Effectiveness of Foliar Fungicides by Timing on Hybrid Corn in Iowa

Fungicide use on hybrid corn has increased considerably in the past three growing seasons primarily due to reports of increased yields, even in the absence of disease and higher corn prices. A number of fungicides are registered for use on corn. The objectives of this project were to 1) evaluate the yield response of hybrid corn to foliar fungicide application, 2) compare the yield response of various products and timing of application, and 3) to assess the effect of fungicide application on stalk rot development.

Effectiveness of Foliar Fungicides by Timing on Hybrid Corn

Fungicides were rarely used on hybrid corn prior to 2007, however, in the past few years some farmers have made fungicides a regular input in their crop production, particularly as the value of grain has increased. Fungicides are recommended for foliar disease management to protect yield potential. There have also been reports of increased yields in the absence of disease. A number of fungicides are registered for use on corn. The objectives of this project were to evaluate the yield response of hybrid corn to foliar fungicide application at various timings.

Chemical and Sr isotopic compositions and timing of carbonate mineral precipitation, ODP Leg 115

The strontium isotope ratios of authigenic carbonates from Indian Ocean sea-floor basalts have been used to determine the timing of carbonate mineral precipitation and fluid flow. The samples include calcites from 57.2 Ma crust from Ocean Drilling Project (ODP) Site 715, and calcites, aragonites, and siderites from 63.7 Ma crust from ODP Site 707. At Site 715, calcite precipitation may have begun at any time after the basalts cooled, and it continued until approximately 31 Ma, or 26 m.y. after basalt eruption. At Site 707, aragonite and siderite did not begin to precipitate until about 36 Ma, almost 30 m.y. after basalt eruption, and continued to precipitate until at least 30 and 28 Ma, respectively. Calcite precipitation began at approximately 32 Ma and continued until 22 Ma. These ages suggest that vein mineral deposition and low-temperature fluid circulation in the ocean crust may continue for much longer periods of time than previously observed.

Simulated agricultural subsistence, timing of transition, and percentage of immigrant farmers

Farming and herding were introduced to Europe from the Near East and Anatolia; there are, however, considerable arguments about the mechanisms of this transition. Were it the people who moved and either outplaced, or admixed with, the indigenous hunter-gatherer groups? Or was it material and information that moved---the Neolithic Package---consisting of domesticated plants and animals and the knowledge of their use? The latter process is commonly referred to as cultural diffusion and the former as demic diffusion. Despite continuous and partly combined efforts by archaeologists, anthropologists, linguists, palaeontologists and geneticists, a final resolution of the debate has not yet been reached. In the present contribution we interpret results from the Global Land Use and technological Evolution Simulator (GLUES). GLUES is a mathematical model for regional sociocultural development, embedded in the geoenvironmental context, during the Holocene. We demonstrate that the model is able to realistically hindcast the expansion speed and the inhomogeneous space-time evolution of the transition to agropastoralism in western Eurasia. In contrast to models that do not resolve endogenous sociocultural dynamics, our model describes and explains how and why the Neolithic advanced in stages. We uncouple the mechanisms of migration and information exchange and also of migration and the spread of agropastoralism. We find that: (1) An indigenous form of agropastoralism could well have arisen in certain Mediterranean landscapes, but not in Northern and Central Europe, where it depended on imported technology and material. (2) Both demic diffusion by migration and cultural diffusion by trade may explain the western European transition equally well. (3) Migrating farmers apparently contribute less than local adopters to the establishment of agropastoralism. Our study thus underlines the importance of adoption of introduced technologies and economies by resident foragers.

Timing of the most recent Neoglacial advance and retreat in Potter Cove, Antarctic Peninsula

The timing of the most recent Neoglacial advance in the Antarctic Peninsula is important for establishing global climate teleconnections and providing important post-glacial rebound corrections to gravity-based satellite measurements of ice loss. However, obtaining accurate ages from terrestrial geomorphic and sedimentary indicators of the most recent Neoglacial advance in Antarctica has been hampered by the lack of historical records and the difficulty of dating materials in Antarctica. Here we use a new approach to dating flights of raised beaches in the South Shetland Islands of the northern Antarctic Peninsula to bracket the age of a Neoglacial advance that occurred between 1500 and 1700 AD, broadly synchronous with compilations for the timing of the Little Ice Age in the northern hemisphere. Our approach is based on optically stimulated luminescence of the underside of buried cobbles to obtain the age of beaches previously shown to have been deposited immediately inside and outside the moraines of the most recent Neoglacial advance. In addition, these beaches mark the timing of an apparent change in the rate of isostatic rebound thought to be in response to the same glacial advance within the South Shetland Islands. We use a Maxwell viscoelastic model of glacial-isostatic adjustment (GIA) to determine whether the rates of uplift calculated from the raised beaches are realistic given the limited constraints on the ice advance during this most recent Neoglacial advance. Our rebound model suggests that the subsequent melting of an additional 16-22% increase in the volume of ice within the South Shetland Islands would result in a subsequent uplift rate of 12.5 mm/yr that lasted until 1840 AD resulting in a cumulative uplift of 2.5 m. This uplift rate and magnitude are in close agreement with observed rates and magnitudes calculated from the raised beaches since the most recent Neoglacial advance along the South Shetland Islands and falls within the range of uplift rates from similar settings such as Alaska.

Upper bound on neutrino mass based on T2K neutrino timing measurements

The Tokai to Kamioka (T2K) long-baseline neutrino experiment consists of a muon neutrino beam, produced at the J-PARC accelerator, a near detector complex and a large 295 km distant far detector. The present work utilizes the T2K event timing measurements at the near and far detectors to study neutrino time of flight as function of derived neutrino energy. Under the assumption of a relativistic relation between energy and time of flight, constraints on the neutrino rest mass can be derived. The sub-GeV neutrino beam in conjunction with timing precision of order tens of ns provide sensitivity to neutrino mass in the few MeV/c^2 range. We study the distribution of relative arrival times of muon and electron neutrino candidate events at the T2K far detector as a function of neutrino energy. The 90% C.L. upper limit on the mixture of neutrino mass eigenstates represented in the data sample is found to be m^2 < 5.6 MeV^2/c^4.

Response timing in the lunge and target change in elite versus medium-level fencers.

The aim of the present work is to examine the differences between two groups of fencers with different levels of competition, elite and medium level. The timing parameters of the response reaction have been compared together with the kinetic variables which determine the sequence of segmented participation used during the lunge with a change in target during movement. A total of 30 male sword fencers participated, 13 elite and 17 medium level. Two force platforms recorded the horizontal component of the force and the start of the movement. One system filmed the movement in 3D, recording the spatial positions of 11 markers, while another system projected a mobile target over a screen. For synchronisation, an electronic signal enabled all the systems to be started simultaneously. Among the timing parameters of the reaction response, the choice reaction time (CRT) to the target change during the lunge was measured. The results revealed differences between the groups regarding the flight time, horizontal velocity at the end of the acceleration phase, and the length of the lunge, these being higher for the elite group, as well as other variables related to the temporal sequence of movement. No significant differences have been found in the simple reaction time or in CRT. According to the literature, the CRT appears to improve with sports practice, although this factor did not differentiate the elite from medium-level fencers. The coordination of fencing movements, that is, the right technique, constitutes a factor that differentiates elite fencers from medium-level ones.

Timing performances of a data acquisition system for time of flight PET

We are investigating the performances of a data acquisition system for Time of Flight PET, based on LYSO crystal slabs and 64 channels Silicon Photomultipliers matrices (1.2 cm2 of active area each). Measurements have been performed to test the timing capability of the detection system (SiPM matices coupled to a LYSO slab and the read-out electronics) with both test signal and radioactive source.

Low-complexity timing synchronization scheme for MB-OFDM UWB receiver based on sign-bit

A unified low complexity sign-bit correlation based symbol timing synchronization scheme for Multiband Orthogonal Frequency Division Multiplexing (MB-OFDM) Ultra Wideband (UWB) receiver system is proposed. By using the time domain sequence of the packet/frame synchronization preamble, the proposed scheme is in charge of detecting the upcoming MB-OFDM symbol and it estimates the exact boundary of the start of Fast Fourier Transform (FFT) window. The proposed algorithm is implemented by using an efficient Hardware-Software co-simulation methodology. The effectiveness of the proposed synchronization scheme and the optimization criteria is confirmed by hardware implementation results.