Modeling, Estimation, and Control of Robot-Soil Interactions

This thesis presents the development of hardware, theory, and experimental methods to enable a robotic manipulator arm to interact with soils and estimate soil properties from interaction forces. Unlike the majority of robotic systems interacting with soil, our objective is parameter estimation, not excavation. To this end, we design our manipulator with a flat plate for easy modeling of interactions. By using a flat plate, we take advantage of the wealth of research on the similar problem of earth pressure on retaining walls. There are a number of existing earth pressure models. These models typically provide estimates of force which are in uncertain relation to the true force. A recent technique, known as numerical limit analysis, provides upper and lower bounds on the true force. Predictions from the numerical limit analysis technique are shown to be in good agreement with other accepted models. Experimental methods for plate insertion, soil-tool interface friction estimation, and control of applied forces on the soil are presented. In addition, a novel graphical technique for inverting the soil models is developed, which is an improvement over standard nonlinear optimization. This graphical technique utilizes the uncertainties associated with each set of force measurements to obtain all possible parameters which could have produced the measured forces. The system is tested on three cohesionless soils, two in a loose state and one in a loose and dense state. The results are compared with friction angles obtained from direct shear tests. The results highlight a number of key points. Common assumptions are made in soil modeling. Most notably, the Mohr-Coulomb failure law and perfectly plastic behavior. In the direct shear tests, a marked dependence of friction angle on the normal stress at low stresses is found. This has ramifications for any study of friction done at low stresses. In addition, gradual failures are often observed for vertical tools and tools inclined away from the direction of motion. After accounting for the change in friction angle at low stresses, the results show good agreement with the direct shear values.

Markov Process Modeling of A System Under WIPLOAD Control

This paper analyzes a proposed release controlmethodology, WIPLOAD Control (WIPLCtrl), using a transfer line case modeled by Markov process modeling methodology. The performance of WIPLCtrl is compared with that of CONWIP under 13 system configurations in terms of throughput, average inventory level, as well as average cycle time. As a supplement to the analytical model, a simulation model of the transfer line is used to observe the performance of the release control methodologies on the standard deviation of cycle time. From the analysis, we identify the system configurations in which the advantages of WIPLCtrl could be observed.

Mission control system for dam inspection with an AUV

This paper presents a complete control architecture that has been designed to fulfill predefined missions with an autonomous underwater vehicle (AUV). The control architecture has three levels of control: mission level, task level and vehicle level. The novelty of the work resides in the mission level, which is built with a Petri network that defines the sequence of tasks that are executed depending on the unpredictable situations that may occur. The task control system is composed of a set of active behaviours and a coordinator that selects the most appropriate vehicle action at each moment. The paper focuses on the design of the mission controller and its interaction with the task controller. Simulations, inspired on an industrial underwater inspection of a dam grate, show the effectiveness of the control architecture

Constraint satisfaction techniques under uncertain conditions for fault diagnosis in nonlinear dynamic systems

The speed of fault isolation is crucial for the design and reconfiguration of fault tolerant control (FTC). In this paper the fault isolation problem is stated as a constraint satisfaction problem (CSP) and solved using constraint propagation techniques. The proposed method is based on constraint satisfaction techniques and uncertainty space refining of interval parameters. In comparison with other approaches based on adaptive observers, the major advantage of the presented method is that the isolation speed is fast even taking into account uncertainty in parameters, measurements and model errors and without the monotonicity assumption. In order to illustrate the proposed approach, a case study of a nonlinear dynamic system is presented

ELEC3035: Control System Design

Lecture slides, handouts for tutorials, exam papers, and numerical examples for a third year course on Control System Design.

Improving social capital : a social network monitoring system. 'Mejorar el capital social : un sistema de red de control social'.

Resumen tomado del autor

New delay-dependent stability criteria for uncertain neutral systems with mixed time-varying delays and nonlinear perturbations

The problem of stability analysis for a class of neutral systems with mixed time-varying neutral, discrete and distributed delays and nonlinear parameter perturbations is addressed. By introducing a novel Lyapunov-Krasovskii functional and combining the descriptor model transformation, the Leibniz-Newton formula, some free-weighting matrices, and a suitable change of variables, new sufficient conditions are established for the stability of the considered system, which are neutral-delay-dependent, discrete-delay-range dependent, and distributeddelay-dependent. The conditions are presented in terms of linear matrix inequalities (LMIs) and can be efficiently solved using convex programming techniques. Two numerical examples are given to illustrate the efficiency of the proposed method

A mission control system for an autonomous underwater vehicle

The presented work focuses on the theoretical and practical aspects concerning the design and development of a formal method to build a mission control system for autonomous underwater vehicles bringing systematic design principles for the formal description of missions using Petri nets. The proposed methodology compounds Petri net building blocks within it to de_ne a mission plan for which it is proved that formal properties, such as reachability and reusability, hold as long as these same properties are also guaranteed by each Petri net building block. To simplify the de_nition of these Petri net blocks as well as their composition, a high level language called Mission Control Language has been developed. Moreover, a methodology to ensure coordination constraints for teams of multiple robots as well as the de_nition of an interface between the proposed system and an on-board planner able to plan/replan sequences of prede_ned mission plans is included as well. Results of experiments with several real underwater vehicles and simulations involving an autonomous surface craft and an autonomous underwater vehicles are presented to show the system's capabilities.

Semiactive control strategies for vibration mitigation in adaptronic structures equipped with magnetorheological dampers

Los sistemas tales como edificios y veh¨ªculos est¨¢n sujetos a vibraciones que pueden causar mal funcionamiento, incomodidad o colapso. Para mitigar estas vibraciones, se suelen instalar amortiguadores. Estas estructuras se convierten en sistemas adaptr¨®nicos cuando los amortiguadores son controlables. Esta tesis se enfoca en la soluci¨®n del problema de vibraciones en edificios y veh¨ªculos usando amortiguadores magnetoreol¨®gicos (MR). Estos son unos amortiguadores controlables caracterizados por una din¨¢mica altamente no lineal. Adem¨¢s, los sistemas donde se instalan se caracterizan por la incertidumbre param¨¦trica, la limitaci¨®n de medidas y las perturbaciones desconocidas, lo que obliga al uso de t¨¦cnicas complejas de control. En esta tesis se usan Backstepping, QFT y H2/H¡Þ mixto para resolver el problema. Las leyes de control se verifican mediante simulaci¨®n y experimentaci¨®n.

Development of a decision support system for the integrated control of membrane bioreactors

The work presented in this PhD thesis includes various partial studies aimed at developing a decision support system for membrane bioreactor integrated control. The decision support systems (DSS) have as a main goal to facilitate the operation of complex processes due to the multiple variables that are processed. For this reason, the research used has focused on aspects related to nutrient removal, and on the development of indicators or sensors capable of facilitating, automating and controlling the filtration process in an integrated way with the biological processes that taking place. Work has also been done on the design, development, implementation and validation of tools based on the knowledge made available by the automatic control and the supervision of the MBRs

Development of an air-scour control system for membrane bioreactors

The thesis involves the development and implementation of a new and robust control system based on permeability trends but at the same time capable of reducing aeration proportionally to permeate flux. Permeability was made a key parameter for directly comparing temporary changes in membrane performance. Transmembrane pressure and flux were gathered every 10 seconds and permeability values were automatically calculated; different mathematical algorithms were applied for the signal filtering of on-line data. Short term and long term permeability trends were compared once a day, and a control action was applied proportionally to the short term/long term permeability ratio without exceeding the aeration flow recommended by the membrane suppliers.

Real-Time software control of neural stimulation in a closed loop Animat system

A recent area for investigation into the development of adaptable robot control is the use of living neuronal networks to control a mobile robot. The so-called Animat paradigm comprises a neuronal network (the ‘brain’) connected to an external embodiment (in this case a mobile robot), facilitating potentially robust, adaptable robot control and increased understanding of neural processes. Sensory input from the robot is provided to the neuronal network via stimulation on a number of electrodes embedded in a specialist Petri dish (Multi Electrode Array (MEA)); accurate control of this stimulation is vital. We present software tools allowing precise, near real-time control of electrical stimulation on MEAs, with fast switching between electrodes and the application of custom stimulus waveforms. These Linux-based tools are compatible with the widely used MEABench data acquisition system. Benefits include rapid stimulus modulation in response to neuronal activity (closed loop) and batch processing of stimulation protocols.

The effects of different forms of advice on the control of a simulated complex system

Three experiments examine the effect of different forms of computer-generated advice on concurrent and subsequent performance of individuals controlling a simulated intensive-care task. Experiment 1 investigates the effect of optional and compulsory advice and shows that both result in an improvement in subjects' performance while receiving the advice, and also in an improvement in subsequent unaided performance. However, although the advice compliance displayed by the optional advice group shows a strong correlation with subsequent unaided performance, compulsory advice has no extra benefit over the optional use of advice. Experiment 2 examines the effect of providing users with on-line explanations of the advice, as well as providing less specific advice. The results show that both groups perform at the same level on the task as the advice groups from Experiment 1, although subjects receiving explanations scored significantly higher on a written post-task questionnaire. Experiment 3 investigates in more detail the relationship between advice compliance and performance. The results reveal a complex relationship between natural ability on the task and the following of advice, in that people who use the advice more tend to perform either better or worse than the more moderate users. The theoretical and practical implications of these experiments are discussed.