Retorno de nutrientes ao solo via deposição de serapilheira de quatro espécies leguminosas arbóreas na região de Botucatu - São Paulo, Brasil

The annual litter fall production and the concentrations of macronutrients of four leguminous tree species were evaluated. The experiment was installed in a distrophic red yellow latosol (Oxisol), derivative of the Bauru sandstone group. The studied species were: Leucaena leucocephala. Acacia melanoxylon, L. diversifolia and Mimosa scabrella. The experimental design was randomized blocks, with four treatments (species) and four replications. The litter fall was collected in boxes measuring 50×50×10 cm, two boxes by treatment in each block. The material was collected monthly and dried, weighed and chemically analyzed. The litter fall deposition occurred in the following order: M. scabrella (7,051 kg ha -1 ano -1), A. melanoxylon (2,789 kg ha -1 ano -1), L. diversifolia (1,576 kg ha -1 ano -1) and L. leucocephala (1,389 kg ha -1 ano -1). The content of nutrients obeyed the following order: N>Ca>K>Mg>P>S, with the exception of L. leucocephala that presented a bigger content of S in relation to the P.

Magnetic domain states in nano-sized Co nuclei electrodeposited onto monocrystalline silicon

In the present work, nano-sized magnetic nuclei of Co have been electrodeposited onto p-Si (111). The deposition follows a mechanism of progressive nucleation and growth controlled by diffusion. MFM studies showed that the transition between magnetic domain states is strongly dependent on the size and shape of the nuclei. A critical height h0 is defined below which the nuclei presented always a single-domain configuration. The limiting lower boundary for the single-domain state calculated from the theory is quantitatively coincident with the experimental results. © 2004 Elsevier B.V. All rights reserved.

Ferroelectric and structural instability of (Pb,Ca)TiO3 thin films prepared in an oxygen atmosphere and deposited on LSCO thin films which act as a buffer layer

Structural, microstructural and ferroelectric properties of Pb0.90Ca0.10TiO3 (PCT10) thin films deposited using La0.50Sr0.50CoO3 (LSCO) thin films which serve only as a buffer layer were compared with properties of the thin films grown using a platinum-coated silicon substrate. LSCO and PCT10 thin films were grown using the chemical solution deposition method and heat-treated in an oxygen atmosphere at 700 °C and 650 °C in a tube oven, respectively. X-ray diffraction (XRD) and Raman spectroscopy results showed that PCT10 thin films deposited directly on a platinum-coated silicon substrate exhibit a strong tetragonal character while thin films with the LSCO buffer layer displayed a smaller tetragonal character. Surface morphology observations by atomic force microscopy (AFM) revealed that PCT10 thin films with a LSCO buffer layer had a smoother surface and smaller grain size compared with thin films grown on a platinum-coated silicon substrate. Additionally, the capacitance versus voltage curves and hysteresis loop measurement indicated that the degree of polarization decreased for PCT10 thin films on a LSCO buffer layer compared with PCT10 thin films deposited directly on a platinum-coated silicon substrate. This phenomenon can be described as the smaller shift off-center of Ti atoms along the c-direction 〈001〉 inside the TiO6 octahedron unit due to the reduction of lattice parameters. Remnant polarization (P r ) values are about 30 μC/cm2 and 12 μC/cm2 for PCT10/Pt and PCT10/LSCO thin films, respectively. Results showed that the LSCO buffer layer strongly influenced the structural, microstructural and ferroelectric properties of PCT10 thin films. © 2013 Elsevier Ltd and Techna Group S.r.l.

Construção e caracterização de células solares de filmes finos de CdS e CdTe

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Preparação e caracterização de semicondutores de PbS e 'B IND. I 'IND. 2' 'S IND. 3' obtidos pelo método de deposição em banho químico

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Estudo in vitro de braquetes ortodônticos: avaliação biomecânica e liberação de íons

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Análise do comportamento biomecânico de fios ortodônticos após tratamento de superfície

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Influência do tratamento de superfície na força friccional de fios ortodônticos de NiTi-estudo in vitro

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Assistência de ar em pulverização no manejo fitossanitário na cultura da soja Glycine max (L.) Merrill

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Filmes evaporados de ftalocianina de cobalto: arquitetura molecular e aplicação sensorial

Pós-graduação em Ciência e Tecnologia de Materiais - FC

Desenvolvimento e seleção de sensores para avaliação de refrigerantes em língua eletrônica

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Síntese de nanofios de óxidos semicondutores para aplicações em dispositivos ópticos e eletrônicos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Fabricação e caracterização estrutural de filmes evaporados de ftalocianinas

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Eletrodos nanoestruturados de 'TI' 'O IND.2' aplicados na degradação fotoeletrocatalítica de aminas aromáticas e desenvolvimento de dispositivo fotovoltaico 'TI 'O IND.2' / 'SB IND.2' 'S IND.3' / 'P3' 'HT'

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Large-Area Plasmonic Substrate of Silver-Coated Iron Oxide Nanorod Arrays for Plasmon-Enhanced Spectroscopy

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)