Interference of Vaccinal Antibodies on Serological Diagnostic of Leptospirosis in Vaccinated Buffalo using Two Types of Commercial Vaccines

The vaccinal antibodies interference represents one of the problems in the leptospirosis diagnostic on serum. The present study aimed to determine the pattern of serum agglutinins anti-Leptospirae spp in vaccinated female buffaloes against leptospirosis using two types of commercial vaccines: bacterin and extern membrane. The temporal interference of vaccinal titers on serum diagnostic was evaluated. Three groups of 11 adult female buffaloes were established as follows: G1 control, non-vaccinated; G2: vaccinated with bacterin containing six serovars and G3 with extern membrane vaccine containing five serovars. A booster was administered at 30 days from the first vaccination (dfv) and two re- vaccinations were performed in each semester (days 210 and 390). Serum samples were collected on days 0, 15, 30, 45 and 60 and every 30 days until 540 dfv, being submitted to Serum Agglutination Microscopy (SAM) against the serovars present in the vaccine. G1 remained always negative. Both vaccines induced serologic responses when assessed by SAM at 150 days post first vaccination against all serovars and they revealed maximum titers around days 45 and 60 after first vaccination. At the re-vaccination there was an increase on agglutinin levels, but of less intensity than the levels previously observed. After six months from the second revaccination (540 dfv), they were almost zero, which demonstrates the short duration of diagnostic interference. The serologic monitoring of the vaccinated herds can be an efficient method to evaluate the status of protection provided by the vaccine.

Influence of Three Types of Abutments on Preload Values Before and After Cyclic Loading with Structural Analysis by Scanning Electron Microscopy

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

The influence of landscape on the spatial and temporal distribution of stream macroalgal communities of two types of subtropical biomes

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Petroleum products biodegradation profile similarity evaluated by F test comparison of weekly CO2 production

Strategies applied to bioremediation contaminated environments are necessary to identify limitations towards biodegradation and to predict remediation performance and thereby rule out technologies that may be inappropriate for the clean-up of the substances of concern. Respirometry applied to bioremediation offers a series of advantages for obtaining CO2 production data when compared to other procedures. It was possible to determinate information regarding the atmosphere's CO2 concentration inside a respirometer containing petroleum products. Afterwards, the CO2 data obtained underwent an in depth statistical analysis by F test. There are some noticeable biodegradation similarity among some substances, such as weathered motor oil and gasoline. Such data provides reliability when revealing important information about how the biodegradation processes happens in those residual oils.

Technical and economic evaluation of different types of control of Brevipalpus phoenicis (Acari: Tenuipalpidae) in citrus leprosies management

The objective of this work was to evaluate the effect of acaricide applications and pruning of symptomatic branches in citrus leprosis management in Brazil. It was conducted in an orange plantation of the 'Pera' variety, grafted onto the 'Cleopatra' tangerine, in two seasons (2006-2007 and 2007-2008). The experimental design was randomized blocks in a factorial scheme consisting of the following factors: (A) acaricide, in three levels: spirodiclofen and cyhexatin applied in rotation, lime sulphur; no acaricides; (B) pruning to remove branches that showed symptoms of leprosis, with two levels: with pruning, without pruning. We carried out periodic assessments of Brevipalpus phoenicis (Geijskes) populations (vector of the leprosis virus), leprosis incidence and severity, fruit yield, and the economic feasibility of the applied strategies. Based on the results, we concluded that spirodiclofen and cyhexatin were more effective than lime sulphur in B. phoenicis control. Control with lime sulphur required more applications than spirodiclofen and cyhexatin in rotation, making it more expensive. Pruning of symptomatic branches used in isolation was not sufficiently effective to control leprosis and significantly increased control costs. Profits were higher when the control involved sprayings of spirodiclofen and cyhexatin in alternation, with or without pruning.

Phytotherapy in the control of helminthiasis in production animals

Parasitic diseases constitute one of the main problems affecting livestock; however the use of chemical medicaments provides drug resistance residues in animal and environmental contamination. Changes in production concepts require that food must be produced in hygienic conditions, per healthy animals and that are not eliminating antibiotic residues, pesticides or other drugs. This scenario has favored organic production and the use of medicinal plants. For the control of endoparasites, several studies have published the benefits of Azadirachta indica A. Juss., Punica granatum Linn., Musa sp., Operculina hamiltonii G. DON., propolis, among others. However, despite the existence in- vitro studies that demonstrate the pharmacological properties of phytotherapics, there is still need for clinical trials to determine dosage and its effects in- vivo. Investigations of new bioactive natural substances can be of great value for the control of animal health and food safety, which is particularly important for organic production systems in which the use of chemical drugs is a limiting factor for certification.

Effects of short-term immersion and brushing with different denture cleansers on the roughness, hardness, and color of two types of acrylic resin

Purpose: To investigate the cumulative effects of brushing (B) or immersion (I), using different cleansing agents, on the surface roughness, hardness and color stability of a heat-polymerized denture resin, Lucitone 550 (L), and a hard chairside reline resin, Tokuyama Rebase Fast II (T). Methods: A total of 316 specimens (10 x 2 mm) were fabricated. The specimens (n= 9) were divided into brushing or immersion groups according to the following agents: dentifrice/distilled water (D), 1% sodium hypochlorite (Na0C1), Corega Tabs (Pb), 1% chlorhexidine gluconate (Chx), and 0.2% peracetic acid (Ac). Brushing and immersion were tested independently. Assays were performed after 1, 3, 21, 45 and 90 blushing cycles or immersion of 10 seconds each. Data were evaluated statistically by repeated measures ANOVA. Tukey's honestly significant difference (HSD) post-hoc test was used to determine differences between means (a= 0.05). Results: For L there was no statistically significant difference in roughness, except a significant decrease in roughness by brushing with D. T showed a significant effect on the roughness after 90 immersions with Ac. Hardness values decreased for L when specimens were immersed or brushed in Na0C1 and Pb. The hardness of T decreased with increases in the repetitions (immersion or brushing), regardless of the cleaning method. Values of color stability for L resin showed significant color change after brushing with and immersion in Ac and Pb. Brushing with D exhibited a higher incidence of color change. For T there were no significant differences between cleaning agents and repetitions in immersion. A color change was noted after three brushings with the Ac, Chx, and D. Brushing with dentifrice decreased roughness of L. Immersion in or brushing with Na0C1 and Pb decreased the hardness of L. For T, hardness decreased with increases in immersions or brushing. Color changes after the immersion in or brushing with cleaning agents were clinically acceptable according to National Bureau of Standards parameters for both resins.

Biological compatibility of some types of endodontic calcium hydroxide and glass ionomer cements

The purpose of this work was to evaluate the biological compatibility of the Sealapex, Apexit, Sealer 26 and Ketac Endo endodontic cements. Polyethylene tubes containing these cements were implanted in the subcutaneous tissue of 40 (forty) rats. The animals were sacrificed after 14 and 90 days. A descriptive analysis of the reactions found in the connective tissue by contact with the cements was performed. The magnitude of inflammatory infiltrate, the presence and predominance of cell types and their distribution as to the filling material and reparative phenomena, such as fibroblastic and angioblastic proliferation and formation of fibrous capsules, were subjectively measured. After 90 days, all cements presented statistically significant reduction of the inflammatory reaction, presence of a fibrous tissue capsule in contact with the opening of the tubes containing the filling materials, and reduction of fibroblastic proliferation. Angioblastic proliferation decreased only for the Sealer 26 and Ketac Endo groups. All cements tested were either partially or totally phagocyted, and the mildest inflammatory response was found for the Sealer 26 group at both evaluation periods.

Comparison between common traffic lights and three types of traffic lights with visual cycle a safety and capacity analysis

The objective of this paper is compare the common traffic lights (CTL) to three different types of traffic lights with countdown displays (SCD) and assess their effects on road safety and capacity. This comparison is required because the results found in the literature are divergent among countries and cities, and one of the SCD analyzed in our study is different from the SCD used worldwide. An observational before-after study was conducted to evaluate the safety and capacity in a period of one year before and one year after the implementation of the SCD in three Brazilian cities. The results indicate that the SCD models 1 and 3 had around 35%±14% reduction in the total number of accidents; the model 2, does not have significant reduction. In order to perform the capacity analysis a framework for data collection and an adaptation for estimation of initial lost time in each phase were developed. Considering the capacity analysis there was a reduction around 11% in the lost time in SCD model 1, 7% in SCD model 2 and 3% in SCD model 3. However the implications of this on capacity are trifle due to a small increase in the average headways for all SCD models compare to CTL.

Influence of seasonality and production method on the antibacterial activity of propolis

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Growth potential of Salmonella spp. and Listeria monocytogenes in nine types of ready-to-eat vegetables stored at variable temperature conditions during shelf-life

Growth potential (delta) is defined as the difference between the population of a microorganism at the end of shelf-life of specific food and its initial population. The determination of 6 of Salmonella and Listeria monocytogenes in RTE vegetables can be very useful to determine likely threats to food safety. However, little is known on the behavior of these microorganisms in several RTE vegetables. Therefore, the aim of this study was to determine the delta of both pathogens in nine different types of RTE vegetables (escarole, collard green, spinach, watercress, arugula, grated carrot, green salad, and mix for yakisoba) stored at refrigeration (7 degrees C) and abuse temperature (15 degrees C). The population of aerobic microorganisms and lactic acid bacteria, including those showing antimicrobial activity has been also determined. Results indicated that L monocytogenes was able to grow (delta >= 0.5 log(10)) in more storage conditions and vegetables than Salmonella. Both microorganisms were inhibited in carrots, although a more pronounced effect has been observed against L monocytogenes. The highest 5 values were obtained when the RTE vegetables were stored 15 degrees C/6 days in collard greens (delta=3.3) and arugula (delta=3.2) (L monocytogenes) and arugula (delta=4.1) and escarole (delta=2.8) (Salmonella). In most vegetables and storage conditions studied, the counts of total aerobic microorganisms raised significantly independent of the temperature of storage (p<0.05). Counts of lactic acid bacteria were higher in vegetables partially or fully stored at abuse temperature with recovery of isolates showing antimicrobial activity. In conclusion, the results of this study show that Salmonella and L monocytogenes may grow and reach high populations in RTE vegetables depending on storage conditions and the definition of effective intervention strategies are needed to control their growth in these products. (C) 2012 Elsevier B.V. All rights reserved.

Reconnection studies under different types of turbulence driving

We study a model of fast magnetic reconnection in the presence of weak turbulence proposed by Lazarian and Vishniac (1999) using three-dimensional direct numerical simulations. The model has been already successfully tested in Kowal et al. (2009) confirming the dependencies of the reconnection speed V-rec on the turbulence injection power P-inj and the injection scale l(inj) expressed by a constraint V-rec similar to P(inj)(1/2)l(inj)(3/4)and no observed dependency on Ohmic resistivity. In Kowal et al. (2009), in order to drive turbulence, we injected velocity fluctuations in Fourier space with frequencies concentrated around k(inj) = 1/l(inj), as described in Alvelius (1999). In this paper, we extend our previous studies by comparing fast magnetic reconnection under different mechanisms of turbulence injection by introducing a new way of turbulence driving. The new method injects velocity or magnetic eddies with a specified amplitude and scale in random locations directly in real space. We provide exact relations between the eddy parameters and turbulent power and injection scale. We performed simulations with new forcing in order to study turbulent power and injection scale dependencies. The results show no discrepancy between models with two different methods of turbulence driving exposing the same scalings in both cases. This is in agreement with the Lazarian and Vishniac (1999) predictions. In addition, we performed a series of models with varying viscosity nu. Although Lazarian and Vishniac (1999) do not provide any prediction for this dependence, we report a weak relation between the reconnection speed with viscosity, V-rec similar to nu(-1/4).

Mapping an uncertainty zone between interpolated types of a categorical variable

Categorical data cannot be interpolated directly because they are outcomes of discrete random variables. Thus, types of categorical variables are transformed into indicator functions that can be handled by interpolation methods. Interpolated indicator values are then backtransformed to the original types of categorical variables. However, aspects such as variability and uncertainty of interpolated values of categorical data have never been considered. In this paper we show that the interpolation variance can be used to map an uncertainty zone around boundaries between types of categorical variables. Moreover, it is shown that the interpolation variance is a component of the total variance of the categorical variables, as measured by the coefficient of unalikeability. (C) 2011 Elsevier Ltd. All rights reserved.

Erosive potential of different types of grape juices

The purpose of the present study was to evaluate the erosive potential of different types (concentrated and powdered) and commercial brands of industrialised grape juices. The pH of all five fruit drinks was measured at two time points: immediately after preparation and 24 hours later. Sixty specimens of bovine enamel were randomly allocated and immersed in different types of grape juice (n = 10) for 10 minutes four times a day for fifteen days. The enamel alteration was analysed using surface Knoop microhardness (KHN) and surface roughness (R-a) tests at baseline and on the 5th, 10th and 15th days of the experiment. Two way ANOVA, Tukey's post hoc and Pearson's correlation tests were used for statistical analysis (alpha = 5%). The grape juices presented pH values ranging from 2.9 to 3.5. All of the tested juices promoted significant enamel mineral loss (p < 0.05) on the first evaluation (5th day of immersion) and produced a significant increase in the mean roughness from the 10th day on when compared to the control group (p < 0.05). By the 15th day, all of the beverages had produced surface roughnesses that were significantly higher than that of the control group. The results suggest that all grape juices, regardless of their commercial presentation, present erosive potential.