used to quantify cytotoxicity. Nine extracts showed IC50 values lower than 100 µg/mL against P. falciparum, four extracts were classified as marginally active (SI < 4), one as partially active (Parthenium hysterophorus) exhibiting SI equal to 6.2 and two extracts as active (Bambusa vulgaris and Punica granatum), showing SI > 10. B. vulgaris showed the most potent and specific antiplasmodial action (IC50 = 4.7 µg/mL, SI = 28.9). Phytochemical characterization of active extracts confirmed the presence of triterpenoids in B. vulgaris and polar compounds with phenol free groups and fluorescent metabolites in both extracts as major phytocompounds, by thin layer chromatography. In conclusion, antimalarial use of B. vulgaris and P. hysterophorus was validated. B. vulgaris and P. granatum extracts were selected for follow-up because of their strong antimalarial activity.

Effect of bioactive compounds extracted from euphorbious plants on hematological and biochemical parameters of Channa punctatus

Channa punctatus was exposed to four different concentrations of Rutin, Taraxerol and Apigenin. Changes in some hematological parameters of Channa punctatus were assessed to determine the influence of these compounds on test fish. Fish were exposed to sublethal concentrations (80% of LC50 of 24h) of these compounds for one week. Control fish were also administered for one week. Thereafter, blood samples were obtained from the control and experimental fish. Blood was assayed for selected hematological parameters (hematocrit, hemoglobin, red blood cell count, white blood cell count total plasma protein and plasma glucose concentration). The derived hematological indices of mean corpuscular hemoglobin concentration (MCHC), mean corpuscular hemoglobin (MCH) and mean corpuscular volume (MCV) were calculated. Sublethal concentrations of these compounds caused a dose dependent decrease in hemoglobin values coupled with a decrease in hematocrit values and red blood cell counts are an obvious indication of anemia. The total white blood cell counts and the differential white blood cell counts were decreased except for the lymphocytes, where there was a slight increase. Plasma protein and glucose were also lower in exposed fish when compared with control. The hematological indices MCH, MCHC, MCV were also lowered. The result from this study reveals high mortality rate and deleterious consequences on the health of fish subjected to acute exposure of Rutin, Taraxerol and Apigenin and therefore, should not be used directly in aquaculture without having the proper knowledge.

Risk-based decision support system for life cycle management of industrials plants

Dissertação para obtenção do Grau de Doutor em Engenharia Electrotécnica e de Computadores

Spatial point pattern analysis of gorilla nest sites in the Kagwene Sanctuary, Cameroon: Towards understanding the nesting behavior of a critically endangered subspecies

Dissertation submitted in partial fulfillment of the requirements for the Degree of Master of Science in Geospatial Technologies.

Insights into the role of almond CBF transcription factors in the environmental control of cold acclimation and dormancy break

Dissertation presented to obtain the Ph.D degree in Biology

Evaluation of neuroprotective potential of plyphenols derived from Portuguese native plants: Juniperus sp. and Rubus sp.

Dissertation presented to obtain the Ph.D degree in Biochemistry

Plants used in the treatment of leishmanial ulcers due to Leishmania (Viannia) braziliensis in an endemic area of Bahia, Brazil

This paper records the plants used in the treatment of cutaneous leishmaniasis due to Leishmania (Viannia) braziliensis (L(V)b) among the rural population of a cocoa- producing coastal area of Bahia state, Brazil. An enquiry conducted among a hundred patients identified 49 plant species used to treat skin ulceration caused by this Leishmania species. The principal plants used are caju-branco (Anacardium occidentale - Anacardiaceae), used by 65% of the population, folha-fogo (Clidemia hirta - Melastomataceae) 39%, alfavaca-grossa (Plectranthus amboinicus - Lamiaceae) 33%, mastruz (Chenopodium ambrosioides - Chenopodiaceae) 31%, erva-de-santa-maria (Solatium americanum - Solanaceae) (25%) and transagem (Plantago major - Plantaginaceae.) 2%.

Study on the valorization routes of ashes from thermoelectric power plants working under mono-and co-combustion regimes

Thesis submitted to obtain the Doctoral degree in Energy and Bioenergy

Monda mecânica de flores em pessegueiro: impacto na qualidade e produtividade da "Very Good" na região de Castelo Branco

Dissertação apresentada à Escola Superior Agrária do Instituto Politécnico de Castelo Branco para cumprimento dos requisitos necessários à obtenção do grau de Mestre em Engenharia Agronómica.

Preliminary assessment of medicinal plants used as antimalarials in the southeastern Venezuelan Amazon

Eighteen species of medicinal plants used in the treatment of malaria in Bolívar State, Venezuela were recorded and they belonged to Compositae, Meliaceae, Anacardiaceae, Bixaceae, Boraginaceae, Caricaceae, Cucurbitaceae, Euphorbiaceae, Leguminosae, Myrtaceae, Phytolaccaceae, Plantaginaceae, Scrophulariaceae, Solanaceae and Verbenaceae families. Antimalarial plant activities have been linked to a range of compounds including anthroquinones, berberine, flavonoids, limonoids, naphthquinones, sesquiterpenes, quassinoids, indol and quinoline alkaloids.

Fermentation of fruit juices by the osmotolerant yeast Candida magnoliae

This study focuses on the assessment of the fermentation conditions required to modulate the metabolic flux in the osmotolerant yeast Candida magnoliae and evaluate its potential to produce low-alcoholic and low-caloric fermented beverages. For that purpose, two strains, PYCC 2903 and PYCC 3191, were used and fermentation conditions as oxygenation, sugar concentration and the ratio of glucose to fructose were studied using synthetic culture media. Candida magnoliae PYCC 2903 was subsequently used to ferment real industrial fructose-rich substrates such as fruit juices. Sugar consumption profiles for C.magnoliae PYCC 2903 incubated aerobically in the presence of high fructose and glucose concentrations (15%, 10% and 5%) showed a selective utilization of fructose, denoting a preference for this sugar over glucose. The lower ratio between ethanol and sugar alcohols yield was obtained for both strains incubated under oxygen limitation simulating industrial fructose-rich substrates, confirming the ability of this yeast to direct fermentation towards alternative products. Enzymatic assays for hexokinase activity in terms of capacity and affinity for glucose and fructose were performed, aiming to elucidate its contribution to the fructophilic behaviour of this yeast. Enzymatic assays for both strains showed that the Vmax is two to threefold higher for fructose than for glucose but Km is also 10-20-fold higher for this sugar than for glucose. Hence, hexokinase kinetic properties do not explain fructophily in C.magnoliae. This indicates that fructose transport is probably determining in this respect, as observed for other fructophilic yeasts. Fruit juice fermentations with C.magnoliae PYCC 2903 revealed a potential for the production of beverages with interesting sensorial properties. Pear and peach fermentations exhibited the best results with the lowest ratio between ethanol and sugar alcohols yield and the most pleasant organoleptic features.

Context-based identification of energy consumption in industrial plants

Nowadays, reducing energy consumption is one of the highest priorities and biggest challenges faced worldwide and in particular in the industrial sector. Given the increasing trend of consumption and the current economical crisis, identifying cost reductions on the most energy-intensive sectors has become one of the main concerns among companies and researchers. Particularly in industrial environments, energy consumption is affected by several factors, namely production factors(e.g. equipments), human (e.g. operators experience), environmental (e.g. temperature), among others, which influence the way of how energy is used across the plant. Therefore, several approaches for identifying consumption causes have been suggested and discussed. However, the existing methods only provide guidelines for energy consumption and have shown difficulties in explaining certain energy consumption patterns due to the lack of structure to incorporate context influence, hence are not able to track down the causes of consumption to a process level, where optimization measures can actually take place. This dissertation proposes a new approach to tackle this issue, by on-line estimation of context-based energy consumption models, which are able to map operating context to consumption patterns. Context identification is performed by regression tree algorithms. Energy consumption estimation is achieved by means of a multi-model architecture using multiple RLS algorithms, locally estimated for each operating context. Lastly, the proposed approach is applied to a real cement plant grinding circuit. Experimental results prove the viability of the overall system, regarding both automatic context identification and energy consumption estimation.