Observation of manganese deposits in the Blake Plateau, Florida and Caribbean sea areas

Designed by the Westinghouse Corporation in collaboration with Jacques Cousteau, DEEPSTAR-4000 is a deep diving research vehicle based on Captain Cousteau's DIVING SAUCER. An evaluation of DEEPSTAR's operational performance at sea is presented in this report through a description of typical dive procedures and the actual NAVOCEANO dive results.

Development of a novel autonomous robot for navigation and inspect in oil wells

This paper proposes a novel robotic system that is able to move along the outside of the oil pipelines used in Electric Submersible Pumps (ESP) and Progressive Cavity Pumps (PCP) applications. This novel design, called RETOV, proposes a light weight structure robot that can be equipped with sensors to measure environmental variables avoiding damage in pumps and wells. In this paper, the main considerations and methodology of design and implementation are discussed. Finally, the first experimental results that show RETOV moving in vertical pipelines are analyzed.

Experimental investigation on box-wing configuration for UAS

The range for airframe configurations available for UAS is as diverse as those used for manned aircraft and more since the commercial risk in trying unorthodox solutions is less for the UAS manufacturer. This is principally because the UAS airframes are usually much smaller than the manned aircraft and operators are less likely to have a bias against unconventional configurations. One of these unconventional configurations is the box-wing, which is an unconventional solution for the design of the new UAS generation. The existence of two wings separated in different planes that are, however, significantly close together, means that the aerodynamic analysis by theoretical or computational methods is a difficult task, due to the considerable interference existing. Considering the fact that the flight of most UAS takes place at low Reynolds numbers, it is necessary to study the aerodynamics of the box wing configuration by testing different models in a wind tunnel to be able to obtain reasonable results. In the present work, the study is enhanced by varying not only the sweepback angles of the two wings, but also their position along the models’ fuselage. Certain models have shown being more efficient than others, pointing out that certain relative positions of wing exists that can improve the aerodynamics efficiency of the box wing configuration.

A vision-based strategy for autonomous aerial refueling tasks

Autonomous aerial refueling is a key enabling technology for both manned and unmanned aircraft where extended flight duration or range are required. The results presented within this paper offer one potential vision-based sensing solution, together with a unique test environment. A hierarchical visual tracking algorithm based on direct methods is proposed and developed for the purposes of tracking a drogue during the capture stage of autonomous aerial refueling, and of estimating its 3D position. Intended to be applied in real time to a video stream from a single monocular camera mounted on the receiver aircraft, the algorithm is shown to be highly robust, and capable of tracking large, rapid drogue motions within the frame of reference. The proposed strategy has been tested using a complex robotic testbed and with actual flight hardware consisting of a full size probe and drogue. Results show that the vision tracking algorithm can detect and track the drogue at real-time frame rates of more than thirty frames per second, obtaining a robust position estimation even with strong motions and multiple occlusions of the drogue.

Desarrollo e implementación de un sistema robótico aéreo con programación tridimensional orientado al recorrido de rutas

En la actualidad se estudia en numerosos campos cómo automatizar distintas tareas ejecutadas por aeronaves con tripulación humana. Estas tareas son en todos los casos muy costosos, debido al gran consumo de combustible, gran coste de adquisición y mantenimiento de la propia aeronave, todo ello sin contar el riesgo para los mismos tripulantes. Como ejemplo de estas tareas se puede incluir la vigilancia policial y fronteriza, revisiones de tendidos de alta tensión, la alerta temprana de incendios forestales y la medición de parámetros contaminantes. El objetivo de este proyecto es el diseño y la construcción de un prototipo electrónico empotrado basado en microcontrolador con núcleo C8051 de Silicon labs, que sea capaz de gobernar una aeronave de radiocontrol de forma transparente, de manera que en un futuro se pueda sustituir el propio aeromodelo, con la modificación de algunos parámetros, para poder incorporar sistemas de video o distintos medios de detección de variables. El prototipo seguirá una ruta confeccionada y transferida como un archivo de texto con un formato determinado que contendrá los datos necesarios para poder navegar mediante GPS. El trabajo con los modelos de motorización térmica (motores de combustión interna tipo glow, en este caso) resulta peligroso debido a la gran energía que son capaces de alcanzar. A fin de mantener la máxima seguridad durante la evolución del proyecto, se ha diseñado un proceso de tres partes independientes que permitan la correcta familiarización de los distintos componentes que se emplearán. Las fases son las siguientes: 1. Test y modelado de todos los componentes mediante pequeños montajes con protoboard de inserción y programas individuales. Se realizará mediante una tarjeta multipropósito que contendrá un microcontrolador similar en características, aunque de menor complejidad, al del prototipo final. 2. Integración de todos los componentes mediante una tarjeta especialmente diseñada que servirá de interfaz entre la tarjeta multipropósito y todo el hardware necesario para el control de un vehículo terrestre de iguales características (actuadores y motorización) al aeromodelo. 3. Diseño de un sistema embebido que concentre todos los subsistemas desarrollados en las fases anteriores y que integre todos los componentes necesarios para el gobierno de una aeronave de ala fija. ABSTRACT. Nowadays, the way of automating different tasks done by manned vehicles is studied. These tasks are any case very expensive, due to large fuel consumption, costs of aircraft buying, without taking into account the risk for human crew. As an example of these tasks, we can include policing or border surveillance, maintenance of high voltage lines, early warning of forest fire and measuring of pollution parameters. The target of this project is the design and construction of an embedded electronic prototype, based on a microcontroller with C8051 core from Silicon labs, and it will be able to controlling an aircraft transparently, in order that in the future the flying model could be changed with the modification of some parameters, and video or any variables detection systems could be added. The prototype will follow a designed and transferred path as an plain text file with a given format, that will contain all the necessary data for GPS navigation. Working with heat engine models (internal combustion engine, glow type, in this case) becomes dangerous due to the large energy that can be able to acquire. In order to keep the maximum safety level during the project evolution a three independent stages process have been designed, this allows familiarizing properly with the parts that will be used. The stages are as follows: 1. Test and modeling of all of the parts by little assemblies with through-hole protoboard and stand alone programs. It will be done with a multipurpose card which contains a microcontroller of similar characteristics, although less complex, of the final prototype. 2. Integrating of all of parts through a dedicated design card that will serve as interface between multipurpose card and all the necessary hardware for controlling a ground vehicle with the same characteristics (actuators and engine) of the flying model. 3. Embedded system designing that contains all the developed subsystems in the previous stages and integrates all the necessary parts for controlling a fixed-wing aircraft.

Redes de información y conocimiento climatológico en el mundo hispánico del siglo XVIII

Durante la Ilustración, el imperio español alcanzó su máxima amplitud y las instituciones oficiales incrementaron su apoyo a las ciencias. Para defender sus fronteras y ejercer con eficacia el poder político, económico y religioso, la Corona y la Iglesia necesitaban obtener información precisa --incluida la climatológica-- de las posesiones españolas y de los pobladores de éstas. Fueron varios los procedimientos empleados para ello: sistema de cuestionarios y relaciones geográficas, estudios medico-topográficos, visitas e inspecciones oficiales, expediciones político-científicas, correspondencia epistolar, artículos periodísticos, etc. Dichos procedimientos fueron aplicados por redes de informadores cuyas actuaciones se basaban en la división del trabajo, el reparto de colaboradores en diferentes lugares, el uso de códigos de comunicación comprensibles, el envío de los resultados a los superiores jerárquicos y la toma de decisiones por las autoridades competentes. Las redes de información estaban sometidas a dictámenes que normalizaban su creación y continuidad temporal, daban forma a su estructura interna, especificaban sus cometidos y obligaban a cumplir protocolos y plazos. En su seno se idearon planes de investigación integrados en el estudio general de la Tierra, el ser humano y la cultura. El beneficio de las actuaciones de sus miembros se plasmó en cubrir grandes ámbitos geográficos con el consiguiente ahorro de tiempo, esfuerzos y medios. En sus correspondientes contextos, los miembros de las redes efectuaron estudios climatológicos conforme a intereses, imposiciones y circunstancias específicas. Así, los médicos se interesaron por las condiciones climáticas que influían en la salud humana; los funcionarios reales y los ingenieros militares describieron los climas locales y regionales aptos para el fomento y el control político, jurídico y educativo de los habitantes de los territorios hispánicos; los expedicionarios estudiaron las interacciones entre los fenómenos naturales y las influencias de los accidentes geográficos en los climas; los clérigos se interesaron por los aspectos estéticos, apologéticos y contemplativos de los climas; finalmente, en la prensa de la época se publicaron registros meteorológicos periódicos y trabajos climatológicos varios. En definitiva, el saber climatológico en el mundo hispánico ilustrado aportó algunos rasgos esenciales a la climatología en una etapa pre-fundacional de esta disciplina. Dichos rasgos se desarrollaron generalmente en una escala local o regional y se refirieron a los siguientes asuntos: el calor como principal agente de las modificaciones atmosféricas, de la formación de vapor acuoso y de las precipitaciones; la influencia del suelo en el aumento de humedad y calor en el aire; el poder de los vientos para trasladar de un lugar a otro el frío o el calor, el vapor de agua, los fenómenos atmosféricos y los agentes responsables de las enfermedades contagiosas; las propiedades del aire atmosférico y su capacidad para interaccionar con el medio ambiente; la condición estática y repetitiva de los climas, si bien se admitió que dichos fenómenos podían sufrir modificaciones; la corroboración experimental de las diferencias climáticas entre las zonas tropicales y medias del planeta; la refutación de que la naturaleza americana y sus habitantes eran inferiores a los europeos; y la demostración de que los principios rectores de los fenómenos físicos del Viejo y el Nuevo Mundo eran idénticos. Desde el último tercio del siglo XVIII, los documentos producidos por los componentes de las redes de información incluyeron datos meteorológicos. Pero no siempre se emplearon los mismos instrumentos de medida ni se siguieron los mismos protocolos de indagación en idénticas condiciones. Además, y salvo excepciones, los períodos durante los cuales se recabaron datos atmosféricos fueron relativamente cortos, y los expertos no efectuaron las mismas operaciones aritméticas con los parámetros. Por esta razón, y por la orientación utilitaria de los ilustrados hispánicos, el saber climatológico no obtuvo en el período y en el ámbito geográfico considerados resultados teóricos apreciables; en cambio, dio lugar a una gran cantidad de actividades prácticas con aplicaciones a la medicina, la agricultura, la náutica, el fomento, la prevención de riesgos naturales, etc. La principal utilidad de este trabajo consiste en servir de complemento a los procedimientos actualmente en uso en historia de la hidrología y en climatología histórica. ABSTRACT During the Enlightenment, the Spanish Empire achieved its highest length and State institutions increased their support to sciences. In order to defend their frontiers and to exercise political, economical and religious power, the Crown and the Church needed exact information --including the climatologic one-- about its possessions and its habitants. Some of the procedures employed to get that objective were: system of questionnaires and geographic relations, medical-topographic studies, official visits and inspections, political-scientific expeditions, direct mail, journalistic articles, etc. Those procedures were applied by informers´ networks which obtained, manned and transmitted every kind of data about the natural and moral reality of the Hispanic territories; their actions were based on the division of tasks, the distribution of collaborators at several places, the use of understandable communication codes and the sending of results to the hierarchical superiors; after, the competent authorities took decisions. The information networks were subjected to rules witch regulated its creation, temporary continuity, interior structure, objectives, protocols and periods. Their memberships invented plans about the general research of the Earth, the human beings and the culture; and they contributed to get benefits because of covering large geographic frames and economizing time, effort and means. According to their specifics contexts, concerns, impositions and circumstances, the informers performed climatologic tasks. Thus, the physicians were interested in the climatic conditions which affected to human health; the royal officers and military engineers described the most propitious climates to patronage and political, lawful and educative control of inhabitants of Hispanic territories; the participants in politic-scientific expeditions studied the interactions among natural phenomena and the influence of geographic aspects on the climate; the clergymen underlined the esthetic, apologetic and contemplative face of climates; finally, in the newspapers were published a lot of meteorological data and climatologic works. So, the climatologic knowledge in the Hispanic enlightened world added these essential aspects --referred in a local and regional area-- during the pre-foundational epoch of the climatology: the heat as first agent of atmospheric modifications, aqueous vapor and precipitations; the influx of the land in the increment of humidity and heat of the air; the power of the winds to convey the cold, the heat, the aqueous vapor, the atmospheric phenomena and the agents which caused contagious maladies; the properties of the air and its faculty to mediate with the environs; the static and repetitive condition of the climate and its possibility to experience change; the experimental confirmation of climatic varieties between tropical and central areas of the planet; the negation of the inferiority of the American nature and inhabitants; the demonstration about the equality of the rules which conducted physical phenomena in the Old and the New world. Since the last third part of the eighteenth century, the documents produced by the members of the networks included meteorological data. But the informers were not used to employ the same measure instruments and homogeneous protocols completion in the same conditions. Exceptions besides, the times of taking atmospheric data, usually were very short; and the experts did not carry out the same arithmetical operations with parameters. Because of this reason and the utilitarian guidance of the informers, during the Hispanic Enlightenment, it was not possible to obtain theoretic conclusions about climatologic knowledge; but there were a lot of practical activities applied to Medicine, Agriculture, Navigation, patronage, prevention of natural risks, etc. The main utility of this work consist in favoring the present procedures of the History of Hydrology and Historic Climatology.

What is the optimal stitching orientation from an aerial survey perspective?

Mosaicing is a technique that allows obtaining a large high resolution image by stitching several images together. These base images are usually acquired from an elevated point of view. Until recently, low-altitude image acquisition has been performed typically by using using airplanes, as well as other manned platforms. However, mini unmanned aerial vehicles (MUAV) endowed with a camera have lately made this task more available for small for cicil applications, for example for small farmers in order to obtain accurate agronomic information about their crop fields. The stitching orientation, or the image acquisition orientation usually coincides with the aircraft heading assuming a downwards orientation of the camera. In this paper, the efect of the image orientation in the eficiency of the aerial coverage path planning is studied. Moreover, an algorithm to compute an optimal stitching orientation angle is proposed and results are numerically compared with classical approaches.