926 resultados para Poor growth of CGTMSE lending
Resumo:
Nucleation and growth of mullite whiskers in the La2O3-Al2O3-SiO2 system were investigated in the 1500degrees-1700degreesC temperature range. A differential thermal analysis (DTA) showed that the mullitization temperature decreases from 1350degreesC to 1240degreesC as a result of lanthania doping. In the temperature range of 1250-1500degreesC, most of the mullite grains have an Al2O3/SiO2 = 1.5 composition throughout the ceramic body; however, from 1400degreesC upward, the number of anisotropic grains with the Al2O3/SiO2 = 1.3 composition begins to increase. The concentration of alumina in the composition of the grain-boundary phase decreases as firing temperatures increase. At temperatures > 1500degreesC, alumina grains and whiskers grow on the internal and external surfaces of the ceramic body with the characteristic Al2O3/SiO2 = 1.3 composition. Removal of the mullite whisker layer by acid attack revealed an alumina-rich, rosace-like patterned microstructure correlated with the process of whisker nucleation and growth. In the early stages, whisker growth rates were found to be near 60 mum/h. Experimental evidence pointed to nucleation inside the thin glass layer on the external surface.
Resumo:
Arenaeus cribrarius is a mainly tropical crab that occurs in the Western Atlantic Ocean, Brazil being its type-locality. The species ranges from Vinevard Sound, Massachusetts, USA to La Paloma, Uruguay. Information about this species is scarce. The relative growth of A. cribrarius was analyzed, based on some morphometric relations, where the carapace width, excluding lateral spines (CW), was used as an independent variable. A total of 403 specimens (189 males and 214 females), was collected in Ubatuba, State of São Paulo, Brazil, with otter-trawls. The animals were sexed and sorted to maturation phase (juvenile or adult). Some measurements were made: carapace (length and width excluding lateral spines), abdomen (greatest width of the fifth somite in females and the sixth in males) and major chela (greatest length, width and height, dactylus length). This study was made by the application of the power function (y=a.x(b)) which was fitted to the data and the pattern of growth established for each parameter by the ''b''-value (constant of allometry), as positive allometry (b>1), negative allometry (b<1) or isometry (b=1). The morphometric relations of the carapace showed a tendency to isometry. In females, the abdominal width grew in positive allometry, higher in juveniles (b=1.33) than in adults (b=1.18). In this case, an overlap and discontinuity was noticed between the phases over a carapace width range of 55 to 70 mm, where the puberty molt occurs. The majority of relationships showed that the major chela of the males grew in positive allometry, however, the greatest allometric difference between the phases was observed towards the propodus length with 1.09 as juvenile and 1.26 as adult ''b''values. In the males, this variable showed an inflection between the CW range of 45' to 55 mm, where the transition to the maturation phase occurs. The relative growth of this species is similar to those of previously studied species. This indicates, that the propodus length and the abdominal width are the morphometric variables most appropriate to estimate the size of the beginning of the sexual maturity for males and females of this species, respectively.
Resumo:
Indium-tin oxide nanostructures were deposited by excimer laser ablation in a nitrogen atmosphere using catalyst-free oxidized silicon substrates at 500 degrees C. Up to 1 mbar, nanowires grew by the vapor-liquid-solid (VLS) mechanism, with the amount of liquid material decreasing as the deposition pressure increased. The nanowires present the single-crystalline cubic bixbyite structure, oriented < 100 >. For the highest pressure used, pyramids were formed and no sign of liquid material could be observed, indicating that these structures grew by a vapor-solid mechanism. (c) 2006 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
Resumo:
The dimensions of chelar propodus and abdomen were utilized for the morphometric analysis about the relative growth studies of Acanthonyx scutiformis (Dana, 1851). A total of 297 specimens (114 males and 183 females), was collected in Ubatuba, State of São Paulo, Brazil. The animals were sexed and soarted to maturation phase (immature and mature). The following measurements were made: carapace (length and width), abdomen width and chelar propodus (length and height). In this study was applicated the power function (y= a.x(b)), in which the growth was considered positive allometric with isometric with b=1, and negative allometric with b<1. The alometry becomes isometric, when the results concerning immature and mature females and males are analysed. In the Brachyura male chelipeds are utilized in territorial defense, fight, display and courtship and female abdomens are utilized as a chamber that protect and incubate the eggs.
Resumo:
Experimental programs in constant and variable amplitude loading were performed to obtain a x N curves and to study retardation in fatigue crack growth due to overloads. The main aim of this research program was to analyse the effect of overload ratio and number of overload peaks. The effect of underloads, before and after the overload blocks was also studied. The generalised equation of Paris-Erdogan type was used for modelling of obtained data on crack propagation under constant amplitude load.
Resumo:
The effect of boron (B) on cotton growth and fruit shedding may be due not only to physiological or biochemical effects, but also to vascular tissue malformation. This experiment investigated petiole and floral peduncle anatomical alterations and growth of cotton supplied with deficient and sufficient B in nutrient solution. Cotton (Gossypium hirsutum cv. 'Delta Opal') plants were grown in solutions containing 0, 1.5, 3.0, 4.5, and 6.0 mu mol L-1 of B from 22 to 36 d after plant emergence (DAPE). From 36 to 51 DAPE, B was omitted from the nutrient solution. Petioles from young leaves and floral bud peduncles (first position of the first sympodial) were sampled and the cross-section anatomy observed under an optical microscope. The number of vascular bundles of the petiole was decreased in B-deficient plants and the xylem was disorganized. Phloem elements in the peduncle vascular cylinder of B-deficient plants did not show clear differentiation. The few xylem elements that were formed were also disorganized. Modifications caused by B deficiency may have impaired B and photosynthate translocation into new cotton growth. Boron accumulation in the shoot of B-deficient plants suggested that there was some B translocation within the plant. It could be inferred that cotton growth would be impaired by the decrease in carbohydrate translocation rather than by B deficiency in the tissue alone.
Resumo:
Meat production by goats has become an important livestock enterprise in several parts of the world. Nonetheless, energy and protein requirements of meat goats have not been defined thoroughly. The objective of this study was to determine the energy and protein requirements for maintenance and growth of 34 3/4 Boer x 1/4 Saanen crossbred, intact male kids (20.5 +/- 0.24 kg of initial BW). The baseline group was 7 randomly selected kids, averaging 21.2 +/- 0.36 kg of BW. An intermediate group consisted of 6 randomly selected kids, fed for ad libitum intake, that were slaughtered when they reached an average BW of 28.2 +/- 0.39 kg. The remaining kids (n = 21) were allocated randomly on d 0 to 3 levels of DMI (treatments were ad libitum or restricted to 70 or 40% of the ad libitum intake) within 7 slaughter groups. A slaughter group contained 1 kid from each treatment, and kids were slaughtered when the ad libitum treatment kid reached 35 kg of BW. Individual body components (head plus feet, hide, internal organs plus blood, and carcass) were weighed, ground, mixed, and subsampled for chemical analyses. Initial body composition was determined using equations developed from the composition of the baseline kids. The calculated daily maintenance requirement for NE was 77.3 +/- 1.05 kcal/kg(0.75) of empty BW (EBW) or 67.4 +/- 1.04 kcal/kg(0.75) of shrunk BW. The daily ME requirement for maintenance (118.1 kcal/g(0.75) of EBW or 103.0 kcal/kg(0.75) of shrunk BW) was calculated by iteration, assuming that the heat produced was equal to the ME intake at maintenance. The partial efficiency of use of ME for NE below maintenance was 0.65. A value of 2.44 +/- 0.4 g of net protein/kg(0.75) of EBW for daily maintenance was determined. Net energy requirements for growth ranged from 2.55 to 3.0 Mcal/kg of EBW gain at 20 and 35 kg of BW, and net protein requirements for growth ranged from 178.8 to 185.2 g/kg of EBW gain. These results suggest that NE and net protein requirements for growing meat goats exceed the requirements previously published for dairy goats. Moreover, results from this study suggest that the N requirement for maintenance for growing goats is greater than the established recommendations.
Resumo:
This article reports on the growth of SnO nanobelts and dendrites by a carbothermal reduction process. The materials were synthesized in a sealed tube furnace at 1210 degrees C and at 1260 degrees C for 2 h. in a dynamic nitrogen atmosphere of 40 seem. After synthesis, gray-black materials were collected downstream in the tube and the samples were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), and energy-dispersive X-ray spectroscopy (EDX). The results showed that the gray-black materials were composed of nanobelts, which grew in the [110] direction of the orthorhombic structure of SnO. Some of the belts also presented dendritic growth. The dendrites grew in the (110) planes of the SnO structure, and no defects were observed at the junction between the nanobelts and the dendrites. A self-catalytic vapor-liquid-solid (VLS) process was proposed to explain the growth of the SnO nanobelts and dendrites.
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)