Experimental validation of a fracture model for pearlitic steel bars based on the cohesive zone model

Steel is, together with concrete, the most widely used material in civil engineering works. Not only its high strength, but also its ductility is of special interest, since it allows for more energy to be stored before failure. A better understanding of the material behaviour before failure may lead to better structural safety strategies.

Finite element simulation of sandwich panels of laminated plaster and rockwool under mixed mode fracture

Sandwich panels of laminated gypsum and rock wool have shown large pathology of cracking due to excessive slabs deflection. Currently the most widespread use of this material is as vertical elements of division or partition, with no structural function, what justifies that there are no studies on the mechanism of fracture and mechanical properties related to it. Therefore, and in order to reduce the cracking problem, it is necessary to progress in the simulation and prediction of the behaviour under tensile and shear load of such panels, although in typical applications have no structural responsability.

Cover cracking of the reinforced concrete due to rebar corrosion induced by chloride penetration

This paper is focused on the problem of the chloride-induced corrosion of the rebar in reinforced concrete, with special application to the slabs and decks of the bridges. High superficial concentrations may be usual in these structures (marine environments or de-icing salts in roadway bridges, e.g.). Like any aggressive agent such as water, gases or other dissolved ions, chloride induced deterioration is very conditioned by possibilities of transport through concrete mass.

What can we learn from voice therapy of the speaking voice for singers's voice?

Voice therapies of muscle tension dysphonia in Germany need to be increased in effectiveness by applying intensive, manualized procedures and standardized assessment protocols. The same holds true for therapies of disturbed singer's voices. According to a Cochrane review on the effectiveness of therapies of functional dysphonia neither direct nor indirect voice therapies alone but combinations of both elements are effective (Ruotsalainen et al., 2007).

Development of a PWR-W and an AP1000® containment building 3D model with a CFD code for Best-Estimate Thermal-Hydraulic Analysis

The simulation of design basis accidents in a containment building is usually conducted with a lumped parameter model. The codes normally used by Westinghouse Electric Company (WEC) for that license analysis are WGOTHIC or COCO, which are suitable to provide an adequate estimation of the overall peak temperature and pressure of the containment. However, for the detailed study of the thermal-hydraulic behavior in every room and compartment of the containment building, it could be more convenient to model the containment with a more detailed 3D representation of the geometry of the whole building. The main objective of this project is to obtain a standard PWR Westinghouse as well as an AP1000® containment model for a CFD code to analyze the thermal-hydraulic detailed behavior during a design basis accident. In this paper the development and testing of both containment models is presented.

Qualitative operational value at risk for an electric utility based on the guidelines of the basel committee

This paper presents a model for determining value at operational risk ?OpVaR? in electric utilities, with the aim to confirm the versatility of the Bank for International Settlements (BIS) proposals. The model intends to open a new methodological approach in risk management, paying special attention to underlying operational sources of risk.

A Porposal: "Agro-ERASMUS"

The rural population is getting smaller as percentage of the total population in the countries. There is a constant depopulation of rural areas to urban areas. The most extreme data are in countries like USA, where the rural population is 1.5%, from which 1% of that amount is part time and only 0.5% full time. On the other side, we have countries with more than 50% rural population. Related to training, cultural development, business and specific weight in society, rural residents have no significance in their societies. As they are few, and separated across the territory they have no influence on their societies. Comparing the USA farmer with one from the EU, we see that the American one is a businessperson and the European one, in most cases is a farm worker. To reduce this gap between these different farmers, we believe that we must train the new generations of children belonging to farming Europe. They must have a common language, English; they must know other countries culture and farming systems, live and network with other young Europeans colleagues,future young farmers. It is what we have coined as AGRO-ERASMUS. A project to be placed within the EU Common Agriculture Policies. The project must be designed before its implementation. Even some previous experience should make better viability. It should make use of a network of agricultural universities in several European countries. Each university would build a "farm school" where young people would learn "English?, and visit and work in small agricultural practices with a correct use of the time. One important subject dealing with should be agribusiness. The procedure based on the ?Farm School? (F-S) experience, should start with young people from 13 years up to 18 years. Their attendance, every summer, to the F-S should be rotated between different countries besides their own. The first and second year, with young people 13/14 years old, the Farm School would last less than three weeks in an English speaking country (Ireland, UK or someone else). They should live with a local family the time they stay outside of the Farm School (F-S). This two years period must be devoted to learn and become familiar with the English language and cultural differences. The rest of the four years left, the Farm Schools will have longer duration and be placed in other countries from the network. The living way would be in multinational teams of young people where the only spoken language would be English. After six years of summer oexistence speaking English and learning new competences and skills with colleagues from other countries, we would have a great team of young and future European farmers, able to travel free and confident through the whole Europe and ready to be engaged in productive, commercial and research activities. These new young farmers may revive European agriculture and would not look any more like rural habitants, but international business-farmers, professionally speaking. In a brief survey among the assistants to the Fifth International Academic Conference titled "Alternative Income Sources in Small Agricultural Holdings of the European Union" held in Krakow (PL) in June 2015, participants from universities and countries like Poland, Hungary, Rep. Czech, Portugal, Romania, etc., expressed the necessity of addressing this problem in a new and bold way.

Indicators of obesity and the educational attainment of the Czech female population

The aim of this paper was to evaluate the relationship between selected indicators of obesity and the highest completed level of education in the adult female population of the Czech republic. As basic indicators of obesity, these following parameters were selected and measured via the bioimpedance method on the device InBody 720: BMI, WHR (waist-to-hip ratio), % body fat, % skeletal muscle mass, fitness score. The educational attainment of the tested women was inquired by a questionnaire. Based on the responses, we subsequently divided our sample into four categories according to the level of education: primary education, secondary education-apprenticeship, secondary education-graduate diploma, and university. The research was realized within the project CZ.1.07/2.3.00/20.0044. The measurements on the device InBody 720 and the accompanying survey were conducted between 2011-2013 in different regions of the Czech Republic. The sample consisted of 754 women divided into 3 age groups (18-39, 40-59, 60+ years). Based on the results (p<0.05), we can say that average values of the indicators obesity (BMI: 22.76, 24.88, 26.49 kg/m2, WHR: 0.85, 0.88, 0.90 and % body fat: 25.76, 30.23, 34.62%) increase with the increasing age of examined women. The average values of the fitness score (75.53, 73.86, 70.04 points) and % skeletal muscle mass (40.78, 38.15, 33.95%) decrease with increasing age. With regard to the educational attainment, women with secondary education-apprenticeship achieved the worst results. In contrast, the values in university educated women were the best in most indicators of obesity.

Isometric strength of the upper extremities in Czech men older than 18 years

The aim of this study was to compare isometric strength of the upper extremities in a sample of men from the Czech republic (n=638). Only the dominant upper limb was tested. The examined subjects were 18 years old or older. The measured values (in kilograms) were obtained via hand-held dynamometry testing (a digital hand-held dynamometer). The results of the hand-held dynamometry testing were compared across six age categories (18-29, 30-39, 40-49.... 70+ years). It was found that isometric strength of the dominant upper limb in men increases up to the age group 30-39 years and then declines. The highest average value (55.6 kg) was found in the age group 30-39 years, and expectably, the lowest values (34.4 kg) were documented in the age category 70+ years. The largest decline in isometric strength (-8.8 kg) was found between the age groups 60-69 years and 70+ years.

The effect of smoking on visceral fat accumulation in Czech men and women

Many studies indicate that smoking is one of risk factors influencing the accumulation of visceral fat (VFA). The mechanism by which smoking contributes to the accumulation of visceral fat is not yet fully understood, but it is assumed that smoking increases the level of plasma cortisol, causes imbalance between male and female sex hormones in women, and decreases testosterone levels in men (Chiolero et al., 2008). The objection of this study was to evaluate the effect of smoking on the accumulation of VFA in the population of the Czech Republic. The research included 1,412 individuals of both genders divided into categories of smokers vs nonsmokers and physically active vs. physically inactive. VFA was measured by the device InBody 720 and information about physical activity and smoking was collected via a questionnaire. We supposed that smokers would have a higher percentage of VFA than non-smokers. The results showed that smokers had a higher amount of VFA, but the difference was not statistically significant. In contrast, statistically significant differences were found in the waist-to-hip ratio (WHR) and total % body fat. Physically active individuals had a much more favourable results than physically inactive individuals. Remarkably, the amount of VFA, WHR and % body fat tended to be smaller in smoking men than in non-smoking men, but higher in smoking women than in non-smoking women.

Bene ahuvah : ...beʾurim ʻal Rambam ḥeleḳ sheni Hilkhot ishut, gerushim ṿe-isure biʾah.

Hebrew and common era dates do not correspond.

Outsourcing: a Theoretical Viewpoint

Outsourcing or offshoring as it is now known has been around for many decades. In the beginning, it was only very peripheral activities that were outsourced, i.e. blue-collar (lower skilled) work but this is now all changing with the outsourcing of white-collar jobs. The digital revolution, the falling costs of transport and telecom costs and the opening up of the global economy helped the outsourcing market. For companies going down or contemplating the road of outsourcing there are both potential benefits and challenges, for example, the type of outsourcing they want to get involved in, and the country they want to outsource to. Outsourcing can potentially happen anywhere in the world where the costs are lower and the quality higher. The main places that have been used for outsourcing have been India, China, Ireland, South-East Asia, Russia, Mexico and the Czech Republic. The research currently underway is initially focusing on a literature review of current outsourcing applications in the market place. From this literature review, a questionnaire is being developed to assess the impact Outsourcing has on businesses. This research focuses on the Irish Market place.

Editorial

This time of year we look back at the year that has passed and make plans for the next year. I like to reflect on things that I have learnt and people that I have met, especially those who facilitated that learning. In 2009 I went to various conferences, The BCLA conference in Manchester, The Romanian Optical Society meeting in Brasov, Transylvania (where the university is actually on Vlad Tepes Street), The European Council for Optometry and Optics (ECOO) in Brno, Czech Republic, The American Academy of Optometry (AAO) in Orlando USA, The International Association of Contact Lens Educators (IACLE) meeting in Tianjin China and finally The Vereinigung Deutscher Contactlinsen-Spezialisten (VDCO) meeting in Jena. All were interesting places and thoroughly all were enjoyable conferences with their own highlights but I wanted to focus on Jena and one person I met there and his inspirational search for knowledge and the contributions he made in the field of contact lenses. Jena itself is a fascinating place and should be on the ‘must visit’ list of anyone involved in eye care. It is the birth place of Carl Zeiss of course and where he started his company. It is also the birth place of Ernst Abbe (physicist and optometrist and expert lens maker), and Otto Schott (chemist and technologist who made high quality glass. There are many road signs bearing witness to these famous pioneers. The optical museum is worth spending a few hours looking around too. I was invited to speak at the VDCO at the kind invitation from colleagues at the Jena School of Optometry, Professor Wolfgang Sickenberger and Professor Sebastian Marx. At this meeting I met 87-year-old Willi KAUE who was being awarded the Adolf Wilhelm Müller-Welt prize by the VDCO for contribution to contact lenses over his 60-year career. At the age of 15 Willi Kaue took up an apprenticeship to become an Optician in Germany in 1937. At this time he first heard about the scleral glass lenses made by the Carl Zeiss Company in Jena. This started his lifelong fascination which was to become his passion but not yet his career. During the war he was enlisted into military service but immediately after was back to his former career. In 1950 Willi corrected his own 3.5 dioptres of myopia with a plastic scleral lens. His fascination strengthened as for the first time he himself could experience a wider field of view than his spectacles gave him, less aberrations and less retinal minification. He also appreciated the fact that contact lenses did not cause pressure on the nose or ears and did not slide down his nose plus remained optically centred with his eye movements. He decided that form now on he would make fitting contact lenses his career. He travelled to London to learn more about contact lenses and how to fit them but initially did not find many willing teachers and to start with became largely self-taught. He wanted to know how to make scleral lenses. So far he only knew that pulverized polymethyl methacrylate (PMMA) was pressed and moulded. In 1951 he met Berlin optician Otto Marzock. He made his only scleral lenses from using military PMMA windshields. His process involved lathe cutting the lenses and resulted in lenses that were thinner than moulded ones. Willi developed a manufacturing method, using a rotary diamond drill, starting form the outer edge and towards the centre at a constant cut speed. This enabled him to make more reproducible lenses and in less time. His enthusiasm in the field was clear from the travels he made in the pursuit of advancement - travelling around Europe, South America, North America and Asia. In 1963 he visited George Nissel in Hemel Hempstead, England. Constantly thriving towards innovations Willi came across the new Naturalens from the USA made from HEMA at a congress in Marseille in 1969. Amongst his contributions to the field, was his own technique of fitting ocular prosthetics, using an alginate impression of the orbit. I was fortunate enough to have dinner with Willi Kaue and learnt more about his fascinating career through the patient interpreting skills of Hilmar Bussacker (the 2008 winner of the same award and the 2007 winner of the European Federation of the Contact Lens and IOL Industries Award). I look forward to 2010 with eager anticipation as to what I may learn and who I might meet!!! Copyright © 2009 British Contact Lens Association. Published by Elsevier Ltd. All rights reserved.

Manuscript Digitization and Electronic Processing of Manuscripts in the Czech National Library

The paper informs about the history of manuscript digitization in the National Library of the Czech Republic as well as about other issues concerning processing of manuscripts. The main consequence of the massive digitization and record and/or full text processing is a paradigm shift leading to the digital history.