Revised depth scale, splice tie points and chron boundaries of ODP Hole 151-907A and Site 162-907

The magnetic polarity stratigraphy at Site 907 obtained from the shipboard pass-through magnetometer and from discrete samples is readily interpretable back to the onset of the Gilbert Chron (5.89 Ma). From this level to the base of the section at ~14 Ma, the interpretation is corroborated by silicoflagellate datums with predictable correlation to polarity chrons. The resulting magnetostratigraphic interpretation differs from those proposed in the Leg 151 (Hole 907A) and 162 (Holes 907B and 907C) Initial Reports volumes. An important hiatus in the 7-10 Ma interval at Site 907 caused sedimentation to slow or cease for ~2.7 m.y. We have revised the shipboard correlation among the three holes at Site 907, resulting in a new composite section splice and recalculation of composite depths. For Site 985, magnetostratigraphic interpretation is possible down to ~150 meters below seafloor (mbsf) (C3An/C3Ar) at ~6 Ma. There are no useful biostratigraphic datums from Site 985 to support this interpretation; however, the interpretation is supported by the correlation of Sites 985 and 907 using natural gamma data from the shipboard multisensor track. Below ~150 mbsf at Site 985, drilling-related deformation at the onset of extended core barrel drilling precluded magnetostratigraphic interpretation.

Composite depth scale, tie points and magnetic susceptibilities of ODP Site 178-1098 sediments

Multiple holes were cored at Ocean Drilling Program Leg 178 Sites 1098 and 1099 in two subbasins of the Palmer Deep in order to recover complete and continuous records of sedimentation. By correlating measured properties of cores from different holes at a site, we have established a common depth scale, referred to as the meters composite depth scale (mcd), for all cores from Site 1098. For Site 1098, distinct similarities in the magnetic susceptibility records obtained from three holes provide tight constraints on between-hole correlation. Additional constraints come from lithologic features. Specific intervals from other data sets, particularly gamma-ray attenuation bulk density, magnetic intensity, and color reflectance, contain distinctive anomalies that correlate well when placed into the preferred composite depth scale, confirming that the scale is accurate. Coring in two holes at Site 1099 provides only a few meters of overlap. None of the data sets within this limited overlap region provide convincing correlations. Thus, the preferred composite depth scale for Site 1099 is the existing depth scale in meters below seafloor (mbsf).

Core alignment and composite depth scale of DSDP Site 86-577

Deep Sea Drilling Project Site 577 on Shatsky Rise (North Pacific Ocean) recovered a series of cores at three holes that contain calcareous nannofossil ooze of latest Cretaceous (late Maastrichtian) through early Eocene age. Several important records have been generated using samples from these cores, but the stratigraphy has remained outdated and confusing. Here we revise the stratigraphy at Site 577. This includes refining several age datums, realigning cores in the depth domain, and placing all stratigraphic markers on a current time scale. The work provides a template for appropriately bringing latest Cretaceous and Paleogene data sets at old drill sites into current paleoceanographic literature for this time interval. While the Paleocene Eocene Thermal Maximum (PETM) lies within core gaps at Holes 577* and 577A, the sedimentary record at the site holds other important events and remains crucially relevant to understanding changes in oceanographic conditions from the latest Cretaceous through early Paleogene.

Fig. S1. Loci of possible event locations based on differential ts - tp arrival times at the single functioning geophone

Geological storage of CO2 that has been captured at large, point source emitters represents a key potential method for reduction of anthropogenic greenhouse gas emissions. However, this technology will only be viable if it can be guaranteed that injected CO2 will remain trapped in the subsurface for thousands of years or more. A signi?cant issue for storage security is the geomechanical response of the reservoir. Concerns have been raised that geomechanical deformation induced by CO2 injection will create or reactivate fracture networks in the sealing caprocks, providing a pathway for CO2 leakage. In this paper, we examine three large-scale sites where CO2 is injected at rates of ab. 1 megatonne/y or more: Sleipner, Weyburn, and In Salah. We compare and contrast the observed geomechanical behavior of each site, with particular focus on the risks to storage security posed by geomechanical deformation. At Sleipner, the large, high-permeability storage aquifer has experienced little pore pressure increase over 15 y of injection, implying little possibility of geomechanical deformation. At Weyburn, 45 y of oil production has depleted pore pressures before increases associated with CO2 injection. The long history of the ?eld has led to complicated, sometimes nonintuitive geomechanical deformation. At In Salah, injection into the water leg of a gas reservoir has increased pore pressures, leading to uplift and substantial microseismic activity. The differences in the geomechanical responses of these sites emphasize the need for systematic geomechanical appraisal before injection in any potential storage site.

Millenial-Scale stable oxygen isotope record of ODP Site 172-1058

We use the oxygen isotopic composition of planktonic foraminifera Globigerinoides ruber (white) from Ocean Drilling Program Site 1058 in the subtropical northwestern Atlantic to construct a high-resolution (~800 year) climate record spanning the mid-Pleistocene climate transition (~410 ka to 1350 ka). We investigate whether or not millennial-scale instabilities in the proxy record are associated with the extent of continental glaciation. G. ruber d18O values display high-frequency fluctuations throughout the record, but the amplitude about mean glacial and interglacial d18O values increases at marine isotope stage (MIS) 22 (880 ka) and is highest during MIS 12. These observations support that millennial-scale climate instabilities are associated with ice sheet size. Time series analysis illustrates that these variations have significant concentration of spectral power centered on periods of ~10-12 ka and ~5 ka. The timing of these fluctuations agrees well, or coincides with, the periodicities of the second and fourth harmonics, respectively, of precessional forcing at the equator. An insolation-based origin of the millennial-scale instabilities would be independent of ice volume and explains the presence of these fluctuations before the mid-Pleistocene climate transition as well as during interglacial intervals (e.g., MIS 37 and 17). Because the amplitude of the millennial-scale variations increases during the mid-Pleistocene transition, feedback mechanisms associated with the growth of large, 100-ka-paced, polar ice sheets may be important amplifiers of regional surface water hydrographic changes.

Minerals, geochemistry and x-ray power characteristics at DSDP Sites 54-424, 60-458 and 60-459

Secondary minerals filling veins and vesicles in volcanic basement at Deep Sea Drilling Project Sites 458 and 459 indicate that there were two stages of alteration at each site: an early oxidative, probably hydrothermal, stage and a later, low-temperature, less oxidative stage, probably contemporaneous with faulting in the tectonically active Mariana forearc region. The initial stage is most evident in Hole 459B, where low-Al, high Fe smectites and iron hydroxides formed in vesicles in pillow basalts and low-Al palygorskite formed in fractures. Iron hydroxides and celadonite formed in massive basalts next to quartz-oligoclase micrographic intergrowths. Palygorskite was found in only one sample near the top of basement in Hole 458, but it too is associated with iron hydroxides. Palygorskite has previously been reported only in marine sediments in DSDP and other occurrences. It evidently formed here as a precipitate from fluids in which Si, Mg, Fe, and even some Al were concentrated. Experimental data suggest that the solutions probably had high pH and somewhat elevated temperatures. The compositions of associated smectites resemble those in hydrothermal sediments and in basalts at the Galapagos mounds geothermal field. The second stage of alteration was large-scale replacement of basalt by dioctahedral, trioctahedral, or mixed-layer clays and phillipsite along zones of intense fracturing, especially near the bottom of Holes 458 and 459B. The basalts are commonly slickensided, and there are recemented microfault offsets in overlying sediments. Native copper occurs in one core of Hole 458, but associated smectites are dominantly dioctahedral, unlike Hole 459B, where they are mainly trioctahedral, indicating nonoxidative alteration. The alteration in both holes is more intense than at most DSDP ocean crust sites and may have been augmented by water derived from subducting ocean crust beneath the fore-arc region.

Procyclical Productivity and Returns-to-Scale in Philippine Manufacturing

The Philippines is regarded as a highly oligopolistic economy, and it is argued that this is a cause of the relative stagnation of the economy to neighbouring East Asian economies. This presumption might be associated with increasing returns to scale and market power, which are consistent with the procyclical total factor productivity that is observed in the Philippines and the United States. However, this study found no strong evidence supporting increasing returns for aggregate manufacturing and three-digit manufacturing industries during 1956-1980 in the Philippines, based on data constructed by Hooley (1985). Further, this study does not support external effect discussed in Caballero and Lyons (1992).

Clean Coal Technologies Scenario and Evaluation of Present CO2 Dwindling Initiatives to Approach Zero Emission Power Stations By Coal Combustion. Deployment Situation and Evaluation Study

In the present uncertain global context of reaching an equal social stability and steady thriving economy, power demand expected to grow and global electricity generation could nearly double from 2005 to 2030. Fossil fuels will remain a significant contribution on this energy mix up to 2050, with an expected part of around 70% of global and ca. 60% of European electricity generation. Coal will remain a key player. Hence, a direct effect on the considered CO2 emissions business-as-usual scenario is expected, forecasting three times the present CO2 concentration values up to 1,200ppm by the end of this century. Kyoto protocol was the first approach to take global responsibility onto CO2 emissions monitoring and cap targets by 2012 with reference to 1990. Some of principal CO2emitters did not ratify the reduction targets. Although USA and China spur are taking its own actions and parallel reduction measures. More efficient combustion processes comprising less fuel consuming, a significant contribution from the electricity generation sector to a CO2 dwindling concentration levels, might not be sufficient. Carbon Capture and Storage (CCS) technologies have started to gain more importance from the beginning of the decade, with research and funds coming out to drive its come in useful. After first researching projects and initial scale testing, three principal capture processes came out available today with first figures showing up to 90% CO2 removal by its standard applications in coal fired power stations. Regarding last part of CO2 reduction chain, two options could be considered worthy, reusing (EOR & EGR) and storage. The study evaluates the state of the CO2 capture technology development, availability and investment cost of the different technologies, with few operation cost analysis possible at the time. Main findings and the abatement potential for coal applications are presented. DOE, NETL, MIT, European universities and research institutions, key technology enterprises and utilities, and key technology suppliers are the main sources of this study. A vision of the technology deployment is presented.