An In Vitro Comparison of Different Cementation Strategies on the Pull-out Strength of a Glass Fiber Post

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Influência da fotopolimerização e da cor da resina composta na microdureza

Objective: To study the influence of color opacity and light-curing systems (halogen light vs blue LED) on the microhardness of a composite resin. Methods: Esthet-X composite resin (Dentsply), shades A2 and A2-O, was inserted in a stainless steel matrix (5 mm diameter and 2 mm deep) and was light cured for 40 seconds with a halogen light source (XL 3000; 3M/ESPE) or a blue LED (Optilight LD II; Gnatus). Eight groups of 15 specimens each were formed, and were further divided according to the light-curing systems, the exposed area (base and surface), and the opacity of the composite resin, producing 120 specimens. The specimens were next stored in distilled water for 24 hours, embedded in a chemically activated acrylic resin, then subjected to finishing and polishing with sandpaper and felt discs. Microhardness was measured with a Vickers Digital Microhardness meter, with a 50 g load for 30 seconds. The obtained microhardness means were analyzed by ANOVA and Tukey's multiple-comparison test at 5% significance level. Results: The surface microhardness was always greater than the base microhardness, regardless of the light-curing source. The halogen light lamp produced significantly higher composite resin microhardness means than the blue LED (57.61 vs. 42.53 HV) (p<0.05). Statistically significant differences (p<0.05) were obtained between the microhardness means for the different composite opacities; lowest microhardness in depth was produced by the A2-O shade. Conclusion: Composite resin opacity as well as the light-curing system influenced the microhardness of the material.

On Non-ideal and Chaotic Energy Harvester Behavior

In this paper, we deal with the research of a proposed mathematical model of energy harvesting, including nonlinearities in the piezoelectric coupling and a non-ideal force of excitation. We showed using numerical simulations to analysis of the dynamic responses that, the power harvested was influenced by the nonlinear vibrations of the structure, as well as by the influence of the non-linearities in the piezoelectric coupling. We concluded through of the numerical results that the limited energy source was interacting with the system. Thus, the increasing of the voltage in DC motor led the system produce a good power response, especially in high-energy orbits in the resonance region, but the Sommerfeld effect occurs in the system and a chaotic behavior was found in the post-resonance region. So the power harvested along the time decreases because occurs loses of energy due the interaction between energy source and structure. Keeping the energy harvested constant over time is essential to make possible the use of energy harvesting systems in real applications. To achieve this objective, we applied a control technique in order to stabilize the chaotic system in a periodic stable orbit. We announced that the results were satisfactory and the control maintained the system in a stable condition. © 2012 Foundation for Scientific Research and Technological Innovation.

Análise de dois modais de sistemas de colheita mecanizados de eucalipto em 1ª rotação

Pós-graduação em Agronomia (Energia na Agricultura) - FCA

Perdas na colheita e qualidade da fibra de cultivares de algodão adensado em função de sistemas de colheita

Pós-graduação em Agronomia (Energia na Agricultura) - FCA

Microencapsulação de oleoresina de cúrcuma (curcuma longa l.) em matrizes de gelatina, goma arábica e colágeno hidrolisado

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Doses de potássio no sistema integração lavoura-pecuária

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Valoração econômica das perdas de nutrientes por erosão em cana-de-açúcar

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Comportamento dos óxidos de ferro da fração argila e do fósforo adsorvido, em diferentes sistemas de colheita de cana-de-açúcar

In agriculture, the search for higher crop yields based on sustainable soil management has led to a gradual pursuit of knowledge of the variables related to production systems. The identification of the causes of variability of these properties has become a part of strategic planning in the sugar and ethanol industry. This study investigated the spatial variability of iron oxides in the clay fraction and its relationship to soil physical and chemical properties in different sugarcane cultivation systems in the region of Ribeirão Preto, São Paulo State. Two 1-ha plots were outlined in areas with mechanical and manual harvesting systems. Soil samples were taken at 126 points from the 0.00-0.25 m layer in both areas. The mineralogical and chemical data were subjected to geostatistical analyses, to determine the spatial dependence, semivariograms and kriging maps of the properties. To analyze the correlation between the parameters cross-semivariograms were constructed. The spatial variability of chemical properties was greater in areas with mechanical harvesting than burnt harvesting (manual harvesting), whereas the range of the mineralogical properties was largest in the area of green-harvested sugarcane. The properties organic matter, mean crystal diameter goethite had a negatively spatial correlation, while clay was positive correlated with P sorption in the two sugarcane harvest systems.

Espacialização do banco de sementes de plantas daninhas sob diferentes manejos de cana-de-açúcar em Rio Brilhante, Mato Grosso do Sul

The State of Mato Grosso do Sul is in full growth of this sector, thus the concern about harvesting systems are being studied, and these systems may influence the weed community interference of weeds in the cane sugar. The integrated management tool attached to geostatistics is to avoid productivity losses due to weed interference. The objective of this work was to study the spatial variability of the seed bank of weeds depending on the system for collecting cane sugar (raw and burning). The experiment was conducted in the area of commercial cultivation of the plant ETH Bioenergy S/A Eldorado Unity. Soil samples were taken with auger layer from 0.00 to 0.40 m depth in both cropping systems. The experimental plot was composed by a mesh consisting of 50 points georeferenced with irregular distances. Soil samples were taken to the greenhouse for germination. The number of weed species was analyzed using descriptive statistics and geostatistical techniques. The seeds of B. pilosa, dicots, bitter grass, nutsedge, dayflower monocots and spatial dependence of the seed bank in the collection system with burning of cane sugar. For the system of harvest only the raw sedge species present spatial dependence of distribution in the seed bank. In the harvest green cane enable the mapping of these species through the kriging maps produced, spot applications of herbicides in integrated management of Cyperus rotundus.

Effect of melatonin on tumor growth and angiogenesis in xenograft model of breast cancer

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Vibrational spectroscopy for probing molecular-level interactions in organic films mimicking biointerfaces

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Human dental enamel and dentin structural effects after Er:yag laser irradiation

Ideally projected to be applied on soft tissues, infrared lasers were improved by restorative dentistry to be used in hard dental tissues cavity preparations-namely enamel and dentin. This paper evidentiates the relevant aspects of infrared Erbium laser's action mechanism and its effects, and characterizes the different effects deriving from the laser's beams emission. The criteria for use and selection of optimal parameters for the correct application of laser systems and infuence of supporting factors on the process, such as water amount and its presence in the ablation process, protection exerted by the plasma shielding and structural factors, which are indispensable in dental tissues cavity preparation related to restorative technique, are subordinated to optical modifcations caused by the interaction of the energy dissipated by these laser light emission systems in the targeted tissue substrate. Clinical relevance: Differences in the action of infrared Erbium laser system in regard to the nature of the ablation process and variations on the morphological aspects observed in the super-fcial structure of the target tissue irradiated, may be correlated to the structural optical modifcations of the substrate produced by an interaction of the energy propagated by laser systems.

Profile and crowding of currents in mesoscopic superconductors with an array of antidots

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Sistema de geração e armazenamento de energia elétrica utilizando transdutor piezelétrico na forma pulsada

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)