Does gestation or feeding affect the body temperature of the golden lancehead, Bothrops insularis (Squamata: Viperidae) under field conditions?

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Optimality conditions for infinite horizon control problems with state constraints

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Serpentine leafminer (Liriomyza trifolii) on potato (Solanum tuberosum): field observations and plant photosynthetic responses to injury

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Control of retention and fatigue-free characteristics in CaBi4Ti4O15 thin films prepared by chemical method

Ferroelectric CaBi4Ti4O15 (CBTi144) thin films were deposited on Pt/Ti/SiO2/Si substrates by the polymeric precursor method. The films present a single phase of layered-structured perovskite with polar axis orientation after annealing at 700 degrees C for 2 h in static air and oxygen atmosphere. The a/b-axis orientation of the ferroelectric film is considered to be associated with the preferred orientation of the Pt bottom electrode. It is noted that the films annealed in static air showed good polarization fatigue characteristics at least up to 10(10) bipolar pulse cycles and excellent retention properties up to 10(4) s. on the other hand, oxygen atmosphere seems to be crucial in the decrease of both, fatigue and retention characteristics of the capacitors. Independently of the applied electric field, the retained switchable polarization approached a nearly steady-state value after a retention time of 10 s. (C) 2006 Elsevier B.V. All rights reserved.

Multivariate quality control studies applied to Ca(II) and Mg(II) determination by a portable method

A portable or field test method for simultaneous spectrophotometric determination of calcium and magnesium in water using multivariate partial least squares (PLS) calibration methods is proposed. The method is based on the reaction between the analytes and methylthymol blue at pH 11. The spectral information was used as the X-block, and the Ca(II) and Mg(II) concentrations obtained by a reference technique (ICP-AES) were used as the Y-block. Two series of analyses were performed, with a month's difference between them. The first series was used as the calibration set and the second one as the validation set. Multivariate statistical process control (MSPC) techniques, based on statistics from principal component models, were used to study the features and evolution with time of the spectral signals. Signal standardization was used to correct the deviations between series. Method validation was performed by comparing the predictions of the PLS model with the reference Ca(II) and Mg(II) concentrations determined by ICP-AES using the joint interval test for the slope and intercept of the regression line with errors in both axes. (C) 1998 John Wiley & Sons, Ltd.

Fabrication and testing of a poly(vinylidene fluoride) (PVDF) microvalve for gas flow control

A microactuator made from poly(vinylidene fluoride) (PVDF), a piezoelectric polymer, was fabricated to control the gas flow rate through a glass micronozzle. The actuator was formed by gluing together two PVDF sheets with opposite polarization directions. The sheets were covered with thin conducting films on one side, that were then used as electrodes to apply an electric field to move the valve. The actuator has a rectangular shape, 3 mm x 6 mm. The device was incorporated with a micronozzle fabricated by a powder blasting technique. Upon applying a DC voltage across the actuator electrodes, one sheet expands while the other contracts, generating an opening motion. A voltage of +300 V DC was used to open the device by moving the actuator 30 mu m, and a voltage of -200 V DC was used to close the device by moving the actuator 20 mu m lower than the relaxed position. Flow measurements were performed in a low-pressure vacuum system, maintaining the microvalve inlet pressure constant at 266 Pa. Tests carried out with the actuator in the open position and with a pressure ratio (inlet pressure divided by outlet pressure) of 0.5, indicated a flow rate of 0.36 sccm. In the closed position, and with a pressure ratio of 0.2, a flow rate of 0.32 sccm was measured.

Host specificity of Metriona elatior, a potential biological control agent of tropical soda apple, Solanum viarum, in the USA

The leaf beetle Metriona elatior from Brazil-Argentina was screened in the Florida (USA) State quarantine facility as a potential biological control agent of tropical soda apple, Solanum viarum, a recently arrived weed species. Multiple-choice host-specificity tests were conducted in small cages (60 cm x 60 cm x 60 cm) using 95 plant species in 29 families. Adults fed heavily on the main target weed (S. viarum), and on turkeyberry, Solanum torvum (noxious weed of Asiatic origin); fed moderately on red soda apple, Solanum capsicoides (weed of South American origin), and eggplant, Solanum melongena (economic crop); and fed lightly on aquatic soda apple, Solanum tampicense (weed of Mexican-Caribbean-Central American origin), and on silverleaf nightshade, Solanum elaeagnifolium (native weed widely distributed). M. elatior adults laid 84 to 97% of their egg masses on S. viarum, and 3 to 16% on S. melongena. Non-choice host-specificity tests were also conducted in quarantine in which M. elatior adults and neonate larvae were exposed to 17 and 19 plant species, respectively. Tests with the neonates indicate that this insect was able to complete its development on S. viarum, S. torvum, S. melongena, and S. capsicoides. Although some adult feeding and oviposition occurred on S. melongena in quarantine on potted plants in small cages, no feeding or oviposition by M. elatior was observed in field experiments conducted in Brazil. Surveys in unsprayed S. melongena fields in Argentina and Brazil indicated that M. elatior is not a pest of S. melongena in South America. The evidence obtained from the South-American field surveys, Brazil open-field experiments, and Florida quarantine host specificity tests indicate that M. elatior causes significant feeding damage to S. viarum, and does not represent a threat to S. melongena crops in the USA. Therefore an application for permission to release M. elatior against S. viarum in the USA was submitted in October 1998.

PHEIDOLE ANTS AS POTENTIAL BIOLOGICAL-CONTROL AGENTS OF THE BOLL-WEEVIL, ANTHONOMUS-GRANDIS (COL, CURCULIONIDAE), IN SOUTHEAST BRAZIL

This study evaluates the potential of ants as natural biological control agents of the boil weevil (Anthonomus grandis), during the between-season period, in South-east Brazil. Active adults of Anthonomus were experimentally distributed on the ground of the cotton field. Results show that 20% of the adult Anthonomus are attacked and removed by foraging ants. The native ant Pheidole oliveirai was by far the most efficient predator, accounting for 94% of the predation on Anthonomus. Recruited workers of P. oliveirai were usually very fast at transporting the weevils to their nests. The potential benefit of suppressing overwintering adult Anthonomus during the between-season period is mainly that of reducing the risk of high level infestations during the next cropping cycle.

Microstructure, dielectric properties and optical band gap control on the photoluminescence behavior of Ba[Zr0.25Ti0.75]O-3 thin films

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

The application of biochemical responses to assess environmental quality of tropical estuaries: field surveys

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Improving the field production environment for soybeans

During the past 10 years, soybeans have reached a prominent position among crops in the world. A substantial contribution to world production has been achieved by tropical countries, due to favorable conditions for high yields. Two limitations keep commercial yields below those obtained in experimental results (above 3,000 kg/ha): one is the lack of local adapted varieties and the other is an adequate field production environment. Solutions must be obtained by local research data. Seedbed preparation is one of the most important production steps, since the other production practices are dependent on it. Conventional methods and minimum tillage, when soybeans follow another crop, are being used, with the problem of soil compaction and losses by erosion. Looking for superior strains of Rhizobium is crucial because nitrogen can be supplied by a proper symbiosis. The addition of limestone to the soil is a common practice used to raise the pH to proper levels. The use of fertilizers should be guided by local research findings. Chemical control of weeds, pests and diseases is needed to prevent yield losses, but possible effects on the environment should be considered. © 1981 American Oil Chemists' Society.

Effect of Alternaria cassiae, Pseudocercospora nigricans, and soybean (Glycine max) planting density on the biological control of sicklepod (Senna obtusifolia)

The interactions of two fungal biocontrol agents, Alternaria cassiae and Pseudocercospora nigricans, and soybean planting density on sicklepod mortality and dry weight were studied in the field over 2 yr. The experimental field was divided into three equal areas: one without soybean and two where the soybean was sown in densities of 20 and 36 seeds per meter row with a 0.95-m row spacing. The fungi were sprayed alone or in a mixture at three growth stages of sicklepod plants grown at three levels of crop interference resulting from the three soybean planting densities. The fungal treatments were: an untreated control, A. cassiae (105 spores/m2), P. nigricans (3.3 g mycelium/m2), and the mixture of these two fungi. Sicklepod was at the cotyledonary leaf, two-leaf, and four-leaf stages when treated. Alternaria cassiae was most effective in reducing both sicklepod survival and dry weight. The mixture of P. nigricans and A. cassiae was generally comparable to but not better than A. cassiae alone in killing the weed (mortality) and reducing its growth (dry weight). Soybean density did not have significant effects on the mortality or the dry weight of sicklepod. Thus, there is no advantage to combining the highly effective biocontrol agent A. cassiae with the less effective P. nigricans or with soybean interference to control sicklepod. However, the results validate the efficacy of A. cassiae by itself as a bioherbicide.

Parasitism of Greenbugs (Homoptera: Aphididae) by Lysiphlebus testaceipes (Hymenoptera: Braconidae) in Grain Sorghum: Implications for Augmentative Biological Control

Field cage studies were conducted to describe the relationship between the percentage of Lysiphlebus testaceipes (Cresson) parasitism (as measured by aphid mummies) and densities of greenbug, Schizaphis graminum Rondani, on grain sorghum, Sorghum bicolor L. In 1993 and 1994, a biotype E-susceptible grain sorghum hybrid was grown in field cages and L. testaceipes adults were released after each plant was infested with 20 biotype E greenbugs. The release rates were 0, 0.5, 1.0, and 2.0 wasps per plant in 1993, and 0, 0.16, 0.33, and 0.5 wasps per plant in 1994. Greenbugs and mummies were counted 1-2 times a week on all leaves of 2-4 randomly selected plants per cage. A release rate of 0.33-0.5 wasps per plant infested with 20 greenbugs maximized the number of mummies produced and prevented the greenbugs from reaching an economic threshold of 1,000 greenbugs per plant. Peak numbers of mummies occurred ≈400-500 DD (10°C base) after the initial wasp release. Regression analyses showed that the greenbug population started decreasing when the percentage of parasitism (as measured by mummies) reached 20-30 %. Greenbugs in the absence of wasps significantly reduced yield in 1994, but not in 1993.

Activity of benomyl for control of postbloom fruit drop of citrus caused by Colletotrichum acutatum

Postbloom fruit drop (PFD) of citrus caused by Colletotrichum acutatum produces orange-brown lesions on petals and induces the abscission of young fruitlets and the retention of the calyces. Despite the fact that C. acutatum is not highly sensitive to benomyl in culture, this fungicide provides good control of the disease under field conditions. This study was undertaken to determine the effect of benomyl on various stages of disease development to understand the basis for its effectiveness in the field. We found that benomyl at 1.0 μg/ml reduced colony area of C. acutatum by about 75% and completely inhibited growth of C. gloeosporioides. Benomyl did not prevent conidial germination even at 100 μg/ml, but reduced germ tube elongation at 10 and 100 μg/ml. When benomyl was applied to flower clusters on screen-house-grown plants before inoculation, disease severity was greatly reduced. Applications at 24 and 48 h, but not at 72 h, after inoculation reduced PFD severity. Application of benomyl to symptomatic petals not bearing conidia did not prevent or reduce production of inoculum. Application to petals bearing conidia reduced viability of these fungal propagules by only about 50%. The viability of appressoria on mature leaves was not affected by benomyl application. Even when appressoria on mature leaves were stimulated to germinate by treatment with flower extracts, subsequent application of benomyl did not reduce propagule numbers below original levels. Benomyl appears to act by preventing infection and early development of the fungus in petals. However, once symptoms have developed, this fungicide has only minimal effects on further disease development and spread.

An AC voltage regulator with high-power-factor, and control using a FPGA device

This paper presents the analysis, design, simulation, and experimental results for a high frequency high Power-Factor (PF) AC (Alternate Current) voltage regulator, using a Sepic converter as power stage. The control technique employed to impose a sinusoidal input current waveform, with low Total Harmonic Distortion (THD), is the sinusoidal variable hysteresis control. The control technique was implemented in a FPGA (Field Programmable Gate Array) device, using a Hardware Description Language (VHDL). Through the use of the proposed control technique, the AC voltage regulator performs active power-factor correction, and low THD in the input current, for linear and non-linear loads, satisfying the requirements of the EEC61000-3-2 standards. Experimental results from an example prototype, designed for 300W of nominal output power, 50kHz (switching frequency), and 127Vrms of nominal input and output voltages, are presented in order to validate the proposed AC regulator. © 2005 IEEE.